Analytical solution to the zero-inertia problem for surge flow phenomena in nonprismatic channels

Surge flow phenomena. e.g.. as a consequence of a dam failure or a flash flood, represent free boundary problems. ne extending computational domain together with the discontinuities involved renders their numerical solution a cumbersome procedure. This contribution proposes an analytical solution to the problem, It is based on the slightly modified zero-inertia (ZI) differential equations for nonprismatic channels and uses exclusively physical parameters. Employing the concept of a momentum-representative cross section of the moving water body together with a specific relationship for describing the cross sectional geometry leads, after considerable mathematical calculus. to the analytical solution. The hydrodynamic analytical model is free of numerical troubles, easy to run, computationally efficient. and fully satisfies the law of volume conservation. In a first test series, the hydrodynamic analytical ZI model compares very favorably with a full hydrodynamic numerical model in respect to published results of surge flow simulations in different types of prismatic channels. In order to extend these considerations to natural rivers, the accuracy of the analytical model in describing an irregular cross section is investigated and tested successfully. A sensitivity and error analysis reveals the important impact of the hydraulic radius on the velocity of the surge, and this underlines the importance of an adequate description of the topography, The new approach is finally applied to simulate a surge propagating down the irregularly shaped Isar Valley in the Bavarian Alps after a hypothetical dam failure. The straightforward and fully stable computation of the flood hydrograph along the Isar Valley clearly reflects the impact of the strongly varying topographic characteristics on the How phenomenon. Apart from treating surge flow phenomena as a whole, the analytical solution also offers a rigorous alternative to both (a) the approximate Whitham solution, for generating initial values, and (b) the rough volume balance techniques used to model the wave tip in numerical surge flow computations.

Ecological interface design for pasteurizer II: A process description of semantic mapping

Ecological interface design (EID) is proving to be a promising approach to the design of interfaces for complex dynamic systems. Although the principles of EID and examples of its effective use are widely available, few readily available examples exist of how the individual displays that constitute an ecological interface are developed. This paper presents the semantic mapping process within EID in the context of prior theoretical work in this area. The semantic mapping process that was used in developing an ecological interface for the Pasteurizer II microworld is outlined, and the results of an evaluation of the ecological interface against a more conventional interface are briefly presented. Subjective reports indicate features of the ecological interface that made it particularly valuable for participants. Finally, we outline the steps of an analytic process for using EID. The findings presented here can be applied in the design of ecological interfaces or of configural displays for dynamic processes.

Quantum error correction for continuously detected errors

We show that quantum feedback control can be used as a quantum-error-correction process for errors induced by a weak continuous measurement. In particular, when the error model is restricted to one, perfectly measured, error channel per physical qubit, quantum feedback can act to perfectly protect a stabilizer codespace. Using the stabilizer formalism we derive an explicit scheme, involving feedback and an additional constant Hamiltonian, to protect an (n-1)-qubit logical state encoded in n physical qubits. This works for both Poisson (jump) and white-noise (diffusion) measurement processes. Universal quantum computation is also possible in this scheme. As an example, we show that detected-spontaneous emission error correction with a driving Hamiltonian can greatly reduce the amount of redundancy required to protect a state from that which has been previously postulated [e.g., Alber , Phys. Rev. Lett. 86, 4402 (2001)].

Role of compaction versus aggregate disruption on slumping and shrinking of repacked hardsetting seedbeds

Slumping of hardsetting seedbeds upon wetting is likely to determine the shrinking and development of strength on drying. Different processes have been invoked, including aggregate disruption, material relocation, and compaction. To gain a better understanding of the role played by compaction compared with aggregate disruption in seedbed slumping and shrinking, mechanical analysis was combined with previous morphogenetical description. The global structural behavior of repacked seedbeds of a hardsetting sandy loam soil was studied after wetting and again after subsequent drying. Bulk density was measured in 5-mm-depth increments using gamma attenuation, and water content was determined at 10-mm-depth increments. Various wetting conditions were used to simulate a range of climatic and management conditions, including flood irrigation, furrow irrigation of a formed seedbed, drip irrigation, and rainfall. Aggregate coalescence under overburden pressure played the main role in slumping, even though microcracking enhanced coalescence. Most of the slumping occurred at calculated effective stress > 1.1 kPa. Intense aggregate breakdown at the top of seedbeds under fast wetting led to slight slumping because the resulting clogging of the initial interaggregate packing voids was balanced, in part, by the increase in microporosity resulting from aggregate disruption. However, aggregate coalescence induced by overburden pressure developing at the seedbed bottom often resulted in a strong decrease in total porosity. The effect of rainfall kinetic energy on crust bulk density was strong compared with the effect of fast wetting (bulk density increase of about 0.07 Mg m(-3) and 0.03 Mg m(-3), respectively) and could be ascribed to compaction rather than to aggregate breakdown. Shrinking on drying was related to the continuity of the microstructure resulting from wetting rather than to the intensity of slumping. Aggregate breakdown led to more shrinking than did aggregate coalescence.

Quantum technology: the second quantum revolution

We are currently in the midst of a second quantum revolution. The first quantum revolution gave us new rules that govern physical reality. The second quantum revolution will take these rules and use them to develop new technologies. In this review we discuss the principles upon which quantum technology is based and the tools required to develop it. We discuss a number of examples of research programs that could deliver quantum technologies in coming decades including: quantum information technology, quantum electromechanical systems, coherent quantum electronics, quantum optics and coherent matter technology.

Quantum control and quantum entanglement

We discuss quantum error correction for errors that occur at random times as described by, a conditional Poisson process. We shoo, how a class of such errors, detected spontaneous emission, can be corrected by continuous closed loop, feedback.

Quantum process tomography of a controlled-NOT gate

We demonstrate complete characterization of a two-qubit entangling process-a linear optics controlled-NOT gate operating with coincident detection-by quantum process tomography. We use a maximum-likelihood estimation to convert the experimental data into a physical process matrix. The process matrix allows an accurate prediction of the operation of the gate for arbitrary input states and a calculation of gate performance measures such as the average gate fidelity, average purity, and entangling capability of our gate, which are 0.90, 0.83, and 0.73, respectively.

Revision of the larval morphology (Zoea I) of the family Hippolytidae (Decapoda, Caridea), with a description of the first stage of the shrimp Hippolyte obliquimanus Dana, 1852

The aim of this study was to summarize the available data on larval morphology of the first zoea of the family Hippolytidae and describe the first zoeal stage of H. obliquimanus from two geographically distinct populations, Brazilian and Caribbean in order to discuss inter- and intraspecific variability. Ovigerous females of Hippolyte obliquimanus were collected at Cahuita (Limon, Costa Rica) and at Ubatuba (Sao Paulo, Brazil). We compiled the published descriptions of all available hippolytid Zoea I (66 spp., 21%), and all zoeae share several characteristics. However, such morphological features cannot be used to distinguish the first zoeae of Hippolytidae from other caridean larvae. Historically, the presence of an exopodal seta at the maxillule and the absence of the anal spine/papilla have been considered as characteristic for the Zoea I of the genus Hippolyte. The results of our revision, however, did not support these conclusions: although H. obliquimanus showed an exopodal seta at the maxillule, four congeners did not bear such structure; moreover, H. obliquimanus as well as one other congener have an anal spine/papilla. All morphological characters observed in the first zoeal stage of H. obliquimanus are shared with others species of the family Hippolytidae. Intraspecific variability in Hippolyte obliquimanus was detected in one morphological aspect: the first zoea had four denticles on the ventral margin of the carapace in the Brazilian population, while specimens from the Costa Rican population had three.

Re-description and new combination of five New World species of Chrysotus Meigen, with comments on the Neotropical genus Lyroneurus Loew (Diptera: Dolichopodidae)

Five New World species of Chrysotus Meigen are redescribed, four of them herein transferred from Diaphorus Meigen: C. angustifrons (Robinson), comb.nov., C. maculatus (Parent), comb.nov. (= D. maculipennis Robinson), C. robustus(Robinson), comb. nov., C. spectabilis (Loew) and C. wirthi (Robinson), comb. nov. The female of C. maculatus is described for the first time. Terminalia of both males and females are illustrated. The previous suggestion that C. angustifrons, C. robustus, C. wirthi, and C. spectabilis and the Neotropical genus Lyroneurus Loew are closely related based on wing venation similarities is analyzed and rejected.

Description of a new species of Asymmetrione (Isopoda: Bopyridae: Pseudioninae) infesting the hermit crab Paguristes tomentosus (Anomura: Diogenidae) from Peru, with a key to species and a review of southeastern Pacific bopyrids

A new species of bopyrid isopod is described from a host hermit crab Paguristes tomentosus collected from Pisco, Peru and assigned to the pseudionine isopod genus Asymmetrione Codreanu, Codreanu and Pike, 1965. This is the second species in the genus with less than 20 asymmetry in females, but agrees with all other species in the genus in having the characteristic ""socket"" on the propodus of the female`s pereopods, and in all characters of the males. A key is provided to the 10 species now in Asymmetrione. New records of an Anathelges sp. from Pagurus villosus collected in central Chile are given but additional material is required to determine whether these specimens represent the eastern Pacific A. thompsoni or the western Atlantic A. hyptius. A review of all the bopyrid species known from the western South American coast, with remarks on their taxonomy and biology, is provided.