An algorithm for optimum control of static VAR compensators to meet phase-wise unbalanced reactive power demands

The operation of thyristor-controlled static VAR compensators (SVCs) at various conduction angles can be used advantageously to meet the unablanced reactive power demands in a system. However, such operation introduces harmonic currents into the AC system. This paper presents an algorithm to evaluate an optimum combination of the phase-wise reactive power generations from SVC and balanced reactive power supply from the AC system, based on the defined performance indices, namely, the telephone influence factor (TIF), the total harmonic current factor (IT) and the distortion factor (D). Results of the studies conducted on a typical distribution system are presented and discussed.

Wear characteristics and bearing performance of aluminium-mica particulate composite material

Some tribological properties of a mica-dispersed Al-4%Cu-1.5%Mg alloy cast by a conventional foundry technique are reported. The effect of mica dispersion on the wear rate and journal bearing performance of the matrix alloy was studied under different pressures and under different interface friction conditions. The dispersion of mica was found (a) to increase the wear rate of the base alloy, (b) to decrease the temperature rise during wear and (c) to improve the ability of the alloy to resist seizure.

Performance of an Al-Si-graphite particle composite piston in a diesel engine

Al-Si-graphite particle composite alloy pistons containing different percentages of about 80 μm uncoated graphite particles were successfully cast by foundry techniques. Tests with a 5 hp single-cylinder diesel engine show that Al-Si-graphite particle composite pistons can withstand an endurance test of 500 h without any apparent deterioration and do not seize during the running-in period. The use of the Al-Si-3% graphite particle composite piston also results in (a) up to 3% reduction in the specific fuel consumption, (b) considerable reduction in the wear of all four piston rings, (c) a reduction in piston wear, (d) a 9% reduction in the frictional horsepower losses of the engine as determined by the motoring test and (e) a slight increase in the exhaust gas temperature. These reductions (a)–(d) appear to be due to increased lubrication from the graphite particles which are smeared on the bearing surface, the higher damping capacity of the composite pistons and the reduced coefficient of thermal expansion of the composite pistons. Preliminary results indicate that aluminum-graphite particle composite alloy is a promising material for automotive pistons.

Application of the method of initial functions for the analysis of composite laminated plates

The method of initial functions has been applied for deriving higher order theories for cross-ply laminated composite thick rectangular plates. The equations of three-dimensional elasticity have been used. No a priori assumptions regarding the distribution of stresses or displacements are needed. Numerical solutions of the governing equations have been presented for simply supported edges and the results are compared with available ones.

Insulating phase of a disordered system: Fermi glass versus electron glass

The authors examine the critical divergence of the low-frequency conductivity of the noninteracting Fermi glass and interacting electron glass models of the insulating phase of a disordered system as the metallic phase is approached. Results for the two are found to be rather different, which can be tested experimentally. In particular, for the electron glass, there exists a nonvanishing contribution to the dielectric constants from the low-frequency (hopping) conductivity even at low temperatures, which scales with the high-frequency (optical) contribution, and diverges with the same exponent at the insulator-metal transition.

Mordenite-incorporated PVA-PSSA membranes as electrolytes for DMFCs

Composite membranes with mordenite (MOR) incorporated in poly vinyl alcohol (PVA)–polystyrene sulfonic acid (PSSA) blend tailored with varying degree of sulfonation are reported. Such a membrane comprises a dispersed phase of mordenite and a continuous phase of the polymer that help tuning the flow of methanol and water across it. The membranes on prolonged testing in a direct methanol fuel cell (DMFC) exhibit mitigated methanol cross-over from anode to the cathode. The membranes have been tested for their sorption behaviour, ion-exchange capacity, electrochemical selectivity and mechanical strength as also characterized by Fourier transform infrared spectroscopy and thermogravimetric analysis. Water release kinetics has been measured by magnetic resonance imaging (NMR imaging) and is found to be in agreement with the sorption data. Similarly, methanol release kinetics studied by volume-localized NMR spectroscopy (point resolved spectroscopy, PRESS) clearly demonstrates that the dispersion of mordenite in PVA–PSSA retards the methanol release kinetics considerably. A peak power-density of 74 mW/cm2 is achieved for the DMFC using a PVA–PSSA membrane electrolyte with 50% degree of sulfonation and 10 wt.% dispersed mordenite phase. A methanol cross-over current as low as 7.5 mA/cm2 with 2 M methanol feed at the DMFC anode is observed while using the optimized composite membrane as electrolyte in the DMFC, which is about 60% and 46% lower than Nafion-117 and PVA–PSSA membranes, respectively, when tested under identical conditions.

Macadamia Regional Variety Trials Series 3 - Phase 2

Regional variety trials (RVT) established in 1983 and again in 1997 identified superior varieties for the macadamia industry. From the 1983 trials, guidelines were developed to assist growers to select the most appropriate new varieties for their particular orchards and many of these superior varieties have been enthusiastically adopted by industry. This is also being done for varieties in the 1997 trials. Many of the best cultivars have already been adopted by growers on the basis of annual reports of yield and quality. Industry development over the next 10 to 20 years will be largely dependent on new, superior varieties selected in these RVT5, including new selections from the macadamia industry breeding program.

Phase field study of precipitate growth: Effect of misfit strain and interface curvature

We have used phase field simulations to study the effect of misfit and interfacial curvature on diffusion-controlled growth of an isolated precipitate in a supersaturated matrix. Treating our simulations as computer experiments, we compare our simulation results with those based on the Zener–Frank and Laraia–Johnson–Voorhees theories for the growth of non-misfitting and misfitting precipitates, respectively. The agreement between simulations and the Zener–Frank theory is very good in one-dimensional systems. In two-dimensional systems with interfacial curvature (with and without misfit), we find good agreement between theory and simulations, but only at large supersaturations, where we find that the Gibbs–Thomson effect is less completely realized. At small supersaturations, the convergence of instantaneous growth coefficient in simulations towards its theoretical value could not be tracked to completion, because the diffusional field reached the system boundary. Also at small supersaturations, the elevation in precipitate composition matches well with the theoretically predicted Gibbs–Thomson effect in both misfitting and non-misfitting systems.

Use of a volatile buffer at ambient temperature *1: Versatile approach to the purification of self-complementary synthetic deoxyoligonucleotides by reversed-phase high-performance liquid chromatography

Abstract is not available.

DAQ00152 Herbicide Tolerance Screening in Northern Region (Phase IV)

The previous projects (phase I - III) highlighted that northern region wheat and barley cultivars differ considerably in their sensitivity to herbicides. The new project will focus on increased screening of advanced breeding lines and new cultivars lines to commonly used herbicides, for barley, chickpea and wheat. Studies on impact of environment on herbicide x genotype responses will also be undertaken with the national team. The new information will be added to the existing information package on herbicide tolerance. Thus, adverse impacts of herbicides on productivity in northern region will be reduced, as growers and agronomists will select safer herbicides for their sown variety, or select more tolerant varieties for their important herbicides.

Australian Herbicide Resistance Initiative (phase 4)

A national focus on strategic and applied research to minimise herbicide resistance in Australian cropping.

Central Queensland Sustainable Farming Systems - Phase 3

This project employed a participatory development and extension (D&E) approach involving on-farm trials and capacity- building activities to improve the economic and environmental performance of grain and mixed farming enterprises in central Queensland (CQ). The project's activities delivered (1) enhanced knowledge and understanding of key system variables that underpin grain and mixed farming businesses, and parameter values for these variables in relation to a range of environmental and management factors, (2) new and refined practices, technologies and management strategies to sustain the profitability of cropping and (3) products and information to support continuous improvement in farm business performance.

Farm Program Management - Phase II

Jointly manage The Farm Program within the Cotton Catchment Communities CRC.

Risk assessment and preventive strategies for herbicide resistance in NR (phase III)

The threat and management of glyphosate# resistant weeds are major issues facing northern region growers. At present five weeds are confirmed glyphosate-resistant: barnyard grass, liverseed grass, windmill grass, annual ryegrass and flaxleaf fleabane. This project used 25 experiments to investigate the ecology of the grass weeds, plus new or improved chemical and non-chemical control tactics for them. The refined glyphosate resistance model developed in this project used the experiments' findings to predict the long-term impacts on evolution of resistance and on seed bank numbers of resistant weeds. These data led to revised management and resistance avoidance strategies, which were published in the Reporter newsletter, and via an on-line risk assessment tool. - See more at: http://finalreports.grdc.com.au/UQ00054#sthash.oTkCN4Sk.dpuf

Queensland pharmacist immunisation pilot phase 1 pharmacist vaccination - Influenza final report

The results of the pilot demonstrated that a pharmacist delivered vaccinations services is feasible in community pharmacy and is safe and effective. The accessibility of the pharmacist across the influenza season provided the opportunity for more people to be vaccinated, particularly those who had never received an influenza vaccine before. Patient satisfaction was extremely high with nearly all patients happy to recommend the service and to return again next year. Factors critical to the success of the service were: 1. Appropriate facilities 2. Competent pharmacists 3. Practice and decision support tools 4. In-­‐store implementation support We demonstrated in the pilot that vaccination recipients preferred a private consultation area. As the level of privacy afforded to the patients increased (private room vs. booth), so did the numbers of patients vaccinated. We would therefore recommend that the minimum standard of a private consultation room or closed-­‐in booth, with adequate space for multiple chairs and a work / consultation table be considered for provision of any vaccination services. The booth or consultation room should be used exclusively for delivering patient services and should not contain other general office equipment, nor be used as storage for stock. The pilot also demonstrated that a pharmacist-­‐specific training program produced competent and confident vaccinators and that this program can be used to retrofit the profession with these skills. As vaccination is within the scope of pharmacist practice as defined by the Pharmacy Board of Australia, there is potential for the universities to train their undergraduates with this skill and provide a pharmacist vaccination workforce in the near future. It is therefore essential to explore appropriate changes to the legislation to facilitate pharmacists’ practice in this area. Given the level of pharmacology and medicines knowledge of pharmacists, combined with their new competency of providing vaccinations through administering injections, it is reasonable to explore additional vaccines that pharmacists could administer in the community setting. At the time of writing, QPIP has already expanded into Phase 2, to explore pharmacists vaccinating for whooping cough and measles. Looking at the international experience of pharmacist delivered vaccination, we would recommend considering expansion to other vaccinations in the future including travel vaccinations, HPV and selected vaccinations to those under the age of 18 years. Overall the results of the QPIP implementation have demonstrated that an appropriately trained pharmacist can deliver safely and effectively influenza vaccinations to adult patients in the community. The QPIP showed the value that the accessibility of pharmacists brings to public health outcomes through improved access to vaccinations and the ability to increase immunisation rates in the general population. Over time with the expansion of pharmacist vaccination services this will help to achieve more effective herd immunity for some of the many diseases which currently have suboptimal immunisation rates.