Study of carbon-supported Au catalyst as the cathodic catalyst in a direct formic acid fuel cell prepared using a polyvinyl alcohol protection method

In this paper, it is reported for the first time that a carbon-supported Au (Au/C) catalyst for the cathodic catalyst in a direct formic acid fuel cell (DFAFC) was prepared using a polyvinyl alcohol (PVA) protection method. The results indicated that for oxygen reduction, the electrocatalytic activity of the Au/C catalyst prepared with the PVA protection method is much better than that of a Au/C catalyst prepared with the pre-precipitation method. This is due to the small average size and low relative crystallinity of the An particles in the Au/C catalyst prepared by the PVA protection method, compared to that of the Au/C catalyst prepared by the pre-precipitation method, illustrating that the average size and the relative crystallinity of the ALL particles has an effect on the electrocatalytic activity of the Au/C catalyst for oxygen reduction. In addition, because An has no electrocatalytic activity for the oxidation of formic acid, the Au/C catalyst possesses a high formic acid tolerance. After the electrocatalytic activity of the Au/C catalyst for the oxygen reduction is improved, it is suitable to be used as the cathodic catalyst in DFAFC.

Synthesis, crystal structure and properties of H-8[P4W14O58Na4 (H2O)(20)] center dot 16H(2)O

A novel heteropoly tungstophosphates, H-8[P4W14O58Na4(H2O)(20)] . 16H(2)O, was synthesized by hydrothermal method and characterized by elemental analysis, IR spectrum and single-crystal X-ray structure analysis. The thermal stability of the compound was investigated by using TG-DTA. The crystal is triclinic system with space group P (1) over bar, a = 1. 137 9(2) nm, b=1. 363 2(3) nm, c=1. 627 1(3) nm; alpha=78. 20(3)degrees, beta=71, 20(3)degrees, gamma= 71. 62(3)degrees; V = 2. 252 5(8) nm(3), Z=1, M-r= 4 374. 38, D-c = 3. 225 mg/cm(3), mu = 18. 007 mm(-1), F(000)=1 972, R=0. 074 2, R-w=0. 200 4. The result of structure analysis shows that the anion of the compound consists of two PW7O29Na2(H2O)(10) subunits and two linked phosphorous atoms. A kind of microporous with size of 0. 661 4 nm X 0. 318 9 nm was formed in the crystal structure.

Study of (TPP)H-2 vapor deposited film on iron

The film by tetraphenylporphyrin((TPP)H-2) vapor deposition on iron was investigated by means of XPS, SEM and visible spectroscopy. N(1s) binding energy characteristic of(TPP)H-2 was gained directly from the deposited samples. N(1s) binding energy of the surface was greatly changed after the deposited sample was washed with solvent. It is indicated that the deposited film is composed of an outer-layer of physically adsorbed (TPP)H-2, and an inner-layer of chemically modified (TPP)H-2.

Synthesis and Characterization of Side-Chain Liquid Crystalline (M6MPP/M6NPAP) Copolymers with NLO Properties

A series of novel thermotropic side-chain liquid crystalline polymer based on polymethacrylate backbone containing electron-accepting 4-(4'-nitrophenylazo)phenoxy as nonlinear optical active group and electron-donating 4(4'-methoxyphenyl) phenoxy group as mesogen attached covalently to the backbone through the flexible spacer was prepared and characterized, respectively. The results from differential scanning calorimetry showed that these series of copolymers were enantiotropic liquid crystal with single mesophase. The melting points and the relative enthalpy change of the copolymers depressed with increasing the molar percent of 4'-nitroazobenzene monomer units over 0 similar to 50mol%, but the enthalpies change of the transition from mesophase to isotropic state increased for the copolymers containing 0 similar to 50mol% 4'-nitroambenzene units. The texture observed under polarized optical microscope identified that the copolymers containing 24molar% or more than 24mol% 4-nitroambenzene monomer units could form smectic mesophase with the focal-conic texture. The results detected by WAXD were in good agreement with the results observed by POM.

Bond-charge calculation of nonlinear optical susceptibilities of LiXO3 type complex crystals

Second order nonlinear optical (NLO) tensor coefficients of LiXO3 (X = I, Nb, Ta) type crystals have been evaluated on the basis of the dielectric theory of complex crystals and the modified bond charge model. The current method is capable of calculating single bond contributions to the total second order NLO susceptibility. The tenser values thus calculated agree well with experimental data. By introducing the subformula equation and the concept of the effective charge of one valence electron, we are able to successfully treat such complex crystals as LiXO3 type compounds. In addition, the bond charge expression is modified to a more reasonable form for complex crystals. (C) 1998 Elsevier Science B.V.

The influence of heat treatment on structures of the aggregated state of polyamide-1010

The structural parameters of the aggregated state of polyamide (PA)-1010 annealed at various temperatures were computed by means of the desmearing intensity from Smalt Angle X-ray Scattering (SAXS) measurements and by using the concept of the distance distribution function. The results indicated that the structural parameters of the aggregated state were strongly dependent upon heat treatment conditions and the maximum values of the structural parameters were obtained for the samples annealed at T = 175 degrees C. The particle size Z annealed at different temperature was ranged between 8.1-12.8nm, and the values of the distance distribution function P-max(Z) were obtained when Z = 4.0-6.8 nm. Using one dimension electron density correlation function (1D EDCF) method long period (L) and thickness of the lamellar (d(0)) were estimated and were found to increase with the increase of the degree of crystallinity.

Rheological properties and crystallization behavior of yttrium oxide filled low ethylene content polypropylene copolymer

The rheological properties and crystallization characteristics of low ethylene content poly propylene (EPM) with and without Yittrium oxide (Y2O3) as a filler was investigated by cone-plate viscometer and differential scanning calorimetry. Yittrium oxide had a profound effect on the viscosities of the systems. To determine the nonisothermal crystallization rate of the materials, a new estimation method was used. From the results, we can conclude that Y2O3 acts as a nucleating agent, which increased the crystallization rate of the EPM. (C) 1996 John Wiley & Sons, Inc.

A new topological index for the Changchun institute of applied chemistry C-13 NMR information system

A method to assign a single number representation for each atom (node) in a molecular graph, Atomic IDentification (AID) number, is proposed based on the counts of weighted paths terminated on that atom. Then, a new topological index, Molecular IDentification (MID) number is developed from AID. The MID is tested systematically, over half a million of structures are examined, and MID shows high discrimination for various structural isomers. Thus it can be used for documentation in the Changchun Institute of Chemistry C-13 NMR information system.

PREPARATION AND STRUCTURE OF HALF-OPEN VANADOCENE, V[2,4-(CH3)2C5H5](C5H5)CO

The half-open vanadocene, V[2,4-(CH3)2C5H5](C5H5)CO, was obtained by the reaction of V[2,4-(CH3)2C5H5](C5H5)PMe3 with CO in petroleum ether at room temperature. Its crystal structure was determined by X-ray diffraction technique. The crystal was monoclinic with space group P2(1)/n, a = 16.614(3), b = 7.636(1), c = 19.128(6) angstrom, beta = 99.92(2)-degrees, V = 2390.5(9) angstrom3, and Z = 8. The final R value was 0.043. The V(1)-CPD(1) (half) (PD = 2,4-(CH3)2C5H5) bonds were shorter (0.038 angstrom) than the V(1)-CCP(1) (half) (CP = C5H5) bonds, averaging 2.224(4) versus 2.262(4) angstrom, respectively. 4V[2,4-(CH3)2C5H5](C5H5)CO has been characterized by IR and EPR methods.

Er_xY_(1-x)AlO_3晶体的荧光动力学研究

本文详细计算了辐射跃迁几率、无辐射跃迁几率、交叉弛豫几率和其他光谱参数。并且在考虑上述三种辐射过程的情况下,讨论了Er~(3+)离子的荧光动力学过程,研究了荧光发射特征与Er~(3+)离子浓度的关系,给出了它们的规律。

多层结构半导体膜的XPS和AES分析

本文采用VG ESCALAB MK-Ⅱ电子能谱仪对多层结构的薄膜Cu_2S-CdS太阳电池进行了X-光电子能谱、俄歇电子谱和深度分析。指出了电池表面的组成、结构和状态。由于制备工艺和处理方法的不同,电池表面和界面会发生变化,从而影响薄膜Cu_2S-CdS太阳电池的电性能和稳定性。本文为电池机理的研究提供了一些数据。

The structure of Aquifex aeolicus sulfide:quinone oxidoreductase, a basis to understand sulfide detoxification and respiration

Sulfide: quinone oxidoreductase (SQR) is a flavoprotein with homologues in all domains of life except plants. It plays a physiological role both in sulfide detoxification and in energy transduction. We isolated the protein from native membranes of the hyperthermophilic bacterium Aquifex aeolicus, and we determined its X-ray structure in the "as-purified,'' substrate-bound, and inhibitor-bound forms at resolutions of 2.3, 2.0, and 2.9 angstrom, respectively. The structure is composed of 2 Rossmann domains and 1 attachment domain, with an overall monomeric architecture typical of disulfide oxidoreductase flavoproteins. A. aeolicus SQR is a surprisingly trimeric, periplasmic integral monotopic membrane protein that inserts about 12 angstrom into the lipidic bilayer through an amphipathic helix-turn-helix tripodal motif. The quinone is located in a channel that extends from the si side of the FAD to the membrane. The quinone ring is sandwiched between the conserved amino acids Phe-385 and Ile-346, and it is possibly protonated upon reduction via Glu-318 and/or neighboring water molecules. Sulfide polymerization occurs on the re side of FAD, where the invariant Cys-156 and Cys-347 appear to be covalently bound to polysulfur fragments. The structure suggests that FAD is covalently linked to the polypeptide in an unusual way, via a disulfide bridge between the 8-methyl group and Cys-124. The applicability of this disulfide bridge for transferring electrons from sulfide to FAD, 2 mechanisms for sulfide polymerization and channeling of the substrate, S2-, and of the product, S-n, in and out of the active site are discussed.