Mid-Holocene climate variations recorded by palaeolake in marginal area of east Asian monsoon: A multi-proxy study

IEECAS SKLLQG

Precipitation at Lake Qinghai；NE Qinghai-Tibet Plateau；and its relation to Asian summer monsoons on decadal/interdecadal scales during the past 500 years

IEECAS SKLLQG

水稻化感品种根分泌物中非酚酸类化感物质的鉴定与抑草活性

水稻化感品种能从根系分泌释放化感作用物质 ,长期以来 ,酚酸类物质被认为是水稻根分泌的主要化感物质 ,但这一结论常常被质疑。利用连续循环和直接树脂吸收两种方法采集典型的水稻化感品种 PI31 2 777幼苗的根分泌物 ,并用液相色谱 /质谱(L C/ MS)联用技术鉴定了根分泌物中的非酚酸类物质。结果显示 ,水稻 PI31 2 777幼苗根系能分泌释放 7-甲氧基羟基肟酸、羟基肟酸、3-异丙基 - 5 -乙酰氧基环己烯酮 - 1、5 ,7,4′-三羟基 - 3′,5′-二甲氧基黄酮、二萜内酯 A和二萜内酯 B6个非酚酸类化合物。经液相色谱 (HPL C)定量分析 ,这些化合物在水稻生长 1 0 d的根分泌物中的浓度为 5～ 1 9μmol/ L���进一步的生测结果显示 ,这些化合物在其释放的浓度范围能对稻田常见的稗草和异型莎草有抑制活性 ,尤其是这些化合物的等摩尔混合物的抑草活性增加 ,同时水稻根分泌物的抑草活性与土壤载体显著相关。表明羟基肟酸、环己烯酮、黄酮和二萜内酯四类非酚酸类物质是水稻的主要化感物质 ,这与近期愈来愈多的研究结果一致

用淋洗法修复张士灌区CdPb污染沉积物的研究

采用淋洗法,以组成为0.5m ol��L-1C aC l2和0.1m ol��L-1H C l���复合药剂作为淋洗剂处理沈阳张士灌区C d、Pb污染沉积物(C d39m g·kg-1,Pb1250m g·kg-1),在pH=1.0、反应时间30m in、淋洗剂液固比3∶1、搅拌速度500r·m in-1、温度25℃的条件下,复合淋洗剂对C d和Pb的去除率分别达到70.8%和29.3%。粒级分析表明,沉积物中C d和Pb主要存在于细粒部分,因此,分级处理能够减少处理量,降低成本。一定酸度下C l-的络合作用可能是复合淋洗剂的主要强化淋洗机制。

Microstructure analysis of nylon 66 by WAXD and SAXS

The analysis of the small angle X-ray scattering (SAXS) data was based upon particle characteristic function, one-dimensional electron-density correlation function and particle distribution function. The microstructure of nylon 66 with different degrees of crystallinity was studied by means of X-ray scattering method. The radius of gyration R-g, the Porod radius R-p, the thickness of crystalline region L-c the thickness of non-crystalline region L-n, the thickness of interphase region d(tr), the long period L, the semiaxises of particles (a, a, b), the distribution of the particle sizes and the scattering invariant were calculated. The results indicate that there was a significant interphase region between the crystalline region and the non-crystalline region. and its content (W-t,W-x) should not be neglected in comparison with that of crystalline region W-c,W-x. The morphology of nylon 66 prepared by isothermal crystallization at a high temperature was mainly a lamellar structure, while the spherical crystals dominated in the quenched sample. The size of the particles in the quenched sample was smaller than that of those in the isothermally crystallized sample. and the distribution of the particle sizes in the isothermally crystallized sample was wider.

Influence of annealing on structure of Nylon 11

Differential scanning calorimeter (DSC), wide-angle X-ray diffraction (WAXD), small-angle X-ray scattering (SAXS), and density techniques have been used to investigate the structural parameters of the solid state of Nylon 11 annealed at different temperatures. The equilibrium heat of fusion Delta H-m(0) and equilibrium melting temperature T-m(0) were estimated to be 189.05 J g(-1) and 202.85 degrees C respectively by using the Hoffman-Weeks approach. The degree of crystallinity (W-c,W-x) ranged approximately 24-42% was calculated by WAXD and compared with those by calorimetry (W-c,W-h) and density (W-c,W-d) measurements. The radius of gyration R-g, crystalline thickness L-c, noncrystalline thickness L-a, long period L, semiaxes of the particles (a, b), electron-density difference between the crystalline and noncrystalline regions eta(c) - eta(a), and the invariant Q increased with increasing annealing temperature. The analysis of the SAXS data was based upon the particle characteristic function and the one-dimensional electron-density correlation function. An interphase region existed between the crystalline and noncrystalline region with a clear dimension of about 2 nm for semicrystalline Nylon 11. Instead of the traditional two-phase model, a three-phase model has been proposed to explain these results by means of SAXS.

Study on the structure and miscibility of PBPI-E/PTI-E blends

The crystallization, miscibility and structure of polyimide PBPI-E/PTI-E blends were studied by DSC, DMA, NMR and fluorescence techniques, where PBPI-E is a biphenyldianhydride-based polyimide, and PTI-E is a polyimide from 4,4'-thiodiphthalic anhydride and 4,4'-oxydianiline. The results obtained show that PBPI-E/PTI-E blends are miscible at a molecular level for all the compositions studied. However, the glass transition temperature of the blends is well below the value predicted by the Fox equation, and the blends are not stable at high temperature, i.e. phase separation will occur when the blends are annealed about T-g. Moreover, the melting point T-m, differential enthalpy Delta H and spin-lattice relaxation time T-l(c) of the blends increase with the annealing time. (C) 1997 Elsevier Science Ltd. All rights reserved.

Small angle X-ray scattering study of structural parameters of the aggregated state in polyamide 1010+BMI

The structural parameters of the aggregated state in the polyamide PA1010 and N,N'-bismaleimide-4,4'-diphenyl methane (BMI) system were computed by means of the desmearing intensity from SAXS and using the concept of the distance distribution function. The results revealed that the parameters Q, I(0), l(c) and L decreased with the increase BMI component, whereas O-s increased. The particle dimension Z for different BMI contents was less than 13.2 nm, and the maximum value of the distance distribution function P(Z) was found to be in the range Z = 6.5-7.0 nm.

MOLECULAR CHARACTERISTICS AND CRYSTALLINE-STRUCTURE OF ETHYLENE-DIMETHYLAMINOETHYL-METHACRYLATE COPOLYMERS

The relationship between molecular and crystalline structural characteristics of the ethylene -dimethylaminoethylmethacrylate copolymers (EDAM) was investigated and related to melt flow index MI and average gross content of DAM comonomer, in comparison with low density polyethylene (LDPE) produced by the common high-pressure radical polymerization process. Although the average molecular weight and its distribution are influenced predominantly by the polymerization conditions, DAM-content seems not to depend significantly on molecular weight according to the GPC-FT/IR measurement. Comonomer sequence distributions were determined quantitatively with the C-13-NMR spectra entirely assigned by DEPT and H-1-C-13 COSY techniques. The result suggests the alternating copolymerization tendency and surprisingly coincides with the simulation out-puts based on the assumption of continuous complete mixing reactor model, using Mayo-Lewis equation and the same Q-e values as previously reported on different types of copolymers such as EVA and St.DAM (VA;vinylacetate, St;styrene). It was confirmed by WAXD and SAXS analyses that the crystallinity X(c) and the thickness of lamellar crystal l(c) decreased with increasing DAM-content, whereas the a-lattice and b-lattice dimensions enlarged. X(c) and l(c) can definitely be correlated to the heats of fusion and crystallization measured by DSC. The average size of spherulites measured with light scattering photometry tends to be enlarged with decreasing molecular weight (increasing MI) and DAM-content.

Impact of microzooplankton and Calanus sinicus (Brodsky, 1962) on phytoplankton in the Yellow Sea during early summer

Dilution incubations and Calanus sinicus addition incubations were simultaneously conducted at five stations in the Yellow Sea in June of 2004 to evaluate the impact of microzooplankton and Calanus sinicus on phytoplankton based on the Chlorophyll a (Chl-a) levels. The Chl-a growth rates (k) ranged from 0.60-1.67 d(-1), while microzooplankton grazed the Chl-a at rates (g) of 0.29-0.62 d(t-1). The addition of C. sinicus enhanced the Chl-a growth rate (Z) by 0.004-0.037 d(-1) ind.(-1) L. C. sinicus abundance ranged from 84.1-160.9 ind. m(-3), which occupied 90.7%-99.1% of the copepod (> 500 mu m) population. The in-situ increase in phytoplankton by C. sinicus community was estimated to be 0.000 4-0.005 9 d(-1). These results showed that microzooplankton were the main grazers of phytoplankton, while C. sinicus induced a slight increase in the levels of phytoplankton.