(Table 1) Os and Sr isotopes in low-temperature hydrothermal fluids from the Juan de Fuca Ridge at ODP Site 168-1026B

We present Os and Sr isotopes and Mg, Os, and Sr concentrations for ridge-crest high-temperature and diffuse hydrothermal fluids, plume fluids and ridge-flank warm spring fluids from the Juan de Fuca Ridge. The data are used to evaluate the extent to which (1) the high- and low-temperature hydrothermal alteration of mid-ocean ridge basalts (MORBs) provides Os to the deep oceans, and (2) hydrothermal contributions of non-radiogenic Os and Sr to the oceans are coupled. The Os and Sr isotopic ratios of the high-temperature fluids (265-353°C) are dominated by basalts (187Os/188Os = 0.2; 87Sr/86Sr = 0.704) but the concentrations of these elements are buffered approximately at their seawater values. The 187Os/188Os of the hydrothermal plume fluids collected ~1 m above the orifice of Hulk vent is close to the seawater value (=1.05). The low-temperature diffuse fluids (10-40°C) associated with ridge-crest high-temperature hydrothermal systems on average have [Os] = 31 fmol/kg, 187Os/188Os = 0.9 and [Sr] = 86 µmol/kg, 87Sr/86Sr = 0.709. They appear to result from mixing of a high-temperature fluid and a seawater component. The ridge-flank warm spring fluids (10-62°C) on average yield [Os] = 22 fmol/kg, 187Os/188Os = 0.8 and [Sr] = 115 µmol/kg, 87Sr/86Sr = 0.708. The data are consistent with isotopic exchange of Os and Sr between basalt and circulating seawater during low-temperature hydrothermal alteration. The average Sr concentration in these fluids appears to be similar to seawater and consistent with previous studies. In comparison, the average Os concentration is less than seawater by more than a factor of two. If these data are representative they indicate that low-temperature alteration of MORB does not provide adequate non-radiogenic Os and that another source of mantle Os to the oceans must be investigated. At present, the magnitude of non-radiogenic Sr contribution via low-temperature seawater alteration is not well constrained. If non-radiogenic Sr to the oceans is predominantly from the alteration of MORB, our data suggest that there must be a different source of non-radiogenic Os and that the Os and Sr isotope systems in the oceans are decoupled.

Wave Statistics and Space-time Extremes via Stereo Imaging

We present an analysis of the space-time dynamics of oceanic sea states exploiting stereo imaging techniques. In particular, a novel Wave Acquisition Stereo System (WASS) has been developed and deployed at the oceanographic tower Acqua Alta in the Northern Adriatic Sea, off the Venice coast in Italy. The analysis of WASS video measurements yields accurate estimates of the oceanic sea state dynamics, the associated directional spectra and wave surface statistics that agree well with theoretical models. Finally, we show that a space-time extreme, defined as the expected largest surface wave height over an area, is considerably larger than the maximum crest observed in time at a point, in agreement with theoretical predictions.

Mejora de la seguridad de las presas de escollera frente a percolación accidental mediante protecciones tipo repié

Esta tesis doctoral es el fruto de un trabajo de investigación cuyo objetivo principal es definir criterios de diseño de protecciones en forma de repié en presas de materiales sueltos cuyo espaldón de aguas abajo esté formado por escollera. La protección propuesta consiste en un relleno de material granular situado sobre el pie de aguas abajo de la presa y formado a su vez por una escollera con características diferenciadas respecto de la escollera que integra el espaldón de la presa. La función de esta protección es evitar que se produzcan deslizamientos en masa cuando una cantidad de agua anormalmente elevada circula accidentalmente por el espaldón de aguas abajo de la presa por distintos motivos como pueden ser el vertido por coronación de la presa o la pérdida de estanqueidad del elemento impermeable o del cimiento. Según los datos de la International Commission on Large Dams (ICOLD 1995) el 70% de las causas de rotura o avería grave en presas de materiales sueltos en el mundo están dentro de las que se han indicado con anterioridad. Esta circulación accidental de agua a través del espaldón de escollera, típicamente turbulenta, se ha denominado en esta tesis percolación (“through flow”, en inglés) para diferenciarla del término filtración, habitualmente utilizada para el flujo laminar a través de un material fino. El fenómeno físico que origina la rotura de presas de materiales sueltos sometidas a percolación accidental es complejo, entrando en juego diversidad de parámetros, muchas veces no deterministas, y con acoplamiento entre procesos, tanto de filtración como de arrastre y deslizamiento. En esta tesis se han realizado diferentes estudios experimentales y numéricos con objeto de analizar el efecto sobre el nivel de protección frente al deslizamiento en masa que producen los principales parámetros geométricos que definen el repié: la anchura de la berma, el talud exterior y su altura máxima desde la base. También se han realizado estudios sobre factores con gran influencia en el fenómeno de la percolación como son la anisotropía del material y el incremento de los caudales unitarios en el pie de presa debidos a la forma de la cerrada. A partir de los resultados obtenidos en las distintas campañas de modelación física y numérica se han obtenido conclusiones respecto a la efectividad de este tipo de protección para evitar parcial o totalmente los daños provocados por percolación accidental en presas de escollera. El resultado final de la tesis es un procedimiento de diseño para este tipo de protecciones. Con objeto de completar los criterios de dimensionamiento, teniendo en cuenta los mecanismos de rotura por erosión interna y arrastre, se han incluido dentro del procedimiento recomendaciones adicionales basadas en investigaciones existentes en la bibliografía técnica. Finalmente, se han sugerido posibles líneas de investigación futuras para ampliar el conocimiento de fenómenos complejos que influyen en el comportamiento de este tipo de protección como son el efecto de escala, la anisotropía de la escollera, las leyes de resistencia que rigen la filtración turbulenta a través de medios granulares, los efectos de cimentaciones poco competentes o la propia caracterización de las propiedades de la escollera de presas. This thesis is the result of a research project that had the main objective of defining criteria to design rockfill toe protections for dams with a highly‐permeable downstream shoulder. The proposed protection consists of a rockfill toe berm situated downstream from the dam with specific characteristics with respect to the rockfill that integrates the shoulder of the main dam. The function of these protections is to prevent mass slides due to an abnormally high water flow circulation through the dam shoulder. This accidental seepage flow may be caused by such reasons as overtopping or the loss of sealing at the impervious element of the dam or its foundation. According to data from the International Commission on Large Dams (ICOLD 1995), 70% of the causes of failure or serious damage in embankment dams in the world are within that described previously. This accidental seepage of water through the rockfill shoulder, typically turbulent, is usually called through‐flow. The physical phenomenon which causes the breakage of the rockfill shoulder during such through‐flow processes is complex, involving diversity of parameters (often not deterministic) and coupling among processes, not only seepage but also internal erosion, drag or mass slide. In this thesis, numerical and experimental research is conducted in order to analyze the effects of the main parameters that define the toe protection, i.e. the toe crest length, its slope and maximum height. Additional studies on significant factors which influence the seepage, such as the anisotropy of the material and the increase of the unit flows at the dam toe due to the valley shape are also performed. In addition, conclusions regarding the effectiveness of this type of protection are obtained based on the results of physical and numerical models. The main result of the thesis is a design procedure for this type of protection to avoid mass sliding. In order to complete the design criteria, additional recommendations about internal and external erosion based on the state of the art are included. Finally, new lines of research are suggested for the future to expand the level of knowledge of the complex phenomena that influence the behavior of this type of protection, such as the effects of scale, rockfill anisotropy, non‐linear seepage laws in turbulent seepage through granular media, effects of erodible foundations, or new procedures to characterize the properties of dam rockfill as a construction material.

Space-time Measurements of Oceanic Sea States

Stereo video techniques are effective for estimating the space–time wave dynamics over an area of the ocean. Indeed, a stereo camera view allows retrieval of both spatial and temporal data whose statistical content is richer than that of time series data retrieved from point wave probes. We present an application of the Wave Acquisition Stereo System (WASS) for the analysis of offshore video measurements of gravity waves in the Northern Adriatic Sea and near the southern seashore of the Crimean peninsula, in the Black Sea. We use classical epipolar techniques to reconstruct the sea surface from the stereo pairs sequentially in time, viz. a sequence of spatial snapshots. We also present a variational approach that exploits the entire data image set providing a global space–time imaging of the sea surface, viz. simultaneous reconstruction of several spatial snapshots of the surface in order to guarantee continuity of the sea surface both in space and time. Analysis of the WASS measurements show that the sea surface can be accurately estimated in space and time together, yielding associated directional spectra and wave statistics at a point in time that agrees well with probabilistic models. In particular, WASS stereo imaging is able to capture typical features of the wave surface, especially the crest-to-trough asymmetry due to second order nonlinearities, and the observed shape of large waves are fairly described by theoretical models based on the theory of quasi-determinism (Boccotti, 2000). Further, we investigate space–time extremes of the observed stationary sea states, viz. the largest surface wave heights expected over a given area during the sea state duration. The WASS analysis provides the first experimental proof that a space–time extreme is generally larger than that observed in time via point measurements, in agreement with the predictions based on stochastic theories for global maxima of Gaussian fields.

Chamber of valves in the Arenoso reservoir

Of the south of Spain, near the province of Cordova, in a tributary of the Guadalquivir River it has been constructed during the years 2004 to 2007 the reservoir called El Arenoso. El Arenoso reservoir that belongs to Environment Ministry is destined to downstream Guadalquivir’s water supply and the general regulation of the river. The dam is located on the same name river and it is next to the Montoro’s municipal district, 41 km northeast of Cordova. The main work consists on an embankment dam, with central clay core, and slates and greywacke shoulders. The core is covered downstream with a filter material and upstream with a transition material. The dimensions of the dam are 80 m high, 1.480 m long at its crest, and it has been needed more than 3 million m3 of materials, creating a waterproof barrier able to keep 160 hm3 as a useful reservoir. In the zone of the core is located the chamber of valves with a horizontal clearance of 10 m and a vertical clearance of 14,517 m. The present article exposes the most important characteristics of project and construction, of valves chamber of the Arenoso reservoir.

A bivariate return period based on copulas for hydrologic dam design: accounting for reservoir routing in risk estimation

A multivariate analysis on flood variables is needed to design some hydraulic structures like dams, as the complexity of the routing process in a reservoir requires a representation of the full hydrograph. In this work, a bivariate copula model was used to obtain the bivariate joint distribution of flood peak and volume, in order to know the probability of occurrence of a given inflow hydrograph. However, the risk of dam overtopping is given by the maximum water elevation reached during the routing process, which depends on the hydrograph variables, the reservoir volume and the spillway crest length. Consequently, an additional bivariate return period, the so-called routed return period, was defined in terms of risk of dam overtopping based on this maximum water elevation obtained after routing the inflow hydrographs. The theoretical return periods, which give the probability of occurrence of a hydrograph prior to accounting for the reservoir routing, were compared with the routed return period, as in both cases hydrographs with the same probability will draw a curve in the peak-volume space. The procedure was applied to the case study of the Santillana reservoir in Spain. Different reservoir volumes and spillway lengths were considered to investigate the influence of the dam and reservoir characteristics on the results. The methodology improves the estimation of the Design Flood Hydrograph and can be applied to assess the risk of dam overtopping

Análisis del contenido en frecuencias de vibraciones por voladura

Este proyecto tiene por objeto el análisis de las diferentes frecuencias y tipos de onda presentes en los registros de vibraciones de las voladuras. Se han utilizado 108 registros de 4 barrenos sencillos disparados individualmente y una voladura de producción. Se estudian así mismo la evolución de las frecuencias (en relación a la distancia y a la geología particular de cresta y plaza) y la ley de atenuación del terreno que relaciona la evolución velocidad de partícula en función de la distancia escalada. Para la voladura de producción se analiza si las vibraciones cumplen la normativa vigente según la norma UNE 22.381.93 “Control de Vibraciones Producidas por Voladuras”. Abstract The main objective of this project is to analyze the different types and frequencies of seismic waves found in blasting logs. 108 logs from 4 single shots and a standard production blasting have been used. The evolution of frequencies (regarding distance and different geologies of crest and toe) and the attenuation law which allows us to obtain peak particle velocity regarding distance are also studied. For the production blasting, data is compared to the limits set by current regulations following the standard UNE 22.381.93 “Control de Vibraciones Producidas por Voladuras”.

Casa de Blas. Spain 1999

Placed on the crest of a north-facing hill with views of the mountains near Madrid, the house is, more than anything else, a response to its location.