Overtopping of harbour breakwaters: a comparison of semi-empirical equations, neural networks, and physical model tests

This paper reports extensive tests of empirical equations developed by different authors for harbour breakwater overtopping. First, the existing equations are compiled and evaluated as tools for estimating the overtopping rates on sloping and vertical breakwaters. These equations are then tested using the data obtained in a number of laboratory studies performed in the Centre for Harbours and Coastal Studies of the CEDEX, Spain. It was found that the recommended application ranges of the empirical equations typically deviate from those revealed in the experimental tests. In addition, a neural network model developed within the European CLASH Project is tested. The wind effects on overtopping are also assessed using a reduced scale physical model

Field and laboratory performance evaluation of a field-blended rubber asphalt.

ALICE is one of four major experiments of particle accelerator LHC installed in the European laboratory CERN. The management committee of the LHC accelerator has just approved a program update for this experiment. Among the upgrades planned for the coming years of the ALICE experiment is to improve the resolution and tracking efficiency maintaining the excellent particles identification ability, and to increase the read-out event rate to 100 KHz. In order to achieve this, it is necessary to update the Time Projection Chamber detector (TPC) and Muon tracking (MCH) detector modifying the read-out electronics, which is not suitable for this migration. To overcome this limitation the design, fabrication and experimental test of new ASIC named SAMPA has been proposed . This ASIC will support both positive and negative polarities, with 32 channels per chip and continuous data readout with smaller power consumption than the previous versions. This work aims to design, fabrication and experimental test of a readout front-end in 130nm CMOS technology with configurable polarity (positive/negative), peaking time and sensitivity. The new SAMPA ASIC can be used in both chambers (TPC and MCH). The proposed front-end is composed of a Charge Sensitive Amplifier (CSA) and a Semi-Gaussian shaper. In order to obtain an ASIC integrating 32 channels per chip, the design of the proposed front-end requires small area and low power consumption, but at the same time requires low noise. In this sense, a new Noise and PSRR (Power Supply Rejection Ratio) improvement technique for the CSA design without power and area impact is proposed in this work. The analysis and equations of the proposed circuit are presented which were verified by electrical simulations and experimental test of a produced chip with 5 channels of the designed front-end. The measured equivalent noise charge was <550e for 30mV/fC of sensitivity at a input capacitance of 18.5pF. The total core area of the front-end was 2300?m × 150?m, and the measured total power consumption was 9.1mW per channel.

Ventilated Stone Veneer: Mechanical Behaviour, Calculation Methodologies, Major Pathologies and Existing Tests

The increase of building pathologies related to the use of stone materials and the use of ventilated stone veneers, requires the reformulation of design concepts in building façades and also the reformulation of the architectural project. The aim of this paper is to identify, analyze and evaluate synthetically building pathologies in stone ventilated façades in order to obtain the main technical conditions to be considered in the architectural design, by interpreting its mechanical behavior and capabilities to prevent such pathologies and to ensure the proper features during the building lifetime. The methodology is based on both laboratory stone tests and in situ tests about construction systems, by analyzing physical and mechanical behavior of the outer layer in relation to other building requirements. The results imply the need of proper sizing, specific quality control and practical application of calculation methods, to control high concentration pressures in ventilated façades by reaching appropriate project solutions. In conclusion, the research about different pathologies of stone ventilated façades, the study of their mechanical behavior, their anchorage and their connection with their constructive aspects, will help to improve the construction quality of the stone ventilated façade in buildings and to enhance the use of natural stone in modern architecture.

Development of tire intermix performance and inspection system. Volume III: laboratory tire test data. Final report.

National Highway Traffic Safety Administration, Washington, D.C.

Stabilization/solidification of CERCLA and RCRA wastes : physical tests, chemical testing procedures, technology screening, and field activities.

"May 1989."

Tests of the dual differential radiometer under field conditions /

Issued Aug. 1978.

Boom configuration tests for calm-water, medium-current oil spill diversion /

Mode of access: Internet.

Report on tests of welding filter plates /

Mode of access: Internet.

Performance tests for the evaluation of computerized gas chromatography/mass spectrometry equipment and laboratories /

"April 1980"--Cover.

Basic research in crashworthiness II - low speed impact tests of unmodified vehicles. Interim technical report.

National Highway Traffic Safety Administration, Washington, D.C.

Laboratory measurement of vehicle characteristics for predicting highway behavior. Final report.

Federal Highway Administration, Washington, D.C.

Laboratory procedures to determine the breakaway behavior of luminaire supports in minisized vehicle collisions. Volume 1. Executive summary.

Federal Highway Administration, Safety Design Division, Mclean, Va.

Laboratory procedures to determine the breakaway behavior of luminaire supports in minisized vehicle collisions. Volume 2. Technical report. Final report.

Federal Highway Administration, Safety Design Division, McLean, Va.

Laboratory procedures to determine the breakaway behavior of luminaire supports in minisized vehicle collisions. Volume 3. FOIL operation and safety plan.

Federal Highway Administration, Safety Design Division, McLean, Va.