Chemistry of peridotites of ODP Hole 103-637A

A ridge of peridotite was drilled off of the Galicia margin (Hole 637A) during ODP Leg 103. The ridge is located at the approximate boundary between oceanic and continental crust. This setting is of interest because the peridotite may be representative of upwelling upper mantle beneath an incipient ocean basin. The composition of the Galicia margin peridotite is compared with those of other North Atlantic peridotites. Hole 637A ultramafic lithologies include clinopyroxene-rich spinel harzburgite and lherzolite, as well as plagioclase-bearing peridotites. Variations in mineral modal abundances and mineral compositions are observed but are not systematic. The peridotites are broadly similar in composition to other peridotites recovered from ocean basins, but the mineral compositions and abundances suggest that they are less depleted in basaltic components than other North Atlantic peridotites by about 10%. In particular, the peridotites are enriched in the magmaphilic elements Na, Al, and Ti, as compared with other abyssal peridotites. The high abundances of these elements suggest that the Hole 637A peridotites had experienced, at most, very small amounts of partial melting prior to their emplacement. The presence of plagioclase rimming spinel in some samples suggests that the peridotite last equilibrated at about 9 kbar, near the transition between plagioclase- and spinel-peridotite stability fields. Temperatures of equilibration of the peridotite are calculated as 900°-1100°C. The relatively undepleted composition of the peridotite indicates that it was emplaced at a shallow mantle level under a relatively cool thermal regime and cooled below solidus temperatures without having participated in any significant partial melting and basalt production. This is consistent with the emplacement of the peridotite during incipient rifting of the ocean basin, before a true spreading center was established.

Chemistry of bulk-rocks and minerals of ODP Hole 120-748C

Five hundred meters of a unique Upper Cretaceous Cr-rich glauconitic sequence (Unit III) that overlies a 3-m-thick alkali-basalt flow with underlying epiclastic volcanogenic sediments was drilled at ODP Leg 120 Site 748. The Cr-rich glauconitic sequence is lithostratigraphically and biostratigraphically divided into three subunits (IIIA, IIIB, IIIC) that can also be recognized by the Cr concentration of the bulk sediment, which is low (<200 ppm) in Subunits IIIC and IIIA and high (400-800 ppm) in Subunit IIIB. The Cr enrichment is caused by Cr-spinel, which is the only significant heavy mineral component beside Fe-Ti ores. Other Cr-bearing components are glauconite pellets and possibly some other clay minerals. The glauconitic sequence of Subunit IIIB was formed by reworking of glauconite and volcanogenic components that were transported restricted distances and redeposited downslope by mass-transportation processes. The site of formation was a nearshore, shallow inner shelf environment, and final deposition may have been on the outer part of a narrow shelf, at the slope toward the restricted, probably synsedimentary, faulted Raggatt Basin. The volcanic edifices uncovered on land were tholeiitic basalts (T-MORB), alkali-basaltic (OIB) and (?)silicic volcanic complexes, and ultramafic rocks. The latter were the ultimate source for the Cr-spinel contribution. Terrestrial aqueous solutions carried Fe, K, Cr, Si, and probably Al into the marine environment, where, depending on the redox conditions of microenvironments in the sediment, green (Fe- and K-rich) or brown (Al-rich) glauconite pellets formed. The Upper Cretaceous glauconitic sequence at Site 748 on the Southern Kerguelen Plateau constitutes the transition in space and time from terrestrial to marine, from magmatically active subaerial to magmatically passive submarine conditions, and from a tranquil platform to active rifting conditions.

Composition of minerals at DSDP Leg 67 Holes

During the Leg 67 drilling of the Middle America Trench (Guatemala transect), basalts were reached in Hole 495, 22 km seaward from the Trench axis, in Holes 500 and 500B at the foot of the continental slope, and at four other holes not sampled for this study. Only olivine-plagioclase phyric basalts are present in Hole 495, whereas in Holes 500 and 500B these rocks are associated with plagioclase phyric high-alumina basalts. As illustrated by the content of TiO2, Al2O3, and the K2O/K2O + Na2O ratio, some of the Middle America Trench basalts do not differ essentially from oceanic tholeiites, but others have a composition transitional to island-arc tholeiitic basalts. It is suggested that basalts transitional from oceanic to island-arc tholeiites are typical manifestations of magmatism in zones of convergence of the oceanic and continental or island-arc crust.

Composition of bottom sediments, rocks, and ores from the Tropical Atlantic

Geological features of some areas of the Tropical Atlantic (stratigraphy, tectonic structure, lithology, distribution of ore components in bottom sediments, petrography of bedrocks, etc.) are under consideration in the book. Regularities of concentration of trace elements in iron-manganese nodules, features of these nodules in bottom sediments, distribution of phosphorite nodules and other phosphorites have been studied. Much attention is paid to rocks of the ocean crust. A wide range of mineralization represented by magnetite, chromite, chalcopyrite, pyrite, pentlandite, and other minerals has been found.

Average compositions and analyses range for clinopyroxene, olivines, orthopyroxene, and spinel from the MARK area at DSDP Site 45-395A, and ODP Site 153-920

Mineral compositions of residual peridotites collected at various locations in the Mid-Atlantic Ridge south of the Kane transform (MARK area) are consistent with generally smaller degrees of melting in the mantle near the large offset Kane transform than near the other, small offset, axial discontinuities in the area. We propose that this transform fault effect is due to along-axis variations in the final depth of melting in the subaxial mantle, reflecting the colder thermal regime of the ridge near the Kane transform. Calculations made with a passive mantle flow regime suggest that these along-axis variations in the final depth of melting would not produce the full range of crustal thickness variations observed in the MARK area seismic record. It is therefore likely that the transform fault effect in the MARK area is combined with other mechanisms capable of producing crustal thickness variations, such as along-axis melt migration, the trapping of part of the magma in a cold mantle root beneath the ridge, or active mantle upwelling.

Chemistry of peridotites from ODP 109-670A

During Leg 109 of the Ocean Drilling Program, about 100 m of serpentinized peridotites were drilled on the western wall of the M.A.R. axial rift valley, 45 km south of the Kane Fracture Zone. The present study reports petrological and mineralogical data obtained from 29 small pieces of these ultramafic rocks, including about 60% serpentinized harzburgites, 26% serpentinized lherzolites, 14% serpentinized dunites, and one sample of olivine websterite. Modal analyses show that all these rocks are plagioclase-free four-phase peridotites equilibrated in the spinel lherzolite facies. The estimated average modal composition of the sample set is about 80% olivine, 14% opx, 5% cpx, and 1% spinel, that is, a cpx-poor lherzolite. The well developed porphyroclastic structures and mineralogical characteristics of these rocks indicate their affinity with the group of residual mantle tectonites, among the abyssal peridotites. Features typical of magmatic cumulates are lacking. The high contents in Al2O3 of the cpx (average 5.4%) and of the opx (average 4.3%) porphyroclasts, the low Cr# of the spinels (average 22.9%), and the rather high content in modal cpx (about 5%), indicate a moderate percentage of melting, of the order of 10%-15%. Site 670 peridotites plot close to the least depleted mantle rocks collected in the oceans in most diagrams used to define the average trend of the ocean-floor peridotites. Microprobe traverses across the cores of the exsolved opx and cpx porphyroclasts permitted the recalculation of the magmatic compositions of these pyroxenes: the 'primitive' opx were equilibrated at about 1300°C, probably at the end of the main melting episodes, whereas the 'primitive' cpx show lower equilibration temperatures, at about 1200°C, reflecting a more complex thermal history. The subsolidus evolution is well recorded, from 1200°C to about 950CC, by the exsolved pyroxenes and the olivine and spinel phases. Unusually high blocking temperatures, close to 1000°C, indicate that the peridotite body was cooled very rapidly between 1000°C and the beginning of serpentinization. Oxygen fugacities, calculated for 10 kb and at the blocking temperatures indicated by the olivine/spinel geothermometer, are close to the usual fugacities calculated in oceanic peridotites and basalts (of the order of 10**-10 to 10**-11, on the QFM buffer). Site 670 peridotites have compositions close to those of the peridotites collected in the Kane Fracture Zone area, and obviously belong to the moderately depleted mantle peridotites which characterize abyssal peridotites collected away from mantle plumes and oceanic islands. In particular, they differ from the highly residual harzburgites collected along the M.A.R. over the Azores bulge.

Geochemistry of DSDP Hole 86-577B samples

THE chemical, mineralogical and isotopic characteristics of deposits at the Cretaceous/Tertiary (K/T) boundary are suggestive of a large impact event, the prime candidate (Sharpton et al., 1992, doi:10.1038/359819a0) being the Chicxulub crater in Yucatan, Mexico. Spinel-bearing spherules, which may be associated with such impacts, have been reported (Smit and Romein, 1985, doi:10.1016/0012-821X(85)90019-6) at several K/T boundary sites worldwide, but their origin is still uncertain. We have examined the spinel-bearing material recovered from K/T boundary deposits at site 577 in the Pacific Ocean (Heath et al., 1985, doi:10.2973/dsdp.proc.86.104.1985) and find two distinct populations of particles: spherules with dendritic spinel textures dispersed throughout the grains and irregularly shaped fragments with spinels essentially confined to the rim. The morphology and composition of the particles are characteristic of melted and partially melted meteoritic ablation debris, but their location is difficult to reconcile with an impact on the Yucatan peninsula, some 10,000 km away. We suggest instead that the spinel-bearing particles at site 577 are derived from the impact of a 2-km asteroid in the Pacific Ocean, and that several accretionary events of this type are required to explain the global distribution of spinel-bearing spherules at the K/T boundary.

C and H geochemistry of altered oceanic crus of ODP/IODP Hole 1256D

Carbon and hydrogen concentrations and isotopic compositions were measured in 19 samples from altered oceanic crust cored in ODP/IODP Hole 1256D through lavas, dikes down to the gabbroic rocks. Bulk water content varies from 0.32 to 2.14 wt% with dD values from -64per mil to -25per mil. All samples are enriched in water relative to fresh basalts. The dD values are interpreted in terms of mixing between magmatic water and another source that can be either secondary hydrous minerals and/or H contained in organic compounds such as hydrocarbons. Total CO2, extracted by step-heating technique, ranges between 564 and 2823 ppm with d13C values from -14.9per mil to -26.6per mil. As for water, these altered samples are enriched in carbon relative to fresh basalts. The carbon isotope compositions are interpreted in terms of a mixing between two components: (1) a carbonate with d13C = -4.5per mil and (2) an organic compound with d13C = -26.6per mil. A mixing model calculation indicates that, for most samples (17 of 19), more than 75% of the total C occurs as organic compounds while carbonates represent less than 25%. This result is also supported by independent estimates of carbonate content from CO2 yield after H3PO4 attack. A comparison between the carbon concentration in our samples, seawater DIC (Dissolved Inorganic Carbon) and DOC (Dissolved Organic Carbon), and hydrothermal fluids suggests that CO2 degassed from magmatic reservoirs is the main source of organic C addition to the crust during the alteration process. A reduction step of dissolved CO2 is thus required, and can be either biologically mediated or not. Abiotic processes are necessary for the deeper part of the crust (>1000 mbsf) because alteration temperatures are greater than any hyperthermophilic living organism (i.e. T > 110 °C). Even if not required, we cannot rule out the contribution of microbial activity in the low-temperature alteration zones. We propose a two-step model for carbon cycling during crustal alteration: (1) when "fresh" oceanic crust forms at or close to ridge axis, alteration starts with hot hydrothermal fluids enriched in magmatic CO2, leading to the formation of organic compounds during Fischer-Tropsch-type reactions; (2) when the crust moves away from the ridge axis, these interactions with hot hydrothermal fluids decrease and are replaced by seawater interactions with carbonate precipitation in fractures. Taking into account this organic carbon, we estimate C isotope composition of mean altered oceanic crust at ? -4.7per mil, similar to the d13C of the C degassed from the mantle at ridge axis, and discuss the global carbon budget. The total flux of C stored in the altered oceanic crust, as carbonate and organic compound, is 2.9 ± 0.4 * 10**12 molC/yr.

Petrology and geochemistry of altered ocenaic crust of ODP Hole 140-504B

Altered basalt dikes from Hole 504B were partially melted at 1150°C and 1180°C to determine the composition of the first melts as oceanic Layer 2C is assimilated by a magma chamber. The partial melts are chemically similar to actinolite, the most abundant secondary mineral, but the melts are not simply melted actinolite. High TiO2, P2O5, and K2O abundances of the melts indicate that minor secondary minerals that are enriched in these elements also contribute to the melt. The incorporation of partial melts into a ridge-crest magma chamber may explain the local variability that is sometimes found in ocean ridge basalts that are not readily explained fractional crystallization or partial melting.