986 resultados para NICKEL(II) PHOSPHATE
Resumo:
Reaction of salts of the 2,5-disubstituted amino-p-benzoquinone bridging ligand (la-e) with trans-bis(triphenylphosphane)phenylnickel(II) chloride results in the binuclear complexes 2a-e, which show high activities for ethylene polymerization without any cocatalysts. High-molecular-weight, moderately branched polyethylene of broad molecular-weight distribution was obtained.
Resumo:
A new iron hydrogen phosphate, heptairon bis(phosphate) tetrakis(hydrogenphosphate), Fe-7(PO4)(2)(HPO4)(4), has been prepared hydrothermally and characterized by single-crystal X-ray diffraction. The compound has one Fe atom on an inversion centre and is isostructural with Mn-7(PO4)(2)(HPO4)(4) and Co-7(PO4)(2)(HPO4)(4). The structure is based on a framework of edge- and corner-sharing FeO6, Fe-5 and PO4 polyhedra, isotypic with that found in the mixed-valence iron phosphate Fe-7(PO4)(6). The Fe atoms in the title compound are purely in the divalent state, just like the Co atoms in Co-7(PO4)(2)(HPO4)(4), the necessary charge balance being maintained by the addition of H atoms in the form of bridging Fe-OH-P groups.
Resumo:
Neutral Ni(II) salicylaldiminato complexes activated with modified methylaluminoxane as catalysts were used for the vinylic polymerization of norbornene. Catalyst activities of up to 7.08 x 10(4) kg(pol)/(mol(Ni) (.) h) and viscosity-average molecular weights of polymer up to 1.5 x 10(6) g/mol were observed at optimum conditions. Polynorbornenes are amorphous, soluble in organic solvents, highly stable, and show glass-transition temperatures around 390 degreesC. Catalyst activity, polymer yield, and polymer molecular weight can be controlled over a wide range by the variation of the reaction parameters such as the Al/Ni ratio, monomer/catalyst ratio, monomer concentration, polymerization reaction temperature, and time.
Resumo:
A new family of self-immobilized ethylene polymerization catalysts, derived from neutral, single-component salicylaldiminato phenyl nickel complexes, is described.
Resumo:
Graphite powder-supported nickel(II) hexacyanoferrate (NiHCF) was prepared by the in situ chemical deposition method and then dispersed into methyltrimethoxysilane-derived gels to form a conductive composite. The composite was used as electrode material to construct a surface-renewable three-dimensional NiHCF-modified carbon ceramic electrode. Electrochemical behavior of the chemically modified electrode was well characterized using cyclic and square-wave voltammetry. The electrode presented a good electrocatalytic activity toward the oxidization of thiosulfate and thus was used as an amperometric sensor for thiosulfate in the photographic waste effluent. In addition, the electrode exhibited a distinct advantage of surface-renewal by simple mechanical polishing, as well as simple preparation, good chemical and mechanical stability. (C) 2001 Elsevier Science B.V. All rights reserved.
Resumo:
A nickel molybdenum phosphate, (NH3CH2CH2NH3)(4).(NH3CH2CH2NH2). Na .[Ni2Mo12O30(PO4)(HPO4)(4)(H2PO4)(3)]. 6H(2)O, invoicing molybdenum present in V oxidation, has been hydrothermally synthesized and structurally characterized by single crystal X-ray diffraction. Deep brown-red crystals are formed in the triclinic system, space group P (1) over bar, a = 12,011(2), b = 14,612(3), c = 21.252(4) Angstrom, alpha = 80.54(2)degrees, beta = 83.10(2)degrees, gamma = 76.29(2)degrees, V = 3561.4(12) Angstrom(3), Z = 2, lambda(MoK alpha) = 0.71073 Angstrom (R(F) = 0.0529 for 9880 reflections), Data mere collected on a Siemens P4 diffractometer at 20 degrees C in the range of 1.75 degrees < theta < 23.02 degrees using the omega-scan technique. The structure was solved by direct methods using the program SHELXTL-93 and refined with the method of fun-matrix least-squares on F-2. The structure of the title compound may be considered to be two [Mo6O15(HPO4)(H2PO4)(3)](5-) units bonded together with a nickel atom, although several P-O groups are not protonated on account of coordination with a Na+ cation, The one-dimensional tunnels were formed in the solid of the title compound. A probe reaction of the oxidation of acetaldehyde with H2O2 using the title compound as catalyst was carried out in a liquid- solid system, showing that the title compound had high catalytic activity in the reaction, (C) 1999 Academic Press.
Resumo:
A new nickel (II)-cyanometallates modified on glassy carbon electrode was prepared by a new method and studied by cyclic voltammetry and in situ Fourier transform infrared (FTIR) spectroelectrochemistry. It was found that the NiHCF film existed in two forms: Ni2Fe(II)-(CN)(6) and M2NiFe(II)(CN)(6), Fe(CN)(3)(6-) codeposited in the NiHCF film existing in free cation or bridged-bond state depended on the property of the cations in electrolyte: in NaCl and LiCl solution, it is in bridges-bonded, but in HCl and KCl, it is free.
Resumo:
The binuclear complex [Ni(oxae)Ni(phen)2](ClO4)(2) . H2O (oxae=N,N'bis(2-aminoethyl) oxamido dianion, phen = 1, 10-phenanthroline) was prepared from the planar monomeric complex Ni(oxae) and characterized through analytical and spectroscopic measurements. The structure of [Ni(oxae)Ni(phen)(2)] (ClO4)2 . 3H(2)O was investigated by single-crystal X-ray analysis. The complex has an extended oxamido-bridged structure and consists of two nickel(II) ions, one of them in a square planar environment and another in a distorted octahedral environment. The Ni-Ni distance is 5.267 Angstrom.
Resumo:
Amperometic flow measurements were made at +0.55 V (vs. Ag/AgCl) in 0.1 mol l-1 KOH electrolyte with an Ni(II) chemically modified electrode (CME) with an Eastman-AQ polymer film. The use and characteristics of a Ni(II)-containing crystalline and polymer-modified electrode obtained by a double coating step as a detector for amino acids in a flow-injection system using reversed-phase liquid chromatography are described. The detection of these analytes is based on the higher oxidation state of nickel (NiOOH) controlled by the applied potential. The electroanalytical parameters and the detection current for a series of amines and amino acids were investigated. The use of such a CME in the flow-injection technique was found to be suitable in a solution at low pH. The linear range for glycine is 5 X 10(-6)-0.1 mol 1-1 with a detection limit of 1.0 X 10(-6) mol l-1. A 1 X 10(-4) mol 1-1 mixture of serine and tyrosine was also detected after separation on an Nucleosil C18 column.
Resumo:
Epoxidation of styrene was catalyzed by some nickel(II) complexes, with NaOCl as the oxygen donor. The catalyst Ni(PA)(2). 2H(2)O has been found to be stable for the epoxidation of styrene. Some additives were introduced in the reaction to improve the "micro-environment" of the catalyst. Radical trap had little influence on styrene epoxidation. It was interesting to find that phase-transfer agent had negative influence on epoxidation in this biphase reaction. A possible mechanism of styrene epoxidation catalyzed by Ni(PA)(2). 2H(2)O has been proposed.
Resumo:
The title compound, [Ni2Cl2(C9H10NO2)(2)]center dot CH3OH, is a dinuclear unit built up by two nickel(II) complexes, bridged by two Cl atoms. The coordination geometry around each Ni-II atom can be considered as distorted square-pyramidal, with the tridendate chelate Schiff base ligands coordinating in a trans conformation through their imine N atom and phenoxy and alkoxy O atoms.
Resumo:
The Ni-II centre in the cation of the title compound, [Ni(C6H12S3)(2)]Br-2. 4H(2)O, occupies a crystallographic inversion centre and is octahedrally coordinated by six S-donors from two [9]aneS(3) ligands. Ni-S distances range from 2.3749 (16) to 2.4077 (15) Angstrom and S-Ni-S angles where both thia donors belong to the same ligand lie in a narrow range between 88.09 (5) and 88.67 (6)degrees. The water molecules participate in extensive hydrogen bonding with each other and with the Br- anions to form double chains with eight- and 12-membered hydrogen-bonded rings running along the crystallographic a direction.
Resumo:
Ce mémoire décrit la synthèse, la caractérisation spectroscopique et l’étude de la réactivité catalytique d’une nouvelle série de complexes pinceurs de Ni(II) formés à partir du ligand POCOPPh (P,C,P-2,6-{Ph2PO}2C6H4), très peu étudié dans le cas du nickel. Les études décrites dans ce mémoire examinent l’effet des substituants des phosphines sur les propriétés spectroscopiques et électrochimiques ainsi que les activités catalytiques. La synthèse du ligand a été améliorée par rapport à la procédure connue dans la littérature en diminuant le temps de réaction à 30 min et la température jusqu'à température ambiante. Les composés pinceur (P,C,P-2,6-{Ph2PO}2C6H3)NiX ont été obtenus avec des rendements variant entre 60% et 88%. Le premier complexe a été synthétisé en faisant réagir le précurseur NiBr2(NCCH3)x avec le ligand POCOPPh pour donner (POCOPPh)NiBr. Ce dernier réagit par la suite avec les sels d’argent et de potassium pour donner 4 nouveaux complexes soient : (POCOPPh)NiCN, (POCOPPh)NiOTf, (POCOPPh)NiOAc et (POCOPPh)NiONO2 (OTf = triflate et OAc = acetate). Vu la réactivité limitée du dérivé bromure, le dérivé (POCOPPh)NiOTf a été utilisé pour la préparation du composé (POCOPPh)NiCCPh. Le dérivé Ni-OTf a été utilisé également pour la synthèse des complexes (POCOPPh)NiR qui ont été détectés par RMN. Ces complexes (POCOPPh)NiR ont montré une stabilité trop faible et donnent des nouveaux complexes de type (POCOPPh)NiX en échangeant l’halogène avec le Mg ou de type (POCOPPh)NiOH en s’hydrolysant. Les espèces cationiques [(POCOPPh)NiNCR][OTf] (R= Me, CHCH2, CHCHMe, C(Me)CH2, NCCH2CH2N(Ph)H) ont été obtenues facilement et avec des bon rendements à partir du (POCOPPh)NiOTf. Tous les composés obtenus ont été caractérisés par la spectroscopie RMN (1H, 13C{1H}, 31P{1H}, 19F{1H}), la spectroscopie IR et la spectroscopie UV-vis. L’analyse élémentaire et l’analyse par la diffraction des rayons X, dont le but est de résoudre la structure à l’état solide, ont été utilisées pour la plupart des complexes. Des études de voltampérométrie cyclique ont été menées pour déterminer la densité électronique des centres métalliques et l’effet des phosphines sur cette propriété électrochimique. Dans le but de déterminer l’effet des substituants des phosphines sur l’activité catalytique des complexes, nous avons évalué les réactivités catalytiques des deux complexes (POCOPPh)NiOTf et (POCOPi-Pr)NiOTf dans la réaction d’hydroamination des oléfines activés et plus spécifiquement l’acrylonitrile. Après optimisation des conditions expérimentales, on a constaté que la réactivité des deux composés sont similaires mais une grande différence apparaît après l’ajout des additifs. En effet, le complexe (POCOPi-Pr)NiOTf donne une bonne activité catalytique en présence de la triéthylamine, tandis que cette activité diminue considérablement en présence d’eau, contrairement au complexe (POCOPPh)NiOTf qui est plus actif en présence d’eau. Dans le cas du complexe (POCOPPh)NiOTf, on a pu montrer que la base se coordonne au nickel dans le produit formé après la réaction d’hydroamination, ce qui diminue l’activité de ce complexe dans certains cas. Également on a exploré la réaction de l’addition du lien O-H sur l’acrylonitrile, et étonnamment le complexe (POCOPPh)NiOTf est beaucoup plus actif que son homologue (POCOPi-Pr)NiOTf dans le cas des alcools aromatiques. Par contre, les alcools aliphatiques restent un défi majeur pour ce genre de complexe. Le mécanisme de cette réaction qui a été proposé montre que l’alcoolyse passe par les deux intermédiaires (POCOPPh)NiOAr et [(POCOPPh)NiOAr][HOAr] mais l’isolation de ces intermédiaires observés par RMN semble être difficile.
Resumo:
Thèse numérisée par la Division de la gestion de documents et des archives de l'Université de Montréal
Resumo:
Mémoire numérisé par la Division de la gestion de documents et des archives de l'Université de Montréal