COMPARISON OF THE BEHAVIOR OF CYCLIC AND LINEAR POLYSTYRENE IN DILUTE-SOLUTION

Using a low angle laser light scattering photometer, the second virial coefficients (A2) of both cyclic and linear polystyrene were determined in cyclohexane, toluene and methyl ethyl ketone (MEK) solutions. From the data obtained in cyclohexane solution the theta-temperature of cyclic polystyrene was determined to be 30-degrees-C. In toluene solution A2 of cyclic polystyrene is smaller than that of linear polystyrene with the same molecular weight, but in MEK the values are similar.

INVESTIGATION OF PHASE SEPARATION BEHAVIOR IN POLY (METHYL METHACRYLATE)/POLY (STYRENE-CO-ACRYLONITRILE) MIXTURES WITH PULSED NUCLEAR MAGNETIC RESONANCE

Thermally induced phase separation in the mixture of poly (methyl methacrylate) (PMMA) with poly(styrene-co-acrylonitite (SAN) has intern studied with pulsed nuclear magnetic resonance(NMR) in single spin-lattice retaxation time T-1 of the eornpatibl. mixture two T-1 corresponding to those of PM MA-rich and SAN-rich comairis. Meanwhile, both T-1 gradually changing with annealing time provides the direct evidence that the phase separation takes place with a decomposition mechanism. Diffusion coeffieient was to lac negative, indicating an uphal diffusion characteristics, The basic parameters governing its kinetics were estimated using NMR date which were in good agreement with those evaluated from time-resolved light scattering experiments for a 60/40(PMMA/SAN) mixture annealed at 180.0 degrees C.

BLENDS OF PHENOLPHTHALEIN POLY(ETHER ETHER KETONE) WITH PHENOXY AND EPOXY-RESIN

The properties of miscible phenolphthalein poly(ether ether ketone)/phenoxy (PEK-C/phenoxy) blends have been measured by dynamic mechanical analysis and tensile testing. The blends were found to have single glass transition temperatures (T(g)) that vary continuously with composition. The tensile moduli exhibit positive deviations from simple additivity. Marked positive deviations were also observed for tensile strength. The tensile strengths of the 90/10 and 75/25 PEK-C/phenoxy blends are higher than those of both the pure components. Embrittlement, or transition from the brittle to the ductile mode of failure, occurs in the composition range of 50-25 wt% PEK-C. These observations suggest that mixing on the segmental level has occurred and that there is enough interaction between the components to decrease its internal mobility significantly. PEK-C was also found to be miscible with the epoxy monomer, diglycidyl ether of bisphenol A (DGEBA), as shown by the existence of a single glass transition temperature (T(g)) within the whole composition range. Miscibility between PEK-C and DGEBA could be considered to be due mainly to entropy. However, PEK-C was judged to be immiscible with the diaminodiphenylmethane-curved epoxy resin (DDM-cured ER). It was observed that the PEK-C/ER blends have two T(g), which remain invariant with composition and are almost the same as those of the pure components, respectively. Scanning electron microscopy showed that the PEK-C/ER blends have a two-phase structure. The different miscibility with PEK-C between DGEBA and the DDM-cured ER is considered to be due to the dramatic change in the chemical and physical nature of ER after curing.

COMPATIBILIZING EFFECT OF POLY(ETHYLENE OXIDE)-B-POLYSTYRENE-B-POLY(ETHYLENE OXIDE) IN PHENOLPHTHALEIN POLY(ETHER ETHER KETONE) POLY(2,6-DIMETHYL-1,4-PHENYLENE OXIDE) BLENDS

The morphology and mechanical behaviour of phenolphthalein poly(ether ether ketone) (PEK-C)/poly(2,6-dimethyl-1,4-phenylene oxide) (PPO) blends has been investigated. A poly(ethylene oxide)-b-polystyrene-b-poly(ethylene oxide) (PEO-PS-PEO) triblock copolymer was used as compatibilizer. It was found that PEO-PS-PEO has a compatibilizing effect on the PEK-C/PPO blends. The addition of PEO-PS-PEO to the blends greatly improves phase dispersion and interfacial interfacial adhesion and also enhances the ultimate tensile strength and Young's modulus at compositions ranging from 30 to 70% PEK-C. However, all the values of the ultimate tensile strength within the whole composition range are lower than those expected by simple additivity, probably owing to the poor mechanical properties of PEO-PS-PEO copolymer.

HREM IMAGING OF POLY(ARYL-ETHER-KETONE) CRYSTAL

High resolution transmission electron microscope (HREM) was used to observe the rigid chain polymer poly(aryl-ether-ketone) (PEK), so as to study the morphology of the crystals and molecular arrangement within a crystal.Many kinds of material crystal structures have been studied with HREM in recent years. So far as polymeric materials are concerned, the application of HREM

New sphingolipids with a previously unreported 9-Methyl-C-20-sphingosine moiety from a marine algous endophytic fungus Aspergillus niger EN-13

Asperamides A (1) and B (2), a sphingolipid and their corresponding glycosphingolipid possessing a hitherto unreported 9-methyl-C-20-sphingosine moiety, were characterized from the culture extract of Aspergillus niger EN-13, an endophytic fungus isolated from marine brown alga Colpomenia sinuosa. The structures were elucidated by spectroscopic and chemical methods as (2S,2'R,3R,3'E,4E,8E)-N-(2'-hydroxy-3'-hexadecenoyl)-9-methyl-4,8-icosadien-1,3-diol (1) and 1-O-beta-D-glucopyranosyl-(2S,2'R,3R,3'E,4E,8E)-N-(2'-hydroxy-3'-hexadecenoyl)-9-methyl-4,8-icosadien-1,3-diol (2). In the antifungal assay, asperamide A (1) displayed moderate activity against Candida albicans.

Bromophenols coupled with methyl gamma-ureidobutyrate and bromophenol sulfates from the red alga Rhodomela confervoides

Four new bromophenols C-N coupled with methyl gamma-ureidobutyrate (1-4), a phenylethanol bromophenol (5), and three phenylethanol sulfate bromophenols (6-8) have been isolated from polar fractions of an ethanolic extract of the red alga Rhodomela confervoides. On the basis of spectroscopic evidence including HRMS and 2D NMR data, the structures of the new compounds were determined as methyl N'-(2,3-dibromo-4,5-dihydroxybenzyl)-gamma-ureidobutyrate (1), methyl N,N'-bis(2,3-dibromo-4,5-dihydroxybenzyl)-gamma-ureidobutyrate (2), methyl N'-[3-bromo-2-(2,3-dibromo-4,5-dihydroxybenzyl)-4,5-dihydroxybenzyl]-gamma-ureidobutyrate (3), methyl N'-(2,3-dibromo-4,5-dihydroxybenzyl)-A7-[3-bromo2-(2,3-dibromo-4,5-dihydroxybenzyl)-4,5-dihydroxybenzyl]-gamma-ureidobutyrate (4), 2,3-dibromo-4,5-dihydroxyphenylethanol (5), 2,3-dibromo-4,5-dihydroxyphenylethanol Sulfate (6), 3-bromo-4,5-dihydroxyphenylethanol sulfate (7), and 3-bromo2-(2,3-dibromo-4,5-dihydroxybenzyl)-4,5-dihydroxyphenylethanol sulfate (8). The cytotoxicity of all compounds was evaluated against several human cancer cell lines including human colon cancer (HCT-8), hepatoma (Bel7402), stomach cancer (BGC-823), lung adenocarcinoma (A549), and human ovarian cancer (A2780). Among them, the phenylethanol and the phenylethanol sulfate bromophenols (5-8) showed moderate cytotoxicity against all tested cell lines.