Implementation of an F-statistic all-sky search for continuous gravitational waves in Virgo VSR1 data

We present an implementation of the F-statistic to carry out the first search in data from the Virgo laser interferometric gravitational wave detector for periodic gravitational waves from a priori unknown, isolated rotating neutron stars. We searched a frequency f(0) range from 100 Hz to 1 kHz and the frequency dependent spindown f(1) range from -1.6(f(0)/100 Hz) x 10(-9) Hz s(-1) to zero. A large part of this frequency-spindown space was unexplored by any of the all-sky searches published so far. Our method consisted of a coherent search over two-day periods using the F-statistic, followed by a search for coincidences among the candidates from the two-day segments. We have introduced a number of novel techniques and algorithms that allow the use of the fast Fourier transform (FFT) algorithm in the coherent part of the search resulting in a fifty-fold speed-up in computation of the F-statistic with respect to the algorithm used in the other pipelines. No significant gravitational wave signal was found. The sensitivity of the search was estimated by injecting signals into the data. In the most sensitive parts of the detector band more than 90% of signals would have been detected with dimensionless gravitational-wave amplitude greater than 5 x 10(-24).

First all-sky search for continuous gravitational waves from unknown sources in binary systems

We present the first results of an all-sky search for continuous gravitational waves from unknown spinning neutron stars in binary systems using LIGO and Virgo data. Using a specially developed analysis program, the TwoSpect algorithm, the search was carried out on data from the sixth LIGO science run and the second and third Virgo science runs. The search covers a range of frequencies from 20 Hz to 520 Hz, a range of orbital periods from 2 to similar to 2,254 h and a frequency-and period-dependent range of frequency modulation depths from 0.277 to 100 mHz. This corresponds to a range of projected semimajor axes of the orbit from similar to 0.6 x 10(-3) ls to similar to 6,500 ls assuming the orbit of the binary is circular. While no plausible candidate gravitational wave events survive the pipeline, upper limits are set on the analyzed data. The most sensitive 95% confidence upper limit obtained on gravitational wave strain is 2.3 x 10(-24) at 217 Hz, assuming the source waves are circularly polarized. Although this search has been optimized for circular binary orbits, the upper limits obtained remain valid for orbital eccentricities as large as 0.9. In addition, upper limits are placed on continuous gravitational wave emission from the low-mass x-ray binary Scorpius X-1 between 20 Hz and 57.25 Hz.

Continuous Electrical Current and Zinc Sulphate Administered by Transdermal Iontophoresis Improves Skin Healing in Diabetic Rats Induced by Alloxan: Morphological and Ultrastructural Analysis

Purpose. Evaluated the effects of continuous electrical current (CEC) or zinc administrated by transdermal iontophoresis (Zn+TDI). Methods. 120 male Wistar rats were submitted to an incision surgery at the anterior region of abdomen and distributed into 6 experimental groups with 40 animals: 3 diabetic groups and 3 normal groups, untreated and treated with CEC alone or with Zn+TDI. Each group was further divided into 4 subgroups with 10 rats each to be evaluated on the 4th, 7th, 14th, and 21st day after surgery. In each period, clinical and laboratory parameters from the animals were analyzed. Results. The analysis by optical and scanning electron microscopy showed a delay in the phases of wound healing in diabetic rats without treatment in all periods of the experiment; breaking strength (BS) was significantly reduced in skin scars of untreated diabetic rats when compared to other groups. In contrast, BS in skin scars of nondiabetic groups and diabetic rats treated with Zn+TDI showed significant increase in those, besides not presenting delayed healing. Conclusion. Electrical stimulation of surgical wounds used alone or in association with zinc by TDI is able to consistently improve the morphological and ultrastructural changes observed in the healing of diabetic animals.

Comparison of cyclic fatigue and torsional resistance in reciprocating single-file systems and continuous rotary instrumentation systems

As compared with continuous rotary systems, reciprocating motion is believed to increase the fatigue resistance of NiTi instruments. We compared the cyclic fatigue and torsional resistance of reciprocating single-file systems and continuous rotary instrumentation systems in simulated root canals. Eighty instruments from the ProTaper Universal, WaveOne, MTwo, and Reciproc systems (n = 20) were submitted to dynamic bending testing in stainless-steel simulated curved canals. Axial displacement of the simulated canals was performed with half of the instruments (n = 10), with back-and-forth movements in a range of 1.5 mm. Time until fracture was recorded, and the number of cycles until instrument fracture was calculated. Cyclic fatigue resistance was greater for reciprocating systems than for rotary systems (P < 0.05). Instruments from the Reciproc and WaveOne systems significantly differed only when axial displacement occurred (P < 0.05). Instruments of the ProTaper Universal and MTwo systems did not significantly differ (P > 0.05). Cyclic fatigue and torsional resistance were greater for reciprocating systems than for continuous rotary systems, irrespective of axial displacement.

Desempenho de bovinos de corte em pastos de Brachiaria brizantha cv. Xaraés manejados em diferentes alturas de pastejo

The production of grazing cattle has been very interesting, due to the low cost to produce fodder, compared to other sources of forage used to feed these animals, but the adequate management pasture has high influence on the success and profitability of cattle production systems. Thus, the objective of this study was to determine the optimum grazing height of Brachiaria brizantha cv. Xaraes, which provides the highest individual weight gain and gain per area. The stocking rate was continuous, with variable stocking rate. The experimental period was from January to December 2010. Three Nellore males were used in each experimental plot, and, when needed, additional animals were used for adjusting the desired heights. Monthly sampling was obtained to estimate forage mass (kg.ha(-1) of DM) and the structural characteristics of the pastures, such as, leaf: stem ratio. The animals were weighed at the beginning of the experiment and every 28 days, after 12 hours of fasting, to measure the average daily gain (ADG) After weighings were performed adjustments stocking rate to desired heights. Throughout the experimental period the animals received mineral supplementation. The desired sward heights were 15, 30, 45 and 60 cm, with three replicates each. The experimental design was completely randomized with four treatments and three replications. To body weight gain (BWG) and average daily gain (ADG), each animal was considered an experimental unit. To gain per area and stocking rate, the paddock was considered the experimental unit. The leaf: stem ratio showed a linear increasing behavior in the spring and summer seasons. The smaller grazing heights provided higher gain per unit area (812.15 kg ha(-1)), while the highest grazing heights promoted high individual weight gain (0.790 kg.dia(-1)). The results suggest that Xaraes grass pastures should be grazed between 30 and 45 cm to allow reasonable performances by area and individual performances.

Produção de forragem e composição estrutural de pastos de Brachiaria brizantha cv. Xaraés manejados em diferentes alturas de pastejo

The objective of this study was to analyze the production of dry mass, forage accumulation rate and the structural composition of Brachiaria brizantha cv. Xaraes pastures, managed under different grazing heights in continuous stocking. The experimental area was 12 hectares, divided in paddocks of one hectare each. The treatments were 15, 30, 45 and 60 cm of defoliation heights. Nellore steers were used to reach the desired heights. Every 28 days four cut samples and eight visual samples were collected for comparative performance in the experimental plots. Two grazing exclusion cages were used per treatment to estimate accumulation rates kg.ha(-1) DM. The cut material was taken to the laboratory for separation of the botanical components (green leaf, stem and senescent material), weighing and determination of dry matter. The experimental design was the completely randomized with three replicates. There were treatments effects at all seasons for the production of total mass, except in the spring. In summer and spring seasons it was observed the highest values for leaf blades (1.100 kg DM.ha(-1)). In the winter, the highest values of senescent material was observed, as expected. The average accumulation showed no significant difference among the treatments, except for stem and total mass in the summer and stem in the fall. The tillers were heavier and higher values for number of green leaves per tiller occurred in the fall, but for senescent leaves per tiller ocurred in the winter. Swards grazed at heights between 45 and 60 cm of defoliation, had good production of forage mass and leaf constituent.

Características produtivas e morfológicas do capim Tanzânia em diferentes intensidades de pastejo

The objective of this study was to determine the best height of the Tanzania grass under grazing, assessing morphological and productive characteristics of the sward. This experiment was conducted in Cidade Gaucha, Parana, where he was rated the accumulation rate and morphological characteristics of Tanzania grass pastures grazed at 20, 40, 60 and 80 cm grazing under continuous stocking with variable stocking rate for beef cattle. The experimental area was 12 hectare divided in paddocks of one hectare each. For each paddock were allocated two grazing exclusion cage for estimating herbage accumulation, and eight samples were taken every 28 days throughout the year 2010. The completely randomized design. The herbage mass of the morphological structures showed a linear positive function of sward heights. The height of defoliation did not influence the rate of herbage accumulation for any of the morphological structures: green leaf, stem + sheaths and senescent material. There were also no differences in leaf: stem ratio. All heights within the range studied provided adequate number of green leaves per tiller. Tanzania grass pastures grazed under continuous stocking between 40 and 60 cm, for providing a good association between accumulation and mass of green leaf blades, and acceptable values of the mass of stem + sheaths and senescent material. Pasture of Tanzania grass under 60 and 80 cm allow of leaves satisfactory accumulation in the autumn.

CONTRIBUTION OF BASAL AND AERIAL TILLERS IN DYNAMICS OF HERBAGE PRODUCTION OF SIGNALGRASS AFTER GRAZING DEFERRED

During the spring, the understanding of regrowth in basal and aerial tillers of deferred pasture in winter it is necessary. Thus, the objective was to evaluate the morphogenesis and herbage accumulation during spring in Brachiaria decumbens cv. Basilisk (signalgrass) pasture used under deferred grazing in winter. The basal and aerial tillers in same pasture were evaluated. The signalgrass was managed with grazing cattle and with an average height of 25 cm. The randomized block design with three replications was adopted. The leaf appearance rate, phyllochron and the numbers of expanded, expanding and live leaves did not differ between basal and aerial tillers. The aerial tiller possessed lower rates of leaf senescence, of leaf elongation and of stem elongation, as well as lower number of dead leaf and stem and leaf lamina lengths, compared to basal tiller. The leaf lifespan was higher in aerial tillers than at basal. The basal tiller also contributed to higher rates of tissue growth and forage accumulation in pasture when compared to aerial tiller. After deferred grazing during the spring, the aerial tiller has low participation in forage production of signalgrass pasture.

Bispectral index in calves anesthetized with xylazine, midazolam, ketamine, isoflurane and subjected to continuous rate infusion of lidocaine

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

The effect of gastrointestinal nematode infection level on grazing distance from dung

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

On the Limit Cycles for a Class of Continuous Piecewise Linear Differential Systems with Three Zones

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Narrow-band search of continuous gravitational-wave signals from Crab and Vela pulsars in Virgo VSR4 data

In this paper we present the results of a coherent narrow-band search for continuous gravitational-wave signals from the Crab and Vela pulsars conducted on Virgo VSR4 data. In order to take into account a possible small mismatch between the gravitational-wave frequency and two times the star rotation frequency, inferred from measurement of the electromagnetic pulse rate, a range of 0.02 Hz around two times the star rotational frequency has been searched for both the pulsars. No evidence for a signal has been found and 95% confidence level upper limits have been computed assuming both that polarization parameters are completely unknown and that they are known with some uncertainty, as derived from x-ray observations of the pulsar wind torii. For Vela the upper limits are comparable to the spin-down limit, computed assuming that all the observed spin-down is due to the emission of gravitational waves. For Crab the upper limits are about a factor of 2 below the spin-down limit, and represent a significant improvement with respect to past analysis. This is the first time the spin-down limit is significantly overcome in a narrow-band search.

Mathematical modeling of a continuous alcoholic fermentation process in a two-stage tower reactor cascade with flocculating yeast recycle

Experiments of continuous alcoholic fermentation of sugarcane juice with flocculating yeast recycle were conducted in a system of two 0.22-L tower bioreactors in series, operated at a range of dilution rates (D (1) = D (2) = 0.27-0.95 h(-1)), constant recycle ratio (alpha = F (R) /F = 4.0) and a sugar concentration in the feed stream (S (0)) around 150 g/L. The data obtained in these experimental conditions were used to adjust the parameters of a mathematical model previously developed for the single-stage process. This model considers each of the tower bioreactors as a perfectly mixed continuous reactor and the kinetics of cell growth and product formation takes into account the limitation by substrate and the inhibition by ethanol and biomass, as well as the substrate consumption for cellular maintenance. The model predictions agreed satisfactorily with the measurements taken in both stages of the cascade. The major differences with respect to the kinetic parameters previously estimated for a single-stage system were observed for the maximum specific growth rate, for the inhibition constants of cell growth and for the specific rate of substrate consumption for cell maintenance. Mathematical models were validated and used to simulate alternative operating conditions as well as to analyze the performance of the two-stage process against that of the single-stage process.

Source and frequency of dry season lipid supplementation of grazing, finishing cattle

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)