959 resultados para PN1997.2 W35 2008


Relevância:

30.00% 30.00%

Publicador:

Resumo:

Al2O3/SiO2 films have been deposited as UV antireflection coatings on 4H-SiC by electron-beam evaporation and characterized by reflection spectrum, scanning electron microscopy (SEM) and X-ray photoelectron spectroscopy (XPS). The reflectance of the Al2O3/SiO2 films is 0.33% and 10 times lower than that of a thermally grown SiO2 single layer at 276 nm. The films are amorphous in microstructure and characterize good adhesion to 4H-SiC substrate. XPS results indicate an abrupt interface between evaporated SiO2 and 4H-SiC substrate free of Si-suboxides. These results make the possibility for 4H-SiC based high performance UV optoelectronic devices with Al2O3/SiO2 films as antireflection coatings. (C) 2007 Elsevier B.V. All rights reserved.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Al2O3/SiO2 films have been prepared by electron-beam evaporation as ultraviolet (UV) antireflection coatings on 4H-SiC substrates and annealed at different temperatures. The films were characterized by reflection spectra, ellipsometer system, atomic force microscopy (AFM), X-ray diffraction (XRD) and Xray photoelectron spectroscopy (XPS), respectively. As the annealing temperature increased, the minimum reflectance of the films moved to the shorter wavelength for the variation of refractive indices and the reduction of film thicknesses. The surface grains appeared to get larger in size and the root mean square (RMS) roughness of the annealed films increased with the annealing temperature but was less than that of the as-deposited. The Al2O3/SiO2 films maintained amorphous in microstructure with the increase of the temperature. Meanwhile, the transition and diffusion in film component were found in XPS measurement. These results provided the important references for Al2O3/SiO2 films annealed at reasonable temperatures and prepared as fine anti-reflection coatings on 4H-SiC-based UV optoelectronic devices. (c) 2008 Elsevier B.V. All rights reserved.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Zirconium dioxide (ZrO2) thin films were deposited on BK7 glass substrates by the electron beam evaporation method. A continuous wave CO2 laser was used to anneal the ZrO2 thin films to investigate whether beneficial changes could be produced. After annealing at different laser scanning speeds by CO2 laser, weak absorption of the coatings was measured by the surface thermal lensing (STL) technique, and then laser-induced damage threshold (LIDT) was also determined. It was found that the weak absorption decreased first, while the laser scanning speed is below some value, then increased. The LIDT of the ZrO2 coatings decreased greatly when the laser scanning speeds were below some value. A Nomarski microscope was employed to map the damage morphology, and it was found that the damage behavior was defect-initiated both for annealed and as-deposited samples. The influences of post-deposition CO2 laser annealing on the structural and mechanical properties of the films have also been investigated by X-ray diffraction and ZYGO interferometer. It was found that the microstructure of the ZrO2 films did not change. The residual stress in ZrO2 films showed a tendency from tensile to compressive after CO, laser annealing, and the variation quantity of the residual stress increased with decreasing laser scanning speed. The residual stress may be mitigated to some extent at proper treatment parameters. (c) 2007 Elsevier GmbH. All rights reserved.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

This paper describes the preparation and the characterization Of Y2O3 stabilized ZrO2 thin films produced by electric-beam evaporation method. The optical properties, microstructure, surface morphology and the residual stress of the deposited films were investigated by optical spectroscopy, X-ray diffraction (XRD), scanning probe microscope and optical interferometer. It is shown that the optical transmission spectra of all the YSZ thin films are similar with those of ZrO2 thin film, possessing high transparency in the visible and near-infrared regions. The refractive index of the samples decreases with increasing of Y2O3 content. The crystalline structure of pure ZrO2 films is a mixture of tetragonal phase and monoclinic phase, however, Y2O3 stabilized ZrO2 thin films only exhibit the cubic phase independently of how much the added Y2O3 content is. The surface morphology spectrum indicates that all thin films present a crystalline columnar texture with columnar grains perpendicular to the substrate and with a predominantly open microporosity. The residual stress of films transforms tensile from compressive with the increasing Of Y2O3 molar content, which corresponds to the evolutions of the structure and packing densities. (C) 2008 Elsevier Ltd. All rights reserved.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Ta2O5 films were deposited by conventional electron beam evaporation method and then annealed in air at different temperature from 873 to 1273 K. It was found that the film structure changed from amorphous phase to hexagonal phase when annealed at 1073 K, then transformed to orthorhombic phase after annealed at 1273 K. The transmittance was improved after annealed at 873 K, and it decreased as the annealing temperature increased further. The total integrated scattering (TIS) tests and AFM results showed that both scattering and root mean square (RMS) roughness of films increased with the annealing temperature increasing. X-ray photoelectron spectroscopy (XPS) analysis showed that the film obtained better stoichiometry and the O/Ta ratio increased to 2.50 after annealing. It was found that the laser-induced damage threshold (LIDT) increased to the maximum when annealed at 873 K, while it decreased when the annealing temperature increased further. Detailed damaged models dominated by different parameters during annealing were discussed. (C) 2008 Elsevier B. V. All rights reserved.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

A series or Ta2O5 films with different SiO2 additional layers including overcoat, undercoat and interlayer was prepared by electron beam evaporation under the same deposition process. Absorption of samples was measured using the surface thermal lensing (STL) technique. The electric field distributions of the samples were theoretical predicted using thin film design software (TFCalc). The laser induced damage threshold (LIDT) was assessed using an Nd:YAG laser operating at 1064 nm with a pulse length of 12 ns. It was found that SiO2 additional layers resulted in a slight increase of the absorption, whereas they exerted little influence on the microdefects. The electric field distribution among the samples was unchanged by adding an SiO2 overcoat and undercoat, yet was changed by adding an interlayer. SiO2 undercoat. The interlayer improved the LIDT greatly, whereas the SiO2 overcoat had little effect on the LIDT. (C) 2007 Elsevier Ltd. All rights reserved.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Influence of ZrO2 in HfO2 on the reflectance of HfO2/SiO2 multilayer at 248 nm was investigated. Two kinds of HfO2 with different ZrO2 content were chosen as high refractive index material and the same kind of SiO2 as low refractive index material to prepare the mirrors by electron-beam evaporation. The impurities in two kinds of HfO2 starting coating materials and in their corresponding single layer thin films were determined through glow discharge mass spectrum (GDMS) technology and secondary ion mass spectrometry (SIMS) equipment, respectively. It showed that between the two kinds of HfO2, either the bulk materials or their corresponding films, the difference of ZrO2 was much larger than that of the other impurities such as Ti and Fe. It is the Zr element that affects the property of thin films. Both in theoretical and in experimental, the mirror prepared with the HfO2 starting material containing more Zr content has a lower reflectance. Because the extinction coefficient of zirconia is relatively high in UV region, it can be treated as one kind of absorbing defects to influence the optical property of the mirrors. (C) 2008 Elsevier B.V. All rights reserved.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Nb2O5 sculptured thin. films deposited by electron beam evaporation with glancing angle deposition were prepared. Nb2O5 sculptured thin. films with tilted columns are optical anisotropy. XRD, SEM, UV-vis-NIR spectra are employed to characterize the microstructure and optical properties. The maximum of birefringence (Delta n) is up to 0.045 at alpha = 70 degrees with packing density of 0.487. With increasing the deposition angle, refractive index and packing density of Nb2O5 STF are decreasing. The relationship among deposition parameter, microstructure and optical properties was investigated in detail. (C) 2008 Elsevier B. V. All rights reserved.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Cod captured by commercial fi shery in the Bornholm Basin in quarter 2 of 2001 were not suitable for the mechanical processing due to low condition and weight. The absolute mean weight of cod captured by the commercial fishery in the Arkona Sea and Bornholm Basin in the same quarter during the last fi ve years was studied to describe its development. The results of a GLM (Generalized Linear Model) analysis showed similar development of body weight in the Bornholm Basin and in the Arkona Sea between 2007 and 2011. The mean weight of cod in the Bornholm Basin increased from 2007 to 2008 in both areas followed by a relative stable weight until 2009 and a decrease until 2011. In the Arkona Sea the mean weight of cod 2009 has decreased in comparison to 2008, then have increased 2010 slightly and last have decreased in 2011. The analyses showed that the weight of cod is signifi cantly infl uenced by length, age and maturity of individuals.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Esta pesquisa que se insere na linha Infância, Juventude e Educação do Programa de Pós-Graduação em Educação da Universidade do Estado do Rio de Janeiro/RJ buscou analisar como as coordenadoras/diretoras das 23 creches públicas de Juiz de Fora/MG compreendem o recente processo de transição da gestão das creches vinculadas à assistência social através da Associação Municipal de Apoio Comunitário (Amac) para a Secretaria de Educação, quando confrontadas com as perspectivas anunciadas na política oficial. Alguns objetivos específicos orientaram este estudo: (1) analisar a política oficial de inserção das creches ao sistema de ensino no município em questão; (2) Compreender como as coordenadoras/diretoras de creches percebem e vivenciam a implementação das políticas de inserção das creches ao sistema de ensino; (3) Identificar os principais embates e desafios que surgiram no contexto da prática após a implementação da transição e como as coordenadoras/diretoras lidam com eles. Como referencial para análise da política em foco, adotou-se a abordagem do ciclo de políticas (policy cycle approach) formulada por Stephen Ball e seus colaboradores. Segundo essa matriz as políticas educacionais são tratadas como textos, discursos e práticas produzidos em três contextos articulados entre si: o contexto de influência, o contexto da produção de texto e o contexto da prática. O contexto de influência foi acessado a partir de pesquisas bibliográficas. O contexto da produção de texto ganhou visibilidade pela via da análise documental. Os dados do contexto da prática, foco principal desta pesquisa, foram produzidos em três sessões reflexivas realizadas entre 2008 e 2013 com as coordenadoras/diretoras das 23 creches públicas de Juiz de Fora/MG. As análises apontaram que o processo de transição das creches tem sido produzido em meio a discursos e textos sujeitos a influências e inter-relações com as políticas locais, nacionais e globais. Mostrou também que a ausência de representantes do contexto da prática na elaboração inicial da política gerou apreensão e insegurança nos profissionais das creches. A produção da política foi marcada por conflitos entre as coordenadoras/diretoras e a Secretaria de Educação, e dificuldades advindas do modelo fragmentado de gestão da rede de creches em duas instâncias (Amac e Secretaria de Educação). A redução desses conflitos demandou negociações e adaptações de ambos os lados. A formação continuada no contexto das creches emergiu como uma contribuição para o avanço das práticas educativas. No entanto, a necessidade do poder público rever a carreira e as condições de trabalho dos profissionais dessas instituições foi ressaltada como uma questão fundamental para a construção de um atendimento com qualidade

Relevância:

30.00% 30.00%

Publicador:

Resumo:

◾PICES Science in 2007 (pdf, 0.1 Mb) ◾2007 Wooster Award (pdf, 0.1 Mb) ◾FUTURE - A milestone reached but our task is not done (pdf, < 0.1 Mb) ◾International symposium on "Reproductive and Recruitment Processes of Exploited Marine Fish Stocks" (pdf, 0.1 Mb) ◾Recent results of the micronekton sampling inter-calibration experiment (pdf, 0.1 Mb) ◾2007 PICES workshop on "Measuring and monitoring primary productivity in the North Pacific" (pdf, 0.1 Mb) ◾2007 Harmful Algal Bloom Section annual workshop events (pdf, 0.1 Mb) ◾A global approach for recovery and sustainability of marine resources in Large Marine Ecosystems (pdf, 0.3 Mb) ◾Highlights of the PICES Sixteenth Annual Meeting (pdf, 0.4 Mb) ◾Ocean acidification of the North Pacific Ocean (pdf, 0.3 Mb) ◾Workshop on NE Pacific Coastal Ecosystems (2008 Call for Salmon Survival Forecasts) (pdf, 0.1 Mb) ◾The state of the western North Pacific in the first half of 2007 (pdf, 0.4 Mb) ◾PICES Calendar (pdf, 0.4 Mb) ◾The Bering Sea: Current status and recent events (pdf, 0.3 Mb) ◾PICES Interns (pdf, 0.3 Mb) ◾Recent trends in waters of the subarctic NE Pacific (pdf, 0.3 Mb) ◾Election results at PICES (pdf, 0.2 Mb) ◾A new PICES award for monitoring and data management activities (pdf, < 0.1 Mb)