A Review of Wave Makers for 3D Numerical Simulations

Numerical methods have enabled the simulation of complex problems in off-shore and marine engineering. A significant challenge in these simulations is the creation of a realistic wave field. A good numerical tank requires wave creation and absorption of waves at various locations. Several numerical wavemakers with these capabilities have been presented in the past. This paper reviews four different wave-maker methods and discusses limitations, computational efficiency, requirements on the mesh and preprocessing and complexity of implementation.

Changes in the acoustic environment alter the foraging and sheltering behaviour of the cichlid Amititlania nigrofasciata

Anthropogenic noise can affect behaviour across a wide range of species in both terrestrial and aquatic environments. However, behaviours might not be affected in isolation. Therefore, a more holistic approach investigating how environmental stressors, such as noise pollution, affect different behaviours in concert is necessary. Using tank-based noise exposure experiments, we tested how changes in the acoustic environment affect the behaviour of the cichlid Amatitlania nigrofasciata. We found that exposure to anthropogenic noise affected a couple of behaviours: an increase in sheltering was accompanied by a decrease in foraging. Our results highlight the multiple negative effects of an environmental stressor on an individual's behaviour.

Field testing a full-scale tidal turbine Part 2: In-line Wake Effects

Recent research has shown that higher ambient turbulence leads to better wake recovery, so turbines could be installed in closer proximity in real tidal flows than might be assumed from typical towing tank tests that do not take into account turbulent inflow conditions. The standard tools to assess flow velocities in field conditions are Doppler based sonar devices, such as Acoustic Doppler Profilers (ADPs) or Acoustic Doppler Velocimeters (ADVs). The use of these devices poses some challenges when assessing the wake of a tidal turbine. While ADPs allow the three-dimensional measurement of a velocity profile over a distance, the data is calculated as a mean of three diverging beams and with low temporal resolution. ADVs can measure with higher sampling frequency but only at a single point in the flow. During the MaRINET testing of the SCHOTTELSIT turbine at the QUB tidal test site in Portaferry, Northern Ireland, ADP and ADV measurements were successfully tested.Two methods were employed for measuring the wake: firstly, with a rigidly mounted ADP and secondly, with a submerged ADV which was streamed behind the turbine. This paper presents the experimental set-up and results and discusses limitations and challenges of the two methods used.

Multiloop robust H∞ control design based on the dynamic PLS approach to chemical processes

In this paper, a multiloop robust control strategy is proposed based on H∞ control and a partial least squares (PLS) model (H∞_PLS) for multivariable chemical processes. It is developed especially for multivariable systems in ill-conditioned plants and non-square systems. The advantage of PLS is to extract the strongest relationship between the input and the output variables in the reduced space of the latent variable model rather than in the original space of the highly dimensional variables. Without conventional decouplers, the dynamic PLS framework automatically decomposes the MIMO process into multiple single-loop systems in the PLS subspace so that the controller design can be simplified. Since plant/model mismatch is almost inevitable in practical applications, to enhance the robustness of this control system, the controllers based on the H∞ mixed sensitivity problem are designed in the PLS latent subspace. The feasibility and the effectiveness of the proposed approach are illustrated by the simulation results of a distillation column and a mixing tank process. Comparisons between H∞_PLS control and conventional individual control (either H∞ control or PLS control only) are also made

Predicting axial velocity profiles within a diffusing marine propeller jet

A full understanding of the hydrodynamic processes within the jet produced by a manoeuvring ship’s propeller is essential in the development and maintenance of ports, docks and harbours. In this study the predominant axial velocity component of a diffusing propeller jet was studied. The flow fields formed by four propellers, each operating at four power levels (speeds of rotation), were investigated under bollard pull conditions within a large free surface tank using Laser Doppler Anemometry. Comparison were made to existing methodologies by which a prediction of the magnitudes of the axial velocity can be made, and where deficient modifications to the methodologies have been developed. The jets were found to produce a maximum axial velocity along the initial efflux plane at a location near the blade mid-span. The position and magnitude of the axial velocity was seen to decrease as the jet entrained more flow and transitioned from the zone of flow establishment into the zone of established flow.

Interactions of cetaceans with Spanish and Portuguese fisheries in Atlantic waters : costs, benefits and implications for management

With the aim to provide new insights into operational cetacean-fishery interactions in Atlantic waters, this thesis assesses interactions of cetaceans with Spanish and Portuguese fishing vessels operating in Iberian and South West Atlantic waters. Different opportunistic research methodologies were applied, including an interview survey with fishers (mainly skippers) and onboard observations by fisheries observers and skippers, to describe different types of interactions and to identify potential hotspots for cetacean-fishery interactions and the cetacean species most involved, and to quantify the extent and the consequences of these interactions in terms of benefits and costs for cetaceans and fisheries. In addition, the suitability of different mitigation strategies was evaluated and discussed. The results of this work indicate that cetaceans interact frequently with Spanish and Portuguese fishing vessels, sometimes in a beneficial way (e.g. cetaceans indicate fish schools in purse seine fisheries), but mostly with negative consequences (depredation on catch, gear damage and cetacean bycatch). Significant economic loss and high bycatch rates are, however, only reported for certain fisheries and associated with particular cetacean species. In Galician fisheries, substantial economic loss was reported as a result of bottlenose dolphins damaging artisanal coastal gillnets, while high catch loss may arise from common dolphins scattering fish in purse seine fisheries. High cetacean bycatch mortality arises in trawl fisheries, mainly of common dolphin and particularly during trawling in water depths below 350 m, and in coastal set gillnet fisheries (mainly common and bottlenose dolphins). In large-scale bottom-set longline fisheries in South West Atlantic waters, sperm whales may significantly reduce catch rates through depredation on catch. The high diversity of cetacean-fishery interactions observed in the study area indicates that case-specific management strategies are needed to reduce negative impacts on fisheries and cetaceans. Acoustic deterrent devices (pingers) may be used to prevent small cetaceans from approaching and getting entangled in purse seines and set gillnets, although possible problems include cetacean habituation to the pinger sounds, as well as negative side effects on non-target cetaceans (habitat exclusion) and fisheries target species (reduced catch rates). For sardine and horse mackerel, target species of Iberian Atlantic fisheries, no aversive reaction to pinger sounds was detected during tank experiments conducted in the scope of this thesis. Bycatch in trawls may be reduced by the implementation of time/area restrictions of fishing activity. In addition, the avoidance of fishing areas with high cetacean abundance combined with the minimization of fishery-specific sound cues that possibly attract cetaceans, may also help to decrease interactions. In large-scale bottom-set longline fisheries, cetacean depredation on catch may be reduced by covering hooked fish with net sleeves ("umbrellas") provided that catch rates are not negatively affected by this gear modification. Trap fishing, as an alternative fishing method to bottom-set gillnetting and longlining, also has the potential to reduce cetacean bycatch and depredation, given that fish catch rates are similar to the rates obtained by bottom-set gillnets and longlines, whereas cetacean by-catch is unlikely. Economic incentives, such as the eco-certification of dolphin-safe fishing methods, should be promoted in order to create an additional source of income for fishers negatively affected by interactions with cetaceans, which, in turn, may also increase fishers’ willingness to accept and adopt mitigation measures. Although the opportunistic sampling methods applied in this work have certain restrictions concerning their reliability and precision, the results are consistent with previous studies in the same area. Moreover, they allow for the active participation of fishers that can provide important complementary ecological and technical knowledge required for cetacean management and conservation.

Algoritmos inteligentes de baixa complexidade

A domótica é uma área com grande interesse e margem de exploração, que pretende alcançar a gestão automática e autónoma de recursos habitacionais, proporcionando um maior conforto aos utilizadores. Para além disso, cada vez mais se procuram incluir benefícios económicos e ambientais neste conceito, por forma a garantir um futuro sustentável. O aquecimento de água (por meios elétricos) é um dos fatores que mais contribui para o consumo de energia total de uma residência. Neste enquadramento surge o tema “algoritmos inteligentes de baixa complexidade”, com origem numa parceria entre o Departamento de Eletrónica, Telecomunicações e Informática (DETI) da Universidade de Aveiro e a Bosch Termotecnologia SA, que visa o desenvolvimento de algoritmos ditos “inteligentes”, isto é, com alguma capacidade de aprendizagem e funcionamento autónomo. Os algoritmos devem ser adaptados a unidades de processamento de 8 bits para equipar pequenos aparelhos domésticos, mais propriamente tanques de aquecimento elétrico de água. Uma porção do desafio está, por isso, relacionada com as restrições computacionais de microcontroladores de 8 bits. No caso específico deste trabalho, foi determinada a existência de sensores de temperatura da água no tanque como a única fonte de informação externa aos algoritmos, juntamente com parâmetros pré-definidos pelo utilizador que estabelecem os limiares de temperatura máxima e mínima da água. Partindo deste princípio, os algoritmos desenvolvidos baseiam-se no perfil de consumo de água quente, observado ao longo de cada semana, para tentar prever futuras tiragens de água e, consequentemente, agir de forma adequada, adiantando ou adiando o aquecimento da água do tanque. O objetivo é alcançar uma gestão vantajosa entre a economia de energia e o conforto do utilizador (água quente), isto sem que exista necessidade de intervenção direta por parte do utilizador final. A solução prevista inclui também o desenvolvimento de um simulador que permite observar, avaliar e comparar o desempenho dos algoritmos desenvolvidos.

Propriedades de lamas de salinas de Aveiro, tendo em vista aplicações dermoterapêuticas e dermocosméticas

Desde tempos históricos que diferentes tipos de lama são utilizados para aplicações externas no corpo humano, para fins terapêuticos e cosméticos. As lamas cuja beneficiação e caracterização físico-química são apresentadas nesta dissertação são formadas no ambiente hipersalino que existe nas salinas da Troncalhada e de São Tiago da Fonte, localizadas no estuário do rio Vouga, em Aveiro, Portugal. As salinas são constituídas por uma sequência de tanques onde, no período de verão, da água do mar e por evaporação natural, se produz sal marinho que precipita no último tanque (o cristalizador) do qual é extraído. Na base dos tanques ocorrem lamas que correspondem a sedimentos constituídos por material argiloso de cor preto-cinzento e que incorporam argila, silte, areia, bioclastos, sal, matéria orgânica e gás. A componente inorgânica da lama extraída do cristalizador foi estudada por Difracção de Raios-X (DRX) e Fluorescência de Raios-X (FRX), enquanto a componente orgânica da mesma lama foi estudada por Cromatografia de Gás- Espectrometria de Massa (GC-MS). Os estudos efectuados incidiram sobre amostras representativas de lama, obtidas antes e após refinação e beneficiação a que foi submetida a lama tal-qual colhida nas salinas. Foram utilizados métodos geofísicos para caracterizar e distinguir as lamas depositadas na época de safra e no período de interregno. Para o efeito, foram cravados tubos amostradores no sedimento que reveste o fundo dos tanques, tubos que seguidamente foram transportados para o laboratório para medição da condutividade eléctrica do topo até à base da coluna de sedimento amostrado. A refinação foi efectuada por elutriação de suspensões aquosas de lama utilizando um equipamento desenvolvido para o efeito e que permitiu concentrar a lama fina no overflow. Após floculação, sifonagem da água sobrenadante, dessalinização e centrifugação a lama refinada e beneficiada pôde ser incorporada em formulações com objectivos terapêuticos e cosméticos. O estudo microbiológico efectuado nas amostras de lama com sal e sem sal e na água das salinas permitiu identificar diversos tipos de bactérias e colónias presentes na lama e avaliar também os processos de esterilização testados. Concluiu-se que a lama hipersalina ou dessalinizada resultante do processamento a que foram submetidas, não deve ser aplicada ou incorporada em formulações tal-qual, pelo facto de em ambas terem sido identificadas bactérias como é o caso de Clostridium perfringens. Não obstante, se submetidas a esterilização utilizando autoclave a lama salina refinada e beneficiada poderá ser aplicada como peloide extemporâneo. Assim sendo foram desenvolvidas formulações dermoterapêuticas e dermocosméticas contendo lama beneficiada e dessalinizada e esterilizada termicamente.

Q-enhancement with on-chip inductor optimization for reconfigurable Δ-Σ radio-frequency ADC

The paper details on-chip inductor optimization for a reconfigurable continuous-time delta-sigma (Δ-Σ) modulator based radio-frequency analog-to-digital converter. Inductor optimisation enables the Δ-Σ modulator with Q enhanced LC tank circuits employing a single high Q-factor on-chip inductor and lesser quantizer levels thereby reducing the circuit complexity for excess loop delay, power dissipation and dynamic element matching. System level simulations indicate at a Q-factor of 75 Δ- Σ modulator with a 3-level quantizer achieves dynamic ranges of 106, 82 dB and 84 dB for RFID, TETRA, and Galileo over bandwidths of 200 kHz, 10 MHz and 40 MHz respectively.

O microfitoplâncton e possível interferência no crescimento da dourada (Sparus aurata, Linnaeus, 1758) em tanques de aquacultura semi-intensiva

Dissertação de Mestrado, Biologia Marinha, Especialização em Aquacultura e Pescas, Faculdade de Ciências do Mar e do Ambiente, Universidade do Algarve, 2008

Economical and operational optimization of CALB immobilization on MP1000 for amidation of olein fatty acids with ethanolamine

Dissertação de Mestrado , Engenharia Biológica, Faculdade de Engenharia de Recursos Naturais, Universidade do Algarve, 2008

Validation of a method for the analysis of volatile organic compounds in water

Dissertação de mestrado, Qualidade em Análises, Faculdade de Ciências e Tecnologia, Universidade do Algarve, 2015

UST news

The Underground Storage Tank program at the South Carolina Department of Health and Environmental Control publishes a biannual publication of compliance, technical, and financial information to supply outreach to tank owners, contractors, and the general public.

Sistemas solares térmicos por medida: avaliação de comportamento térmico a longo prazo

Tese de mestrado integrado em Engenharia da Energia e do Ambiente, apresentada à Universidade de Lisboa, através da Faculdade de Ciências, 2014