Self-diffusion of metals and associated phenomena :

"Contract AT-30-1-GEN-367."

Iwo Jima Photo Album, Image 24

Marines scaling a hill. Caption; "Inch by inch they creep up and over…"

Microstructure and mechanical properties of high pressure die cast magnesium alloy AE42 with 1% strontium

The addition of 1 wt-%Sr to AE42 results in an improvement in the tensile strength of the alloy at elevated temperatures of 150 and 175degreesC and an improvement in the constant load creep properties at 175degreesC. The improved elevated temperature tensile and creep strength of the alloy can be attributed to the presence of a strontium-containing phase in the microstructure of the alloy along with an increase in the stability of the microstructure of the alloy at high temperatures. (C) 2004 W. S. Maney Son Ltd.

Formation of spinel from olivine

High-resolution transmission electron microscopy (HRTEM) was used to study the olivine to spinel transformation. HRTEM structure images of Mg2GeO4 olivine deformed under a pressure of 6 GPa at 600 degreesC clearly show that a shear mechanism dominates the transformation. The transformation is not a nucleation and growth mechanism. It also differs in certain crucial aspects from the type of martensitic transformation proposed before. During the transformation, it is a shear movement that brings the oxygen anions to their positions in the spinel structure. An edge dislocation following each shear then puts the cations in their spinel sites. The Burgers' vector of each dislocation is perpendicular to the anion shear direction. (C) 2004 American Institute of Physics.

Mechanical effects of plant cell wall enzymes on cellulose/xyloglucan composites

Xyloglucan-acting enzymes are believed to have effects on type I primary plant cell wall mechanical properties. In order to get a better understanding of these effects, a range of enzymes with different in vitro modes of action were tested against cell wall analogues (bio-composite materials based on Acetobacter xylinus cellulose and xyloglucan). Tomato pericarp xyloglucan endo transglycosylase (tXET) and nasturtium seed xyloglucanase (nXGase) were produced heterologously in Pichia pastoris. Their action against the cell wall analogues was compared with that of a commercial preparation of Trichoderma endo-glucanase (EndoGase). Both 'hydrolytic' enzymes (nXGase and EndoGase) were able to depolymerise not only the cross-link xyloglucan fraction but also the surface-bound fraction. Consequent major changes in cellulose fibril architecture were observed. In mechanical terms, removal of xyloglucan cross-links from composites resulted in increased stiffness (at high strain) and decreased visco-elasticity with similar extensibility. On the other hand, true transglycosylase activity (tXET) did not affect the cellulose/xyloglucan ratio. No change in composite stiffness or extensibility resulted, but a significant increase in creep behaviour was observed in the presence of active tXET. These results provide direct in vitro evidence for the involvement of cell wall xyloglucan-specific enzymes in mechanical changes underlying plant cell wall re-modelling and growth processes. Mechanical consequences of tXET action are shown to be complimentary to those of cucumber expansin.

TEM characterization of nanostructure and chemistry of semiconductor quantum structures

The power of advanced transmission electron microscopy in determining the nanostructures and chemistry of nanosized materials on the applications in semiconductor quantum structures was demonstrated.

Measurement of glass-rubber transition temperature of skim milk powder by static mechanical test

Stickiness behavior of skim milk powder was investigated based on the mechanical property of the material during the glass-rubber transition. A thermally controlled device was developed for the static mechanical test. This device was attached to a texture analyzer, and skim milk powder, which was used as a model sample, was tested for its glass-rubber transition temperature (Tg-r) using static compression technique (creep test). Changes in compression probe distance as a function of temperature were recorded. Tg-r was determined, in the region where changes in the probe distance were observed, by using linear regression technique. The effect of sample quantity, compression force, and heating rate on the determination of Tg-r was investigated. All these parameters significantly influenced the Tg-r determination (p < 0.05). The Tg-r of skim milk powder measured by this novel technique was found closely correlated to its glass transition temperature (T-g) measured by DSC.

The relationship between acute alcohol consumption and consequent injury type

Aims: The aim of this study was to quantify the relationship between acute alcohol consumption and injury type (nature of injury, body region injured), while adjusting for the effect of known confounders (i.e. demographic and situational variables, usual drinking patterns, substance use and risk-taking behaviour). Methods: A cross-sectional study was conducted between October, 2000 and October, 2001 of patients aged >= 15 years presenting to a Queensland Emergency Department for treatment of an injury sustained in the preceding 24 h. There were three measures of acute alcohol consumption: drinking setting, quantity, and beverage type consumed in the 6 h prior to injury. Two variables were used to quantify injury type: nature of injury (fracture/dislocation, superficial, internal, and CNS injury) and body part injured (head/neck, facial, chest, abdominal, external, and extremities). Both were derived from patient medical records. Results: Five hundred and ninety three patients were interviewed. Logistic regression analyses indicated that, after controlling for relevant confounding variables, there was no significant association between any of the three measures of acute alcohol consumption and injury type. Conclusions: The effects of acute alcohol consumption are not specific to injury type. Interventions aimed at reducing the incidence of alcohol-related injury should not be targeted at specific injury types.

The Corrosion Performance of Magnesium Alloy AM-SC1 in Automotive Engine Block Applications

The magnesium alloy AM-SC1 has been developed as a creep-resistant automotive engine block material. This paper outlines its corrosion performance under laboratory test conditions, considering corrosion on both the external and internal surfaces. This study found that AM-SC1 has a corrosion performance comparable to AZ91 when subjected to an aggressive salt-spray environment or in galvanic-coupling environments. This article further demonstrates that, with the appropriate selection of a commercially available engine coolant, the internal corrosion of AM-SC1 can be maintained at a tolerable level. In addition, internal corrosion resistance can be significantly improved by the addition of fluorides to the coolant solution. It is concluded that AM-SC1 can be successfully used in an engine environment provided that some simple corrosion-prevention strategies are adopted.

The effect of aluminium content on the mechanical properties and microstructure of die cast binary magnesium-aluminium alloys

This paper investigates the relationship between mechanical properties and microstructure in high pressure die cast binary Mg-Al alloys. As-cast test bars produced using high pressure die casting have been tested in tension in order to determine the properties for castings produced using this technique. It has been shown that increasing aluminium levels results in increases in yield strength and a decrease in ductility for these alloys. Higher aluminium levels also result in a decrease in creep rate at 150 degrees C. It has also been shown that an increase in aluminium levels results in an increase in the volume fraction of eutectic Mg17Al12 in the microstructure.

Visoelastic studies on thermoplastic polyurethane nanocomposites using a nano-hardness tester

The viscoelastic behaviour of a range of polyurethane thermoplastic elastomer montmorillonite nanocomposites has been studied using a nanohardness tester. For softer Shore hardness 80A materials, the introduction of the organo-clay increased the creep strain obtained while the nano-indentor was held at constant load. The increase in creep strain was greatest for materials containing an organo-clay modified with a more hydrophilic quaternary alkylammonium surfactant and with higher loadings of the hydrophilic organo-clay. This suggested the effect might be due to a plasticising effect of the excess surfactant. For the harder Shore hardness 55D materials, the addition of the organo-clays produced only a small decrease in the creep strain, probably due to the interconnected hard domains in this material.

Elasticity, yielding and episodicity in simple models of mantle convection

We explore the implications of refinements in the mechanical description of planetary constituents on the convection modes predicted by finite-element simulations. The refinements consist in the inclusion of incremental elasticity, plasticity (yielding) and multiple simultaneous creep mechanisms in addition to the usual visco-plastic models employed in the context of unified plate-mantle models. The main emphasis of this paper rests on the constitutive and computational formulation of the model. We apply a consistent incremental formulation of the non-linear governing equations avoiding the computationally expensive iterations that are otherwise necessary to handle the onset of plastic yield. In connection with episodic convection simulations, we point out the strong dependency of the results on the choice of the initial temperature distribution. Our results also indicate that the inclusion of elasticity in the constitutive relationships lowers the mechanical energy associated with subduction events.

Restriction of intramuscular neurite branching and extension is lost in agrin and rapsyn-deficient mice

The phrenic nerve enters the diaphragm at approximately embryonic day 12.5 (E12.5) in the mouse. The secondary nerve trunk advances along the centre of the diaphragm muscle and extends tertiary branches primarily towards the lateral side during normal embryonic development. In the present study we quantified the intramuscular neurite branching in the most ventral region of the diaphragm at E15.5 and E18.5 in wild-type mice, agrin knock-out mice (KOAG) and rapsyn knock-out mice (KORAP). KOAG and KORAP have decreased muscle contraction due to their inability to maintain/form acetylcholine receptor (AChR) clusters during embryonic development. Heterozygote mothers were anaesthetised via an overdose of Nembutal (30 mg; Boeringer Ingelheim, Ridgefield, CT, USA) and killed via cervical dislocation. There were increases in the number of branches exiting the medial side of the phrenic nerve trunk in KOAG and KORAP compared to wild-type mice, but not on the lateral side at E15.5 and E18.5. However, the number of bifurcations in the periphery significantly increased on both the medial and lateral sides of the diaphragm at E15.5 and E18.5 in KOAG and KORAP compared to control mice. Furthermore, neurites extended further on both the medial and lateral sides of the diaphragm at E15.5 and E18.5 in KOAG and KORAP compared to wild-type mice. Together these results show that the restriction of neurite extension and bifurcations from the secondary nerve trunk is lost in both KOAG and KORAP allowing us the opportunity to investigate the factors that restrict motoneuron behaviour in mammalian muscles.

The motor neurite terminal determines where neuromuscular synapses form in the absence of agrin

Agrin is a proteoglycan secreted by motor neurite terminals that functions to initiate and maintain AChR clusters at the nerve terminal. This led to the theory that neurite terminals decide where neuromuscular synapses form by secreting agrin. However, initiation of AChR clustering occurs in the absence of the innervating motoneuron and in the absence of agrin. In this instance, the muscle, not the nerve, is deciding the location of neuromuscular synapses by drawing neurite terminals towards pre-existing AChR clusters. If this were true, one would expect the initial innervation patterns to be the same in agrin-deficient mice and wild-type mice. To test this we quantified the intramuscular axonal branching and synapse formation in the diaphragm at E14.5 in agrin-deficient mice and wild-type mice. Heterozygote mothers were anaesthetised with Nembutal (30 mg) and killed via cervical dislocation. In the diaphragm, the nerve trunk runs down the centre of the muscle and extends branches primarily toward the lateral side. In agrin-deficient mice however, we found significantly more branches exited the phrenic nerve trunk, branched in the periphery and extended further on the medial side. Moreover, we found that the percentage α-bungarotoxin/synaptophysin colocalisations, markers of pre- and postsynaptic differentiation, respectively, was the same in agrin-deficient mice and wild-type mice. These results show that initial innervation patterns are not the same in agrin-deficient mice and wild-type mice indicating neurite terminals, not muscle, decide the placement of neuromuscular synapses in the absence of agrin.

CRISTIANISMO ETÍOPE A PARTIR DA EXPERIÊNCIA ÉTNICA NARRADA EM ATOS 8, 26-40

Torna-se muito importante demonstrar as experiências cristãs que existiram e coexistiram juntas ou/e imersas nas culturas extrapalestinenses e que exerceram protagonismo no anúncio do querigma. São experiências cristãs vividas e realizadas no período do cristianismo primitivo, e que, sem dúvida, contribuíram significativamente para o seu processo de expansão. Apresentamos a perícope Atos 8,26-40. Trata-se do episódio de Filipe e o Etíope. Acontece um deslocamento do eixo geográfico-missionário de Samaria ao caminho que desce de Jerusalém a Gaza , retornando a Cesaréia. O texto abre o horizonte das experiências cristãs a outros povos e nações, representadas nesta perícope pela figura do Etíope eunuco. Partindo de Atos 8,26-40, na perspectiva da redação lucana como ponto de partida, por meio dos procedimentos exegéticos e dos recursos histórico- literários, apoiado no referencial teórico dos conceitos de etnicidade e fronteiras étnicas, nós pretendemos investigar a possibilidade de uma experiência cristã vivenciada na Etiópia, que se constrói etnicamente desde as identidades que interagem na perícope e que apontam ao imaginário do universo simbólico do Etíope. Assim, resgataremos na exegese bíblica pautas hermenêuticas para a nossa prática teológico-bíblica-pastoral no horizonte das identidades e fronteiras étnicas do universo afro americano e caribenho.