Image quality and dose analysis in PA chest x-ray: comparison between AEC and manual mode acquisition using the 10 kVp rule

Purpose: To compare image quality and effective dose when the 10 kVp rule is applied with manual and AEC mode in PA chest X-ray. Methods and Materials: A total of 68 images (with and without lesions) were acquired of an anthropomorphic chest phantom in a Wolverson Arcoma X-ray unit. The images were evaluated against a reference image using image quality criteria and the 2 alternative forced choice (2 AFC) method by five radiographers. The effective dose was calculated using PCXMC software using the exposure parameters and DAP. The exposure index (lgM) was recorded. Results: Exposure time decreases considerably when applying the 10 kVp rule in manual mode (50%-28%) compared to AEC mode (36%-23%). Statistical differences for effective dose between several AEC modes were found (p=0.002). The effective dose is lower when using only the right AEC ionization chamber. Considering image quality, there are no statistical differences (p=0.348) between the different AEC modes for images with no lesions. Using a higher kVp value the lgM values will also increase. The lgM values showed significant statistical differences (p=0.000). The image quality scores did not present statistically significant differences (p=0.043) for the images with lesions when comparing manual with AEC modes. Conclusion: In general, the dose is lower in the manual mode. By using the right AEC ionising chamber the effective dose will be the lowest in comparison to other ionising chambers. The use of the 10 kVp rule did not affect the detectability of the lesions.

Failure on clinical image quality criteria in digital mammography: how can radiographers do better?

Purpose: To assess image quality using PGMI (perfect, good, moderate, inadequate) scale in digital mammography examinations acquired in DR systems. Identify the main failures and propose corrective actions. Evaluate the most typical breast density. Methods and Materials: Clinical image quality criteria were evaluated considering mammograms acquired in 13 DR systems and classified according to PGMI scale using the criteria described in European Commission guidelines for radiographers. The breast density was assessed according to ACR recommendations. The data were collected on the acquisition system monitor to reproduce the daily practice of the radiographer. Results: The image quality criteria were evaluated in 3044 images. The criteria were fully achieved in 41% of the images that were classified as P (perfect), 31 % of the images were classified as M (moderate), 20% G (good) and 9% I (inadequate). The main cause of inadequate image quality was absence of all breast tissue in the image, skin folders in the pectoral muscle and in the infra-mammary angle. The higher number of failures occurred in MLO projections (809 out of 1022). The most represented (36%) breast type was type 2 (25-50% glandular tissue). Conclusion: Incorrect radiographic technique was frequently detected suggesting potential training needs and poor communication between the team members (radiographer and radiologists). Further correlations are necessary to identify the main causes for the failures, namely specific education and training in digital mammography and workload.

Eficácia do método Pilates no tratamento da dor lombar crónica: uma revisão sistemática da literatura

Mestrado em Fisioterapia

Simulation of offshore wind system with two levels converters: HVDC power transmission

A new integrated mathematical model for the simulation of offshore wind energy conversion system performance is presented in this paper. The mathematical model considers an offshore variable-speed turbine in deep water equipped with a permanent magnet synchronous generator using full-power two-level converter, converting the energy of a variable frequency source in injected energy into the electric network with constant frequency, through a high voltage DC transmission submarine cable. The mathematical model for the drive train is a concentrate two mass model which incorporates the dynamic for the structure and tower due to the need to emulate the effects of the moving surface. Controller strategy considered is a proportional integral one. Also, pulse width modulation using space vector modulation supplemented with sliding mode is used for trigger the transistor of the converter. Finally, a case study is presented to access the system performance. © 2014 IEEE.

Logarithmically proportional objective function for planar surfaces recognition in 3D point cloud

3D laser scanning is becoming a standard technology to generate building models of a facility's as-is condition. Since most constructions are constructed upon planar surfaces, recognition of them paves the way for automation of generating building models. This paper introduces a new logarithmically proportional objective function that can be used in both heuristic and metaheuristic (MH) algorithms to discover planar surfaces in a point cloud without exploiting any prior knowledge about those surfaces. It can also adopt itself to the structural density of a scanned construction. In this paper, a metaheuristic method, genetic algorithm (GA), is used to test this introduced objective function on a synthetic point cloud. The results obtained show the proposed method is capable to find all plane configurations of planar surfaces (with a wide variety of sizes) in the point cloud with a minor distance to the actual configurations. © 2014 IEEE.

Optimal location of supports in beam structures using genetic algorithms

Real structures can be thought as an assembly of components, as for instances plates, shells and beams. This later type of component is very commonly found in structures like frames which can involve a significant degree of complexity or as a reinforcement element of plates or shells. To obtain the desired mechanical behavior of these components or to improve their operating conditions when rehabilitating structures, one of the eventual parameters to consider for that purpose, when possible, is the location of the supports. In the present work, a beam-type structure is considered, and for a set of cases concerning different number and types of supports, as well as different load cases, the authors optimize the location of the supports in order to obtain minimum values of the maximum transverse deflection. The optimization processes are carried out using genetic algorithms. The results obtained, clearly show a good performance of the approach proposed. © 2014 IEEE.

Optimization of structures modeled with a Meshfree approach

Radial basis functions are being used in different scientific areas in order to reproduce the geometrical modeling of an object/structure, as well as to predict its behavior. Due to its characteristics, these functions are well suited for meshfree modeling of physical quantities, which for instances can be associated to the data sets of 3D laser scanning point clouds. In the present work the geometry of a structure is modeled by using multiquadric radial basis functions, and its configuration is further optimized in order to obtain better performances concerning to its static and dynamic behavior. For this purpose the authors consider the particle swarm optimization technique. A set of case studies is presented to illustrate the adequacy of the meshfree model used, as well as its link to particle swarm optimization technique. © 2014 IEEE.

Trends in alcohol and tobacco use among Brazilian students: 1989 to 2010

OBJECTIVE To analyze temporal trends of the prevalence of alcohol and tobacco use among Brazilian students. METHODS We analyzed data published between 1989 and 2010 from five epidemiological surveys on students from the 6th to the 12th grade of public schools from the ten largest state capitals of Brazil. The total sample consisted of 104,104 students and data were collected in classrooms. The same collection tool – a World Health Organization self-reporting questionnaire – and sampling and weighting procedures were used in the five surveys. The Chi-square test for trend was used to compare the prevalence from different years. RESULTS The prevalence of alcohol and tobacco use varied among the years and cities studied. Alcohol consumption decreased in the 10 state capitals (p < 0.001) throughout 21 years. Tobacco use also decreased significantly in eight cities (p < 0.001). The highest prevalence of alcohol use was found in the Southeast region in 1993 (72.8%, in Belo Horizonte) and the lowest one in Belem (30.6%) in 2010. The highest past-year prevalence of tobacco use was found in the South region in 1997 (28.0%, in Curitiba) and the lowest one in the Southeast in 2010 (7.8%, in Sao Paulo). CONCLUSIONS The decreasing trend in the prevalence of tobacco and alcohol use among students detected all over the Country can be related to the successful and comprehensive Brazilian antitobacco and antialcohol policies. Despite these results, the past-year prevalence of alcohol consumption in the past year remained high in all Brazilian regions.

IX International conference on Remote Engineering and Virtual instrumentation REV 2012

THE ninth edition of the International Conference on Remote Engineering and Virtual Instrumentation (REV) [1] was held at the Faculty of Engineering of the University of Deusto, Bilbao (Spain), from the 4th to the 6th of July, 2012. A world-class research community in the subject of remote and virtual laboratories joined the event.

Virtual globes as a platform for developing spatial literacy

Dissertation submitted in partial fulfilment of the requirements for the Degree of Master of Science in Geospatial Technologies

Characterization and performance analysis of a VDFLL GNSS receiver architecture

A non-coherent vector delay/frequency-locked loop architecture for GNSS receivers is proposed. Two dynamics models are considered: PV (position and velocity) and PVA (position, velocity, and acceleration). In contrast with other vector architectures, the proposed approach does not require the estimation of signals amplitudes. Only coarse estimates of the carrier-to-noise ratios are necessary.

Jamming detection in GNSS signals using the sample covariance matrix.

We propose a blind method to detect interference in GNSS signals whereby the algorithms do not require knowledge of the interference or channel noise features. A sample covariance matrix is constructed from the received signal and its eigenvalues are computed. The generalized likelihood ratio test (GLRT) and the condition number test (CNT) are developed and compared in the detection of sinusoidal and chirp jamming signals. A computationally-efficient decision threshold was proposed for the CNT.

TRAILER – e-Portfolio for collecting and recognizing informal learning process and outcomes

Informal learning is becoming more and more important: Nowadays people learn more this way, through the Internet, than in schools or normal trainings. But they don’t get any certificateswhich attest this fact. So they can't show the employer or teacher etc. that they have learned something. TRAILER project aim is to solve this problem by developing a special tool for managing of all competences and skills acquired through informal learning experiences. Both from the perspective of the user and the perspective of an institution or a company. We’ll present the IT tool to show how people can make their informal learning outcomes visible. TRAILER helps users to gather all information about process and outcomes of their informal learning. Users can share this with friends, colleagues or their employees, teachers and so on. They can create an interactive e-portfolio which can be attached to their CV, cover letter or Knowledge Management system etc. After the presentation of the tool we will discuss possible areas and fields to use this tool. Also we would like to discuss all possible use of the tool by the participants and another needs in this area. Moreover we want to discuss other problems in informal learning process, ways to solve the problems and discuss other ideas of different IT tools which could help in informal learning process. During the discussion we’ll use an interactive respond system which can be used on mobile devices: it makes possible for participants to share their opinions individually before knowing another persons' opinion.

Assessment of oltipraz in schistosomiasis mansoni clinical trial

Seventy three children (6-15 years) and 75 adults (18-47 years) with active schistosomiasis mansoni were treated with oltipraz. All cases had at least 100 eggs per gram of feces as determined by the Kato-Katz technique. Children and adults were divided in two groups receiving respectively 25 or 30 mg/kg, as a single oral dose. Clinical examination, laboratories tests (haemogram, urinalysis, hepatic and kidney functions tests, glycemia, cholesterol, triglicerides, lipoprotein — HLD and LDL) and ECG were performed before, 3 or 7 days and 1 month after treatment. Parasitological control with 3 daily coprological examinations, was done on the 1st, 3rd j 6th month after drug administration. Giddiness, somnolence, headache, nausea, vomiting and abdominal distress were the most frequent side effects. Pain in the finger tips that need further investigations also occurred. No significant alteration in complementary tests were observed, whereas eosinophilia 1 month after treatment was detected, probably indicating worm death. The cure rate in children was 81.8% and 74.2% with 25 and 30 mg/kg respectively, and in adults 75.0% and 81.2% of the patients. No statistical significant difference was observed between cure rate and side effects at different dosages employed, neither between adults nor children. In all groups the percentage of egg reduction in feces in the non cured patients was higher than 96.0%. Further investigation with this new compound is necessary to accomplish the real value of oltipraz in the schistosomiasis chemotherapy.

Abordagem ao ensino da educação musical segundo uma perspetiva abrangente

Relatório de Estágio apresentado à Escola Superior de Educação de Lisboa para obtenção de grau de mestre em Educação Musical no Ensino Básico