Isolating the 'farmer' effect as a component of the advantage of growing genetically modified varieties in developing countries: a Bt cotton case study from Jalgaon, India

The present paper explores the 'farmer' effect in economic advantages often claimed for Bt cotton varieties (those with the endotoxin gene from Bacillus thuringiensis conferring resistance to some insect pests) compared to non-Bt varieties. Critics claim that much of the yield advantage of Bt cotton could be due to the fact that farmers adopting the technology are in a better position to provide inputs and management and so much of any claimed Bt advantage is an artefact rather than reflecting a real advantage of the variety per se. The present paper provides an in-depth analysis of 63 non-adopting and 94 adopting households of Bt cotton in Jalgaon, Maharashtra State, India, spanning the seasons 2002 and 2003. Results suggest that Bt adopters are indeed different from non-adopters in a number of ways. Adopters appear to specialize more on cotton (at least in terms of the land area they devote to the crop), spend more money on irrigation and grow well-performing non-Bt varieties of cotton (Bunny). Taking gross margin as the basis for comparison, Bt plots had 2.5 times the gross margin of non-Bt plots in both seasons. If only adopters are considered then the gross margin advantage of Bt plots reduces to 1.6 times that of non-Bt plots. This is still a significant advantage and could well explain the popularity of Bt in Maharashtra. However, it is clear that great care needs to be taken with such comparative studies.

Genetically modified insect resistance in cotton: some farm level economic impacts in India

The paper explores the impact of insect-resistant Bacillus thuringiensis (Bt) cotton on costs and returns over the first two seasons of its commercial release in three sub-regions of Maharashtra State, India. It is the first such research conducted in India based on farmers' own practices rather than trial plots. Data were collected for a total of 7793 cotton plots in 2002 and 1577 plots in 2003. Results suggest that while the cost of cotton seed was much higher for farmers growing Bt cotton relative to those growing non-Bt cotton, the costs of bollworm spray were much lower. While Bt plots had greater costs (seed plus insecticide) than non-Bt plots, the yields and revenue from Bt plots were much higher than those of non-Bt plots (some 39% and 63% higher in 2002 and 2003, respectively). Overall, the gross margins of Bt plots were some 43% (2002) and 73% (2003) higher than those of non-Bt plots, although there was some variation between the three sub-regions of the state. The results suggest that Bt cotton has provided substantial benefits for farmers in India over the 2 years, but there are questions as to whether these benefits are sustainable. (c) 2004 Elsevier Ltd. All rights reserved.

Inequality and GM crops: a case study of Bt cotton in India

Critics of genetically modified (GM) crops often contend that their introduction enhances the gap between rich and poor farmers, as the former group are in the best position to afford the expensive seed as well as provide other inputs such as fertilizer and irrigation. The research reported in this paper explores this issue with regard to Bt cotton (cotton with the endotoxtin gene from Bacillus thuringiensis conferring resistance to some insect pests) in Jalgaon, Maharashtra State, India, spanning the 2002 and 2003 seasons. Questionnaire–based survey results from 63 non–adopting and 94 adopting households of Bt cotton were analyzed, spanning 137 Bt cotton plots and 95 non–Bt cotton plots of both Bt adopters and non–adopters. For these households, cotton income accounted for 85 to 88% of total household income, and is thus of vital importance. Results suggest that in 2003 Bt adopting households have significantly more income from cotton than do non–adopting households (Rp 66,872 versus Rp 46,351) but inequality in cotton income, measured with the Gini coefficient (G), was greater amongst non–adopters than adopters. While Bt adopters had greater acreage of cotton in 2003 (9.92 acres versus 7.42 for non–adopters), the respective values of G were comparable. The main reason for the lessening of inequality amongst adopters would appear to be the consistency in the performance of Bt cotton along with the preferred non–Bt cultivar of Bt adopters—Bunny. Taking gross margin as the basis for comparison, Bt plots had 2.5 times the gross margin of non–Bt plots of non–adopters, while the advantage of Bt plots over non–Bt plots of adopters was 1.6 times. Measured in terms of the Gini coefficient of gross margin/acre it was apparent that inequality was lessened with the adoption of Bunny (G = 0.47) and Bt (G = 0.3) relative to all other non–Bt plots (G = 0.63). Hence the issue of equality needs to be seen both in terms of differences between adopters and non–adopters as well as within each of the groups.

Pesticide productivity and transgenic cotton technology: The South African smallholder case

This paper empirically investigates how the productivity of pesticide differs in Bt versus non-Bt technology for South African cotton smallholders, and what the implications for pesticide use levels are in the two technologies. This is accomplished by applying a damage control framework to farm-level data from Makhathini flats, KwaZulu-Natal. Contrary to findings elsewhere, notably China, that farmers over-use pesticides and that transgenic technology benefits farmers by enabling large reductions in pesticide use, the econometric evidence here indicates that non-Bt smallholders in South Africa under-use pesticide. Thus, the main potential contribution of the new technology is to enable them to realise lost productivity resulting from under-use. By providing a natural substitute for pesticide, the Bt technology enables the smallholders to circumvent credit and labour constraints associated with pesticide application. Thus, the same technology that greatly reduces pesticide applications but only mildly affects yields, when used by large-scale farmers in China and elsewhere, benefits South-African smallholder farmers primarily via a yield-enhancing effect.

Logit models for identifying the factors that influence the uptake of new 'no-tillage' technologies by farmers in the rice-wheat and the cotton-wheat farming systems of Pakistan's Punjab

In the 'rice-wheat' and the 'cotton-wheat' farming systems of Pakistan's Punjab, late planting of wheat is a perennial problem due to often delayed harvesting of the previously planted and late maturing rice and cotton crops. This leaves very limited time for land preparation for 'on-time' planting of wheat. 'No-tillage' technologies that reduce the turn-round time for wheat cultivation after rice and cotton have been developed, but their uptake has not been as expected.-This paper attempts to determine the farm and farmer characteristics and other socio-economic factors that influence the adoption of 'no-tillage' technologies'. Logit models were developed for the analysis undertaken. In the 'cotton-wheat' system personal characteristics like education, tenancy status, attitude towards risk implied in the use of new technologies and contact with extension agents are the main factors that affect adoption. As regards the 'rice-wheat' system, resource endowments such as farm size, access to a 'no-tillage' drill, clayey soils and the area sown to the rice-wheat sequence along with tenancy and contact with extension agents were dominant in explaining adoption. (C) 2002 Elsevier Science Ltd. All rights reserved.

The use of ultraviolet-blocking films in insect pest management in the UK; effects on naturally occurring arthropod pest and natural enemy populations in a protected cucumber crop

Studies in polytunnels were conducted to investigate the effects of ultraviolet (UV)-blocking films on naturally occurring insect pests and their arthropod natural enemies on a cucumber crop. Within tunnels clad with Antibotrytis (blocks light < 400 nm) and UVI/EVA (UV transmitting), 5.8 and 23.4 times more aphids, respectively, were recorded on traps compared with those on traps within tunnels clad with XL 385 (blocks light < 385 nm). When all plants within the UVI/EVA tunnels had become heavily infested with aphids, half of the plants in XL 385 tunnels were uninfested. More Coleoptera and thrips (approximately two times) were recorded under the UVI/EVA film than under the UV-blocking films, but for other arthropod pests (e. g. whitefly, leafhoppers), clear conclusions could not be drawn as low numbers were recorded. Substantial numbers of chalcid parasitoids and syrphids were found under the UV-blocking films, but further research is needed to evaluate fully the effect of such films on biological control of aphids. Higher syrphid numbers and more aphid mummies were recorded under the UVI/EVA film, probably because of the higher numbers of aphids present in tunnels clad with this film. The potential that UV-blocking films have as an effective component of commercial Integrated Pest Management (IPM) systems, for protected horticultural crops, is discussed.

Identification of mutations conferring insecticide-insensitive AChE in the cotton-melon aphid, Aphis gossypii Glover

We have identified two mutations in the ace1 gene of Aphis gossypii that are associated with insensitivity of acetylcholinesterase (AChE) to carbamate and organophosphate insecticides. The first of these, S431F (equivalent to F331 in Torpedo californica), is associated with insensitivity to the carbamate insecticide pirimicarb in a range of A. gossypii clones. The S431F mutation is also found in the peach-potato aphid, Myzus persicae (Sulzer), and a rapid RFLP diagnostic allows the identification of individuals of both aphid species with a resistant genotype. This diagnostic further revealed the presence of S431 in several other pirimicarb-susceptible aphid species. The serine at this position in the wild-type enzyme has only been reported for aphids and provides a molecular explanation of why pirimicarb has a specific aphicidal action. A less specific insensitivity to a wide range of carbamates and organophosphates is associated with a second mutation, A302S (A201 in T. californica).

The interrelationships of winter wheat cultivars, crop density and competition of naturally occurring weed flora

The effects of intraspecific and interspecific competition on a wide range of winter wheat cultivars were investigated in two consecutive split plot field experiments. Significant reductions of grain yield at greatly reduced seed rates were observed in the first experiment, whereas increasing crop density up to 380 plants m(-2) in the second experiment failed to produce a significant yield response due to compensation through increased ears and grains per plant at lower crop densities. Appreciable weed suppression and acceptable grain yield can be achieved at crop densities between 150 and 270 plants m(-2). Reductions in final yield due to weed competition occurred in both experiments; 11.7 and 13.6% for the first and second experiment, respectively, with the onset of weed competition occurring from tittering in the first experiment and from stem elongation in the second. The possibility of enhancing crop competitiveness for weed suppression and improved grain yield is discussed.

Method for the production of cotton somatic embryos. United States Patent Application

The present invention provides Inter alia, a method for the production of cotton somatic embryos comprising (a) isolating a totipotent stomatal cell-containing epidermal explant from leaf material excised from a cotton plant; and (b) culturing said explant in a basal medium which comprises an embryogenic callus-inducing quantity of an auxin and a cytokinin under an embryogenic callus inducing intensity of light until embryogenic callus is formed; and (c) sub-culturing said embryogenic callus onto a somatic embryo differentiation media to produce said somatic embryos. Plants may be regenerated from the somatic embryos and in a particular embodiment of the invention said totipotent stomatal cell is transformed, prior to the inducement of embryogenic callus, with a polynucleotide that provides for a desired agronomic trait.

Structure and biogenesis of the capsular F1 antigen from Yersinia pestis: Preserved folding energy drives fiber formation

Most gram-negative pathogens express fibrous adhesive virulence organelles that mediate targeting to the sites of infection. The F1 capsular antigen from the plague pathogen Yersinia pestis consists of linear fibers of a single subunit (Caf1) and serves as a prototype for nonpilus organelles assembled via the chaperone/usher pathway. Genetic data together with high-resolution X-ray structures corresponding to snapshots of the assembly process reveal the structural basis of fiber formation. Comparison of chaperone bound Caf1 subunit with the subunit in the fiber reveals a novel type of conformational change involving the entire hydrophobic core of the protein. The observed conformational change suggests that the chaperone traps a high-energy folding intermediate of Caf1. A model is proposed in which release of the subunit allows folding to be completed, driving fiber formation.

Performance evaluation of wall mounted convector for pre-heating naturally ventilated spaces

This paper presents the results of performance monitoring under real winter weather conditions, controlled laboratory testing and computational fluid dynamics (CFD) analysis of a wall mounted ventilation air inlet heat convector. For real winter weather monitoring, the wall-mounted convector was installed in a laboratory room of the Engineering Building of the School of Construction Management and Engineering. Air and hot water temperatures and air speeds were measured at the entrance to the convector and in the room. The hot water temperature was controlled at 40, 60 and 80 °C. The monitoring results were later used as boundary conditions for a CFD simulation to investigate the air movement in the room. Controlled laboratory testing was conducted in laboratories at the University of Reading, UK and at Wetterstad Consultancy, Sweden. The results of the performance investigation showed that the system contributed greatly to the room heating, particularly at a water temperature of 80 °C. Also adequate fresh air was supplied to the room. Such a system is able to provide an energy efficient method of eliminating problems associated with cold winter draughts.

Developing a method to characterize indoor environmental parameters in naturally ventilated classrooms

Until recently, there has been little investigation concerning the poor indoor air quality (IAQ) in classrooms. Despite the evidence that the educational building systems in many of the UK institutions have significant defects that may degrade IAQ, systematic assessments of IAQ measurements has been rarely undertaken. When undertaking IAQ measurement, there is a difficult task of representing and characterizing the environment parameters. Although technologies exist to measure these parameters, direct measurements especially in a naturally ventilated spaces are often difficult. This paper presents a methodology for developing a method to characterize indoor environment flow parameters as well as the Carbon Dioxide (CO2) concentrations. Thus, CO2 concentration level can be influenced by the differences in the selection of sampling points and heights. However, because this research focuses on natural ventilation in classrooms, air exchange is provided mainly by air infiltration. It is hoped that the methodology developed and evaluated in this research can effectively simplify the process of estimating the parameters for a systematic assessment of IAQ measurements in a naturally ventilated classrooms.