Concentrações e associações geoquímicas de Pb e Zn em sedimentos do rio São Francisco impactados por rejeitos da produção industrial de zinco

Surface sediments from the River São Francisco were analyzed to investigate the impact, due to the presence of metals (Cd, Cu, Pb, Zn) in wastes from a metallurgical industry in the city of Três Marias/MG, Brazil. The concentrations and geochemical associations of Pb, Zn and trace metals associated with the minerals employed in zinc production were measured. Sediments close to discharge locations were highly contaminated with Pb (332-512 μg g-1) and Zn (7872-10780 μg g-1), with values decreasing rapidly due to dilution and hydraulic sorting. Evaluation of toxicity according to the Consensus-based Sediment Quality Guidelines indicated for Cd, Pb and Zn a high probability of adverse effects on aquatic biota at these sites.

Gas-phase solvolysis type reactions of SiCl3+ cations

Gas-phase SiCl3+ ions undergo sequential solvolysis type reactions with water, methanol, ammonia, methylamine and propylene. Studies carried out in a Fourier Transform mass spectrometer reveal that these reactions are facile at 10-8 Torr and give rise to substituted chlorosilyl cations. Ab initio and DFT calculations reveal that these reactions proceed by addition of the silyl cation to the oxygen or nitrogen lone pair followed by a 1,3-H migration in the transition state. These transition states are calculated to lie below the energy of the reactants. By comparison, hydrolysis of gaseous CCl3+ is calculated to involve a substantial positive energy barrier.

Determinação de constituintes químicos em madeira de eucalipto por Pi-CG/EM e calibração multivariada: comparação entre redes neurais artificiais e máquinas de vetor suporte

Multivariate models were developed using Artificial Neural Network (ANN) and Least Square - Support Vector Machines (LS-SVM) for estimating lignin siringyl/guaiacyl ratio and the contents of cellulose, hemicelluloses and lignin in eucalyptus wood by pyrolysis associated to gaseous chromatography and mass spectrometry (Py-GC/MS). The results obtained by two calibration methods were in agreement with those of reference methods. However a comparison indicated that the LS-SVM model presented better predictive capacity for the cellulose and lignin contents, while the ANN model presented was more adequate for estimating the hemicelluloses content and lignin siringyl/guaiacyl ratio.

Da génese ao ensino da química verde

An analysis of the activities that contributed to the birth of Green Chemistry (GC) about twenty years ago has shown that it emerged in response to the problems of pollution and wastes felt by the Chemical Industry. This close connection between GC and the Chemical Industry is similar to that found earlier between Chemistry and Industrial Chemistry before they separated. It was also found that since its very beginning the Chemical Industry has occasionally practiced GC. Broad implications of these findings to the teaching of GC are discussed.

Recuperação de chumbo, mercúrio e elementos dos grupos 4 a 7 da tabela periódica de seus resíduos

This work shows routes to recover some elements from their laboratory wastes and broken apparatus (thermometers and densimeters). Most elements chosen present a chemical behavior in aqueous solution which is not currently studied in the ordinary experimental classes. The routes were based on the previous knowledge of the qualitative composition of the wastes treated. Wastes containing chromium were the most difficult to treat. The elements were recovered in good yields and can be reused in new experiments. This work was a very good experience in chemistry for students and shows the need of managing wastes for a better environment.

Produção e caracterização de espumas cerâmicas obtidas a partir de lodo de anodização de alumínio

Ceramic foams were produced from a sludge generated in the aluminum anodizing process by using an industrial polyurethane foam (replication method) with open cell sizes of 10 ± 5 ppi (porosity = 97%) which were impregnated with suspensions containing 50-61 wt.% alumina, 1 wt.% citric acid, 6 wt.% bentonite and fired at 1600 ºC for 2 h. The aluminum anodizing sludge shows a high alumina content (87.5 wt.%) and a low particle size (~1.7 mm) after calcination and milling. The obtained filters show porosity of approximately 70%, filtration capability (mass water flow) of 1.7 kg/s and mechanical strength under compression of 2.40 MPa.

Tratamentos dos efluentes gerados na produção de biodiesel

The wastewaters from biodiesel production contain as primarily wastes sodium or potassium soaps, fatty acids, glycerin, alcohol and other contaminants. In general, these waters are chemically unsuitable for release to any water body, so, it is necessary the adoption of techniques for the treatment of this effluent. In this review, electrochemical, biological, physicochemical, and combined treatments reported for the removal of the wastewater containing pollutants come from biodiesel production have been summarized. In addition, the recovery, the reuse, the energy production and the synthesis of new compounds from the organic matter contained in this kind of effluent are also reviewed.

Recuperação de compostos de iodo de reagentes e soluções laboratoriais

This work presents simple routes to recover iodine compounds from oxidized laboratory chemicals and aqueous solutions (HI and KI) used in laboratory chemistry classes. These routes are based on the oxidation of iodide ions (I-) to iodine (I2) by an oxidant (H2O2) or reduction of oxidized iodine by red phosphorus or hydrazine. Both routes presented high yields. The oxidative route is of general use whereas the reductive one is appropriate for restoring original iodine reagents. Final wastes were generated in low amounts. This work is appropriate for teaching many laboratory techniques (e.g., distillation, titration and filtration) in the chemical laboratory.

Efeito da adição de lantânio em catalisadores de Ni/ZrO2 aplicados na reação de reforma a vapor de etanol

The catalytic performance of Ni/ZrO2 catalysts loaded with different lanthanum content for steam reforming of ethanol was investigated. Catalysts were characterized by BET surface area, X-ray diffraction, UV-vis spectroscopy, temperature programmed reduction, and X-ray absorption fine structure techniques. Results showed that lanthanum addition led to an increase in the degree of reduction of both NiO and nickel surface species interacting with the support, due to the higher dispersion effect. The best catalytic performance at 450 ºC was found for the Ni/12LZ catalyst, which exhibited an effluent gaseous mixture with the highest H2 yield.

Processamento de cartuchos de impressoras de jato de tinta: um exemplo de gestão de produto pós-consumo

This work presents a route for processing spent ink-jet cartridges in an experimental course. The disassembly of the cartridges requires several steps and the recognition of their different components is essential to define the best final destination (recycling, co-processing). The plastic strips were chemically processed so as to recover gold and copper. The students recognized the difficulty of processing multicomponent wastes and the importance of the chemical work under the best safety conditions; they also experienced many laboratory techniques and recognized the value of the selective collection and the reverse logistics to reach a viable commercial scale recycling.

Reciclagem do lixo de informática: uma oportunidade para a química

Recycling and sustainable development are increasing in importance around the world. In Brazil, the new National Policy on Solid Wastes has prompted discussion on the future of electronic waste (e-waste). Brazil generates the greatest amount of e-waste among Latin American countries. Nevertheless complete recycling, including end processing of e-waste, does not occur in Brazil. This paper discusses the physical and chemical technologies currently used worldwide and in Brazil for printed circuit board recycling, with emphasis on metal recovery and plastic processing. The goal is to put in evidence the important role that chemistry can play in developing cheaper processes to recycle e-waste.

Síntese de nanomateriais de carbono a partir do resíduo de milho (DDGS)

The world's largest ethanol producer (USA) uses corn as feedstock. DDGS (distillers dried grains with solubles) is the main waste generated from this process (around 32 million t/year). DDGS samples were pyrolyzed at 1000 ºC in a furnace with controlled atmosphere. The effluent was channeled to a second furnace, in which catalyst substrates were placed. Chromatographic analysis was used to evaluate the gaseous effluents, showing that the catalyst reduced hydrocarbon emissions. The solid products formed were analyzed by SEM and TEM. Graphitic structures and carbon nanofibers, 50 µm in length and with diameters of 80-200 nm, were formed.

Classificação de resíduos de madeira tratada com preservativos à base de arseniato de cobre cromatado e de boro/flúor

Classification of waste wood treated with chromated copper arsenate (CCA) and boron/fluorine preservatives, according to NBR 10004, was investigated. The leaching test (ABNT NBR 10005) for As and Cr, and solubilization test (ABNT NBR 10006) for F, were applied to out-of-service wooden poles. Concentrations of As and Cr in leachates were determined by ICP-MS and of F by ESI. Values for As were higher than 1 mg L-1 classifying the waste as hazardous material (Class I) whereas values for F (> 1.5 mg L-1) were non-hazardous but indicated non-inert material (Class IIA).

Uso de materiais recicláveis na determinação gravimétrica de CO2 no ar ambiente e tratamento dos resíduos de laboratório gerados

An alternative system was tested for the determination of CO2 in air using recyclable materials. The results indicate that the proposed system allows for reliable, accurate, robust and efficient collection, comparable to the standard gravimetric method. Laboratory wastes are easily treated using a filtrate that can be discharged into the sewer and solids that can be reused. The proposed system is a simple and low-cost tool that encompasses important aspects of environmental education, which should be part of the education in chemistry of undergraduate students and technicians.

Óxidos de ferro e suas aplicações em processos catalíticos: uma revisão

A review of most of the reported studies on the use of iron oxides as catalyst in specific processes, namely Haber-Bosch reaction, Fischer-Tropsch synthesis, Fenton oxidation and photolytic molecular splitting of water to produce gaseous hydrogen, was carried out. An essential overview is thus presented, intending to address the fundamental meaning, as well as the corresponding chemical mechanisms, and perspectives on new technological potentialities of natural and synthetic iron oxides, more specifically hematite (α-Fe2O3), goethite (α-FeOOH), magnetite (Fe3O4) and maghemite (γ-Fe2O3), in heterogeneous catalysis.