917 resultados para Optic neuritis
Resumo:
为了有效地补偿激光二极管(LD)侧向抽运1000 Hz重复率电光调Q Nd:YAG激光器棒状增益介质内存在的热致双折射损耗,设计了一种新颖的双调Q晶体开关复合谐振腔结构。实验结果表明,设计的双调Q晶体开关结构Nd:YAG激光器输出激光脉冲能量比单调Q晶体开关结构的非补偿腔输出能量提高了56%,当侧面抽运半导体激光器输出功率达到450 W时,激光输出达到30 mJ/pulse,输出光束偏振度优于10:1,激光脉冲宽度约14 ns。并获得6.7%的光-光转换效率。通过对双调Q开光激光谐振腔进行建模,并用求解速
Resumo:
为了同时补偿固体增益介质的热致双折射及热透镜效应,进一步提高重复频率1 kHz激光二极管(LD)侧向抽运高平均功率电光调Q Nd:YAG激光器的输出功率,设计了一种完全消除热退偏损耗的双调Q开关谐振腔结构,此结构在传统调Q谐振腔的基础上沿着偏振片的退偏方向增加了一个调Q谐振支路,并使得激光从增益介质方向输出。实验结果表明,此激光器的单脉冲能量比单Q开关结构的非补偿腔输出能量高出74.7%。当侧面抽运的激光二极管输出脉冲能量达到307 mJ时,激光输出能量达到26.2 mJ,光-光转换效率为8.5%,光束发
Resumo:
高重复频率、窄脉宽的全固态激光器种子源级联光纤放大器是获得高功率脉冲激光输出的有效手段.短上能态寿命的Nd∶YVO4晶体在连续抽运、高重复频率Q开关工作时容易得到接近连续性能的平均输出功率.理论分析了声光(AO)调Q器件中影响输出能量和脉宽大小的主要因素,优化配置了腔型参数.利用激光二极管(LD)光纤耦合模块端面抽运Nd∶YVO4晶体,实现了声-光调Q重复频率100 kHz以上,脉宽20 ns以下,波长1064 nm的激光输出.在抽运功率5.7 W时,得到了脉宽15.3 ns,重复频率150 kHz的种子光输出,在级联单级光纤放大器后,得到了20 W的输出.
Resumo:
实验报道采用我国自行设计的大模场掺镱双包层光纤,利用简单声光调Q装置,成功实现调Q运转;在1-50kHz调制频率下获得了百纳秒的调Q脉冲,其输出光束质量因子大约为2。当重复频率为1kHz时,获得了脉冲宽度为132ns,能量0.93mJ。同时实验中观察到的调Q脉冲常出现一点锁模现象,针对这一现象进行了讨论。
Resumo:
根据激光多普勒测振技术进行声光通信的工作原理,设计一种新型、小型激光多普勒测振信号鉴频电路。该电路根据外差探测原理,本地振荡器输出信号与探测信号混频得到一路信号,经90°移相后的本地振荡器输出信号再与探测信号混频得到另一路信号,利用这两路信号得到了多普勒频移量和声源振动的频率。利用扬声器激发的水面模拟振源进行实验,表明该电路可有效测量的振动频率范围为300 Hz~10 kHz,证明可用于水下光声通信。
Resumo:
The zirconia-titania-ORMOSIL waveguide thin films with considerable optical quality were prepared by the sol-gel process. The refractive index (n) and the extinction coefficient (k) were determined by a scanning ellipsometer. Wavelength tunable output of distributed feedback waveguide lasing was demonstrated in Rhodamine 6G doped ZrO2 TiO2-ORMOSIL thin films by varying the temperature, and about 5.5 nm wavelength tuning range was achieved around the emission wavelength of 599 nm. The thermal-optic coefficient (dn/dT) of the active ZrO2-TiO2-ORMOSIL films was deduced. (c) 2005 Elsevier B.V. All rights reserved.
Resumo:
介绍了激光多普勒振动计(LDV)用于水下声光通信的应用背景,阐述了激光多普勒振动计的工作原理和两种相干检测方式。采用零差的相干探测方式,设计并实现了一套光纤结构的激光多普勒振动计。为了证明系统能够应用于水下声光通信,进行了对水下声源发出的声波频率和强度的探测实验。通过对实验数据的分析得出:第一,系统能够检测出水下声源发出的声波频率,对7 kHz附近的10个声波频率的测量标准偏差小于8 Hz; 第二,系统探测信号强度与水下声源发声的声压级成指数关系,对于水下目标通信所用的3.5 kHz和7 kHz声波频段的
Resumo:
A high repetition rate ytterbium-doped double-clad (YDDC) fiber laser with amplifying effect is described by using acousto-optic modulator. The characteristic of Q-switched pulses are studied with accurate control of opening gate time of modulator. The stable Q-switched pulses with tens of nanoseconds width can be observed at high repetition rate varied from 50 kHz to 500 kHz using this laser. The stable operation area of the Q-switched fiber laser is discussed and the analysis results agree well with that of the experiment. (c) 2007 Elsevier B.V. All rights reserved.
Resumo:
Dynamin-Related Protein 1 (Drp1), a large GTPase of the dynamin superfamily, is required for mitochondrial fission in healthy and apoptotic cells. Drp1 activation is a complex process that involves translocation from the cytosol to the mitochondrial outer membrane (MOM) and assembly into rings/spirals at the MOM, leading to membrane constriction/division. Similar to dynamins, Drp1 contains GTPase (G), bundle signaling element (BSE) and stalk domains. However, instead of the lipid-interacting Pleckstrin Homology (PH) domain present in the dynamins, Drp1 contains the so-called B insert or variable domain that has been suggested to play an important role in Drp1 regulation. Different proteins have been implicated in Drp1 recruitment to the MOM, although how MOM-localized Drp1 acquires its fully functional status remains poorly understood. We found that Drp1 can interact with pure lipid bilayers enriched in the mitochondrion-specific phospholipid cardiolipin (CL). Building on our previous study, we now explore the specificity and functional consequences of this interaction. We show that a four lysine module located within the B insert of Drp1 interacts preferentially with CL over other anionic lipids. This interaction dramatically enhances Drp1 oligomerization and assembly-stimulated GTP hydrolysis. Our results add significantly to a growing body of evidence indicating that CL is an important regulator of many essential mitochondrial functions.
Resumo:
A hanseníase, uma doença conhecida por suas lesões de pele anestésicas, é a principal causa de neuropatia periférica nos países endêmicos. Os episódios reacionais são classicamente conhecidos por promover piora da função nervosa através das chamadas neurites que variam de quadros exuberantes a assintomáticos. Estas características da neuropatia tornam o diagnóstico precoce excepcionalmente desafiador assim como a necessidade de se intervir para se prevenir lesões permanentes nos nervos. Este estudo clínico, prospectivo, foi realizado selecionando-se pacientes com hanseníase, independente da forma clínica, no Ambulatório Souza Araujo, Fiocruz, Rio de Janeiro, que apresentavam episódios reacionais. O objetivo foi estudar o perfil neurológico clínico, eletroneurofisiológico e por imagem do nervo antes e após o tratamento das reações. Foram avaliados vinte e cinco pacientes levando-se em conta: exame neurológico, avaliação fisioterápica, estudo de condução nervosa, avaliação de espessura e ecogenicidade nervosa pelo método ultrassonográfico, fluxometria por laser Doppler e teste quantitativo da sensibilidade durante e um ano após o tratamento da reação. Estes pacientes foram divididos em três grupos: oito pacientes com neurite aguda, nove pacientes com neurite silenciosa e oito pacientes com reação cutânea sem neurite. Nos pacientes com episódios reacionais, observou-se predomínio do sexo masculino (60%), do grupo multibacilar (80%) e da forma clínica borderline-lepromatosa (36%). A neurite isolada foi o tipo de reação mais frequente, seguida de neurite associada à reação do tipo1, seguida da neurite associada à reação do tipo 2. O nervo motor mais acometido por neurite foi o fibular seguido pelo ulnar, enquanto o nervo sensitivo mais acometido foi o sural. O padrão eletroneuromiográfico característico dos episódios reacionais foi a mononeurite múltipla. A ultrassonografia, a fluxometria por laser Doppler e o teste quantitativo de sensibilidade, associados à clínica e ao estudo da condução nervosa, foram tidos como exames úteis para avaliação inicial e para acompanhar o tratamento dos episódios reacionais. Após o tratamento, foi constatada melhora nos parâmetros referentes à função motora, mas o mesmo não ocorreu para sensibilidade. Com esse estudo, observa-se a necessidade de acompanhamento multidiciplinar com exames especializados para os pacientes com hanseníase a fim de diagnóstico de reação e tratamento precoce evitando sequelas neurológicas.
Resumo:
Microvoid arrays were self-organized when femtosecond laser beam was tightly focused at a fixed point inside CaF2 crystal sample. Except void array grown below the focal point which had been reported before, we found another void array grown vertical to the laser propagation direction. This result has potential application in the fabrication of integrated micro-optic elements and photonic crystals. The possible mechanism of the phenomenon was proposed and verified experimentally.
Resumo:
We report on a diode-pumped, cryogenic and room temperature operation of a Tm,Ho:YAlO3 (c-cut) laser. In a temperature of 77 K, an optical-optical conversion efficiency of 27% and a slope efficiency of 29% were achieved with the maximum continuous-wave (CW) output power of 5.0 W at 2.13 mu m. Acousto-optic switched operation was performed at pulse repetition frequency (PRF) from 1 kHz to 10 kHz, the highest pulse energy of 3.3 mJ in a pulse duration of 40 ns was obtained. In room temperature (RT), the maximum CW power of Tm,Ho:YAlO3 laser was 160 mW with a slope efficiency of 11% corresponding to the absorbed pump power. (C) 2008 Optical Society of America.
Resumo:
The measurement of high speed laser beam parameters during processing is a topic that has seen growing attention over the last few years as quality assurance places greater demand on the monitoring of the manufacturing process. The targets for any monitoring system is to be non-intrusive, low cost, simple to operate, high speed and capable of operation in process. A new ISO compliant system is presented based on the integration of an imaging plate and camera located behind a proprietary mirror sampling device. The general layout of the device is presented along with the thermal and optical performance of the sampling optic. Diagnostic performance of the system is compared with industry standard devices, demonstrating the high quality high speed data which has been generated using this system.
Resumo:
Used in chirped-pulse amplification system and based on multi-layer thin film stack, pulse compressor gratings (PCG) are etched by ion-beam and holographic techniques. Diffraction efficiency and laser-induced damage threshold rely on the structural parameters of gratings. On the other hand, they depend greatly on the design of multi-layer. A theoretic design is given for dielectric multi-layer, which is exposed at 413.1 nm and used at 1053 nm. The influences of coating design on optical characters are described in detail. The analysis shows that a coating stack of H3L (H2L) (boolean AND) 9H0.5L2.01H meets the specifications of PCG well. And there is good agreement of transmission between experimental and the theoretic design. (c) 2005 Elsevier GmbH. All rights reserved.
Resumo:
探讨了不同规律的非均匀性对单层膜的光谱特性的影响,与均匀单层膜对比发现:折射率正变引起透射率的极大值减小,折射率负变引起透射率的极大值变大,当非均匀性很小时,透射率的极小值基本不变.对实验制备的单层膜从实验和理论上进行了对比并给出了较好的拟合,发现在薄膜和基底的界面处存在一过渡层,过渡层可近似为线性,并从理论上给予了分析解释.