Permanent magnet synchronous generator design solution for large directdrive wind turbines: Thermal behavior of the LC DD-PMSG

Wind is one of the most compelling forms of indirect solar energy. Available now, the conversion of wind power into electricity is and will continue to be an important element of energy self-sufficiency planning. This paper is one in a series intended to report on the development of a new type of generator for wind energy; a compact, high-power, direct-drive permanent magnet synchronous generator (DD-PMSG) that uses direct liquid cooling (LC) of the stator windings to manage Joule heating losses. The main param-eters of the subject LC DD-PMSG are 8 MW, 3.3 kV, and 11 Hz. The stator winding is cooled directly by deionized water, which flows through the continuous hollow conductor of each stator tooth-coil winding. The design of the machine is to a large degree subordinate to the use of these solid-copper tooth-coils. Both steady-state and timedependent temperature distributions for LC DD-PMSG were examined with calculations based on a lumpedparameter thermal model, which makes it possible to account for uneven heat loss distribution in the stator conductors and the conductor cooling system. Transient calculations reveal the copper winding temperature distribution for an example duty cycle during variable-speed wind turbine operation. The cooling performance of the liquid cooled tooth-coil design was predicted via finite element analysis. An instrumented cooling loop featuring a pair of LC tooth-coils embedded in a lamination stack was built and laboratory tested to verify the analytical model. Predicted and measured results were in agreement, confirming the predicted satisfactory operation of the LC DD-PMSG cooling technology approach as a whole.

Rheological behavior of blueberry

The physical and physicochemical characteristics of blueberry (Vaccinium myrtillus) fruits produced in Brazil were analyzed. Rheological properties were measured at 5, 25, 45 and 65 °C, on a stress controlled rheometer equipped with grooved a stainless-steel parallel-plate in a shear rate range of 0-300 s-1, with the objective of determining the influence of temperature on the rheological properties. The pseudoplastic behavior with yield stress was well described by the Ostwald-de-Waele (Power Law), Herschel-Bulkley (HB) and Mizhari Berk models. The yield stress and behavior index decreased with the increase in the temperatures for 5, 25, and 45 °C whereas for the temperature of 65 °C the effects were the opposite exhibiting elevated values. The viscosity decreased with an increase in temperature, and the Arrhenius equation described adequately the effect of temperature on the apparent viscosity of the puree, in which the activation energy (Ea) determined at a shear rate of 100 s-1 was 9.36 kJ.mol-1.

Rheological behavior and color stability of anthocyanins from Merlot (Vitis vinifera L.) and Bordô (Vitis labrusca L.) grapes in a jam model system

Anthocyanins are the pigments responsible for the color of most red grapes and are easily degraded following various reaction mechanisms affected by oxygen, enzymes, pH, and temperature among other variables. In this study, a jam model system was developed using Merlot and Bordô grape extracts and polysaccharides (xanthan and locust bean gums) and different temperatures (45, 55 and 65 °C). The stability of the anthocyanin pigments and the rheological behavior of the jam model system were studied. For the determination of the stability, the half-life time and first-order reaction rate constants for the anthocyanin pigments were calculated. The rheological behavior was determined through the Power law model. The jam model system produced using a temperature of 45 °C showed the best results for the anthocyanin half-life time. The first-order reaction rate constants for the 45, 55, and 65 °C treatments were not significantly different among each other (p > 0.05). It was observed that with an increase in the jam model system temperature there was an increase in the index of consistency.

Rheological behavior of corn and soy mix as feed ingredients

Foods behave as non-Newtonian fluids, but little is known about how corn and soybean mix behave under viscometric flow. In order to characterize the rheological behavior of animal feed under viscometric flow, a 70:30 (mass:mass) mixture of ground corn and soybean grains was submitted to a capillary rheometer at 3 different temperatures (80, 120, and 160 °C), different moisture levels (26.5 ± 0.08; 30.4 ± 0.31, and 33.4 ± 0.05%), and 4 shear rates (30.4; 72.9; 304.3, and 728.6/second). Different strain rates and die dimensions were used to obtain the target shear rates. The resulting data were fitted to Power Law, Casson, and Bingham models. Based on experimental data, water content, mass temperature, and the effects of shear rate on the apparent shear viscosity of corn-soy mix were fitted to a single expression (p < 0.001, R² = 0.93): η = 18,769.7 (y)-0.86 e (-9.34 U + 935 T), where y is shear rate, U is sample moisture, and T is sample temperature in Kelvin scale. As expected, such mixture presented a pseudoplastic (shear-thinning) behavior.

Hygroscopic behavior of buriti (Mauritia flexuosa) fruit

The objective of this study was to perform an analysis of the characterization of buriti fruit (Mauritia flexuosa). Each part of the fruit (peel, pulp, and fibrous part) was analyzed and their hygroscopic behavior was evaluated to establish the drying and storage conditions. Adsorption and desorption isotherms were obtained at 25 °C to the monolayer value was estimated, and the application of the Halsey, Handerson, Kuhn, Mizrahi, Oswin, Smith, BET, and GAB models was evaluated to the prediction of the isotherms. The fruit pulp was classified as rich in high quality oil, and like the peel and the fibrous part, it was also considered as rich in dietary fiber. The isotherms of the fruit parts were classified as type II, and their microbiological stability (a w < 0.6) can be maintained at 25 °C if the moisture content is lower than 8.5, 7.3, and 11.0 g H2O.100 g-1 of dry matter (d.m.), respectively. The hygroscopic behavior showed that in order to ensure stability, the fruit parts should be packaged with low water vapor permeability. The monolayer demonstrated that the peel, pulp, and the fibrous part cannot be dried under moisture content lower than 5.9, 5.0, and 6.4 g H2O.100 g-1 d.m., respectively. GAB was the most adequate model to describe their isotherms.

Rheological behavior of Brazilian Cherry (Eugenia uniflora L.) pulp at pasteurization temperatures

The rheological behavior of Brazilian Cherry (Eugenia uniflora L.) pulp in the range of temperatures used for pasteurization (83 to 97 °C) was studied. The results indicated that Brazilian Cherry pulp presented pseudoplastic behavior, and the Herschel-Bulkley model was considered more adequate to represent the rheological behavior of this pulp in the range of temperatures studied. The fluid behavior index (n) varied in the range from 0.448 to 0.627. The effect of temperature on the apparent viscosity was described by an equation analogous to Arrhenius equation, and a decrease in apparent viscosity with an increase in temperature was observed.

Psychological well-being of the parents and child development, behavior, and quality of life in very low birth weight infants

The parents of premature infants, especially the mothers, are at increased risk for distress. Infants born prematurely are at risk for developmental problems. The aim of this study was to investigate whether the psychological well-being of both parents is associated with child development in very low birth weight (VLBW, ≤1500g) children. The burden of prematurity-related morbidity to the children and to the family was also assessed. A cohort of 201 VLBW infants born during 2001–2006 in the Turku University Hospital, Finland, and their parents were studied (I–IV). One study included a control group (n=166) of full-term infants (IV). The psychological well-being of the parents was evaluated by assessments of depressive symptoms, parenting stress, the sense of coherence and general family functioning. Cognitive, behavioral, and socio-emotional development, and the health-related quality of life (HRQoL) of the children were determined when the children were 2 to 8 years old. The psychological well-being of the parents was associated with the cognitive, behavioral and social development of the VLBW children. The VLBW infants with prematurity-related morbidities had a poorer HRQoL and the general functioning of the family was inferior compared to the control children and their families. 64.5% of the VLBW children survived without morbidities. Most of the VLBW children did not have significant behavior problems (93%), had normal social skills (63%), had no emotional problems (64%), and had no problems in executive functioning (62%). Only 3% of the surviving VLBW infants had significant cognitive delay. In conclusion, the depressive symptoms and stress of the parents can be risk factors for disadvantageous child development, while a strong sense of coherence can be protective. Parents of the premature children with developmental delays might also experience more depressive symptoms and stress than other parents. Prematurity-related morbidities were a burden to the VLBW child as well as to the family.

Explaining the intention to play and behavior of playing sports betting games of young Finnish adults : an application of the theory of planned behavior

The aim of this Master’s Thesis was to examine the determinants of intention and behavior of playing sports betting games in order to explain the intention to play in a more precise way and to be able to understand the behavior of playing. The theory of planned behavior was applied in explaining the intention of young Finnish adults aged 18 to 34. A quantitative research method was applied and an online survey was sent to the students of Lappeenranta University of Technology and to the subscribers of Urheilulehti in order to reach a sample that present the young population of Finland. The theory of the study focused on the theory of planned behavior and its antecedents, attitude towards behavior, subjective norms, perceived behavioral control as well as motivation. By analyzing the data, causal relationships were found through which the explanation of intention was possible. The results showed that attitude towards playing, subjective norms, perceived behavioral control and motivation impact the formation of intention significantly. The results also indicated that intention impacts significantly to the playing frequency.

Effects of Fabrication Processes on the Behavior of S960 Ultra High Strength Steel (UHSS)

Strenx® 960 MC is a direct quenched type of Ultra High Strength Steel (UHSS) with low carbon content. Although this material combines high strength and good ductility, it is highly sensitive towards fabrication processes. The presence of stress concentration due to structural discontinuity or notch will highlight the role of these fabrication effects on the deformation capacity of the material. Due to this, a series of tensile tests are done on both pure base material (BM) and when it has been subjected to Heat Input (HI) and Cold Forming (CF). The surface of the material was dressed by laser beam with a certain speed to study the effect of HI while the CF is done by bending the specimen to a certain angle prior to tensile test. The generated results illustrate the impact of these processes on the deformation capacity of the material, specially, when the material has HI experience due to welding or similar processes. In order to compare the results with those of numerical simulation, LS-DYNA explicit commercial package has been utilized. The generated results show an acceptable agreement between experimental and numerical simulation outcomes.

Metrics for Predicting User Behavior and Experience in an Interactive Storytelling System

In much of the previous research into the field of interactive storytelling, the focus has been on the creation of complete systems, then evaluating the performance of those systems based on user experience. Less focus has been placed on finding general solutions to problems that manifest in many different types of interactive storytelling systems. The goal of this thesis was to identify potential candidates for metrics that a system could use to predict player behavior or how players experience the story they are presented with, and to put these metrics to an empirical test. The three metrics that were used were morality, relationships and conflict. The game used for user testing of the metrics, Regicide is an interactive storytelling experience that was created in conjunction with Eero Itkonen. Data, in the forms of internal system data and survey answers, collected through user testing, was used to evaluate hypotheses for each metric. Out of the three chosen metrics, morality performed the best in this study. Though further research and refinement may be required, the results were promising, and point to the conclusion that user responses to questions of morality are a strong predictor for their choices in similar situations later on in the course of an interactive story. A similar examination for user relationships with other characters in the story did not produce promising results, but several problems were recognized in terms of methodology and further research with a better optimized system may yield different results. On the subject of conflict, several aspects, proposed by Ware et al. (2012), were evaluated separately. Results were inconclusive, with the aspect of directness showing the most promise.

Influence of disinfestation and osmotic conditioning on the germinating behavior of australian royal palm (Archontophoenix alexandrae)seeds

The technique of Osmotic Conditioning, which consists of partial and controlled hydration of the seeds, has obtained success with various species of seeds, increasing the germinating span and tolerance to the adverse conditions of the environment, and has also reduced the time elapsed between sowing and the emergence of the plants. Associated to ideal storage conditions, the treatment has increased the performance of the seeds of tropical wood species. Aiming at studying the germinating environment and the effect of osmotic conditioning on the germination of seeds of the Australian Royal Palm tree, two experiments were performed. The first one evaluated the effect of disinfestation of the seeds of the Australian Royal Palm tree with NaClO. The treatments applied were: 0.5% sodium hypochlorite, exposure periods of 5, 15, 30, 45, 60, 90, 120 and 240 minutes, and the fungicide Captan, as control. The treatments with NaClO did not differ in relation to the final percentage of germination and to the germination speed index, and did not differ from the treatment control. The second test evaluated solutions with the following osmotic potentials: 0.0MPa (pure water), -0.4MPa, -0.6MPa and -0.8MPa, exposed for the periods of 10 and 20 days. The final percentage of germination did not differ among the treatments. The seeds hydrated in pure water for a period of 20 days showed a germination speed index significantly superior to the other treatments, and they did not show significant differences among themselves.

Exchange rate regulation, the behavior of exchange rates, and macroeconomic stability in Brazil

In the last two decades an entirely new set of rules governing the foreign exchange transactions was established in Brazil, substituting for the framework inherited from the 1930s. Foreign exchange controls were dismantled and a floating exchange rate regime replaced different forms of peg. In this paper we argue that although successful by comparison to previous experiences, the current arrangement has important flaws that should be addressed. We discuss how it first led to high volatility and extremely high interest rates, which, when overcome, gave way to a long lasting appreciation of the real exchange rate with adverse consequences to industry.