Filter Paper Method for the Determination of the Soil Water Retention Curve

ABSTRACT High cost and long time required to determine a retention curve by the conventional methods of the Richards Chamber and Haines Funnel limit its use; therefore, alternative methods to facilitate this routine are needed. The filter paper method to determine the soil water retention curve was evaluated and compared to the conventional method. Undisturbed samples were collected from five different soils. Using a Haines Funnel and Richards Chamber, moisture content was obtained for tensions of 2; 4; 6; 8; 10; 33; 100; 300; 700; and 1,500 kPa. In the filter paper test, the soil matric potential was obtained from the filter-paper calibration equation, and the moisture subsequently determined based on the gravimetric difference. The van Genuchten model was fitted to the observed data of soil matric potential versus moisture. Moisture values of the conventional and the filter paper methods, estimated by the van Genuchten model, were compared. The filter paper method, with R2 of 0.99, can be used to determine water retention curves of agricultural soils as an alternative to the conventional method.

Prospective determination of imipenem concentration of the plasma of critically-ill children

ABSTRACT Imipenem plasma-concentrations were measured in 19 critically-ill children (median 0.8 year, range 0.02-12.9 years). Wide inter-individual variations (2-4x at peak and >10x at through concentrations) resulted in unpredictable plasma-levels in several children. To avoid subtherapeutic drug levels we recommend at least 100 mg/kg/day of imipenem-cilastatin in critically-ill children requiring such therapy.

Intrathecal administration of Ziconotide: does single-shot injection predict efficacy?

Introduction: Though a trial of intrathecal (IT) therapy should always be performed before implantation of a definitive intrathecal pump, there is no agreement as to how this test should be performed. Ziconotide is trialed in most of cases with continuous IT administration using implanted catheters. Unlike other intrathecal drugs, there is little experience with single bolus IT injections of ziconotide. The aim of the study is to assess the feasibility of single-shot IT trialing with ziconotide. Patients and methods: Eleven consecutive patients with chronic neuropathic intractable pain were trialed with a single IT bolus of 2.5 mcg of ziconotide. Pain and side effects are monitored for at least 72 hours after the injection. Depending on the response, a second injection is given a week later, with either the same dose (if VAS decreased ≥50% without side effects), a higher dose of 3.75 mcg (if VAS decreased <50% without side effects) or a lower dose of 1.25 mcg (if VAS decreased ≥50% but with side effects). If VAS decreased less than 50% and side effects occurred, no further injection was performed. When VAS decreased >50% without side effects after the first or the second dose, the result is confirmed by one more injection of the same dose one week later. The trial is considered positive if two successive injections provide a VAS decreased more than 50% without side effects. Results: Eleven patients (6 females and 5 males) were included. Nine patients experienced modest or no pain relief. Four of these had significant side effects (dizziness, nausea, vomiting or abdominal pain) and had no further injection. In the others 5, one patient retired from study and four received a second injection of 3.75 mcg. The trial was negative in all 5 cases because of side effects (dizziness, drowsiness, weakness, muscle cramps), the pain decreased in only 2 patients. Two patients experienced profound pain relief with an IT injection of 2.5 mcg. One patient had no side effects and the other had dizziness and drowsiness that disappeared with an injection of 1.25 mcg. Pain relief without adverse effects was confirmed with the second injection. The trial was considered positive for those two patients. Discussion and conclusion: The response rate of 18% (2/11) is consistent with the success rate of a continuous infusion trialing with an implanted catheter. Single-shot injection of ziconotide may therefore predict efficacy.

Simultaneous determination of Pu and Am radioisotopes in environmental samples: a tool for determining origin and release date

A radiochemical procedure was developed for the sequential determination of Pu and Am radioisotopes in environmental samples. The radioisotope activities were then used to assess the origin and release date of the environmental plutonium. The radioanalytical procedure is based on the separation of Pu and Am on selective extraction chromatographic resins (Eichrom TEVA and DGA). Alpha sources were prepared by electrodeposition on stainless steel discs, and the alpha emitting radionuclides (238Pu, 239,240Pu and 241Am) were measured by alpha spectrometry. For the determination of the beta emitting 241Pu, the Pu alpha source was leached in hot concentrated nitric acid and the Pu fraction further purified by extraction chromatography on a small column of TEVA resin (100 μg of resin in a pipette tip). 241Pu is then measured by ultra low level liquid scintillation counting. Due to the lack of reference material for 241Pu, the proposed radiochemical method was nevertheless validated using four IAEA reference sediments with information values of 241Pu. The proposed method was then used to determine the 238Pu, 239,240Pu, 241Pu and 241Am activity concentrations in alpine soils of France and Switzerland. The soil is the primary receptor of the atmospheric radioactive fallout and, because of the strong binding interaction with soils particles, the isotopes are little fractionated. Therefore, the activity ratios 241Pu/239+240Pu and 238Pu/239,240Pu in soil samples were used to determine the origin (source) and date of the Pu contamination in the investigated alpine sites. The 241Pu/239,240Pu and 238Pu/239,240Pu activity ratios confirmed that the main origin of Pu in the alpine soils was the global fallout from the nuclear bomb tests (NBT) in the fifties and sixties. Furthermore, the 241Pu/241Am activity ratios were used to determine the age of the Pu contamination, which is also an important data for distinguishing the Pu sources. The estimation of the date of the contamination, by the 241Pu/241Am age-dating method, further confirmed the NBT as the Pu source. However, the 241Pu/241Am dating method was limited to samples where Pu-Am fractionation was insignificant. If any, the contribution of the Chernobyl accident in the studied sites is negligible.

Determination of radionuclide levels in rainwater using ion exchange resin and gamma-spectrometry.

The evaluation of radioactivity accidentally released into the atmosphere involves determining the radioactivity levels of rainwater samples. Rainwater scavenges atmospheric airborne radioactivity in such a way that surface contamination can be deduced from rainfall rate and rainwater radioactivity content. For this purpose, rainwater is usually collected in large surface collectors and then measured by gamma-spectrometry after such treatments as evaporation or iron hydroxide precipitation. We found that collectors can be adapted to accept large surface (diameter 47mm) cartridges containing a strongly acidic resin (Dowex AG 88) which is able to quantitatively extract radioactivity from rainwater, even during heavy rainfall. The resin can then be measured by gamma-spectrometry. The detection limit is 0.1Bq per sample of resin (80g) for (137)Cs. Natural (7)Be and (210)Pb can also be measured and the activity ratio of both radionuclides is comparable with those obtained through iron hydroxide precipitation and air filter measurements. Occasionally (22)Na has also been measured above the detection limit. A comparison between the evaporation method and the resin method demonstrated that 2/3 of (7)Be can be lost during the evaporation process. The resin method is simple and highly efficient at extracting radioactivity. Because of these great advantages, we anticipate it could replace former rainwater determination methods. Moreover, it does not necessitate the transportation of large rainwater volumes to the laboratory.

The role of dynamical polarization of the ligand-to-metal charge transfer excitations in the ab initio determination of effective exchange parameters

The role of the bridging ligand on the effective Heisenberg coupling parameters is analyzed in detail. This analysis strongly suggests that the ligand-to-metal charge transfer excitations are responsible for a large part of the final value of the magnetic coupling constant. This permits us to suggest a variant of the difference dedicated configuration interaction (DDCI) method, presently one of the most accurate and reliable for the evaluation of magnetic effective interactions. This method treats the bridging ligand orbitals mediating the interaction at the same level than the magnetic orbitals and preserves the high quality of the DDCI results while being much less computationally demanding. The numerical accuracy of the new approach is illustrated on various systems with one or two magnetic electrons per magnetic center. The fact that accurate results can be obtained using a rather reduced configuration interaction space opens the possibility to study more complex systems with many magnetic centers and/or many electrons per center.

Development of a two-step screening ESI-TOF-MS method for rapid determination of significant stress-induced metabolome modifications in plant leaf extracts: the wound response in Arabidopsis thaliana as a case study.

To study the stress-induced effects caused by wounding under a new perspective, a metabolomic strategy based on HPLC-MS has been devised for the model plant Arabidopsis thaliana. To detect induced metabolites and precisely localise these compounds among the numerous constitutive metabolites, HPLC-MS analyses were performed in a two-step strategy. In a first step, rapid direct TOF-MS measurements of the crude leaf extract were performed with a ballistic gradient on a short LC-column. The HPLC-MS data were investigated by multivariate analysis as total mass spectra (TMS). Principal components analysis (PCA) and hierarchical cluster analysis (HCA) on principal coordinates were combined for data treatment. PCA and HCA demonstrated a clear clustering of plant specimens selecting the highest discriminating ions given by the complete data analysis, leading to the specific detection of discrete-induced ions (m/z values). Furthermore, pool constitution with plants of homogeneous behaviour was achieved for confirmatory analysis. In this second step, long high-resolution LC profilings on an UPLC-TOF-MS system were used on pooled samples. This allowed to precisely localise the putative biological marker induced by wounding and by specific extraction of accurate m/z values detected in the screening procedure with the TMS spectra.

Treatment of velopharyngeal insufficiency by autologous fat injection.

Velopharyngeal insufficiency (VPI) is a structural or functional trouble, which causes hypernasal speech. Velopharyngeal flaps, speech therapy and augmentation pharyngoplasty, using different implants, have all been used to address this trouble. We hereby present our results following rhinopharyngeal autologous fat injection in 18 patients with mild velopharyngeal insufficiency (12 soft palate clefts, 4 functional VPI, 2 myopathy). 28 injections were carried out between 2004 and 2007. The degree of hypernasal speech was evaluated pre- and postoperatively by a speech therapist and an ENT specialist and quantified by an acoustic nasometry (Kay Elemetrics). All patients were exhaustively treated with preoperative speech therapy (average, 8 years). The mean value of the nasalance score was 37% preoperatively and 23% postoperatively (p = 0.015). The hypernasality was reduced postoperatively in all patients (1-3 degrees of the Borel-Maisonny score). There were no major complications, two minor complications (one hematoma, one cervical pain). The autologous fat injection is a simple, safe, minimally invasive procedure. It proves to be efficient in cases of mild velopharyngeal insufficiency or after a suboptimal velopharyngoplasty.

Evaluation of the MIT-Scan-T2 for Non-Destructive PCC Pavement Thickness Determination Final Report, July 2008

The MIT-Scan-T2 device is marketed as a non-destructive way to determine pavement thickness on both HMA and PCC pavements. PCC pavement thickness determination is an important incentivedisincentive measurement for the Iowa DOT and contractors. The thickness incentive can be as much as 3% of the concrete contact unit price and the disincentive can be as severe as remove and replace. This study evaluated the potential of the MIT device for PCC pavement thickness quality assurance. The limited testing indicates the unit is sufficiently repeatable and accurate enough to replace core drilling as the thickness measurement method. Further study is needed to statistically establish the single user and multi-user/device precision as well as establish an appropriate sampling protocol and PWL specification.

A role for altered TLR gene expression in association with increased expression of CD200R in the induction of mucosal tissue CD4(+) Treg in aged mice following gavage with a liver extract along with intramuscular monophosphoryl lipid A (MPLA) injection.

Previous studies showed a fetal sheep liver extract (FSLE), in association with LPS, injected into aged (>20 months) mice reversed the altered polarization (increased IL-4 and IL-10 with decreased IL-2 and IFN-gamma) in cytokine production seen from ConA stimulated lymphoid cells of those mice. Aged mice show a >60% decline in numbers and suppressive function of both CD4(+)CD25(+)Foxp3(+)Treg and so-called Tr3 (CD4(+)TGFbeta(+)). Their number/function is restored to levels seen in control (8-week-old) mice by FSLE. We have reported at length on the ability of a novel pair of immunoregulatory molecules, members of the TREM family, namely CD200:CD200R, to control development of dendritic cells (DCs) which themselves regulate production of Foxp3(+) Treg. The latter express a distinct subset of TLRs which control their function. We report that a feature of the altered Treg expression following combined treatment with FSLE and monophosphoryl lipid A, MPLA (a bioactive component of lipid A of LPS) is the altered gene expression both of distinct subsets of TLRs and of CD200Rs. We speculate that this may represent one of the mechanisms by which FSLE and MPLA alter immunity in aged mice.

Determination of four sequential stages during microautophagy in vitro.

Microautophagy is the transfer of cytosolic components into the lysosome by direct invagination of the lysosomal membrane and subsequent budding of vesicles into the lysosomal lumen. This process is topologically equivalent to membrane invagination during multivesicular body formation and to the budding of enveloped viruses. Vacuoles are lysosomal compartments of yeasts. Vacuolar membrane invagination can be reconstituted in vitro with purified yeast vacuoles, serving as a model system for budding of vesicles into the lumen of an organelle. Using this in vitro system, we defined different reaction states. We identified inhibitors of microautophagy in vitro and used them as tools for kinetic analysis. This allowed us to characterize four biochemically distinguishable steps of the reaction. We propose that these correspond to sequential stages of vacuole invagination and vesicle scission. Formation of vacuolar invaginations was slow and temperature-dependent, whereas the final scission of the vesicle from a preformed invagination was fast and proceeded even on ice. Our observations suggest that the formation of invaginations rather than the scission of vesicles is the rate-limiting step of the overall reaction.