Hidróxido de níquel suportado em carbono: um catalisador de baixo custo para a eletro-oxidação de alcoóis em meio alcalino

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Electrodeposition of copper on titanium wires: Taguchi experimental design approach

Electrodeposition of thin copper layer was carried out on titanium wires in acidic sulphate bath. The influence of titanium surface preparation, cathodic current density, copper sulphate and sulphuric acid concentrations, electrical charge density and stirring of the solution on the adhesion of the electrodeposits was studied using the Taguchi statistical method. A L(16) orthogonal array with the six factors of control at two levels each and three interactions was employed. The analysis of variance of the mean adhesion response and signal-to-noise ratio showed the great influence of cathodic current density on adhesion. on the contrary, the other factors as well as the three investigated interactions revealed low or no significant effect. From this study optimized electrolysis conditions were defined. The copper electrocoating improved the electrical conductivity of the titanium wire. This shows that copper electrocoated titanium wires could be employed for both electrical purpose and mechanical reinforcement in superconducting magnets. (C) 2008 Elsevier B.V. All rights reserved.

Indicadores da resposta ao estresse agudo associados com a familiaridade ao ambiente e aos procedimentos de banho e tosa em cães (Canis familiaris) da raça poodle

The stress responses can be parameters used in order to identify the welfare of animals. Behavior parameters can also be regarded as means to identify their relation to stressing situations. In this study, adult male and female poodle dogs, accustomed (group 1) or not (group 2) to the environment of a bath and grooming salon were analyzed through the plasmatic concentration of cortisol, cell counting of the immune system (total leukocytes and percentage of neutrophils and lymphocytes) and through observation of changes in behavior before and after the bath and grooming service. After arriving at the kennel, the dogs were taken to the bath and grooming facility, where they had their blood samples taken and were observed for ten minutes. The subsequent procedures consisted of the bath and grooming services and the collection of another blood samples. The research results were analyzed through non-parametric statistic tests and p < 0.05. Accustomed and non-accustomed dogs presented different hormonal and behavior responses: accustomed dogs presented an increasing of the cortisol level at the second blood samples collection, thus indicating stress towards the aforementioned procedures and presenting behavior responses which can be described as moderated stress. Non-accustomed dogs presented the same cortisol levels in both first and second samples suggesting that they were already reacting to the new environment. Dogs also shown behavioral responses which can be described as acute stress. Both male and female dogs showed similar immunological changes as well as different endocrine and behavioral profiles. Concerning aggression, this study demonstrates that biting the owner can be a predicting behavior of aggression during the bath and grooming service, male dogs were more aggressive than the female, and that males were more reactive to unknown caretaker. The results of this research propose that the familiarization of the animal with the bath and grooming environment and caretaker is important to the welfare of poodle dogs, especially to that of male dogs

A simple interferometric method to measure the calibration factor and displacement amplification in piezoelectric flextensional actuators

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

A high dynamic range method for the direct readout of a dynamic phase change in homodyne interferometers

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Heterodyne Interferometry Applied to the Characterization of Acousto-Electro-Optic Light Modulators

When the electro-optic and acousto-optic effects are combined into a single device, the resulting acousto-electro-optic (AEO) modulator shows improved flexibility to overcome some limitations of the individual modulators or their cascade combinations. By using optical interferometry, it is possible to investigate the AEO modulator behavior as a function of this applied voltage. By this way, a lithium niobate AEO modulator is positioned in one of the arms of a Mach-Zehnder interferometer and operates at 62 MHz frequency, which constitutes the intermediate frequency of the heterodyne interferometer. Operating the AEO modulator in the acousto-optic small diffraction efficiency regime, the photodetected signal amplitude and phase are analyzed, and the induced phase shift, transmission curve and linearity response are obtained. The experimental results show good agreement with that expected from the coupled-mode theory. The possibility of linear control of the optical phase shift by the external voltage, from 0 to 2 p radians, is demonstrated.

Remediação de solos contaminados com diesel por lavagem com solução de tensoativos

Combating pollution of soils is a challenge that has concerned researchers from different areas and motivated the search for technologies that aim the recovery of degraded soils. Literature shows numerous processes that have been proposed with the intent of remediating soils contaminated by oils and other by-products of the oil industry, considering that the processes available have, generally, high operating costs, this work proposes a costeffective alternative to the treatment of Diesel-contaminated soils. The washing solutions were prepared using water as aqueous phase, the saponified coconut oil (OCS) as surfactant and n-butanol as co-surfactant. In this study, the soil was characterized by physical and chemical analyses. The study of diesel desorption from the soil was held in bath, using hexane and washing solutions, which had 10 and 20 wt.% active matter (AM - co-surfactant/surfactants) respectively. The study of the influence of active matter concentration and temperature in bath agitated used an experimental planning. The experiment also developed a system of percolation in bed to wash the soil and studied the influence of the concentration of active substance and volume of washing solution using an experimental planning. The optimal times to achieve hexane extraction were 30 and 180 min, while the best results using a 10% AM was 60 min and using a 20% AM was 120 min. The results of the experimental planning on bath showed that the maximum diesel removal was obtained when at a 20 wt.% of AM and under 50 °C, removing 99.92% of the oil. As for experiments in the system of percolation soil bed, the maximum diesel removal was high when the volume of the washing solution was of 5 L and the concentration of 20% AM. This experiment concluded that the concentration of AM and the temperature were vital to bath experiments for diesel removal, while in the system of percolation soil bed only concentration of AM influenced the soil remediation

Strain variability in the DNA immigration control region (ICR) of Xylella fastidiosa

The genome of the bacterium Xylella fastidiosa contains four ORFs (XF2721, XF2725, XF2739 and XF0295) related to the restriction modification type I system, ordinarily named R-M. This system belongs to the DNA immigration control region (ICR). Each CIRF is related to different operon structures, which are homologues among themselves and with subunit Hsd R from the endonuclease coding genes. In addition, these ORFs are highly homologous to genes in Pseudomonas aeruginosa, Methylococcus capsulatus str. Bath, Legionella pneumophila, Helicobacter pylori, Xanthomonas oryzae pv. Oryzae and Silicibacter pomeroyi, as well as to genes from X. fastidiosa strains that infect grapevine, almond and oleander plants. This study was carried out on R-M ORFs from forty-three X. fastidiosa strains isolated from citrus, coffee, grapevine, periwinkle, almond and plum trees, in order to assess the genetic diversity of these loci through PCR-RFLP. PCR-RFLP analysis of the four ORFs related to the R-M system from these strains enabled the detection of haplotypes for these loci. When the haplotypes were defined, wide genetic diversity and a large range of similar strains originating from different hosts were observed. This analysis also provided information indicating differences in population genetic structures, which led to detection of different levels of gene transfer among the groups of strains. (c) 2005 Elsevier SAS. All rights reserved.

Avaliação da poatencialidade da perlita natural e expandida na adsorção de metais

The contamination by metal ions has been occurring for decades through the introduction of liquid effluent not treated, mainly from industrial activities, rivers and lakes, affecting water quality. For that the effluent can be disposed in water bodies, environmental standards require that they be adequately addressed, so that the concentration of metals does not exceed the limits of standard conditions of release in the receptor. Several methods for wastewater treatment have been reported in the literature, but many of them are high cost and low efficiency. The adsorption process has been used as effective for removal of metal ions. This paper presents studies to evaluate the potential of perlite as an adsorbent for removing metals in model solution. Perlite, in its natural form (NP) and expanded (EP), was characterized by X-ray fluorescence, X-ray diffraction, surface area analysis using nitrogen adsorption (BET method), scanning electron microscopy and Fourier transform infrared spectroscopy. The physical characteristic and chemical composition of the material presented were appropriate for the study of adsorption. Adsorption experiments by the method of finite bath for model solutions of metal ions Cr3+, Cu2+, Mn2+ and Ni2+ were carried out in order to study the effect of pH, mass of the adsorbent and the contact time on removal of ions in solution. The results showed that perlite has good adsorption capacity. The NP has higher adsorption capacity (mg g-1) than the EP. According to the values of the constant of Langmuir qm (mg g-1), the maximum capacity of the monolayer was obtained and in terms of proportion of mass, we found the following order experimental adsorption: Cr3+ (2.194 mg g- 1) > Ni2+ (0.585 mg g-1) > Mn2+ (0.515 mg g-1) > Cu2+ (0.513 mg g-1) and Cr3+ (1.934 mg g-1)> Ni2+ (0.514 mg g-1) > Cu2+ (0.421 mg g-1) > Mn2+ (0.364 mg g-1) on the NP and EP, respectively. The experimental data were best fitted the Langmuir model compared to Freundlich for Cu2+, Mn2+ and Ni2+. However, for the Cr3+, both models fit the experimental data

Compreendendo a lacuna entre a prática e a evolução técnico-científica do banho no leito

Trata-se de estudo qualitativo, realizado com pacientes acamados, visando compreender a experiência da pessoa dependente da enfermagem para o banho no leito e desenvolver um modelo teórico representativo dessa experiência. Utilizou-se como referencial teórico o Interacionismo Simbólico e, como referencial metodológico, a Grounded Theory. Dos resultados emergiu o fenômeno - aprendendo a avaliar a vida e a enfermagem, ao tornar-se dependente de seus cuidados para o banho no leito. Isso possibilitou identificar a categoria central - propondo um modelo assistencial de enfermagem para o banho no leito, na perspectiva do processo avaliativo do paciente, que contrapõe a evolução técnico-científica relativa ao procedimento.

Fertilizing Capacity of Frozen Epididymal Sperm Collected from Dogs

The collection of epididymal sperm may be a valuable tool for canine reproduction especially since it can enable collection of cells after death of a valuable dog. The aim of the present study was to evaluate the viability of epididymal sperm after freeze-thawing. Epididymides were obtained from four adult dogs by elective orchiectomy. The caudal portion of the epididymides and part of the deferential ducts were squeezed by means of an anatomic clamp into a Petri dish containing either 0.9% saline solution (Group 1) or Ringer solution without lactate (Group 2). Samples were centrifuged at 800 x g for 10 min, the supernatant was removed and the pellet was diluted in one step with a Tris/citric acid/OEP (Orvus Es Paste) extender containing 7% glycerol and subjected to semen freezing. Oocytes were obtained from canine ovaries, after ovariohysterectomy. Only oocytes that were approximately 100 mu m in diameter, with a dark ooplasm surrounded by three-or four-well formed cumulus cell layers were used for sperm testing. Frozen semen samples were thawed in a water bath at 70 degrees C for 8 s and analysed at room temperature for sperm motility and velocity. Oocytes were incubated with spermatozoa in humidified atmosphere containing 5% CO(2) at 38 degrees C for 18 h. Morphological and functional characteristics of spermatozoa were similar in both groups. However, the percentage of sperm cells bound to oocytes was significantly higher in Group 2 than in Group 1. This result suggests that the Ringer solution without lactate was a more suitable medium for collecting epididymal canine sperm than 0.9% saline.

Motility and viability of ram sperm cryopreserved in a Tris-egg yolk extender supplemented with anti-oxidants

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Lipid peroxidation and generation of hydrogen peroxide in frozen-thawed ram semen cryopreserved in extenders with antioxidants

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Flexural strength of acrylic resins polymerized by different cycles

Despite the large number of studies addressing the effect of microwave polymerization on the properties of acrylic resin, this method has received limited clinical acceptance. This study evaluated the influence of microwave polymerization on the flexural strength of a denture base resin. A conventional heat-polymerized (Classico), a microwave-polymerized (Onda-Cryl) and a autopolymerizing acrylic (Jet) resins were used. Five groups were established, according to polymerization cycles: A, B and C (Onda-Cryl, short cycle - 500W/3 min, long - 90W/13 min + 500W/90 see, and manufacturing microwave cycle - 320W/3 min + OW/3 min + 720W/3 min); T(Classico, water bath cycle - 74 degrees C/9h) and Q (Jet, press chamber cycle - 50 degrees C/15 min at 2 bar). Ten specimens (65 x 10 x 3.3 mm) were prepared for each cycle. The flexural strength of the five groups was measured using a three-point bending test at a cross-head speed of 5 mm/min. Flexural strength values were analyzed by one-way ANOVA and the Tukey's test was performed to identify the groups that were significantly different at 5% level. The microwave-polymerized groups showed the highest means (p<0.05) for flexural strength (MPa) (A = 106.97 +/- 5.31; B = 107.57 +/- 3.99; C = 109.63 +/- 5.19), and there were no significant differences among them. The heat-polymerized group (T) showed the lowest flexural strength means (84.40 +/- 1.68), and differ significantly from all groups. The specimens of a microwavable denture base resin could be polymerized by different microwave cycles without risk of decreasing the flexural strength.

Effect of monomer treatment and polymerisation methods on the bond strength of resin teeth to denture base material

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)