Impacts of inorganic turbidity on diquat efficacy against Egeria densa

In clear water, diquat [6,7-dihydrodipyrido (1,2-1a:2',1'-c) pyrazinediium dibromide] provides excellent submersed Plant control at low concentrations, such as <0.5 mg active ingredient (ai) L-1: however. turbid water conditions can interfere with the activity and effectiveness of this herbicide. Little work has been done to examine what ranges of turbidity caused by different Suspended sediment types affect diquat efficacy against a target species. A growth chamber study was conducted rising diquat against the submersed macrophyte -egeria (Egeria densa Planch.) under a range Of turbid conditions. Two materials were used to create turbid beater conditions: 100% bentonite clay for a "worst-case" scenario and a natural partial-clav (20% clay). Results indicated that a high rate of diquat (2 mg ai L-1) controlled egeria under relatively low levels of turbidity (5-10 NTU) using bentonite clay: however. higher levels (25 to 50 NTU) of turbidity essentially blocked effectiveness of diquat when applied at all rates tested (0.5. 1, 2 mg ai L-1). When using a natural partial-clay sediment, rates of 1 to 2 mg ai L-1 diquat provided good control of egeria in moderately turbid water (15 NTU). Additional evaluations rising different clay types would be useful to determine the effect of inorganic turbidity oil diquat efficacy.

A Finite Element Analysis of a Crack Penetrating or Deflecting into an Interface in a Thin Laminate

The crack tip driving force of a crack growing from a pre-crack that is perpendicular to and terminating at an interface between two materials is investigated using a linear fracture mechanics theory. The analysis is performed both for a crack penetrating the interface, growing straight ahead, and for a crack deflecting into the interface. The results from finite element calculations are compared with asymptotic solutions for infinitesimally small crack extensions. The solution is found to be accurate even for fairly large amounts of crack growth. Further, by comparing the crack tip driving force of the deflected crack with that of the penetrating crack, it is shown how to control the path of the crack by choosing the adhesion of the interface relative to the material toughness.

Trace element concentrations in muscle tissue of the benthopelagic grenadier (Coryphaenoides armatus) from the Iberian deep-sea

11 specimens of Coryphaenoides armatus were collected at former dumping sites for radioactive material in the Iberian deep sea at a depth of 4700 m and their muscle tissue was analysed for four trace elements (copper, zinc, cadmium and lead) by differential pulse anodic stripping voltammetry (DPSAV). Concentrations of zinc were typical for fish muscle in general; copper content was somewhat higher than generally found in fish. The cadmium and lead contents were at a level found in fish from the open sea but the lead content of 2 specimens taken in area East-B was found to be higher.

In situ measurement of dissolved inorganic carbon speciation in natural waters, pH, pC02, TA, & TC02, Honolulu, Hawaii, February 16-18, 2005: workshop proceedings

The Alliance for Coastal Technology (ACT) convened a workshop on the in situ measurement of dissolved inorganic carbon species in natural waters in Honolulu, Hawaii, on February 16, 17, and 18, 2005. The workshop was designed to summarize existing technologies for measuring the abundance and speciation of dissolved inorganic carbon and to make strategic recommendations for future development and application of these technologies to coastal research and management. The workshop was not focused on any specific technology, however, most of the attention of the workshop was on in situ pC02 sensors given their recent development and use on moorings for the measurement of global carbon fluxes. In addition, the problems and limitations arising from the long-term deployment of systems designed for the measurement of pH, total dissolved inorganic carbon (DIC), and total alkalinity (TA) were discussed. Participants included researchers involved in carbon biogeochemistry, industry representatives, and coastal resource managers. The primary questions asked during the workshop were: I. What are the major impediments to transform presently used shipboard pC02 measurement systems for use on cost-eficient moorings? 2. What are the major technical hurdles for the in situ measurement of TA and DIC? 3. What specific information do we need to coordinate efforts for proof of concept' testing of existing and new technologies, inter-calibration of those technologies, better software development, and more precise knowledge quantzjjing the geochemistry of dissolved inoeanic carbon species in order to develop an observing system for dissolved inorganic carbon? Based on the discussion resulting from these three questions, the following statements were made: Statement No. 1 Cost-effective, self-contained technologies for making long-term, accurate measurements of the partial pressure of C02 gas in water already exist and at present are ready for deployment on moorings in coastal observing systems. Statement No. 2 Cost-effective, self-contained systems for the measurement of pH, TA, and DIC are still needed to both fully define the carbonate chemistry of coastal waters and the fluxes of carbon between major biogeochemical compartments (e.g., air-sea, shelf-slope, water column-sediment, etc.). (pdf contains 23 pages)