Some aspects of multilevel load-frequency control of a power system

The application of multilevel control strategies for load-frequency control of interconnected power systems is assuming importance. A large multiarea power system may be viewed as an interconnection of several lower-order subsystems, with possible change of interconnection pattern during operation. The solution of the control problem involves the design of a set of local optimal controllers for the individual areas, in a completely decentralised environment, plus a global controller to provide the corrective signal to account for interconnection effects. A global controller, based on the least-square-error principle suggested by Siljak and Sundareshan, has been applied for the LFC problem. A more recent work utilises certain possible beneficial aspects of interconnection to permit more desirable system performances. The paper reports the application of the latter strategy to LFC of a two-area power system. The power-system model studied includes the effects of excitation system and governor controls. A comparison of the two strategies is also made.

Optimum Evaluation of Reactive Power Requirements in Power Distribution-Systems

This paper presents three methodologies for determining optimum locations and magnitudes of reactive power compensation in power distribution systems. Method I and Method II are suitable for complex distribution systems with a combination of both radial and ring-main feeders and having different voltage levels. Method III is suitable for low-tension single voltage level radial feeders. Method I is based on an iterative scheme with successive powerflow analyses, with formulation and solution of the optimization problem using linear programming. Method II and Method III are essentially based on the steady state performance of distribution systems. These methods are simple to implement and yield satisfactory results comparable with the results of Method I. The proposed methods have been applied to a few distribution systems, and results obtained for two typical systems are presented for illustration purposes.

Statistical modelling and power analysis for detecting trends in total suspended sediment loads

The export of sediments from coastal catchments can have detrimental impacts on estuaries and near shore reef ecosystems such as the Great Barrier Reef. Catchment management approaches aimed at reducing sediment loads require monitoring to evaluate their effectiveness in reducing loads over time. However, load estimation is not a trivial task due to the complex behaviour of constituents in natural streams, the variability of water flows and often a limited amount of data. Regression is commonly used for load estimation and provides a fundamental tool for trend estimation by standardising the other time specific covariates such as flow. This study investigates whether load estimates and resultant power to detect trends can be enhanced by (i) modelling the error structure so that temporal correlation can be better quantified, (ii) making use of predictive variables, and (iii) by identifying an efficient and feasible sampling strategy that may be used to reduce sampling error. To achieve this, we propose a new regression model that includes an innovative compounding errors model structure and uses two additional predictive variables (average discounted flow and turbidity). By combining this modelling approach with a new, regularly optimised, sampling strategy, which adds uniformity to the event sampling strategy, the predictive power was increased to 90%. Using the enhanced regression model proposed here, it was possible to detect a trend of 20% over 20 years. This result is in stark contrast to previous conclusions presented in the literature. (C) 2014 Elsevier B.V. All rights reserved.

Statistical power calculation and sample size determination for environmental studies with data below detection limits

Power calculation and sample size determination are critical in designing environmental monitoring programs. The traditional approach based on comparing the mean values may become statistically inappropriate and even invalid when substantial proportions of the response values are below the detection limits or censored because strong distributional assumptions have to be made on the censored observations when implementing the traditional procedures. In this paper, we propose a quantile methodology that is robust to outliers and can also handle data with a substantial proportion of below-detection-limit observations without the need of imputing the censored values. As a demonstration, we applied the methods to a nutrient monitoring project, which is a part of the Perth Long-Term Ocean Outlet Monitoring Program. In this example, the sample size required by our quantile methodology is, in fact, smaller than that by the traditional t-test, illustrating the merit of our method.

The Roman Republican Navy : from the sixth century to 167 BC

Työ käsittelee Rooman laivaston kehitystä, toimintaa ja osallistumista laajenemispolitiikkaan, jossa Rooma kasvoi kaupunkivaltiosta Välimeren hallitsijaksi. Rooma on aikaisemmissa tutkimuksissa nähty maavaltiona vailla kiinnostusta merenkulkuun. On katsottu, että ainoa merkittävä merisota Rooman historiassa on ensimmäinen puunilaissota (264-241 eKr.) ja että siinäkin roomalaiset (jotka historioitsija Polybius kuvaa vasta-alkajiksi) menestyivät Karthagoa vastaan turvautumalla laskusiltoihin, joiden avulla he saattoivat muuttaa meritaistelun maataisteluksi. Polybiuksen kuvaukseen on aina tähän asti luotettu. On katsottu että Roomalla ei ollut laivastoa ennen ensimmäistä puunilaissotaa ja että Rooma kaikissa sodissaan panosti merisodankäyntiin mahdollisimman vähän. Tämä työ pyrkii kumoamaan nämä käsitykset. Laivasto oli osallisena ja ehdottoman välttämätön kaikissa Rooman laajenemispolitiikan käänteissä. Arkeologian tiedot osoittavat, että ennen ensimmäistä puunilaissotaa Rooma kehittyi ja siitä tuli merkittävä kaupunki nimenomaan kaupankäynnin ja ulkomaisten kontaktien seurauksena. Se ei siis ollut puhdas agraarivaltio. Roomalaisilla oli laivasto jo viimeistään 500-luvulta lähtien eKr. ja sitä käytettiin Rooman laajentaessa valtaansa Italiassa. Näin ollen ensimmäisessä puunilaissodassa läntisen Välimeren herruudesta kilpaili kaksi merivaltiota, Rooma ja Karthago. Toinen puunilaissota (218-201) tunnetaan yleensä Hannibalin tulosta Alppien yli Italiaan, mutta se oli myöskin merkittävä merisota ja karthagolaiset hävisivät sen nimenomaan merellä. Rooma osallistui kilpailuun itäisen Välimeren hallinnasta ja kukisti Makedonian ja Syyrian laivastot, jotka eivät olleet mitenkään Rooman laivaston veroisia. Kaikista Rooman vastustajista Karthagolla olisi ollut suurin mahdollisuus pysäyttää Rooman laivaston voittokulu toisessa puunilaissodassa. Laivastoa käytettiin moniin eri tarkoituksiin. Suuret meritaistelut eivät ole ainoa osoitus laivastojen mukanaolosta ja merkityksestä, vaan on myös otettava huomion sotalaivojen rakenne ja toimintaedellytykset. Sotalaivat oli rakennettu taisteluita varten ja niissä oli hyvin niukasti säilytystilaa. Niiden oli päästävä laskemaan maihin aina kun miehistö tarvitsi vettä, ruokaa ja lepoa. Laivastot saattoivat toimia vain niiden rannikoiden tuntumassa, joiden satamiin ja laskupaikkoihin niillä oli turvallinen pääsy. Roomalaiset olivat hyvin tietoisia tästä. Suuret merentakaiset sotaretket Afrikkaan, Espanjaan, Kreikkaan ja Vähän-Aasian rannikolle perustuivat kaikki siihen, että Rooman laivasto hallitsi purjehdusreittejä ja sopivia laskupaikkoja ja saattoi huolehtia joukkojen ja varusteiden kuljettamisesta kaukana taisteleville armeijoille. Samalla Rooman laivasto kävi itsenäistä sotaa merellä ja haastoi ja kukisti kaikki Välimeren merivaltiot. 130-luvulle eKr. tultaessa se oli lyönyt vihollisensa ja riisunut aseista liittolaisensa; Rooman laivasto hallitsi Välimerta yksin.

Optimal scheduling of hydro-thermal power systems under shortage

The problem of optimal scheduling of the generation of a hydro-thermal power system that is faced with a shortage of energy is studied. The deterministic version of the problem is first analyzed, and the results are then extended to cases where the loads and the hydro inflows are random variables.

The impact of global positioning systems and plotters on fishing power in the northern prawn fishery, Australia

The impact of global positioning systems (GPS) and plotter systems on the relative fishing power of the northern prawn fishery fleet on tiger prawns (Penaeus esculentus Haswell, 1879, and P. semisulcatus de Haan, 1850) was investigated from commercial catch data. A generalized linear model was used to account for differences in fishing power between boats and changes in prawn abundance. It was found that boats that used a GPS alone had 4% greater fishing power than boats without a CPS. The addition of a plotter raised the power by 7% over boats without the equipment. For each year between the first to third that a fisher has been working with plotters, there is an additional 2 or 3% increase. It appears that when all boats have a GPS and plotter for at least 3 years, the fishing power of the fleet will increase by 12%. Management controls have reduced the efficiency of each boat and lowered the number of days available to fish, but this may not have been sufficient to counteract the increases. Further limits will be needed to maintain the desired levels of mortality.

A towed instrument package for fisheries research in great barrier reef waters

A tethered remote instrument package (TRIP) has been developed for biological surveys over Queensland's continental shelf and slope. The present system, evolved from an earlier sled configuration, is suspended above the sea bed and towed at low speeds. Survey information is collected through video and film cameras while instrument and environmental variables are handled by a minicomputer. The operator was able to "fly" the instrument package above the substrate by using an altitude echosounder, forward-looking sonar and real-time television viewing. Unwanted movements of the viewing system were stabilized through a gyro-controlled camera-head panning system. the hydrodynamic drag of the umbilical presented a major control problem which could be overcome only by a reduction in towing speed. Despite the constraints of towing a device such as this through the coral reef environment, the package performed well during a recent biological survey where it was worked at 50% of its 350 m design depth.

A Current Source Inverter Fed Induction Motor Drive with Power Factor Angle Control Using Microprocessor

This paper describes a method of adjusting the stator power factor angle for the control of an induction motor fed from a current source inverter (CSI) based on the concept of space vectors (or park vectors). It is shown that under steady state, if the torque angle is kept constant over the entire operating range, it has the advantage of keeping the slip frequency constant. This can be utilized to dispose of the speed feedback and simplify the control scheme for the drive, such that the stator voltage integral zero crossings alone can be used as a feedback for deciding the triggering instants of the CSI thyristors under stable operation of the system. A closed-loop control strategy is developed for the drive based on this principle, using a microprocessor-based control system and is implemented on a laboratory prototype CSI fed induction motor drive.

Developing a Beef Cattle Nutritional Management Education Package for Producers in Northern Australia

Meat and Livestock Australia (MLA) and the Queensland Beef Industry Institute (QBII) used the marketing process Quality Function Deployment (QFD) to determine the education needs of beef producers in northern Australia with regards to beef cattle nutrition management. This is the first time that such a process has been conducted in this sector of the industry. 290 producers from across Queensland, the Northern Territory and Western Australia were interviewed. The results of this process provide considerable insights into issues of concern to northern producers in terms of beef cattle nutrition and how education, extension and research organisations can ensure that they meet the needs of their target audience. Animal production for a consuming world : proceedings of 9th Congress of the Asian-Australasian Association of Animal Production Societies [AAAP] and 23rd Biennial Conference of the Australian Society of Animal Production [ASAP] and 17th Annual Symposium of the University of Sydney, Dairy Research Foundation, [DRF]. 2-7 July 2000, Sydney, Australia.

The development and evaluation of an E-learning package to enhance interprofessional learning

Experience’s of VLE - In some cases was used as little more than a “dumping” ground for lecture/tutorial material. - Allowed easy access to material for staff and students alike. - Attempted use as an interactive teaching and learning platform predominately from a distance learning perspective. Students worked very much in isolation. - Support from Academic and Clinical staff adhoc at times.

On an unexpected career path? Using Wittgenstein’s Family Resemblance concept to determine the power of projects to transform project management careers

The power of projects has been demonstrated by the growth in their use across an increasing range of industries and workplaces in recent years. Not only has the number of people involved in project management increased, but the qualifications and backgrounds of those people have also broadened, with engineering no longer being the only path to project management (PM). Predicting the career trajectories in Project Management has become more important for both organisations employing project managers and project managers building career portfolios. Our research involved interviewing more than 75 project officers and project managers across a range of industries to explore their career journey. We used Wittgenstein’s family resemblance theory is to analyse the information from the transcripts to identify the extent to which the roles of participants fit with the commonly accepted definition of project management. Findings demonstrate diversity of project manager backgrounds and experiences and relational competencies across these backgrounds that form and shape PM careers.

No Wrong Door: The Salvation Army Doorways Case Management Service

The primary aim of the evaluation project was to determine the impact of The Salvation Army Doorways case management model in relation to client satisfaction and meeting client needs. Specifically, the project sought to: • Provide an overview of structural barriers confronting individuals who are entrenched in enduring poverty; • Provide an overview of the specific issues encountered by individuals, including insight into personal challenges, hopes and dreams; • Analyse the effectiveness of Doorways interventions, specifically: o How important is the relationship with staff at the Doorways centre? o What skills and knowledge do staff need? o What Doorways activities are the most successful in breaking the cycle of poverty? o How important are community connections? • Provide information to The Salvation Army on what works well in Doorways and how Doorways might be improved or enhanced.

An adaptive power-system stabiliser which cancels the negative damping torque of a synchronous generator

The paper presents a new criterion for designing a power-system stabiliser, which is that it should cancel the negative damping torque inherent in a synchronous generator and automatic voltage regulator. The method arises from analysis based on the properties of tensor invariance, but it is easily implemented, and leads to the design of an adaptive controller. Extensive computations and simulation have been performed, and laboratory tests have been conducted on a computer-controlled micromachine system. Results are presented illustrating the effectiveness of the adaptive stabiliser.