A DC circuit breaker for an electric vehicle battery pack

Electric vehicle battery packs require DC circuit breakers for safety. These must break thousands of Amps DC at hundreds of Volts. The Sunshark solar racing car has a 140V 17Ahr battery box which needs such a breaker. A static design using 200V MOSFETs to interrupt the fault current is presented. The design specification, decisions and proposed solution circuit are given. The current sensing technique,MOSFET overvoltage protection, and DC bus capacitor precharging scheme are specific focuses. Simulation results are presented and discussed.

Fuel consumption and gas emissions of an automatic transmission vehicle following simple eco-driving instructions on urban roads

Following eco-driving instructions can reduce fuel consumption between 5 to 20% on urban roads with manual cars. The majority of Australian cars have an automatic transmission gear-box. It is therefore of interest to verify whether current eco-driving instructions are e cient for such vehicles. In this pilot study, participants (N=13) drove an instrumented vehicle (Toyota Camry 2007) with an automatic transmission. Fuel consumption of the participants was compared before and after they received simple eco-driving instructions. Participants drove the same vehicle on the same urban route under similar tra c conditions. We found that participants drove at similar speeds during their baseline and eco-friendly drives, and reduced the level of their accelerations and decelerations during eco-driving. Fuel consumption decreased for the complete drive by 7%, but not on the motorway and inclined sections of the study. Gas emissions were estimated with the VT-micro model, and emissions of the studied pollutants (CO2, CO, NOX and HC) were reduced, but no di erence was observed for CO2 on the motorway and inclined sections. The di erence for the complete lap is 3% for CO2. We have found evidence showing that simple eco-driving instructions are e cient in the case of automatic transmission in an urban environment, but towards the lowest values of the spectrum of fuel consumption reduction from the di erent eco-driving studies.

Fluid-structure interaction analysis of full scale vehicle-barrier impact using coupled SPH-FEA

Portable water-filled barriers (PWFB) are roadside structures used to separate moving traffic from work-zones. Numerical PWFB modelling is preferred in the design stages prior to actual testing. This paper aims to study the fluid-structure interaction of PWFB under vehicular impact using several methods. The strategy to treat water as non-structural mass was proposed and the errors were investigated. It was found that water can be treated with the FEA-NSM model for velocities higher than 80kmh-1. However, full SPH/FEA model is still the best treatment for water and necessary for lower impact velocities. The findings in this paper can be used as guidelines for modelling and designing PWFB.

The health outcomes and costs of people attending an interdisciplinary chronic disease service in regional Australia : protocol for a longitudinal cohort investigation

Background Rates of chronic disease are escalating around the world. To date health service evaluations have focused on interventions for single chronic diseases. However, evaluations of the effectiveness of new intervention strategies that target single chronic diseases as well as multimorbidity are required, particularly in areas outside major metropolitan centres where access to services, such as specialist care, is difficult and where the retention and recruitment of health professionals affects service provision. Methods This study is a longitudinal investigation with a baseline and three follow-up assessments comparing the health and health costs of people with chronic disease before and after intervention at a chronic disease clinic, in regional Australia. The clinic is led by students under the supervision of health professionals. The study will provide preliminary evidence regarding the effectiveness of the intervention, and evaluate the influence of a range of factors on the health outcomes and costs of the patients attending the clinic. Patients will be evaluated at baseline (intake to the service), and at 3-, 6-, and 12-months after intake to the service. Health will be measured using the SF-36 and health costs will be measured using government and medical record sources. The intervention involves students and health professionals from multiple professions working together to treat patients with programs that include education and exercise therapy programs for back pain, and Healthy Lifestyle programs; as well as individual consultations involving single professions. Discussion Understanding the effect of a range of factors on the health state and health costs of people attending an interdisciplinary clinic will inform health service provision for this clinical group and will determine which factors need to be controlled for in future observational studies. Preliminary evidence regarding changes in health and health costs associated with the intervention will be a platform for future clinical trials of intervention effectiveness. The results will be of interest to teams investigating new chronic disease programs particularly for people with multimorbidity, and in areas outside major metropolitan centres.

An IEEE 802.11p empirical performance model for cooperative systems applications

IEEE 802.11p is the new standard for Inter-Vehicular Communications (IVC) using the 5.9 GHz frequency band, as part of the DSRC framework; it will enable applications based on Cooperative Systems. Simulation is widely used to estimate or verify the potential benefits of such cooperative applications, notably in terms of safety for the drivers. We have developed a performance model for 802.11p that can be used by simulations of cooperative applications (e.g. collision avoidance) without requiring intricate models of the whole IVC stack. Instead, it provide a a straightforward yet realistic modelisation of IVC performance. Our model uses data from extensive field trials to infer the correlation between speed, distance and performance metrics such as maximum range, latency and frame loss. Then, we improve this model to limit the number of profiles that have to be generated when there are more than a few couples of emitter-receptor in a given location. Our model generates realistic performance for rural or suburban environments among small groups of IVC-equipped vehicles and road side units.

Evidence for the safety and quality issues associated with the care of patients with cognitive impairment in acute care settings : a rapid review

The Australian Commission on Safety and Quality in Health Care commissioned this rapid review to identify recent evidence in relation to three key questions: 1. What is the current evidence of quality and safety issues regarding the hospital experience of people with cognitive impairment (dementia/delirium)? 2. What are the existing evidence-based pathways, best practice or guidelines for cognitive impairment in hospitals? 3. What are the key components of an ideal patient journey for a person with dementia and/or delirium? The purpose of this review is to identify best practice in caring for patients with cognitive impairment (CI) in acute hospital settings. CI refers to patients with dementia and delirium but can include other conditions. For the purposes of this report, ‘Hospitals’ is defined as acute care settings and includes care provided by acute care institutions in other settings (e.g. Multipurpose Services and Hospital in the Home). It does not include residential aged care settings nor palliative care services that are not part of a service provided by an acute care institution. Method Both peer-reviewed publications and the grey literature were comprehensively searched for recent (primarily post 2010) publications, reports and guidelines that addressed the three key questions. The literature was evaluated and graded according to the National Health and Medical Research Council (NHMRC) levels of criteria (see Evidence Summary – Appendix B). Results Thirty-one recent publications were retrieved in relation to quality and safety issues faced by people with CI in acute hospitals. The results indicate that CI is a common problem in hospitals (upwards of 30% - the rate increases with increasing patient age), although this is likely to be an underestimate, in part, due to numbers of patients without a formal dementia diagnosis. There is a large body of evidence showing that patients with CI have worse outcomes than patients without CI following hospitalisation including increased mortality, more complications, longer hospital stays, increased system costs as well as functional and cognitive decline. 4 To improve the care of patients with CI in hospital, best practice guidelines have been developed, of which sixteen recent guidelines/position statements/standards were identified in this review (Table 2). Four guidelines described standards or quality indicators for providing optimal care for the older person with CI in hospital, in general, while three focused on delirium diagnosis, prevention and management. The remaining guidelines/statements focused on specific issues in relation to the care of patients with CI in acute hospitals including hydration, nutrition, wandering and care in the Emergency Department (ED). A key message in several of the guidelines was that older patients should be assessed for CI at admission and this is particularly important in the case of delirium, which can indicate an emergency, in order to implement treatment. A second clear mess...

Examining workload models in online and blended teaching

Over the past decade, most Australian universities have moved increasingly towards online course delivery for both undergraduate and graduate programs. In almost all cases, elements of online teaching are part of routine teaching loads. Yet detailed and accurate workload data are not readily available. As a result, institutional policies on academic staff workload are often guided more by untested assumptions about reduction of costs per student unit, rather than being evidence-based, with the result that implementation of new technologies for online teaching has resulted in poorly defined workload expectations. While the academics in this study often revealed a limited understanding of their institutional workload formulas, which in Australia are negotiated between management and the national union through their local branches, the costs of various types of teaching delivery have become a critical issue in a time of increasing student numbers, declining funding, pressures to increase quality and introduce minimum standards of teaching and curriculum, and substantial expenditure on technologies to support e-learning. There have been relatively few studies on the costs associated with workload for online teaching, and even fewer on the more ubiquitous ‘blended’, ‘hybrid’ or ‘flexible’ modes, in which face-to-face teaching is supplemented by online resources and activities. With this in mind the research reported here has attempted to answer the following question: What insights currently inform Australian universities about staff workload when teaching online?

Data requirements of hedonic models in determining the impact of infrastructure charges on new housing costs

The use of hedonic models to estimate the effects of various factors on house prices is well established. This paper examines a number of international hedonic house price models that seek to quantify the effect of infrastructure charges on new house prices. This work is an important factor in the housing affordability debate, with many governments in high growth areas having user-pays infrastructure charging policies operating in tandem with housing affordability objectives, with no empirical evidence on the impact of one on the other. This research finds there is little consistency between existing models and the data sets utilised. Specification appears dependent upon data availability rather than sound theoretical grounding. This may lead to a lack of external validity with model specification dependent upon data availability rather than sound theoretical grounding.

The role of sleepiness, sleep disorders, and the work environment on heavy-vehicle crashes in 2 Australian states

Heavy-vehicle driving involves a challenging work environment and a high crash rate. We investigated the associations of sleepiness, sleep disorders, and work environment (including truck characteristics) with the risk of crashing between 2008 and 2011 in the Australian states of New South Wales and Western Australia. We conducted a case-control study of 530 heavy-vehicle drivers who had recently crashed and 517 heavy-vehicle drivers who had not. Drivers' crash histories, truck details, driving schedules, payment rates, sleep patterns, and measures of health were collected. Subjects wore a nasal flow monitor for 1 night to assess for obstructive sleep apnea. Driving schedules that included the period between midnight and 5:59 am were associated with increased likelihood of crashing (odds ratio = 3.42, 95% confidence interval: 2.04, 5.74), as were having an empty load (odds ratio = 2.61, 95% confidence interval: 1.72, 3.97) and being a less experienced driver (odds ratio = 3.25, 95% confidence interval: 2.37, 4.46). Not taking regular breaks and the lack of vehicle safety devices were also associated with increased crash risk. Despite the high prevalence of obstructive sleep apnea, it was not associated with the risk of a heavy-vehicle nonfatal, nonsevere crash. Scheduling of driving to avoid midnight-to-dawn driving and the use of more frequent rest breaks are likely to reduce the risk of heavy-vehicle nonfatal, nonsevere crashes by 2–3 times.

Dynamic load sharing in heavy vehicle suspensions - further analysis of the equalisation effects of larger air lines

This paper provides details on comparative testing of axle-to-chassis forces of two heavy vehicles (HVs) based on an experimental programme carried out in 2007. Dynamic forces at the air springs were measured against speed and roughness values for the test roads used. One goal of that programme was to determine whether dynamic axle-to-chassis forces could be reduced by using larger-than-standard diameter longitudinal air lines. This paper presents a portion of the methodology, analysis and results from that programme. Two analytical techniques and their results are presented. The first uses correlation coefficients of the forces between air springs and the second is a student’s t-test. These were used to determine the causality surrounding improved dynamic load sharing between heavy vehicle air springs with larger air lines installed longitudinally compared with the standard sized air lines installed on the majority of air-sprung heavy vehicles.

Assessment for Education : Standards, Judgement and Moderation

Do you need a practical guide to assessment, curriculum and policy? Are you also looking for a book that is firmly grounded in the theory of this subject? Assessment for Education combines both theory and practice, making it the perfect guide for students, researchers, academics and teachers. This book makes assessment processes transparent for practitioners, and shows how assessment should relate to education. It looks at evidence-informed decision-making and the interrelationships between standards, judgment and moderation practice for improved assessment, teacher quality, schools and systems. The book will provide you with: ' Knowledge about quality assessment and judgement practice ' Understanding of relationships across curriculum, assessment, teaching and learning ' Knowledge of the concept of front-ending assessment based on the learner's needs ' An analysis of practitioner judgement approaches ' Understanding of the conditions under which teacher assessment can be valid ' Principles derived from research of social moderation practices Whether you are studying and researching assessment or working in curriculum and assessment policy, this book will show you how practitioner use of achievement standards can improve learning, equity, social justice and accountability.

Settlement offers on appeal : when might costs be awarded on the indemnity basis?

In Roberts v Prendergast [2013] QCA 89 the respondent had offered to settle the appeal, purporting to make the offer under Chapter 9 Part 5 of the Uniform Civil Procedure Rules 1999 (Qld) (UCPR). Differing views were expressed in the Court of Appeal regarding the impact in the circumstances of the offer to settle, with the majority concluding that the appellant should pay the respondent’s costs on the standard basis.

A clear view of costs ‘of and incidental to’ : Mio Art Pty Ltd v Macequest (No.2) Pty Ltd [2013] QSC 271

In Mio Art Pty Ltd v Macequest (No.2) Pty Ltd [2013] QSC 271 Jackson J provided considered analysis of several aspects of costs law. His Honour regarded various orders which are commonly sought or made as reflecting practice that is inappropriate or unnecessary under the Uniform Civil Procedure Rules 1999 (Qld) (UCPR).

Intercontinental haptic teleoperation of a flying vehicle : a step towards real-time applications

This paper describes the theory and practice for a stable haptic teleoperation of a flying vehicle. It extends passivity-based control framework for haptic teleoperation of aerial vehicles in the longest intercontinental setting that presents great challenges. The practicality of the control architecture has been shown in maneuvering and obstacle-avoidance tasks over the internet with the presence of significant time-varying delays and packet losses. Experimental results are presented for teleoperation of a slave quadrotor in Australia from a master station in the Netherlands. The results show that the remote operator is able to safely maneuver the flying vehicle through a structure using haptic feedback of the state of the slave and the perceived obstacles.

Sex and the virtual suburbs : the pornosphere and community standards

This chapter looks at the management and zoning of online sexual culture–the web sites which make up the pornosphere (McNair 2013). It explores the concept of ‘community standards’, which has been a central part of the management of sexually explicit materials in the offline world, and asks what it might mean to talk about ‘community standards’ on the Internet. And finally, it uses the concept of virtual-community standards to revisit the question of managing access to sexually explicit materials on the Internet.