Safety assessment of oral photodynamic therapy in rats

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Modelagem da área foliar de duas cultivares de amendoim em função das dimensões lineares dos folíolos

The purpose of this study was to determine a shape factor to estimate area of leaflets of two peanut cultivars (IAC TATU ST, IAC RUNNER 886). Correlation studies were conducted involving real leaf area (Sf) and leaf length (C), maximum leaf width (L) and the product between C and L. For each cultivar was determined a form factor (f) by means of regression analysis between the product of the length by the width and the actual area of leaves and the correlation between leaf area estimated by the correction factor and direct measurement. All evaluated models (linear, exponential or geometric) provided good estimates of leaf area (above 87%). Linear models had the best fit, passing or not through the origin. From a practical viewpoint, it is suggested to use the linear model involving the C and L product, using a linear coefficient equal to zero, with values of factor f equal to 0.7111 and 0.7266 for IAC RUNNER 886 and IAC TATU ST, respectively. The method of dimensions is feasible for the estimation of leaf area for both peanut cultivars, for showing good r(2) values (0.97), with errors below 3%, even when used with independent data.

Differential gene expression in Acidithiobacillus ferrooxidans LR planktonic and attached cells in the presence of chalcopyrite

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Polishing for glass ceramics: Which protocol?

Purpose: The execution of adjustments on ceramic restorations is sometimes necessary for either correction of occlusion and/or inadequate contours or esthetical improvements. Clinically, the surfaces undergo weariness through fine grinding diamond burs which remove the superficial glazing layer. Several materials for ceramic polishing have been used in an attempt to reach a satisfactory surface smoothness. The aim of this study was to perform a literature review on different polishing protocols of several dental ceramics. Study selection: This is a literature review performed through scientific articles published between 2004 and 2012, indexed in MEDLINE, PubMed and Scielo databases. The study selected and analyzed a total of 20 relevant articles that evaluated different types of ceramics, polishing treatment and surface roughness.Results: After an extensive literature review, this study observed: 1 - after the rupture of the glazing layer due to the adjustments of the restorations, the best choice for the polishing of the surface will depend on the type of ceramics used; 2 - glazing procedure provide excellent results regarding to the superficial smoothness; however, if reglazing is impossible, either abrasive rubber cups/points or sandpaper discs followed by the use of diamond polishing pastes results in a satisfactory superficial smoothness; 3 - clinical studies that take into account the behavior of the protocols polishing are scarce and should be encouraged; 4 - the large number of variables influence the final outcome of polishing should be considered. Conclusions: The necessity in standardization of methodologies to enable a comparison among researches. (c) 2014 Japan Prosthodontic Society. Published by Elsevier Ireland. All rights reserved.

Bacterial and chemical leaching of chalcopyrite concentrates as affected by the redox potential and ferric/ferrous iron ratio at 22 degrees C

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Health related quality of life measure in systemic pediatric rheumatic diseases and its translation to different languages: an international collaboration

Background: Rheumatic diseases in children are associated with significant morbidity and poor health-related quality of life (HRQOL). There is no health-related quality of life (HRQOL) scale available specifically for children with less common rheumatic diseases. These diseases share several features with systemic lupus erythematosus (SLE) such as their chronic episodic nature, multi-systemic involvement, and the need for immunosuppressive medications. HRQOL scale developed for pediatric SLE will likely be applicable to children with systemic inflammatory diseases.Findings: We adapted Simple Measure of Impact of Lupus Erythematosus in Youngsters (SMILEY (c)) to Simple Measure of Impact of Illness in Youngsters (SMILY (c)-Illness) and had it reviewed by pediatric rheumatologists for its appropriateness and cultural suitability. We tested SMILY (c)-Illness in patients with inflammatory rheumatic diseases and then translated it into 28 languages. Nineteen children (79% female, n= 15) and 17 parents participated. The mean age was 12 +/- 4 years, with median disease duration of 21 months (1-172 months). We translated SMILY (c)-Illness into the following 28 languages: Danish, Dutch, French (France), English (UK), German (Germany), German (Austria), German (Switzerland), Hebrew, Italian, Portuguese (Brazil), Slovene, Spanish (USA and Puerto Rico), Spanish (Spain), Spanish (Argentina), Spanish (Mexico), Spanish (Venezuela), Turkish, Afrikaans, Arabic (Saudi Arabia), Arabic (Egypt), Czech, Greek, Hindi, Hungarian, Japanese, Romanian, Serbian and Xhosa.Conclusion: SMILY (c)-Illness is a brief, easy to administer and score HRQOL scale for children with systemic rheumatic diseases. It is suitable for use across different age groups and literacy levels. SMILY (c)-Illness with its available translations may be used as useful adjuncts to clinical practice and research.

Thermal study in solid state of Zn(II)-diclofenac complex: Behavior kinetic of dehydration, transition phase and thermal decomposition

The dehydration, thermal decomposition and transition phase stage of Zn(II)-diclofenac compoundwere studied by simultaneous TG-DTA and DSC techniques. The TG and DSC curves of this compoundwere obtained with the mass of sample of 2 and 5 mg. Additionally, DSC curves were carried out inopened and closed a-alumina pans under static and nitrogen atmosphere. The DTA and DSC curves showthat this compound possesses exothermic transition phase between 170-180 ºC, which it is irreversible(monotropic reaction). The kinetics study of this transition phase stage was evaluated by DSC undernon-isothermal conditions. The obtained data were evaluated with the isoconversional method, where thevalues of activation energy (Ea/kJmol-1) was plotted in function of the conversion degree (a). The resultsshow that due to mass sample, different activation energies were obtained. From these curves a tendencycan be seen where the plots maintain the same profile for closed lids and almost run parallel to each other.

The kinetic of mullite crystallization: Effect of water content

The kinetic of mullite crystallization from sol–gel method, with different water content, was investigated under non-isothermal conditions using DTA. The sols were obtained from Al(NO3)3.9H2O (ANN) and Si(OC2H5)4 (TEOS) mixtures by varying the water–alcohol content of the system. The crystalline phase changes were verified by X-ray diffraction (XRD). For a sample prepared using ethanol-based alkoxide solution (M0), only Al-poor mullite (p-mullite) crystallizes at 1000 °C; for the one synthesized with low water concentration (M6) Al-rich mullite (r-mullite) and spinel crystallize together; and for a sample prepared using a water-based alkoxide solution only spinel is formed. Thus, the variation of water contents during the synthesis caused great variations in the course of mullitization process. The average value of the apparent activation energy determined for p-mullite, r-mullite and spinel phase crystallization were found to be E = (899 ± 61) kJ mol−1, E = (1015 ± 272) kJ mol−1 and E = (980 ± 196) kJ mol−1, respectively. These results showed that sample M(0) was a monophasic gel, where aluminum and silicon atoms are mixed at a molecular level while sample M(100) was a diphasic gel, where silicon and aluminum atoms are distributed in a nanometric level. The fast reaction between TEOS and water molecules is responsible for this great difference in the sample's homogeneity. The kinetic model of the crystallization process was determined using Malek's procedure. It was established that the crystallization of p-mullite, r-mullite and spinel phase can be described by Šesták–Berggren autocatalytic model.

The effect of CPP-ACP and Nd:YAG laser on the bond strength of softened dentin

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Outbreak control and clinical, pathological, and epidemiological aspects and molecular characterization of a bovine herpesvirus type 5 on a feedlot farm in S(a)over-tildeo Paulo State

This paper describes the control, epidemiological, pathological, and molecular aspects of an outbreak of meningoencephalitis in calves due to bovine herpesvirus 5 at a feedlot with 540 animals in Sa (a) over tildeo Paulo State, Brazil. The introduction of new animals and contact between the resident animals and the introduced ones were most likely responsible for virus transmission. Bovine herpesvirus 1 vaccine was used, resulting in the efficacy of the outbreak control, although two bovine herpesvirus 1 positive animals, vaccinated and revaccinated, presented meningoencephalitis, thereby characterizing vaccinal failure.

Pyrolysis, combustion and oxy-combustion studies of sugarcane industry wastes and its blends

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Kinetic study of the co-firing of bagasse-sludge blends

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Hydroxyapatite and a new fibrin sealant derived from snake venom as scaffold to treatment of cranial defects in rats

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Elevated serum folic acid concentrations were associated with higher mRNA expression of DHFR gene in patients with hereditary spherocytosis

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Nicotine dependence and levels of depression and anxiety in smokers in the process of smoking cessation

Background: Depression and anxiety are psychiatric disorders that are related to tobacco use and associated with dependence, the process of cessation, lapses and relapses after quitting smoking. Objective: To analyze the association of nicotine dependence with the level of anxiety and depression in patients who are in the process of smoking cessation. Methods: Cross-sectional study conducted with patients who sought the smoking cessation program in Cuiabá/MT. All the smokers enrolled from May to August 2012, participated in this study. Four instruments were applied: Socio-demographic Questionnaire, Fagerstrom test, Beck Anxiety Inventory and Beck Depression Inventory. Following bivariate analysis, using the crude prevalence ratio, with level of significance lower than 5% (p < 0.05), having as variable outcome the nicotine dependence >= 5 (Fagerstrom). The associations with p < 0.20 were selected for robust Multiple Poisson Regression (RPa). Results: Associations of Fagerstrom >= 5 with the male sex (RP = 1.15 CI 95% 1.03-1.28); number of cigarettes/day (RP = 1,33; CI 95% 1.19-1.48); and moderate/severe level of depression (RP = 1.15; CI 95% 1.04-1.28) were found. In the final model (RPa), the following variables remained associated: male gender (RPa 1.12; CI 95% 1.01-1.24), number of cigarettes/day (RPa 1.28; CI 95% 1.15-1.43) and high level of depression (RPa 1.12; CI 95% 1.01-1.23). Discussion: High level of nicotine dependence was associated significantly with the level of depression, emphasizing the association between smoking and psychiatric comorbidities.