Room temperature co-precipitation of nanocrystalline CeO2 and Ce0.8Gd0.2O1.9-delta powder

This paper describes a simple method to co-precipitate CeO2 and Ce0.8Gd0.2O1.9-delta with ammonium hydroxide from solvents such as: water, ethylene glycol, ethyl alcohol and isopropyl alcohol. Characterization by Raman spectroscopy and XRD evidenced the formation of a solid solution of gadolinium-doped ceria at room temperature. Nanometric particles with crystallite size of 3.1 nm were obtained during synthesis using ethyl alcohol as solvent. This is a promising result compared with those mentioned in the literature, in which the smallest crystallite size reported was, 6.5 nm. (c) 2006 Elsevier B.V. All rights reserved.

Sintering and characterization of PLZT (9/65/35)

PLZT(9/65/35) obtained by association between the Pechini method (ZT) and partial oxalate (PLZT) was prepared. The stoichiometric phase and monophasic (cubic) PLZT obtained by calcination did not occur after sintering. The sintering process, by using two stages, caused a liquid phase formation due to a PbO excess (5 and 10 wt%). Samples with high density (similar to 8 g/cm(3)) and optical transparency(similar to 12%) were obtained. However, an equilibrium between the excess of PbO of sample/atmosphere PbO leads to a segregated PbO phase on the boundaries of the microstructure. A diffusion of Zr, Ti and La ions from PLZT to PbO phase promoted a stoichiometric deviation of the matrix and modified the optical and dielectric characteristics. (C) 2000 Elsevier B.V. Ltd and Techna S.r.l. All rights reserved.

Synthesis and characterization of 9.5/65/35 PLZT prepared from the polymeric precursors

The 9.5/65/35 PLZT was prepared from the polymeric precursors (the Pechini and partial oxalate process) and by sintering in two stages in an oxygen atmosphere. After thermal treatment at 400 degreesC, the powders were calcinated and sintered at 1200 degreesC with slow heating and cooling rates. The second stage of sintering consisted of hot pressing at the same temperature in oxygen atmosphere. After calcination of PLZT powders obtained by both methods, as well as after sintering of PLZT obtained by Pechini process, the paraelectric cubic phase was formed. After sintering of PLZT obtained by partial oxalate procedure, small tetragonality of crystal structure was observed. After hot pressing PLZT was pseudocubic. SEM microstructural analyses were carried out of the sintering and hot pressed samples and indicated the small grain size less than 2 mum. (C) 2001 Elsevier B.V. B.V. All rights reserved.

Serologic profile in hepatitis B virus and hepatitis C virus in a Brazilian liver transplant waiting list

Chronic viral hepatitis is currently the most common indication for liver transplantation (OLT). Knowing the serological profile of patients on the liver transplant waiting list (LTWL) is essential to manage prophylactic and therapeutic strategies pre- and post-OLT. The aim of this study was to determine the hepatitis B virus (HBV) and hepatitis C virus (HCV) serological profile on the LTWL.Methods. Serological data were collected from 44 candidates included on, the LTWL from May 2003 to November 2004. HBV and HCV serological profiles were performed by microenzyme immunoassay.Results. Twenty-eight patients (66.7%) lacked H13V serological markers. Anti-HBs was detected in 9.5% and was positive for HBsAg, anti-HBc, IgM anti-HBc, or HbeAg in 4.8% of patients, probably related to reactivation of chronic infection. In 7.1% of patients, the markers demonstrated serological cure of infection. In HCV patients, 41.5% were positive. There was H13V and HCV co-infection in 12.2% of patients.Conclusion. HBV infection in 21.4% of the patients corroborates the need to use more efficient protocols for prophylactic and therapeutic management pre- and post-OLT. The high prevalence of HCV infection reinforces the need to follow adequate protocols to avoid related complications and guarantee rational and universal use of more efficient drugs.

Hot-pressed 9.5/65/35 PLZT prepared by the polymeric precursor method

A 9.5/65/35 PLZT ceramic with a Pb-0.905 La-0.095 (Zr-0.65 Ti-0.35)(0.976) O-3 + 35 w% PbO formula was prepared using the Pechini method for powder preparation and two-step sintering in an oxygen atmosphere. Thr first step consisted of sintering at 1200 degrees C for 4 h with slow heating and cooling rates. The second step consisted of hot pressing at 1200 degrees C for 3 h, with slow heating and cooling rates and pressing pressures of 20 MPa (initial pressure) and 40 MPa (at sintering temperature). Investigations were made of the powder phase formation and powder morphology, i.e. The structure of sintered and hot-pressed PLZT ceramics. SEM microstructural analyses were carried out on the sintering and hot-pressing processes. (C) 2000 Elsevier B.V. Ltd and Techna S.r.l. All rights reserved.

Preparation of 9/65/35 PLZT thin films deposited by a dip-coating process

Crack-free polycrystalline PLZT (Pb,a)(Zr,Ti)O-3 thin films with the perovskite structure were prepared by dir-coating using the Pechinis process. Lead acetate, hydrated lanthanum carbonate, zirconium n-propoxide and titanium isopropoxide were used as raw materials. The viscosity of the solution was adjusted in the range of 20 to 56 cP and the films were deposited by a dip-coating process on silicon (100) as substrate. Solutions with ionic concentration of 0.1 and 0.2 M were used. Thin film deposition was accomplished by dipping the substrates in the solution with control of withdrawal speed from 5 to 20 mm/min. The thin films were thermally treated in two steps: at 300 degreesC amid 650 degreesC. The influence of withdrawal speed. viscosity, heating rate and ionic concentration on the morphology of PLZT thin film was discussed. (C) 2001 Elsevier B.V. Ltd. All rights reserved.

Structural and microstructural characterization of SrBi2(Ta0.5Nb0.48W0.02)(2)O-9 powders

SrBi2(Ta0.5Nb0.48W0.02)(2)O-9 powders (SBTN-W) were prepared by the polymeric precursor method. The influence of annealing temperature on the phase formation and specific surface area was evaluated. TG/DTA associated with X-ray diffraction (XRD) analyses showed the formation of perovskite phase at around 500-600 degrees C. An orthorhombic structure with A21am space group was identified by Rietveld refinement. BET analysis revealed that the specific surface area reduces with increasing thermal annealing. SEM micrographies showed grains in an almost-spherical morphology with the presence of agglomerates. (C) 2006 Elsevier B.V. All rights reserved.

Structural and electrical properties of SrBi2(Ta0.5Nb0.5)(2)O-9 thin films

SrBi2(Ta0.5Nb0.5)(2)O-9 (SBTN) thin films were obtained by polymeric precursor method on Pt/Ti/SiO2/Si(1 0 0) substrates. The film is dense and crack-free after annealing at 700 degrees C for 2 h in static air. Crystallinity and morphological characteristic were examined by X-ray diffraction (XRD), field emission scanning electron microscopy (FEG-SEM) and atomic force microscopy (AFM). The films displayed rounded grains with a superficial roughness of 3.5 nm. The dielectric permittivity was 122 with loss tangent of 0.040. The remanent polarization (P-r) and coercive field (E-c) were 5.1 mu C/cm(2) and 96 kV/cm, respectively. (C) 2007 Published by Elsevier B.V.

Characterization of antibiosis and antixenosis to the whitefly silverleaf Bemisia tabaci B biotype (Hemiptera: Aleyrodidae) in several squash varieties

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Anti-Angiogenic Effects of the Superantigen Staphylococcal Enterotoxin B and Bacillus Calmette-Guerin Immunotherapy for Nonmuscle Invasive Bladder Cancer

Purpose: We compared and characterized the effects of intravesical bacillus Calmette-Guerin and/or staphylococcal enterotoxin B for nonmuscle invasive bladder cancer.Materials and Methods: A total of 75 female Fisher 344 rats were anesthetized. of the rats 15 received 0.3 ml saline (control) and 60 received 1.5 mg/kg MNU (N-methyl-n-nitrosourea) intravesically every other week for 6 weeks. The rats were divided into 5 groups. The MNU and control groups received 0.3 ml saline. The bacillus Calmette-Guerin group received 10(6) cfu bacillus Calmette-Guerin. The staphylococcal enterotoxin B group received 10 mu g/ml staphylococcal enterotoxin B. The bacillus Calmette-Guerin plus staphylococcal enterotoxin B group received the 2 treatments simultaneously. Each group was treated intravesically for 6 weeks. At 15 weeks all bladders were collected for histopathological and immunological evaluation, and Western blot.Results: Papillary carcinoma (pTa) and high grade intraepithelial neoplasia (carcinoma in situ) were more common in the MNU group. Papillary hyperplasia was more common in the bacillus Calmette-Guerin and enterotoxin groups. Flat hyperplasia was more common in the bacillus Calmette-Guerin plus enterotoxin group. No significant toxicity was observed. The apoptosis and cellular proliferation indexes decreased in the bacillus Calmette-Guerin, enterotoxin and bacillus Calmette-Guerin plus enterotoxin groups compared to the MNU group. Intensified vascular endothelial growth factor, matrix metalloproteinase-9, Ki-67 and insulin-like growth factor receptor-1 immunoreactivity was verified in the MNU group, moderate in the bacillus Calmette-Guerin and enterotoxin groups, and weak in the bacillus Calmette-Guerin plus enterotoxin and control groups. In contrast, intense endostatin immunoreactivity was verified in the control and bacillus Calmette-Guerin plus enterotoxin groups.Conclusions: Bacillus Calmette-Guerin and staphylococcal enterotoxin B showed similar anti-angiogenic effects. Bacillus Calmette-Guerin plus enterotoxin treatment had additional activity compared to that of monotherapy. It was more effective in restoring apoptosis and balancing cellular proliferation, and it correlated with increased endostatin, and decreased vascular endothelial growth factor, matrix metalloproteinase-9, Ki-67 and insulin-like growth factor receptor-1 reactivity.

Downregulation of nuclear factor-kappa B (NF-kappa B) pathway by silibinin in human monocytes challenged with Paracoccidioides brasiliensis

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Application of dissociation curve analysis to radiation hybrid panel marker scoring: generation of a map of river buffalo (B-bubalis) chromosome 20

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Efeitos dos inseticidas utilizados no controle de Bemisia tabaci (Gennadius) biótipo B e sua seletividade aos inimigos naturais na cultura da soja

In recent crop seasons, the whitefly, Bemisia tabaci biotype B has become a serious pest in soybean crops due to high infestations and its control difficulties. Therefore, it is important to search control alternatives in the integrated pest management approach. Thus, it was evaluated in this study the efficacy of the whitefly control using different insecticides in greenhouse conditions and their selectivity to the parasitoids Encarsia formosa, Trichogramma pretiosum and Telenomus remus. Buprofezin 150 g.a.i. ha(-1) + mineral oil 0.2% v/v and pyriproxyfen 100 g.a.i. ha(-1) were considered the best options for the whitefly management due to combine good pest control efficacy with higher selectivity to the parasitoids except Encarsia formosa for which no treatment was classified as harmless. Betacyflutrin 9.375 + imidacloprid 75 g.i.a. ha(-1) was efficient on controlling whiteflies nymphs but was not harmless to the studied natural enemies. In general, the treatments including pyretroids compounds (betacyflutrin 9.375 + imidacloprid 75 + spiromesifen 60, betacyflutrin 9.375 + imidacloprid 75 and lambda-cyhalothrin 26.5 + thiametoxan 35.25 g.a.i. ha(-1)) were the most harmful to the evaluated parasitoids and therefore it use should be avoid whenever possible.