Gel particles in the sea-surface microlayer during an experimental study

Since the early 80's, the sea-surface microlayer (SML) has been hypothesized as being a gelatinous film. Recent studies have confirmed this characteristic, which confers properties that mediate mass and energy fluxes between ocean and atmosphere, including the emission of primary organic aerosols from marine systems. We investigated SML thickness and composition in five replicate indoor experiments between September and December 2010. During each experiment, the SML and underlying seawater were sampled from four seawater tanks: one served as control, and three were inoculated with Thalassiosira weissflogii grown in chemostats at 180, 380 and 780 ppm pCO2. We examined organic material enrichment factors in each tank, paying particular attention to gel particles accumulation such as polysaccharidic Transparent Exopolymer Particles (TEP) and the proteinaceous Coomassie Stainable Particles (CSP). While previous studies have observed carbohydrates and TEP enrichment in the microlayer, little is yet known about proteinaceous gel particles in the SML. Our experiments show that CSP dominate the gelatinous composition of the SML. We believe that the enrichment in CSP points to the importance of bacterial activity in the microlayer. Bacteria may play a pivotal role in mediating processes at the air-sea interface thanks to their exudates and protein content that can be released through cell disruption.

Highly conductive coatings of carbon black/silica composites obtained by a sol-gel process

Conductive submicronic coatings of carbon black (CB)/silica composites have been prepared by a sol-gel process and deposited by spray-coating on glazed porcelain tiles. Stable CB dispersions with surfactant were rheologically characterized to determine the optimum CB-surfactant ratio. The composites were analyzed by Differential Thermal and Thermogravimetric Analysis and Hg-Porosimetry. Thin coatings were thermally treated in the temperature range of 300-500degC in air atmosphere. The microstructure of the coatings was determined by scanning electron microscopy and the structure evaluated by confocal Raman spectroscopy. The electrical characterization of the samples was carried out using dc intensity-voltage curves. The coatings exhibit good adhesion, high density and homogeneous distribution of the conductive filler (CB) in the insulate matrix (silica) that protects against the thermal degradation of the CB nanoparticles during the sintering process. As consequence, the composite coatings show the lowest resistivity values for CB-based films reported in the literature, with values of ~7times10 -5Omegam.

Quinine doped hybrid sol-gel coatings for wave guiding and optical applications

Pure and quinine doped silica coatings have been prepared over sodalime glasses. The coatings were consolidated at low temperature (range 60-180 A degrees C) preserving optical activity of quinine molecule. We designed a device to test the guiding properties of the coatings. We confirmed with this device that light injected in pure silica coatings is guided over distances of meters while quinine presence induces isotropic photoluminescence. With the combined use of both type of coatings, it is possible to design light guiding devices and illuminate regions in glass elements without electronic circuits.

Aplicaciones basadas en las propiedades eléctricas y térmicas de recubrimientos de sílice-cb obtenidos por el método sol-gel

En los últimos años el interés en los recubrimientos obtenidos por sol-gel ha aumentado mucho en aplicaciones de protección y refuerzo de superficies contra la corrosión. Asimismo, el uso de polimorfos de carbono (nanofibras de carbono, grafeno, grafito...) para mejorar las propiedades mecánicas y conferirle propiedades conductoras a algunos materiales, también se ha desarrollado mucho en los últimos años. En trabajos previos se prepararon y estudiaron recubrimientos híbridos de sílice-CB obtenidos por el método sol-gel. Mediante el estudio de la microestructura y composición de estos recubrimientos (SEM, Raman, ATD-TG, y FT-IR) y de las propiedades eléctricas se obtuvo que en función la temperatura de sinterización de los recubrimientos, se podía controlar la respuesta eléctrica de los composites. Esto permite abrir enormemente el campo de aplicaciones, ya que para temperaturas de sinterización por debajo de 400ºC se consiguen resistividades del orden de 10-4Ωm, apropiadas para aplicaciones en dispositivos electrónicos, electrodos, apantallamiento de interferencias electromagnéticas y radiofreciencia, etc; mientras que para temperaturas de sinterización por encima de 400ºC, obtenemos recubrimientos más resistivos que pueden aplicarse como dispositivos calefactores, anticongelantes. Por tanto, el objetivo de este trabajo es desarrollar más profundamente estas aplicaciones, así como diseñar experimentos que demuestren las múltiples posibilidades que estos recubrimientos conductores obtenidos por sol-gel pueden aportar.

Technical note: Comparison of automated ribosomal intergenic spacer analysis (ARISA) and denaturing gradient gel electrophoresis (DGGE) to assess bacterial diversity in the rumen of sheep

The aim of this study was to compare automated ribosomal intergenic spacer analysis (ARISA) and denaturing gradient gel electrophoresis (DGGE) techniques to assess bacterial diversity in the rumen of sheep. Sheep were fed 2 diets with 70% of either alfalfa hay or grass hay, and the solid (SOL) and liquid (LIQ) phases of the rumen were sampled immediately before feeding (0 h) and at 4 and 8 h postfeeding. Both techniques detected similar differences between forages, with alfalfa hay promoting greater (P < 0.05) bacterial diversity than grass hay. In contrast, whereas ARISA analysis showed a decrease (P < 0.05) of bacterial diversity in SOL at 4 h postfeeding compared with 0 and 8 h samplings, no variations (P > 0.05) over the postfeeding period were detected by DGGE. The ARISA technique showed lower (P < 0.05) bacterial diversity in SOL than in LIQ samples at 4 h postfeeding, but no differences (P > 0.05) in bacterial diversity between both rumen phases were detected by DGGE. Under the conditions of this study, the DGGE was not sensitive enough to detect some changes in ruminal bacterial communities, and therefore ARISA was considered more accurate for assessing bacterial diversity of ruminal samples. The results highlight the influence of the fingerprinting technique used to draw conclusions on factors affecting ruminal bacterial diversity.

Sol-gel TiO2 nanoparticles prompt photocatalytic cement for pollution degradation

TiO2 nanoparticles (TiO2NPs) prepared by the sol–gel method have been incorporated to cement paste with the aim of creating a photocatalytic system capable of compensating, through degradation of hazardous molecules, the envi- ronmental impact associated to the production of the clinker. Doping was carried out at different mass ratios with TiO2NPs precursor solutions within a fresh ce- ment paste, which was then characterized using scanning electron microscopy (SEM). The photocatalytic performance was evaluated by the degradation of Methylene Blue (MB) using a 125W UV lamp as irradiating source. Main cement properties such as hydration degree and C-S-H content are affected by TiO2NPs doping level. Cement containing TiO2NPs exhibited an increasing photocatalytic activity for increasing doping, while the pure cement paste control could hardly degrade MB. The kinetics of the system where also studied and their second order behavior related to microstructural aspects of the system.

Peptide nucleic acid pre-gel hybridization: An alternative to Southern hybridization

We have found that it is possible to use labeled peptide nucleic acid (PNA)-oligomers as probes in pre-gel hybridization experiments, as an alternative for Southern hybridization. In this technique, the PNA probe is hybridized to a denatured DNA sample at low ionic strength and the mixture is loaded directly on to an electrophoresis system for size separation. Ensuing gel electrophoresis separates the single-stranded DNA fragments by length. The neutral backbone of PNA allows for hybridization at low ionic strength and imparts very low mobility to excess PNA. Detection of the bound PNA is possible by direct fluorescence detection with capillary electrophoresis, or the DNA/PNA hybrids can be blotted onto a membrane and detected with standard chemiluminescent techniques. Efficient single bp discrimination was achieved routinely using both capillary and slab-gel electrophoresis.

Gel catalysts that switch on and off

We report development of a polymer gel with a catalytic activity that can be switched on and off when the solvent composition is changed. The gel consists of two species of monomers. The major component, N-isopropylacrylamide, makes the gel swell and shrink in response to a change in composition of ethanol/water mixtures. The minor component, vinylimidazole, which is capable of catalysis, is copolymerized into the gel network. The reaction rate for catalytic hydrolysis of p-nitrophenyl caprylate was small when the gel was swollen. In contrast, when the gel was shrunken, the reaction rate increased 5 times. The activity changes discontinuously as a function of solvent composition, thus the catalysis can be switched on and off by an infinitesimal change in solvent composition. The kinetics of catalysis by the gel in the shrunken state is well described by the Michaelis–Menten formula, indicating that the absorption of the substrate by the hydrophobic environment created by the N-isopropylacrylamide polymer in the shrunken gel is responsible for enhancement of catalytic activity. In the swollen state, the rate vs. active site concentration is linear, indicating that the substrate absorption is not a primary factor determining the kinetics. Catalytic activity of the gel is studied for substrates with various alkyl chain lengths; of those studied the switching effect is most pronounced for p-nitrophenyl caprylate.

Detection of competing DNA structures by thermal gradient gel electrophoresis: from self-association to triple helix formation by (G,A)-containing oligonucleotides

Sequence-specific recognition of DNA can be achieved by triple helix-forming oligonucleotides that bind to the major groove of double-helical DNA. These oligonucleotides have been used as sequence-specific DNA ligands for various purposes, including sequence-specific gene regulation in the so-called ‘antigene strategy’. In particular, (G,A)-containing oligonucleotides can form stable triple helices under physiological conditions. However, triplex formation may be in competition with self-association of these oligonucleotides. For biological applications it would be interesting to identify the conditions under which one structure is favoured as compared to the other(s). Here we have directly studied competition between formation of a parallel (G,A) homoduplex and that of a triple helix by a 13 nt (G,A)-containing oligonucleotide. Temperature gradient gel electrophoresis allows simultaneous detection of competition between the two structures, because of their different temperature dependencies and gel electrophoretic mobilities, and characterisation of this competition.