Impact parameters related to bruising in selected fruits.

Impact testing with an instrumented free-fallingmass (50.4 g) device was applied to three varities of pears and two varieties of apples, forincreasing ripeness stages and impact energy (2 to 20 cm drops). Impact parameters were studied in relation to bruise and to ripeness, establishing relations between them and with the different characteristics of the fruits.

Impact bruises in pomaceae fruits: Evaluation methods and structural features.

Using a laboratory impact tester, impacts were applied to fruits of different varieties of apples and pears. The response to impact was analized, and many parameters were recorded, to be correlated to bruise susceptibility and to ripeness changes. Different methods for the detection and evaluation of the bruised Area and its features were studied, using direct observation and various reactives. Different types of bruises were established.

Impact parameters in relation to bruising and other fruit properties.

Impact response in fruits, primarily appl.es and pears (Pomaceae fruits), has been studied during the last five years. Using a laboratory impact testing device and also free-fall tests of instrumented apples, a significant body of results has been established, relative to the parameters which best characterize the impact response of these materials, and to their correlation with bruise damage, variety and ripeness level of the fruits. Bruise damage, measured as the size and/or volume of the affected fruit tissue is related primarily to applied energy (i.e. mainly drop height) for a given variety at a given ripeness stage. The relevant impact response parameters are maximum deformation (DM), permanent deformation (DP), maximum impulse (IM), maximum impact force (FM), maximum value of the force/time slope during impact (F/T) and impact time (T). The effect of ripeness differences was also studied in selected varieties of pears, being the most relevant parameters: maximum force (FM) and F/T slope.

Sensing physical stage of fruits by their response to non destructive impacts.

Fruits of two varieties of both apples and pears were tested in the laboratory to measure their response to a small energy impact applied by an impact tester. Samples of fruits of increasing maturity were tested during several weeks. Non-destructive impacts and other destructive and non-destructive measurements of post-harvest ripeness were applied. A new software was created to control the impact test, calculate the eleven parameters, and sort out the fruit. This software needs a data base and may create new ones. The implementation of an on-line impact device for automatic detection of texture is being designed (patent pending).

Effect of impacting mass on firmness sensing of fruits.

There has been an increased interest in using impact techniques for sensing firmness of fruits and vegetables. When an impacter is used to impact a fruit, the impacting mass is an important parameter which affects both the impact signal and fruit damage. Results of theoretical analysis and tests conducted on two varieties of pears indicate that lowering the impacting mass results in amplifying the measured signal, reducing sensing errors, and minimizing damage to the fruit.

Factors influencing apple and pear physical properties and bruise susceptibility.

Fruit turgidity and firmness have shown to influence impact bruise susceptibility in apples and pears. Analysis of the impact response showed that stresses in the tissues are higher in turgid fruits, so they are more susceptible to bruising. A physical parameter, deformation at skin puncture, was able to detect fruit turgidity changes and showed to be related to bruise susceptibility.

New version of a laboratory impact device for firmness sensing of fruits.

Results of previous studies conducted by different researchers have shown that impact techniques can be used to evaluate firmness (Delwiche et al., 1989; Delwiche et al.;1996; Jaren et al., 1992; Ruiz Altisent et al., 1996). To impact the fruit with a small spherical impactor of known mass and radius of curvature and measure the acceleration of the impactor is a technique described by Chen et al. (1985) and used by several researchers for sensing fruit firmness (Jaren et al., 1992; Correa et al.; 1992). The advantages of this method vs. a force sensor that measures the force as a function of time is that the measured impact-acceleration response is independent of the fruit mass and is less sensitive to the variation in the radius of curvature of the fruit (Chen et al., 1996). Ruiz Altisent et al. (1993) developed and used a 50 g impactor with a 19 mm diameter spherical tip, dropping from different height for fruits (apples, pears, avocados, melons, peaches ...). Another impact device for firmness sensing of fruits was developed by Chen and Ruiz Altisent (1996). They designed and fabricated an experimental low-mass impact sensor for high-speed sensing of fruit firmness. The impactor consisted of a semi-spherical impacting tip attached to the end (near the centre of percussion) of a pivoting arm. Impact is done by swinging the impactor to collide with the fruit. It has been implemented for on-line use. In both devices a small accelerometer is mounted behind the impacting tip. Lateral impactor and vertical impactor have been used in laboratory and the results from non-destructive impact tests have contributed to standardise methods to measure fruit firmness: Barreiro (1992) compared impact parameters and results of Magness-Taylor penetration tests for apples, pears, apricots [and peaches; Agulheiro (1994) studied the behaviour of the impact parameters during seven weeks of cold storage of two melon varieties; Ortiz (1998) used low energy impact and NIR procedures to segregate non crispy, non firm and soft peaches. Steinmetz (1996) compared various non-destructive firmness sensors, based on sound, impact and micro-deformation.

Utilización de una nariz electrónica tipo QCM para la evaluación de la calidad aromática en pera y manzana.

The "Libra Nose" electronic nose has eight Quartz Microbalance Sensors. When gas molecules are adsorbed onto the quartz crystal surface, the oscillation frequency changes in proportion to the amount of mass. The response of sensors depends on numerous factors that may be difficult to control, such as the temperature and the humidity of the carrier gas. All these factors cause changes in the selectivity of sensors affecting the reproducibility of measurements. In this paper additive a multiplicative corrections are proposed to be applied to the raw sensors's signal in order to eliminate sources of variations. After these corrections, the sensors' response gives useful information to distinguish between batch of apples and pears with different ripeness stage.

Antecedentes históricos de la actividad dietética en España: los trabajos del Laboratorio de Higiene de la Alimentación de la Escuela Nacional de Sanidad (1932-1936)

Se analiza la actividad dietética desarrollada por la Escuela Nacional de Sanidad entre 1932 y 1936. Como principal fuente de información se han utilizado los trabajos publicados por el personal adscrito a su Laboratorio de Higiene de la Alimentación. Con el objeto de poder confeccionar regímenes dietéticos adaptados a la realidad española, se pretendía investigar la composición química (agua, fécula, proteínas, grasa y sales minerales) de los alimentos españoles y su contenido vitamínico. Se estudiaron, siguiendo las recomendaciones y los criterios de los organismos internacionales, algunos de los productos de consumo más frecuente, como aceite de oliva, patatas, tomates frescos y en lata, fresa, fresón, peras, ciruelas e higo chumbo, además de algunas conservas. Los resultados obtenidos ponían de manifiesto las diferencias que existían con los datos ofrecidos por autores extranjeros, entre las que destacaba la mayor riqueza vitamínica de productos como el aceite de oliva andaluz o el tomate fresco valenciano. Estas diferencias se atribuían al factor geoclimático. También se estudiaron, en el caso del cocido, la paella y la yema de huevo, las modificaciones que podían producir los procesos culinarios en la composición de los alimentos empleados.

Recursos hídricos superficiais vs subterrâneos na Várzea da Nazaré : implicações na qualidade da água

Tese de doutoramento, Geologia (Hidrogeologia), Universidade de Lisboa, Faculdade de Ciências, 2016

Pests of pear in California /

Mode of access: Internet.

The pear psylla in California /

Mode of access: Internet.

With Morgan to Panama.

Mode of access: Internet.

Evaluation of FMVSS 103 idle test vs. road load test. Final report.

National Highway Traffic Safety Administration, Office of Crash Avoidance, Washington, D.C.

Test methods for high temperature materials characterization /

"Final report for period February 1976-December 1978."