Bacterial cellulose membrane as flexible substrate for organic light emitting devices

Bacterial cellulose (BC) membranes produced by gram-negative, acetic acid bacteria (Gluconacetobacter xylinus), were used as flexible substrates for the fabrication of Organic Light Emitting Diodes (OLED). In order to achieve the necessary conductive properties indium tin oxide (ITO) thin films were deposited onto the membrane at room temperature using radio frequency (r.f) magnetron sputtering with an r.f. power of 30 W, at pressure of 8 mPa in Ar atmosphere without any subsequent thermal treatment. Visible light transmittance of about 40% was observed. Resistivity, mobility and carrier concentration of deposited ITO films were 4.90 x 10(-4) Ohm cm, 8.08 cm(2)/V-s and -1.5 x 10(21) cm(-3), respectively, comparable with commercial ITO substrates. In order to demonstrate the feasibility of devices based on BC membranes three OLEDs with different substrates were produced: a reference one with commercial ITO on glass, a second one with a SiO(2) thin film interlayer between the BC membrane and the ITO layer and a third one just with ITO deposited directly on the BC membrane. The observed OLED luminance ratio was: 1; 0.5; 0.25 respectively, with 2400 cd/m(2) as the value for the reference OLED. These preliminary results show clearly that the functionalized biopolymer, biodegradable, biocompatible bacterial cellulose membranes can be successfully used as substrate in flexible organic optoelectronic devices. (C) 2008 Elsevier B.V. All rights reserved.

Rat nephrotoxic nephritis. The relation between the type and intensity of induced histological lesions and the content of antiglomerular basement membrane antibodies of the inoculated serum

Six groups of 6 rats received equal doses (0.8 ml/100 g of body weight) of different rabbit anti rat kidney sera. The titer of anti GBM antibodies in the sera was evaluated by indirect immunofluorescent test in isolated GBM (IIT GBM). Rats of groups 1, 2, 3, 5, 6 received anti rat GBM sera with titers of 1/320, 1/240, 1/160, 1/60, 1/30 respectively. Group 4 received anti rat kidney serum with a titer of 1/80. The rats of group 1 died from 1 to 5 minutes after inoculation and their kidney were congested, with hialine trombi occluding arterioles and glomerular capillaries. The rats of group 2 and one of group 3 died from 2 to 15 days after inoculation and diffuse cortical necrosis was found. The remaining rats were sacrificed 2 months after inoculation. The kidneys were normal in control group; chronic membranoproliferative glomerulonephritis was observed in group 3 and 4, membranoproliferative glomerulonephritis in group 5 and minimal changes in group 6. By immunofluorescence rabbit gammaglobulin was seen in GBM of group 3, 4, 5 and 6. The IIT GBM performed in the eluates of the kidneys revealed the presence of heterologous antibody in groups 1, 2, 3, 4, 5 and 6 and autologous antibody in groups 3, 4 and 5. One concludes that the IIT GBM identifies and quantifies antibodies which have the property of damaging the kidney.

Treatment of rat nephrotoxic nephritis. Use of 5-fluorouracil or methotrexate-5-fluorouracil association

To evaluate the effect of 5-fluorouracil (F) and methotrexate-5-fluorouracil association (MTX-F) on nephrotoxic nephritis, seven groups of 10 rats were inoculated with anti-rat glomerular basement membrane serum (AGBMS); five groups were treated with different doses of F, beginning on the 2nd or the 6th day, one group with MTX-F beginning on the 2nd day and one group (control) with distilled water. Twenty-four hour proteinuria was determined weekly until the 71st day. The kidneys were examined histologically and by immunofluorescence. The group treated with F (1.3 mg/100 g body weight) developed a severe glomerulonephritis similar to the control group; (b) the groups treated with F (2.0 mg/100 g body weight) or with MTX-F showed progressively lower proteinuria, less severe histological changes and less intense fluorescence due to autologous antibodies. The best results were observed in the MTX-F group and in the F group treated from the 6th day. These groups presented at the 71st day proteinuria of 84 and 91 mg as compared to 312 mg in the control group, and minimal histological lesions as compared to glomerulosclerosis and tubular atrophy in the control group. We concluded that either F or MTX-F produced significant improvement of nephrotoxic nephritis due to inhibition of autologous antibody production.

Immunohistochemical characterisation of probable intravascular haematopoiesis in the vasa rectae of the renal medulla in acute tubular necrosis

Immunohistochemistry was applied to identify the nature of the nucleated cells that accumulate in the vasa rectae of the corticomedullary junction in acute tubular necrosis. In all 6 cases studied, there were intravascular cells that reacted with monoclonal antibodies to erythroblast, macrophages, myeloid cells, T and B lymphocytes and rare megakaryocytes. The findings are consistent with the occurrence of intravascular haematopoiesis in the renal medulia in acute tubular necrosis.

Potentiometric study using chemically modified silica gel with pyridinium as membrane for ClO4 - ions

A potentiometric sensor for the perchlorate anion was developed by mixing chemically modified silicagel with pyridinium perchlorate, with an epoxy polymer and graphite. The electrode showed Nernstian response between 1.0 × 10-2 and 1.0 × 10-3M perchlorate concentrations. The electrode showed high selectivity to this ion at solutions pH between 5.5 and 8.0. The presence of IO4 -, NO3 -,Br-, IO3 -, Cl- and SO4 2- ions in the solutions, had only small interference in the electrode response in the range mentioned. © 1995 Springer-Verlag.

Secretion of salivary glands of the Brazilian termite Serritermes serrifer Hagen & Bates (Isoptera : Serritermitidae)

The salivary glands of termites are composed of several secretory acini connected by ducts. These glands, in the Brazilian termite Serritermes serrifer, were examined through the electron microscope. The ultrastructure of worker salivary acinus revealed central ductule cells and four different types of cells. Cells of type I contain an abundance of electron-lucid vacuoles of various sizes which fuse to form enormous vacuolar structures that fill up most of the cell. Cells of type II are narrow cells in which the secretion is contained in small clear vacuoles of approximately equal diameter. Both of these cellular types have numerous Golgi bodies and rough endoplasmic reticulum. Type III or parietal cells have an apical plasma membrane deeply infolded and lined by microvilli. This type of cell is located in the acinar periphery and occurs in pairs. Cells of type IV are completely filled with electrondense secretion. The secretory granules can be small in some cells or large and similar to fingerprints in others. This is the first report of the occurrence of these spiral or concentric rings of dense material in the salivary gland of Isoptera.

Influence of viscoelastic characteristics of the colloidal suspensions on the formation of SnO2 supported membranes

SnO2 supported membranes have been prepared by sol-casting on alumina tubular substrate, using aqueous colloidal suspensions prepared by sol-gel route. The viscoelastic behaviour during sol ageing was analyzed by dinamic rheologial measurements. The complex viscosity and the storage and loss moduli have been followed during the sol-gel transition and the results have been correlated with the linear aggregates growth and the scalar percolation models. The scanning electron microscopy has evidenced that the homogeneity and thickness of the membrane depend on the sol ageing time. Crack-free and homogeneous membranes have been obtained for coated layers of 0.5μm thickness. © 1997 Trans Tech Publications.

A SequenceSpace analysis of Lys49 phospholipases A2: Clues towards identification of residues involved in a novel mechanism of membrane damage and in myotoxicity

'SequenceSpace' analysis is a novel approach which has been used to identify unique amino acids within a subfamily of phospholipases A2 (PLA2) in which the highly conserved active site residue Asp49 is substituted by Lys (Lys49-PLA2s). Although Lys49-PLA2s do not bind the catalytic co-factor Ca2+ and possess extremely low catalytic activity, they demonstrate a Ca2+-independent membrane damaging activity through a poorly understood mechanism, which does not involve lipid hydrolysis. Additionally, Lys49-PLA2s possess combined myotoxic, oedema forming and cardiotoxic pharmacological activities, however the structural basis of these varied functions is largely unknown. Using the 'SequenceSpace' analysis we have identified nine residues highly unique to the Lys49-PLA2 sub-family, which are grouped in three amino acid clusters in the active site, hydrophobic substrate binding channel and homodimer interface regions. These three highly specific residue clusters may have relevance for the Ca2+-independent membrane damaging activity. Of a further 15 less stringently conserved residues, nine are located in two additional clusters which are well isolated from the active site region. The less strictly conserved clusters have been used in predictive sequence searches to correlate amino acid patterns in other venom PLA2s with their pharmacological activities, and motifs for presynaptic and combined toxicities are proposed.

Novel high-power-factor isolated electronic ballast for multiple tubular fluorescent lamps

This paper presents a novel isolated electronic ballast for multiple fluorescent lamps, featuring high power-factor, and high efficiency. Two stages compose this new electronic ballast, namely, a new voltage step-down isolated Sepic rectifier, and a classical resonant Half-Bridge inverter. The new isolated Sepic rectifier is obtained from a Zero-Current-Switching (ZCS) Pulse-Width-Modulated (PWM) soft-commutation cell. The average-current control technique is used in this preregulator stage in order to provide low phase displacement and low Total-Harmonic-Distortion (THD) at input current, resulting in high power-factor, and attending properly IEC 61000-3-2 standards. The resonant Half-Bridge inverter performs Zero-Voltage-Switching (ZVS), providing conditions for the obtaining of overall high efficiency. It is developed a design example for the new isolated electronic ballast rated at 200W output power, 220Vrms input voltage, 115Vdc dc link voltage, with rectifier and inverter stages operating at 50kHz. Finally, experimental results are presented in order to verify the developed analysis. The THD at input current is equal to 5.25%, for an input voltage THD equal to 1.63%, and the measured overall efficiency is about 88.25%, at rated load.

Evaluation of plasma membrane integrity of frozen-thawed goat spermatozoa with or without seminal plasma

The aim of the present work was to evaluate plasma membrane integrity, motility, vigor and morphology of fresh and frozen goat spermatozoa with or without seminal plasma. Semen samples were diluted in Tris solution, before and after thawing, with a combination of carboxifluorescein diacetate and propidium iodide. The results showed differences (P < 0.01) for motility and minor defects in the presence or absence of seminal plasma, for both fresh and frozen samples. Periods of collection had a significant effect on motility, probably due to changes in the photoperiod. Plasma membrane integrity was significantly reduced by the freezing process, whether seminal plasma was present or absent. In conclusion, removal of seminal plasma decreased motility and vigor rates in frozen samples. The photoperiod probably decreased the testosterone level, contributing negatively to the high percentage of sperm abnormalities, mainly damaged membranes. The use of fluorescent probes allowed a better estimation of the percentage of functional cells, instead of only estimating the percentage of motile cells or morphology defects. © 2001 Elsevier Science B.V. All rights reserved.

Histologic Evaluation of the Osteoinductive Property of Autogenous Demineralized Dentin Matrix on Surgical Bone Defects in Rabbit Skulls Using Human Amniotic Membrane for Guided Bone Regeneration

The aim of this investigation was to evaluate the osteoinductive property of autogenous demineralized dentin matrix (ADDM) on experimental surgical bone defects in the parietal bone of rabbits using the guided bone regeneration (GBR) technique incorporating human amniotic membrane (HAM). Thirty-six rabbits were divided into 2 groups, HAM and ADDM+HAM. It was possible to conclude that HAM did not interfere with bone repair and was resorbed. Slices of ADDM induced direct bone formation and were incorporated by the newly formed bone tissue and remodeled. The bone defects healed faster in the ADDM+HAM group than in the group with HAM only.

A high efficiency HPF-ZCS-PWM Sepic for electronic ballast with multiple tubular fluorescent lamps

This paper presents a high efficiency Sepic rectifier for an electronic ballast application with multiple fluorescent lamps. The proposed Sepic rectifier is based on a Zero-Current-Switching (ZCS) Pulse-Width-Modulated (PWM) soft-commutation cell. The high power-factor of this structure is obtained using the instantaneous average-current control technique, in order to attend properly IEC61000-3-2 standards. The inverting stage of this new electronic ballast is a classical Zero-Voltage-Switching (ZVS) Half-Bridge inverter. A proper design methodology is developed for this new electronic ballast, and a design example is presented for an application with five fluorescent lamps 40W-T12 (200W output power), 220Vrms input voltage, 130Vdc dc link voltage, with rectifier and inverter stages operating at 50kHz. Experimental results are also presented. The THD at input current is equal to 6.41%, for an input voltage THD equal to 2.14%, and the measured overall efficiency is about 92.8%, at rated load.

Dimmable electronic ballast with high power-factor SEPIC preregulator, for multiple tubular fluorescent lamps

An electronic ballast for multiple tubular fluorescent lamps is presented in this paper. The proposed structure features high power-factor, dimming capability, and soft-switching to the semiconductor devices operated in high frequencies. A Zero-Current-Switching - Pulse-Width-Modulated (ZCS-PWM) SEPIC converter composes the rectifying stage, controlled by the instantaneous average input current technique, performing soft-commutations and high input power factor. Regarding the inverting stage, it is composed by a classical resonant Half-Bridge converter, associated to Series Parallel-Loaded Resonant (SPLR) filters. The dimming control technique employed in this Half-Bridge inverter is based on the phase-shift in the current processed through the sets of filter + lamp. In addition, experimental results are shown in order to validate the developed analysis.