Titanium surface topography after brushing with fluoride and fluoride-free toothpaste simulating 10 years of use

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

In Vitro Study of Fracture Load and Fracture Pattern of Ceramic Crowns: A Finite Element and Fractography Analysis

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Microhardness change of enamel due to bleaching with in-office bleaching gels of different acidity

Objective. The aim of this study was to assess the enamel microhardness treated with three in-office bleaching agents, containing 35% hydrogen peroxide with different acidity. Materials and methods. Bovine incisors were divided into three groups that received the following bleaching agents: Whiteness HP, Total Bleach and Opalescence Xtra. Three gel applications/10-min each, totaling 30-min of bleaching treatment, were made on the teeth and activated with a blue LED (1000 mW/470 nm) combined to a LASER (120 mW/795 nm) device (Easy Bleach-Clean Line). Vickers hardness (VH) was evaluated at baseline and after the bleaching procedure. The values of Hardness loss [HNL] (% reduction) were calculated. The two-sample t-test was used for comparison of the HNL of the three bleaching products (5% level of significance). Results. The Opalescence Xtra, which had the lowest pH value (pH = 4.30), showed a significant increase of HNL when compared with Total Bleach bleaching agent, which had the highest pH value (pH = 6.62). Conclusions. The 35% hydrogen peroxide bleaching agents resulted in a reduction in surface enamel microhardness and bleaching with the most acid agent resulted in a significant enamel hardness loss compared to the less acid agent (4.30 vs 6.62). Strategies proposed to reduce the enamel loss after bleaching treatment may include the use of daily fluoride therapy, mouth rinsing (fluoride, milk and sodium bicarbonate solution), fluoride/bicarbonate dentifrices without abrasives, do not toothbrush immediately after bleaching, fluorides and calcium add to bleaching agents.

Low-energy three-body charge transfer reactions with Coulomb interaction in the final state

Three-body charge transfer reactions with Coulomb interaction in the final state are considered within the framework of coordinate-space integro-differential Faddeev-Hahn-type equations within two- and six-state close-coupling approximations. The method is employed to study direct muon transfer in low-energy collisions of the muonic hydrogen H-mu by helium (He2+) and lithium (Li3+) nuclei. The experimentally observed isotopic dependence is reproduced.

Prediction of a weakly bound excited state in the He-4(2)-Li-7 molecule

A scale-independent approach, valid for weakly bound three-body systems, is used to analyze the existence of excited Thomas-Efimov states in molecular systems with three atoms: a helium dimer together with isotopes of lithium (Li-6 and Li-7) and sodium (Na-23). With the present study and the available data, we can clearly predict that the He-4(2)-Li-7 system supports an excited state with binding energy close to 2.31 mK. (C) 2000 American Institute of Physics. [S0021-9606(00)30442-1].

Study on the K3Li2Nb5O15 formation during the production of (Na0.5K0.5)((1-x))LixNbO3 lead-free piezoceramics at the morphotropic phase boundary

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

LiNbO3 thin films prepared through polymeric precursor method

Thin films of lithium niobate were deposited on (100) silicon by the polymeric precursor method (Pechini method). Annealing in static air was performed at 500degreesC for 3 h. The films obtained were characterized by X-ray diffraction, scanning electron microscopy and transmission electron microscopy. Electrical characterization of the films pointed to ferroelectricity via hysteresis loop. The dielectric constant, dissipation factor and resistance were measured in the frequency region from 10 Hz to 10 MHz. At 1 MHz, the dielectric constant was 46 and the dissipation factor was 0.043. (C) 2002 Elsevier B.V. B.V. All rights reserved.

Influence of thickness on crystallization and properties of LiNbO3 thin films

Thin films of lithium niobate were deposited on Pt/Ti/SiO2 (111) substrates by spin coating from the polymeric precursor method (Pechini process). Annealing in static air was performed at 500 degreesC for 3 h. The obtained films were characterized by X-ray diffraction and atomic force microscopy. The dielectric constant, dissipation factor and resistance were measured in frequency region from 10 Hz to 10 MHz and the hysteresis loop was obtained. The influence of number of layers on crystallization, morphology and properties of LiNbO3 thin films is discussed. (C) 2003 Elsevier B.V. All rights reserved.

Influence of oxygen atmosphere on crystallization and properties of LiNbO3 thin films

Thin films of lithium niobate were deposited on the Pt/Ti/SiO2 (111) substrates by spin coating from the polymeric precursor method (Pechini process). Annealing in static air and oxygen atmosphere was performed at 500 degreesC for 3 h. The films obtained were characterized by X-ray diffraction, scanning electron microscopy and transmission electron microscopy. The dielectric constant and dissipation factor were measured in frequency region from 10 Hz to 10 MHz. Electrical characterization of the films pointed to ferroelectricity via hysteresis loop. The influence of oxygen atmosphere on crystallization, morphology and properties of LiNbO3 thin films is discussed. (C) 2003 Elsevier Ltd. All rights reserved.

Voltage-composition profile and synchrotron X-ray structural analysis of low and high temperature LixCoO2 host material

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Correlation between the spectroscopic and structural properties with the occupation of Eu3+ sites in powdered Eu3+-doped LiTaO3 prepared by the Pechini method

In this work we studied the structural and optical properties of lithium tantalate (LiTaO3) powders doped with Eu3+ ions. We have examined the different sites occupied by the rare earth ion through the correlation of the DRX data analyzed with the Rietveld method and some spectroscopic parameters derived from the Eu3+ luminescence. Adirect relation was established between the lattice parameters and the occupation fraction of Eu3+ in each LiTaO3 site. The occupation fraction was set as the relative population of Eu3+ ions for each site obtained by means of the intensity, baricenter, and the spontaneous emission coefficients of the D-5(0)-> F-7(0) transitions. We concluded that the unit cell parameter a presents the same behavior of the Eu3+ occupation fraction in Ta5+ sites as a function of the Eu3+ content in LiTaO3. The same was observed for the variation in Eu3+ occupation fraction in the Li+ site and the unit cell parameter c with the Eu3+ content. (C) 2009 American Institute of Physics. [doi: 10.1063/1.3204967]

Relações lineares múltiplas entre deslocamentos químicos em RMN 13C de haletos alifáticos

Os deslocamentos químicos de RMN 13C de carbonos a , b , g e d de 17 conjuntos de haletos (F, Cl Br e I) alifáticos, inclusive compostos mono, bi e tricíclicos, podem ser reproduzidos por uma equação linear de duas constantes e duas variáveis do tipo : d R-X = A*d R-X1 + B*d R-X2 onde A e B são constantes obtidas por regressão multilinear a partir de deslocamentos químicos de 13C; d R-X, o deslocamento químico de 13C do composto com halogênio (R-X); d R-X1 e d R-X2 deslocamentos químicos de outros haletos. Para brometos (R-X) alifáticos a melhor correlação foi obtida com os dados de fluoretos (R-X1) e iodetos (R-X2) com R2 de 0,9989 e desvio médio absoluto (DM) de 0,39ppm. Para cloretos (R-X) a melhor correlação foi com dados de brometos (R-X1) e iodetos (R-X2) com R2 de 0,9960 e DM de 0,76ppm. Para fluoretos (R-X) a melhor correlação foi com brometos (R-X1) e iodetos (R-X2) com R2 de 0,9977 e DM de 1,10ppm e para iodetos (R-X) foi com fluoretos (R-X1) e brometos (R-X2) com R2 de 0,9972 e desvio médio absoluto de 0,60 ppm.

New compositions of fluoroindate glasses with higher chemical resistance

In this paper, glasses in the systems In-Ba-Mg and In-Ba-Zn-Sr-Mg were water leachead at 80ºC showing surface degradation after 72 hours of leaching. The extent of such degradation is determined by the solubility and the concentration of the elemental fluorides that constitute the glasses. The formation of a layer of crystallized phases on the surface of the samples was observed. Small weight losses were registered and the absence of water on the glass matrix after the attack suggested that the use of MgF2 in the systems studied can lead to better results against moisture corrosion when compared to other fluoride glasses such as the fluorozirconates.

Preparação de LiNbO3 e LiNbO3:Eu3+ pelo método dos precursores poliméricos

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Efeito do lítio sobre a hiperatividade locomotora induzida pela lesão eletrolítica da região do núcleo mediano da rafe em ratos

A lesão do núcleo mediano da rafe (NMR) produz sintomas que sugerem validade de face ao episódio maníaco. Esta pesquisa avaliou o efeito do lítio sobre a hiperatividade locomotora induzida por esta lesão. Vinte e um ratos Wistar machos foram submetidos à lesão eletrolítica da região do NMR (LR) e 17 foram submetidos à lesão fictícia (LF). Após recuperação, a atividade locomotora foi avaliada na caixa de atividade (Med Associates/ENV-515). Parte dos animais destes grupos recebeu tratamentos com lítio (47,5 mg/kg/2x dia i.p.) por 10 dias, enquanto o restante foi tratado com salina no mesmo esquema. A reavaliação ao final dos tratamentos demonstrou que o lítio reduziu significantemente a atividade locomotora em relação à avaliação inicial no grupo LR (ANOVA/Bonferroni p < 0,05), tornando-a equivalente aos baixos níveis dos grupos LF. Estes dados sustentam a hipótese de que as manifestações induzidas pela lesão do NMR podem constituir um modelo animal de mania.