Misunderstanding or Misdirection?: Whistleblower Protection in Queensland

In his report into corruption in Queensland, Fitzgerald listed whistleblower protection as a necessary part of a strong governance regime. "What is required is an accessible, independent body to which disclosures can be made, confidentially (at least in the first instance) and in any event free from fear of reprisals." It was one of the reforms studied by the Electoral and Administrative Review Committee, the report of which resulted in the Whistleblowers Protection Act 1994 (WPA). The need for whistleblower protection was supported by all sides of Parliament. The Premier, Wayne Goss, in his Second Reading Speech on the Public Sector Ethics Bill , said that that Act and the WPA would form a package with the former outlining required behaviour and the WPA encouraging staff to report wrongdoing. The WPA was subsequently passed and has remained virtually unamended for over a decade. Such consistency is either an indication of skilled drafting and effectiveness or the fact that the Act has been neglected. It is the hypothesis of this paper that the latter is the case. This hypothesis will be tested by examining the sincerity and diligence with which the Act has been treated during, and following, its passage.

Particle number and mass emission factors from combustion of wood samples collected from Queensland forest

Knowledge of particle emission characteristics associated with forest fires and in general, biomass burning, is becoming increasingly important due to the impact of these emissions on human health. Of particular importance is developing a better understanding of the size distribution of particles generated from forest combustion under different environmental conditions, as well as provision of emission factors for different particle size ranges. This study was aimed at quantifying particle emission factors from four types of wood found in South East Queensland forests: Spotted Gum (Corymbia citriodora), Red Gum (Eucalypt tereticornis), Blood Gum (Eucalypt intermedia), and Iron bark (Eucalypt decorticans); under controlled laboratory conditions. The experimental set up included a modified commercial stove connected to a dilution system designed for the conditions of the study. Measurements of particle number size distribution and concentration resulting from the burning of woods with a relatively homogenous moisture content (in the range of 15 to 26 %) and for different rates of burning were performed using a TSI Scanning Mobility Particle Sizer (SMPS) in the size range from 10 to 600 nm and a TSI Dust Trak for PM2.5. The results of the study in terms of the relationship between particle number size distribution and different condition of burning for different species show that particle number emission factors and PM2.5 mass emission factors depend on the type of wood and the burning rate; fast burning or slow burning. The average particle number emission factors for fast burning conditions are in the range of 3.3 x 1015 to 5.7 x 1015 particles/kg, and for PM2.5 are in the range of 139 to 217 mg/kg.

Developing a supportive culture for teaching and learning : a university, faculty and school perspective

In the early 1990's the University of Salford was typical of most pre-1992 Universities in that whilst students provided much of it's income, little attention was paid to pedagogy. As Warren Piper (1994) observed, University teachers were professional in their subject areas but generally did not seek to acquire a pedagogy of HE. This was the case in Alsford. Courses were efficiently run but only a minority of staff were engaged in actively considering learning and teaching issues. Instead staff time was spent on research and commercial activity.----- In the mid-1990's the teaching environment began to change significantly. As well as Dearing, the advent of QAA and teaching quality reviews, Salford was already experiencing changes in the characteristics of its student body. Wideing access was on our agenda before it was so predominant nationally. With increasing numbers and heterogeneity of students as well as these external factors, new challenges were facing the University and teaching domain.----- This paper describes how a culture which values teaching, learning and pedagogic inquiry is being created in the university. It then focuses on parts of this process specific to the Faculty of Business and Informatics, namely the Faculty's Learning and Teaching Research Network and the establishment of the Centre for Construction Education in the School of Construction and Property Management.----- The Faculty of Business and Informatics' Learning and Teaching Research Network aims to raise the profile, quality and volume of pedagogic research across the five schools in the faculty. The initiative is targeted at all academics regardless of previous research experience. We hope to grow and nurture research potential where it exists and to acknowledge and use the existing expertise of subject-based researchers in collaborative ventures. We work on the principle that people are deliged to share what they know but need appreciation and feedback for doing so. A further ain is to surface and celebrate the significant amount of tacit knowledge in the area of pedagogy evidenced by the strength of student and employer feedback in many areas of the faculty's teaching.----- The Faculty embraces generic and core management expertise but also includes applied management disciplines in information systems and construction and property management where internationally leading research activities and networked centres of excellence have been established. Drawing from this experience, and within the context of the Faculty network, a Centre for Construction Education is being established with key international external partners to develop a sustainable business model of an enterprising pedagogic centre that can undertake useful research to underpin teaching in the Faculty whilst offering sustainable business services to allow it to benefit from pump-priming grant funding.----- Internal and external networking are important elements in our plans and ongoing work. Key to this are our links with the LTSN subject centres (BEST and CEBE) and the LTSN generic centre. The paper discusses networking as a concept and gives examples of practices which have proved useful in this context.----- The academic influences on our approach are also examined. Dixon’s (2000) work examining how a range of companies succeed through internal knowledge sharing has provided a range of transferable practices. We also examine the notion of dialogue in this context, defined by Ballantyne (1999) as ‘The interactive human process of reasoning together which comes into being through interactions based on spontaneity or need and is enabled by trust’ Social constructionist principles of Practical Authorship (Shotter, 1993, Pavlica, Holman and Thorpe, 1998)) have also proved useful in developing our perspective on learning and knowledge creation within our community of practice.

Particle and gaseous emissions from commercial aircraft at each stage of the landing and takeoff cycle

A novel technique was used to measure emission factors for commonly used commercial aircraft including a range of Boeing and Airbus airframes under real world conditions. Engine exhaust emission factors for particles in terms of particle number and mass (PM2.5), along with those for CO2, and NOx were measured for over 280 individual aircraft during the various modes of landing/takeoff (LTO) cycle. Results from this study show that particle number, and NOx emission factors are dependant on aircraft engine thrust level. Minimum and maximum emissions factors for particle number, PM2.5, and NOx emissions were found to be in the range of 4.16×1015-5.42×1016 kg-1, 0.03-0.72 g.kg-1, and 3.25-37.94 g.kg-1 respectively for all measured airframes and LTO cycle modes. Number size distributions of emitted particles for the naturally diluted aircraft plumes in each mode of LTO cycle showed that particles were predominantly in the range of 4 to 100 nm in diameter in all cases. In general, size distributions exhibit similar modality during all phases of the LTO cycle. A very distinct nucleation mode was observed in all particle size distributions, except for taxiing and landing of A320 aircraft. Accumulation modes were also observed in all particle size distributions. Analysis of aircraft engine emissions during LTO cycle showed that aircraft thrust level is considerably higher during taxiing than idling suggesting that International Civil Aviation Organization (ICAO) standards need to be modified as the thrust levels for taxi and idle are considered to be the same (7% of total thrust) [1].

Particle and gaseous emissions from compressed natural gas and ultralow sulphur diesel-fuelled buses at four steady engine loads

Exhaust emissions from thirteen compressed natural gas (CNG) and nine ultralow sulphur diesel in-service transport buses were monitored on a chassis dynamometer. Measurements were carried out at idle and at three steady engine loads of 25%, 50% and 100% of maximum power at a fixed speed of 60 kmph. Emission factors were estimated for particle mass and number, carbon dioxide and oxides of nitrogen for two types of CNG buses (Scania and MAN, compatible with Euro 2 and 3 emission standards, respectively) and two types of diesel buses (Volvo Pre-Euro/Euro1 and Mercedez OC500 Euro3). All emission factors increased with load. The median particle mass emission factor for the CNG buses was less than 1% of that from the diesel buses at all loads. However, the particle number emission factors did not show a statistically significant difference between buses operating on the two types of fuel. In this paper, for the very first time, particle number emission factors are presented at four steady state engine loads for CNG buses. Median values ranged from the order of 1012 particles min-1 at idle to 1015 particles km-1 at full power. Most of the particles observed in the CNG emissions were in the nanoparticle size range and likely to be composed of volatile organic compounds The CO2 emission factors were about 20% to 30% greater for the diesel buses over the CNG buses, while the oxides of nitrogen emission factors did not show any difference due to the large variation between buses.

Tensions, transisitions and triumphs : examining the transitional experience of fashion students between school and university

Joining any new community involves transition and adaptation. Just as we learn to adapt to different cultures when we choose to live abroad, so students learn the language and culture of an academic community in order to succeed within that environment. At the same time however, students bring with them individual learning styles and expectations, influenced by their prior experiences of learning and of life more generally. Some have excelled at school; others have come to fashion seeking something in which to excel for the first time. Commencing a degree in fashion design brings students into contact with peers and lecturers who share their passion, providing them with a community of practice which can be both supportive and at the same time intimidating.----- In Queensland where university level study in fashion is such a new phenomenon, few applicants have any depth of training in design when they apply to study fashion. Unlike disciplines such as Dance or Visual Art, where lecturers can expect a good level of skill upon entry to a degree program, we have to look for the potential evidenced in an applicant’s portfolio, much of which is untutored work that they have generated themselves in preparation for application. This means that many first year fashion students at QUT whilst very passionate about the idea of fashion design are often very naïve about the practice of fashion design, with limited knowledge of the history or cultural context of fashion and few of the technical skills needed to translate their ideas into three dimensional products.----- For teachers engaging with first year students in the design studios, it is critical to be cognizant of this mix of different experiences, expectations and emotions in order to design curricula and assessment that stretch and engage students without unduly increasing their sense of frustration and anxiety. This paper examines a first year project designed to provide an introduction to design process and to learning within a creative discipline. The lessons learnt provide a valuable and transferable resource for lecturers in a variety of art and design disciplines.

Leveraging sponsorships on the Internet: Activation, congruence, and articulation

This paper considers how the Internet can be used to leverage commercial sponsorships to enhance audience attitudes toward the sponsor. Definitions are offered that distinguish the terms leverage and activation with respect to sponsorship-linked marketing; leveraging encompasses all marketing communications collateral to the sponsorship investment, whereas activation relates to those communications that encourage interaction with the sponsor. Although activation in many instances may be limited to the immediate event-based audience, leveraging sponsorships via sponsors' Web sites enables activation at the mass-media audience level. Results of a Web site navigation experiment demonstrate that activational sponsor Web sites promote more favorable attitudes than do nonactivational Web sites. It is also shown that sponsorsponsee congruence effects generalize to the online environment, and that the effects of sponsorship articulation on audience attitudes are moderated by the commerciality of the explanation for the sponsor-sponsee relationship. Importantly, the study reveals that attitudinal effects associated with variations in leveraging, congruence, and orientation of articulation may be sustained across time.

A multiliteracies project in the middle school : Parents as coteachers

This paper examines the experiences of one middle years’ English and Studies of Society and Environment (SoSE) teacher who adopted a multiliteracies project-based orientation to a unit on War and Refugees. It details the multiliteracies teaching and learning cycle, which is based on four non-hierarchical, pedagogical orientations: situated practice, overt instruction, critical framing and transformed practice (New London Group, 2000; Kalantzis & Cope, 2005a). Following the work of Kalantzis and Cope (2005a), it draws out the knowledge processes exacted in each of these four phases: experiencing the known and the new; conceptualising by naming and theorising; analysing functionally and critically; and, applying appropriately and creatively. Two parents were invited to enter the study as coteachers with the teacher and researcher. Using Bourdieu’s (1992) construct of capital, the findings report on how the multiliteracies approach enabled them to engage in school-based literacy practices differently than they had done previously in classrooms. An unexpected finding concerns the teacher’s altered view about how his role and status were perceived by the parents.

Systemic racism: the hidden barrier to educational success for Indigenous school students

Explanations for poor educational experiences and results for Australian Indigenous school students have, to a great extent, focused on intended or conscious acts or omissions. This paper adopts an analysis based on the legislation prohibiting indirect racial discrimination. Using the elements of the legislation and case law it argues that apparently benign and race-neutral policies and practices may unwittingly be having an adverse impact on Indigenous students' education. These practices or policies include the building blocks of learning, a Eurocentric school culture. Standard English as the language of assessment, legislation to limit schools' legal liability, and teachers' promotions.

In search of a theory of integrated marketing communication

For the most part, the literature base for Integrated Marketing Communication (IMC) has developed from an applied or tactical level rather than from an intellectual or theoretical one. Since industry, practitioner and even academic studies have provided little insight into what IMC is and how it operates, our approach has been to investigate that other IMC community, that is, the academic or instructional group responsible for disseminating IMC knowledge. We proposed that the people providing course instruction and directing research activities have some basis for how they organize, consider and therefore instruct in the area of IMC. A syllabi analysis of 87 IMC units in six countries investigated the content of the unit, its delivery both physically and conceptually, and defined the audience of the unit. The study failed to discover any type of latent theoretical foundation that might be used as a base for understanding IMC. The students who are being prepared to extend, expand and enhance IMC concepts do not appear to be well-served by the curriculum we found in our research. The study concludes with a model for further IMC curriculum development.

A quasi stationary approach to drying kinetics of cylindrical food particulates in a heat pump asisted fluid bed dryer

Experiments were undertaken to study drying kinetics of moist cylindrical shaped food particulates during fluidised bed drying. Cylindrical particles were prepared from Green beans with three different length:diameter ratios, 3:1, 2:1 and 1:1. A batch fluidised bed dryer connected to a heat pump system was used for the experimentation. A Heat pump and fluid bed combination was used to increase overall energy efficiency and achieve higher drying rates. Drying kinetics, were evaluated with non-dimensional moisture at three different drying temperatures of 30, 40 and 50o C. Numerous mathematical models can be used to calculate drying kinetics ranging from analytical models with simplified assumptions to empirical models built by regression using experimental data. Empirical models are commonly used for various food materials due to their simpler approach. However problems in accuracy, limits the applications of empirical models. Some limitations of empirical models could be reduced by using semi-empirical models based on heat and mass transfer of the drying operation. One such method is the quasi-stationary approach. In this study, a modified quasi-stationary approach was used to model drying kinetics of the cylindrical food particles at three drying temperatures.