Chemical changes in skin mucin as an index of early stages of spoilage in fish

Results of a preliminary investigation on the overall chemical nature of fish skin mucin in lung fish, Clarias batrachus, with special reference to water soluble low molecular weight compounds, are presented. Changes observed during room temperature spoilage have been studied with a view to present a new approach towards the assessment of freshness in fish inspection. pH of the mucin was distinctly alkaline (8.2) and remained unchanged during spoilage. Much of the nitrogen was found to be present in the glycoprotein fraction. Free amino acids and purine bases were present in appreciable quantities in the aqueous extracts which registered a significant increase after 10 hrs. Post-mortem increase in total solids was accompanied by a slight rise in protein nitrogen which may indicate tissue breakdown. Increase in TVN was also observed to occur earlier in the outside mucin as compared to the inside muscle. Presence of free sugars or sialic acid could not be confirmed nor was there any indication of cholesterol and lipoid material as stated in earlier literature.

Water soluble nitrogenous component from squilla (Orato squilla nepa)

A water soluble hygroscopic powder has been isolated from squilla in good yield, ranging from 3.5 to 5.0% of the fresh raw material, by a simple direct method. The process consists of homogenising squilla with an equal quantity of water, removal of chitinous matter from the slurry by filtration, heating the filtrate at 0.7 kg/sq.cm steam pressure for 15-20 minutes, removal of the precipitated protein by filtration and concentration and final drying in vacuum of the filtered cooled liquor. The pale brown powder so obtained consists mainly of peptones and proteoses and has been found to be comparable to BDH peptone for growth of bacteria, ability to serve as source for tryptophan for indole production and to provide substrate for the production of hydrogen sulphide. Comparative studies have been made on similar water soluble fractions from two species of prawns, namely, Metapenaeus affinis and Parapenaeopsis stylifera.

Soluble protein isolated from low cost fish and fish wastes

The method of preparation, composition, amino acid content, protein efficiency ratio and areas of possible application of water soluble protein isolates from low cost fish and fish wastes are discussed in detail in this communication.

Report of the baseline survey undertaken on the Chinese cage site in Napoleon Gulf, Northern Lake Victoria, 12 March 2012

The government of the People's Republic of China through a 2007 agreement with the Government of the Republic of Uganda, has establishment of an Agricultural Technology Demonstration Center (ATDC). The first phase covering the building of aquaculture infrastructure at Kajjansi ARDC is complete and the second operation phase has started in which facilities for cage culture have been set up in the Napoleon gulf, northern Lake Victoria near Jinja. The cage facility is aimed at boosting fish farming within the lake as a diversification to the traditional pond fish culture technology. NaFIRRI scientists as well as Chinese experts undertook a baseline survey in the chosen cage site on 12 March 2012. The survey covered determination of water depth, water transparency, measurement of selected physical-chemical parameters (temperature,dissolved oxygen, conductivity and pH; determination of the nutrient status and study of algae, invertebrate and fish communities at the site. Materials and methodologies used in the survey were based on the Standard Operating Procedures (SOPs) of NaFIRRI. The study area was divided into three study sites. Site 1 (upstream) was at 8.9 metre depth while site 2 (proposed cage site) and site 3 (downstream) were 6 and 4.3 metres deep respectively. Water transparency was lowest at site 1 (1.58 m) and highest at site 3 (1.64 m). Dissolved oxygen at the three sites ranged from 6.0 to 8 mg/I. Water temperature profiles fluctuated within narrow limits between 26.5 and 27.5 DC. Measurements of pH were between 7 (neutral) and 8 (alkaline) while electrical conductivity was between 98 and 101 uS/em. These observed physical-chemical parameters at the study site were considered suitable for cage fish rearing purposes. Nitrite-nitrogen levels varied within narrow limits from 0.043 to 0.0453 mgtl. Similarly, Ammonia-nitrogen varied between 0.015 and 0.0185 mg/1. Soluble reactive phosphorus (SRP) level was highest at site 3 (O.012mgll) compared to that at sites 1 and 2 (0.009mgll). Total suspended solids (TSS) were higher at site 1 (83.3mgll), thereafter decreasing to lower levels at sites 2 (24.8mgtl) and 3 (19.8mgl) respectively. The nutrient level results observed here all fall below the maximum permissible limits by NEMA and therefore the site is recommended for cage culture The algal community was constituted by four major groups: Blue greens,Greens, Cryptophytes, and Diatoms with blue greens as the common and dominant group. High algal biomass (19944961 ugtL) of the dominant blue green algae was observed at site 1 compared site 2 and 3 (58655.2 & 27487. 7 ugtL) respectively. Occurrence of toxicin producing algae: microsytis and cylindrospermopsis in the proposed cage area was considered to be of not much significance as their concentrations were below harmful levels. However, monitoring their presence, biomass and seasonality will be critical in order to follow when and where they occur and at what time of the year for ease of management of the cages

Soft-lithographic processed soluble micropatterns of reduced graphene oxide for wafer-scale thin film transistors and gas sensors

PDMS based imprinting is firstly developed for patterning of rGO on a large area. High quality stripe and square shaped rGO patterns are obtained and the electrical properties of the rGO film can be adjusted by the concentration of GO suspension. The arrays of rGO electronics are fabricated from the patterned film by a simple shadow mask method. Gas sensors, which are based on these rGO electronics, show high sensitivity and recyclable usage in sensing NH 3. © 2012 The Royal Society of Chemistry.

Modeling fatigue crack growth in crystalline solids with discrete dislocation plasticity

Analyses of crack growth under cyclic loading conditions are discussed where plastic flow arises from the motion of large numbers of discrete dislocations and the fracture properties are embedded in a cohesive surface constitutive relation. The formulation is the same as used to analyse crack growth under monotonic loading conditions, differing only in the remote loading being a cyclic function of time. Fatigue, i.e. crack growth in cyclic loading at a driving force for which the crack would have arrested under monotonic loading, emerges in the simulations as a consequence of the evolution of internal stresses associated with the irreversibility of the dislocation motion. A fatigue threshold, Paris law behaviour, striations, the accelerated growth of short cracks and the scaling with material properties are outcomes of the calculations. Results for single crystals and polycrystals will be discussed.

Micro-architectured solids: From blast resistant structures to morphing wings

Classes of lattice material are reviewed, and their fracture response is explored in the context of the core of a sandwich panel. Attention is focussed on the strength of a sandwich plate with centre-cracked core made from an elastic-brittle square lattice. Predictions are summarised for the un-notched strength of the sandwiched core and for the fracture toughness of the lattice under remote tension, remote compression or remote shear. It is assumed that the lattice fails when the local stress in the cell walls attains the tensile or compressive strength of the solid, or when local buckling occurs. The local failure mechanism that dictates the unnotched strength may be different from that dictating the fracture toughness. Fracture mechanism maps are generated in order to reveal the dominant local failure mechanism for any given cell wall material.

An analysis of competing toughening mechanisms in layered and particulate solids

The relative potency of common toughening mechanisms is explored for layered solids and particulate solids, with an emphasis on crack multiplication and plasticity. First, the enhancement in toughness due to a parallel array of cracks in an elastic solid is explored, and the stability of co-operative cracking is quantified. Second, the degree of synergistic toughening is determined for combined crack penetration and crack kinking at the tip of a macroscopic, mode I crack; specifically, the asymptotic problem of self-similar crack advance (penetration mode) versus 90 ° symmetric kinking is considered for an isotropic, homogeneous solid with weak interfaces. Each interface is treated as a cohesive zone of finite strength and toughness. Third, the degree of toughening associated with crack multiplication is assessed for a particulate solid comprising isotropic elastic grains of hexagonal shape, bonded by cohesive zones of finite strength and toughness. The study concludes with the prediction of R-curves for a mode I crack in a multi-layer stack of elastic and elastic-plastic solids. A detailed comparison of the potency of the above mechanisms and their practical application are given. In broad terms, crack tip kinking can be highly potent, whereas multiple cracking is difficult to activate under quasi-static conditions. Plastic dissipation can give a significant toughening in multi-layers especially at the nanoscale. © 2013 Springer Science+Business Media Dordrecht.

Mathematical model for solids transport power in a decanter centrifuge

A mathematical model of the transport of sedimented solids within a decanter centrifuge has been developed. The primary purpose of the model is to calculate the power, torque and axial force required for the scroll to transport the solids along the bowl. The model is presented in a non-dimensional form and the procedure for implementing the model is included. The model is compared to test data from an existing publication; there was good agreement between the model and data. Example results are presented in the form of graphs to illustrate the influence of key parameters. © 2013 Elsevier Ltd.

Trends of Superoxide Dismutase and Soluble Protein of Aquatic Plants in Lakes of Different Trophic Levels in the Middle and Lower Reaches of the Yangtze River, China

A limnological study was carried out to determine the responses of superoxide dismutase (SOD) activities and soluble protein (SP) contents of 11 common aquatic plants to eutrophication stress. Field investigation in 12 lakes in the middle and lower reaches of the Yangtze River was carried out from March to September 2004. Our results indicated that non-submersed (emergent and floating-leafed) plants and submersed plants showed different responses to eutrophication stress. Both SOD activities of the non-submersed and submersed plants were negatively correlated with their SP contents (P < 0.000 1). SP contents of non-submersed plants were significantly correlated with all nitrogen variables in the water (P < 0.05), whereas SP contents of submersed plants were only significantly correlated with carbon variables as well as ammonium and Secchi depth (SD) in water (P < 0.05). Only SOD activities of submersed plants were decreased with decline of SD in water (P < 0.001). Our results indicate that the decline of SOD activities of submersed plants were mainly caused by light limitation, this showed a coincidence with the decline of macrophytes in eutrophic lakes, which might imply that the antioxidant system of the submersed plants were impaired under eutrophication stress.