Non-bee insects are important contributors to global crop pollination

Wild and managed bees are well documented as effective pollinators of global crops of economic importance. However, the contributions by pollinators other than bees have been little explored despite their potential to contribute to crop production and stability in the face of environmental change. Non-bee pollinators include flies, beetles, moths, butterflies, wasps, ants, birds, and bats, among others. Here we focus on non-bee insects and synthesize 39 field studies from five continents that directly measured the crop pollination services provided by non-bees, honey bees, and other bees to compare the relative contributions of these taxa. Non-bees performed 25–50% of the total number of flower visits. Although non-bees were less effective pollinators than bees per flower visit, they made more visits; thus these two factors compensated for each other, resulting in pollination services rendered by non-bees that were similar to those provided by bees. In the subset of studies that measured fruit set, fruit set increased with non-bee insect visits independently of bee visitation rates, indicating that non-bee insects provide a unique benefit that is not provided by bees. We also show that non-bee insects are not as reliant as bees on the presence of remnant natural or seminatural habitat in the surrounding landscape. These results strongly suggest that non-bee insect pollinators play a significant role in global crop production and respond differently than bees to landscape structure, probably making their crop pollination services more robust to changes in land use. Non-bee insects provide a valuable service and provide potential insurance against bee population declines.

Participatory crop improvement: the challenges of and opportunities for institutionalisation in the Indian public research sector

This thesis considers Participatory Crop Improvement (PCI) methodologies and examines the reasons behind their continued contestation and limited mainstreaming in conventional modes of crop improvement research within National Agricultural Research Systems (NARS). In particular, it traces the experiences of a long-established research network with over 20 years of experience in developing and implementing PCI methods across South Asia, and specifically considers its engagement with the Indian NARS and associated state-level agricultural research systems. In order to address the issues surrounding PCI institutionalisation processes, a novel conceptual framework was derived from a synthesis of the literatures on Strategic Niche Management (SNM) and Learning-based Development Approaches (LBDA) to analyse the socio-technical processes and structures which constitute the PCI ‘niche’ and NARS ‘regime’. In examining the niche and regime according to their socio-technical characteristics, the framework provides explanatory power for understanding the nature of their interactions and the opportunities and barriers that exist with respect to the translation of lessons and ideas between niche and regime organisations. The research shows that in trying to institutionalise PCI methods and principles within NARS in the Indian context, PCI proponents have encountered a number of constraints related to the rigid and hierarchical structure of the regime organisations; the contractual mode of most conventional research, which inhibits collaboration with a wider group of stakeholders; and the time-limited nature of PCI projects themselves, which limits investment and hinders scaling up of the innovations. It also reveals that while the niche projects may be able to induce a ‘weak’ form of PCI institutionalisation within the Indian NARS by helping to alter their institutional culture to be more supportive of participatory plant breeding approaches and future collaboration with PCI researchers, a ‘strong’ form of PCI institutionalisation, in which NARS organisations adopt participatory methodologies to address all their crop improvement agenda, is likely to remain outside of the capacity of PCI development projects to deliver.

Impacts of climate changes on crop physiology and food quality

Carbon emissions related to human activities have been significantly contributing to the elevation of atmospheric [CO(2)] and temperature. More recently, carbon emissions have greatly accelerated, thus much stronger effects on crops are expected. Here, we revise literature data concerning the physiological effects of CO(2) enrichment and temperature rise on crop species. We discuss the main advantages and limitations of the most used CO(2)-enrichment technologies, the Open-Top Chambers (OTCs) and the Free-Air Carbon Enrichment (FACE). Within the conditions expected for the next few years, the physiological responses of crops suggest that they will grow faster, with slight changes in development, such as flowering and fruiting, depending on the species. There is growing evidence suggesting that C(3) crops are likely to produce more harvestable products and that both C(3) and C(4) crops are likely to use less water with rising atmospheric [CO(2)] in the absence of stressful conditions. However, the beneficial direct impact of elevated [CO(2)] on crop yield can be offset by other effects of climate change, such as elevated temperatures and altered patterns of precipitation. Changes in food quality in a warmer, high-CO(2) world are to be expected, e.g., decreased protein and mineral nutrient concentrations, as well as altered lipid composition. We point out that studies related to changes in crop yield and food quality as a consequence of global climatic changes should be priority areas for further studies, particularly because they will be increasingly associated with food security. (c) 2009 Elsevier Ltd. All rights reserved.

Crop rotation scheduling with adjacency constraints

In this article we propose a 0-1 optimization model to determine a crop rotation schedule for each plot in a cropping area. The rotations have the same duration in all the plots and the crops are selected to maximize plot occupation. The crops may have different production times and planting dates. The problem includes planting constraints for adjacent plots and also for sequences of crops in the rotations. Moreover, cultivating crops for green manuring and fallow periods are scheduled into each plot. As the model has, in general, a great number of constraints and variables, we propose a heuristics based on column generation. To evaluate the performance of the model and the method, computational experiments using real-world data were performed. The solutions obtained indicate that the method generates good results.

Sustainable vegetable crop supply problem

We consider an agricultural production problem, in which one must meet a known demand of crops while respecting ecologically-based production constraints. The problem is twofold: in order to meet the demand, one must determine the division of the available heterogeneous arable areas in plots and, for each plot, obtain an appropriate crop rotation schedule. Rotation plans must respect ecologically-based constraints such as the interdiction of certain crop successions, and the regular insertion of fallows and green manures. We propose a linear formulation for this problem, in which each variable is associated with a crop rotation schedule. The model may include a large number of variables and it is, therefore, solved by means of a column-generation approach. We also discuss some extensions to the model, in order to incorporate additional characteristics found in field conditions. A set of computational tests using instances based on real-world data confirms the efficacy of the proposed methodology. (C) 2009 Elsevier B.V. All rights reserved.

Estimating losses in an entanglement concentration scheme using the phenomenological operator approach to dissipation in cavity quantum electrodynamics

In a previous paper, we developed a phenomenological-operator technique aiming to simplify the estimate of losses due to dissipation in cavity quantum electrodynamics. In this paper, we apply that technique to estimate losses during an entanglement concentration process in the context of dissipative cavities. In addition, some results, previously used without proof to justify our phenomenological-operator approach, are now formally derived, including an equivalent way to formulate the Wigner-Weisskopf approximation.

Heat losses and thermal performance of commercial combined solar and pellet heating systems

Various pellet heating systems are marketed in Sweden, some of them in combination with a solar heating system. Several types of pellet heating units are available and can be used for a combined system. This article compares four typical combined solar and pellet heating systems: System 1 and 2 two with a pellet stove, system 3 with a store integrated pellet burner and system 4 with a pellet boiler. The lower efficiency of pellet heaters compared to oil or gas heaters increases the primary energy demand. Consequently heat losses of the various systems have been studied. The systems have been modeled in TRNSYS and simulated with parameters identified from measurements. For almost all systems the flue gas losses are the main heat losses except for system 3 where store heat losses prevail. Relevant are also the heat losses of the burner and the boiler to the ambient. Significant leakage losses are noticed for system 3 and 4. For buildings with an open internal design system 1 is the most efficient solution. Other buildings should preferably apply system 3. The right choice of the system depends also on whether the heater is placed inside or outside of the heated are. A large potential for system optimization exist for all studied systems, which when applied could alter the relative merits of the different system types.

COMPARISON OF PARTIAL SHADING LOSSES IN FREE FIELD PV-PLANTS WITH DIFFERENT ARRAY CONFIGURATIONS

A common problem when planning large free field PV-plants is optimizing the ground occupation ratio while maintaining low shading losses. Due to the complexity of this task, several PV-plants have been built using various configurations. In order to compare the shading losses of different PV technologies and array designs, empirical performance data of five free field PV-plants operating in Germany was analyzed. The data collected comprised 140 winter days from October 2011 until March 2012. The relative shading losses were estimated by comparing the energy output of selected arrays in the front rows (shading-free) against that of shaded arrays in the back rows of the same plant. The results showed that landscape mounting with mc-Si PV-modules yielded significantly better results than portrait one. With CIGS modules, making cross-table strings using the lower modules was not beneficial as expected and had more losses than a one-string-per-table layout. Parallel substrings with CdTe showed relatively low losses. Among the two CdTe products analyzed, none showed a significantly better performance.

Thermal losses in sealed, gas-filled flat plate solar collectors

A sealed space between absorber and cover glass makes it possible reducing the influence of humidity condensate and dust at the same time as the enclosed space can be filled with a suitable gas for lowering the losses. This paper is about the size of the losses in these collectors. A calculating model of a gas-filled flat plate solar collector was built in Matlab with standard heat transfer formulas. It showed that the total loss can be reduced up to 20% when changing to an inert gas. It is also possible using a much shorter distance and still achieve low losses at the same time as the mechanical stresses in the material is reduce.

Distribution Of Hydrological Losses For Varying Rainfall And Antecedent Wetness Conditions

Hydrological loss is a vital component in many hydrological models, which are usedin forecasting floods and evaluating water resources for both surface and subsurface flows. Due to the complex and random nature of the rainfall runoff process, hydrological losses are not yet fully understood. Consequently, practitioners often use representative values of the losses for design applications such as rainfall-runoff modelling which has led to inaccurate quantification of water quantities in the resulting applications. The existing hydrological loss models must be revisited and modellers should be encouraged to utilise other available data sets. This study is based on three unregulated catchments situated in Mt. Lofty Ranges of South Australia (SA). The paper focuses on conceptual models for: initial loss (IL), continuing loss (CL) and proportional loss (PL) with rainfall characteristics (total rainfall (TR) and storm duration (D)), and antecedent wetness (AW) conditions. The paper introduces two methods that can be implemented to estimate IL as a function of TR, D and AW. The IL distribution patterns and parameters for the study catchments are determined using multivariate analysis and descriptive statistics. The possibility of generalising the methods and the limitations of this are also discussed. This study will yield improvements to existing loss models and will encourage practitioners to utilise multiple data sets to estimate losses, instead of using hypothetical or representative values to generalise real situations.

Some losses brought out by the WTO agreement for TRIPs

The WTO established two rules concerning the international protection of the TRIPs - trade related intellectual property rights, which includes patents and copyrights. One of these rules is the non-discrimination, which has shown to be efficiency-enhancing in the context of trade tariff reductions. The other is the national-treatment commitment rule. We develop in this paper a simple framework to show that the extended version of this rule - which is nowadays being imposed to members - brings out a loss of economic efficiency and a reduction in the levels of protection of intellectual property rights worldwide. As a consequence, it tends to reduce the investments on Research and Development throughout the world. This exactly contradicts the objectives of the Agreement.

Valorização dos gases da carbonização da madeira via rota de combustão

A produção de carvão vegetal a partir de florestas plantadas mudou de forma determinante a logística desta atividade dotando-a de escala e fixando a estrutura de produção composta por fornos e periféricos. A lógica de se ter os fornos construídos ao lado das frentes de exploração florestal, e se deslocando junto com ela à medida em que a colheita é realizada foi abandonada. A partir de então, tem-se buscado uma forma de aproveitar a disponibilidade energética contida nos gases da carbonização, que segue sem uso, tendo quando muito um aproveitamento incipiente e marginal. Esta dissertação apresenta uma proposta de lay out para a Unidade de Produção de Carvão (UPC) de fornos retangulares tradicionais em alvenaria projetados e posicionados de forma a possibilitar seu acoplamento a um sistema de coleta e queima dos gases da carbonização. Após exaustiva pesquisa bibliográfica e visitas técnicas para conhecimento de diferentes tecnologias de carbonização, elaborou-se o projeto, com objetivo de eliminar as limitações identificadas nas tecnologias tradicionais em uso atualmente pelas empresas com produção em escala industrial, reduzindo as perdas e dificuldades operacionais para aproveitamento dos gases. É caracterizado pela saída dos gases somente por uma chaminé instalada no fundo do forno, possui entradas de ar do processo em minicâmaras, que atuam evitando excesso de ar, queima excessiva de madeira e consequente geração excessiva de CO2 e metano – dois gases causadores de efeito estufa. Preconiza-se a queima dos gases da carbonização para uso posterior em geração de energia elétrica e/ou secagem da madeira antes da carbonização. Os resultados dos indicadores técnicos (ciclos dos fornos e produtividade, etc.) e de produção obtidos até o momento na planta em operação vêm confirmando a operacionalidade do conjunto de fornos na nova disposição concebida. Não houve perda de produtividade dos fornos causada pela nova disposição, e as modificações no projeto do forno não impactaram negativamente em seu desempenho operacional. A capacidade produtiva da Unidade vem se confirmando até o momento. Tivemos frustradas nossas expectativas de já apresentar nesta dissertação os resultados operacionais dos fornos juntamente com os do sistema de queima dos gases dado que houve considerável atraso na construção do mesmo impedindo-nos de tê-los antes da data limite de entrega da dissertação. Apresentamos os conceitos que nos levaram à tomada de decisão para o novo lay out e propomos a continuidade dos estudos comprobatórios da viabilidade econômica operacional do sistema, tão logo ele entre em operação.

Interferência entre espécies de planta daninha e duas cultivares de feijoeiro em duas épocas de semeadura

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)