Spectrophotometric flow injection system for determination of Zn2+ in ophthalmic formulations using Alizarin red S

A spectrophotometric flow injection method for the determination of Zn(II) in ophthalmic formulations was developed. In this work, Zn(II) ion was complexed with Alizarin red S in borate buffer solution (pH 9.0) and the chromophore produced was monitored at 520 nm. The analytical curve was linear in the Zn(II) concentration range from 6.05 x 10-6 to 1.50 x 10-4 mol L-1 with a detection limit of 3.60 x 10-6 mol L-1. Recoveries ranged from 96.3 to 105 % and a relative standard deviation of 1.2 % (n = 10) for 5.5x10-5 mol L-1 Zn(II) reference solution were obtained. The sampling rate was 60 h-1 and the results obtained of Zn(II) in ophthalmic products using this procedure are in close agreement with those obtained using a comparative spectrophotometric procedure at 95 % confidence level.

Titrimetric and spectrophotometric assay of bupropion hydrochloride in pharmaceuticals using mercury(II) nitrate

Two simple, rapid and accurate methods for the determination of bupropion hydrochloride (BUP) in pure and in pharmaceutical preparations are described. Both methods are based on the measurement of the chloride of its hydrochloride. In the titrimetric method, the chloride content of bupropion hydrochloride is determined by titrating with mercury(II)nitrate using diphenylcarbazone-bromophenol blue as indicator. Titrimetric method is applicable over a range 2-20 mg of BUP and the reaction stoichiometry is found to be 2:1 (BUP: Hg(NO3)2). The spectrophotometric method involves the addition of a measured excess of mercury(II) nitrate reagent in formate buffer to the drug, and after ensuring the reaction had gone to completion, the unreacted mercury(II) is treated with a fixed amount of diphenylcarbazone, and absorbance measured at 515 nm. The absorbance is found to decrease linearly with increasing concentration of BUP and the calibration curve is linear over 1.0-15.0 µg mL-1 BUP. The proposed methods were successfully applied to the determination of BUP in commercially available dosage forms with good accuracy and precision, and without detectable interference by excipients. The accuracy was further ascertained by placebo blank and synthetic mixture analyses and also by recovery experiments via standard-addition procedure.

Estimation of standard enthalpy of formation of alkanes in gaseous state by calculating size, structural and electronic parameters in the molecules

A quantitative analysis is made on the correlation ship of thermodynamic property, i.e., standard enthalpy of formation (ΔH fº) with Kier's molecular connectivity index(¹Xv),vander waal's volume (Vw) electrotopological state index (E) and refractotopological state index (R) in gaseous state of alkanes. The regression analysis reveals a significant linear correlation of standard enthalpy of formation (ΔH fº) with ¹Xv, Vw, E and R. The equations obtained by regression analysis may be used to estimate standard enthalpy of formation (ΔH fº) of alkanes in gaseous state.

Cotton resistance to ramulose and variability of Colletotrichum gossypii f. sp. cephalosporioides

Four cultivars and 21 lines of cotton were evaluated for resistance to ramulose (Colletotrichum gossypii f. sp. cephalosporioides) in a field where the disease is endemic. The seeds of each genotype were planted in 5 x 5 m plots with three replications. The lines CNPA 94-101 and 'CNPA Precoce 2'were used as standard susceptible and resistant references, respectively. The disease incidence (DI) was calculated from the proportion of diseased plants in the plot. The disease index (DIn) was calculated from the disease severity using a 1 to 9 scale, and was evaluated at weekly intervals starting 107 days after emergence. The data collected was used to calculate the area under disease progress curve (AUDPC). In general, the DIn increased linearly with time and varied from 20.0 to 57.1 and AUDPC from 567 to 1627 among the genotypes which could be clustered in to two distinct groups. The susceptible group contained two cultivars and nine lines and the resistant group contained one cultivar and 12 lines. The relationship between disease index and evaluation times was linear for the 25 genotypes tested. The line CNPA 94-101, used as susceptible standard, was the most susceptible with an average DI = 83.4, DIn = 57.1 and AUDPC = 1627.7. The line CNPA 96-08 with DI = 37.8, DIn = 20.0 and AUDPC = 567.7 was the most resistant one. Among the commercial cultivars 'IAC 22' was the most susceptible and 'CNPA Precoce 2', used as resistant standard was the most resistant. The variability in virulence of the pathogen was studied by spray inoculating nine genotypes with conidial suspensions (10(5)/mL) of either of the 10 isolates. The disease severity was evaluated 30 days later using a scale of 1 to 5. The virulence of the isolate was expressed by DIn. All the isolates were highly virulent but their virulence avaried for several genotypes and could be clustered in two distinct groups of less and more virulent isolates. The isolate MTRM 14 from Mato Grosso was the least virulent while Minas Gerais was the most virulent, with DIn of 6.36 and 46.47, respectively. In this experiment the line HR 102 and the cultivar 'Antares' were the most resistant ones with DIns of 18.32 and 19.14, respectively.

Control of Asian soybean rust with mancozeb, a multi-site fungicide

An experiment conducted in the field the action of mancozeb, a fungicide of multi-site action was tested, to control soybean rust caused by Phakopsora pachyrhizi. Its performance was compared to that of the mixture cyproconazole (DMI) + azoxystrobin (QoI). The soybean cultivar NA 7337 RR was used with a population of 400,000 plants/ha cultivated in 20m2 plots. Treatments consisted of mancozeb levels (1.5 and 2.0 kg/ha) applied four, six and eight times. The DMI + QoI mixture was applied three times at 0.3 L/ha + Nimbus. Rust severity was assessed six times in the plots and data were integrated as the area under the disease progress curve (AUDPC). The plots were harvested and grain yield was expressed as kg/ha. Data on AUDPC and yield were subjected to analysis of variance and means compared according to Turkey's test (p = 0.005). Treatments with mancozeb were superior to DMI + QoI mixture both for rust control and grain yield. Four applications of 2.0 k/ha mancozeb were more efficient than three applications of the mixture used as standard. Mancozeb has the potential to be added to fungicide mixtures in the establishment of soybean rust anti-resistance strategy.

Turbidimetry as an alternative method to determine the rating curve of suspended sediments

Understanding hydrosedimental behavior of a watershed is essential for properly managing and using its hydric resources. The objective of this study was to verify the feasibility of the alternative procedure for the indirect determination of the sediment key curve using a turbidimeter. The research was carried out on the São Francisco Falso River, which is situated in the west of the state of Paraná on the left bank of ITAIPU reservoir. The direct method was applied using a DH-48 sediment suspended sampler. The indirect method consisted of the use of a linigraph and a turbidimeter. Based on the results obtained, it was concluded that the indirect method using a turbidimeter showed to be fully feasible, since it gave a power function-type mathematical model equal of the direct method. Furthermore, the average suspended sediment discharge into the São Francisco Falso River during the 2006/2007 harvest was calculated at 7.26 metric t day-1.

Mathematical analysis of maximum power generated by photovoltaic systems and fitting curves for standard test conditions

The rural electrification is characterized by geographical dispersion of the population, low consumption, high investment by consumers and high cost. Moreover, solar radiation constitutes an inexhaustible source of energy and in its conversion into electricity photovoltaic panels are used. In this study, equations were adjusted to field conditions presented by the manufacturer for current and power of small photovoltaic systems. The mathematical analysis was performed on the photovoltaic rural system I-100 from ISOFOTON, with power 300 Wp, located at the Experimental Farm Lageado of FCA/UNESP. For the development of such equations, the circuitry of photovoltaic cells has been studied to apply iterative numerical methods for the determination of electrical parameters and possible errors in the appropriate equations in the literature to reality. Therefore, a simulation of a photovoltaic panel was proposed through mathematical equations that were adjusted according to the data of local radiation. The results have presented equations that provide real answers to the user and may assist in the design of these systems, once calculated that the maximum power limit ensures a supply of energy generated. This real sizing helps establishing the possible applications of solar energy to the rural producer and informing the real possibilities of generating electricity from the sun.

Estudo da linfadenectomia radical comparada à linfadenectomia standard no tratamento cirúrgico do adenocarcinoma da papila de Vater

OBJETIVO: avaliar a morbidade e a mortalidade cirúrgica em pacientes submetidos a gastroduodenopancreatectomia (GDP) com linfadenectomia padrão e radical para adenocarcinoma de papila, analisando os fatores prognósticos com relação à sobrevida global e livre de doença. MÉTODOS: foram analisados retrospectivamente no período de 1999 a 2007, no Serviço de Cirurgia Abdômino-Pélvica do INCa-RJ, 50 casos de GDP para adenocarcinoma da papila duodenal divididos em dois grupos de acordo com a linfadenectomia (grupo A: linfadenectomia padrão e grupo B: linfadenectomia radical). RESULTADOS: A mediana de idade foi semelhante nos dois grupos, assim como a distribuição entre os sexos. Na comparação entre as linfadenectomias somente o número de linfonodos ressecados (grupo A: 12,3 e grupo B: 26,5) e o tempo operatório (grupo A: 421 e grupo B: 474) foram significativamente diferentes. Não ocorreram diferenças estatisticamente significativas nos dois grupos com relação a morbi-mortalidade operatória e tempo de internação. A sobrevida livre de doença (grupo A: 35 meses e grupo B: 51 meses) e sobrevida global (grupo A: 38 meses e grupo B: 53 meses) foi maior no grupo da linfadenectomia radical, porém não foram significantes estatisticamente. CONCLUSÃO: no presente estudo não ocorreram casos de linfonodos metastáticos para outros grupos nodais sem o acometimento linfonodal das cadeias pancreato-duodenais (13 e 17), sugerindo um padrão de disseminação linfonodal. Apesar da linfadenectomia radical apresentar taxas de sobrevida livre de doença e sobrevida global maiores esses dados não foram significativos estatisticamente. Novos estudos devem ser realizados para avaliar o real papel da linfadenectomia radical no adenocarcinoma da papila duodenal.

Establishment of a health and safety management system according to the OHSAS 18001 standard

The thesis develops guidelines for the implementation of the health and safety management system according to the OHSAS 18001 standard, as well as the feasible threat analysis, project proposal schedule, future system quality improvements and organizational change evaluation. The theoretical part clarifies determination of occupational health and safety, its management system, the OHSAS 18001 standard and integrated management system compounded of triple ISO 14001, ISO 9001 and OHSAS 18001 standards. The literature includes such important aspects as human factor, organizational policies, possible benefits, threats, organizational safety culture, Deming’s quality improvement cycle, system implementation, maintenance and cost matters. The empirical part demonstrates real-life situation by using Andritz Pulp & Paper Oy as a case study. Prior the thesis proposal, Andritz Group is analysed including separate business areas, acquisition and integration strategies, current status of the health and safety management and parallel experiences of the largest business area Andritz Hydro. The proposal is aimed at improving the current health and safety system for the permanent and sub-contracted employees at Andritz Pulp & Paper both in Finland and in various projects globally.

Luettelo Wanderer moottoreista, Wanderer ja Standard polkupyöristä

kuv., 16 x 25 cm

Standard motor oil autoöljyt hinnasto

kuv., 10 x 22 cm

Standard motor oil autoöljyt hinnasto

kuv., 10 x 22 cm

Standard motor oils automobiloljor prislista n:o 2

kuv., 8 x 20 cm

Standard motor oil autoöljyt hinnasto n:o 2

kuv., 8 x 20 cm

Standard tuotteita

kuv., 10 x 15 cm