PHOTOLUMINESCENCE OF ORDERED GA0.5IN0.5P GROWN BY METALORGANIC VAPOR-PHASE EPITAXY

Optical properties of ordered Ga0.5In0.5P epitaxial layers grown by metalorganic vapor phase epitaxy are investigated by photoluminescence (PL) in a temperature range of 10-200 K using excitation power densities between 0.35 W/cm(2) and 20 W/cm(2). It is found that the intensity of the highest-energy PL peak of the ordered Ga0.5In0.5P epilayer decreases first, then increases and finally goes down again with increasing temperature. A model of ordered Ga0.5In0.5P epitaxial layers is proposed, in which the ordered Ga0.5In0.5P epilayer is regarded as a type-II quantum well structure with band-tail states, and the dependence of PL spectra on the temperature and excitation intensity is reasonably explained. (C) 1995 American Institute of Physics.

780nm InGaAsP/InGaP/AlGaAs高功率半导体激光器

采用MOCVD生长了InGaAsP/InGaP/AlGaAs材料系分别限制异质结构(SCH) 的高功率半导体激光器.对于厚度为10nm 的单量子阱,通过计算量子阱增益谱优化了器件的激射波长. 在室温下外延材料的荧光峰值波长为764nm,由于In原子的记忆效应(In carry-over effect)和As/P的替换作用使材料的InGaP/AlGaAs界面不陡峭,通过在InGaP/AlGaAs间长一层5nm的GaAsP大大改善了界面质量. 器件的阈值电流从界面改善前的560mA 减小到改善后的450mA, 斜率效率也从0.61W/A提高到了0.7W/A, 特别是单面最大输出功率已经从370mW 增加到了940mW,发生灾变性光学损伤时的工作电流已经由原来的1100mA 上升为1820mA.

Design and Fabrication of Thermo-Optic 4×4 Switching Matrix in Silicon-on-Insulator

A rearrangeable nonblocking thermo-optic 4×4 switching matrix,which consists of five 2×2 multimode interference-based Mach-Zehnder interferometer(MMI-MZI) switch elements，is designed and fabricated.The minimum and maximum excess loss for the matrix are 6.6 and 10.4dB,respectively.The crosstalk in the matrix is measured to be between －12 and －19.8dB.The switching speed of the matrix is less than 30μs.The power consumption for the single switch element is about 330mW.

通用可组合的组密钥交换协议

该文提出了一个通用可组合框架下的组密钥交换理想函数,并在防篡改硬件令牌的基础上,利用部分隔离状态下证据不可区分知识证明,设计了一个组密钥交换协议,安全地实现了这个理想函数.和采用CRS模型的协议相比,降低了把整个信任集中于一处带来的风险.提出的组密钥交换协议经过证明具有AKE安全,并且能够抵抗适应性敌手攻击和恶意参与者攻击.

超重核合成时的驱动势与热熔合反应截面

在双核模型框架下,双核系统生成超重复合核的机理是由双核中的弹核的核子全部转移到靶核产生的,而核子转移是由双核系统驱动势确定的.对有的反应道,核子转移与中质比变化路径之间有比较复杂的关系.原则上动力学方程与驱动势都应该是中子和质子的二维显函数.为处理方便,采用与中质比相关的核子转移路径的选择来取驱动势,得到了接近实验值的超重核合成蒸发剩余截面.

The driving potential and cross sections for synthesizing super heavy nuclei with hot fusion

The dinuclear model of the formation mechanism of a superheavy compound nucleus assumes that when all nucleons of the projectile have been transferred in to the target nucleus the compound nucleus is formed. The nucleon transfer is determined by the driving potential. For some reaction channels, the relation between nucleon transfer and the evolution path of the neutron/proton ratio is rather complicated. In principle, both the dynamical equation and the driving potential should be a twodimensional explicit function of the neutron and proton. For the sake of simplicity we calculated the driving potential by choosing the path of the nucleon transfer which is related to the nutron/proton ratio, and the calculated evaporation residue cross-sections to synthesize the superheavy nuclei are much closer to the experimental data

1,2,4-三氯苯胁迫对萌发大豆种子中活性氧的影响

以盆栽法研究了不同浓度 1,2 ,4 三氯苯 (TCB)胁迫对萌发大豆种子中活性氧代谢的影响 .结果表明 ,10 0～ 30 0 μg·g-1TCB胁迫初期 (1～ 3天 )促使萌发大豆种子呼吸强度升高及其峰值提前出现 ,超氧阴离子自由基 (O2 - )及过氧化氢 (H2 O2 )的积累显著增加 ,同时伴随丙二醛 (MDA)含量升高 ,显示发生膜脂质过氧化作用 .TCB胁迫 1～ 6天使活性氧清除酶功能紊乱 ,其中过氧化物酶 (POD)活性升高 ,超氧化物岐化酶 (SOD)活性开始上升后转为下降 .在萌发大豆种子受TCB胁迫伤害过程中 ,活性氧代谢失衡造成的膜脂质过氧化将起着重要作用 .

A 2-kW COIL with a square pipe-array JSOG and nitrogen buffer gas

A 2-kW-class chemical oxygen-iodine laser (COIL) using nitrogen buffer gas has been developed and tested since industrial applications of COIL devices will require the use of nitrogen as the buffer gas. The laser, with a gain length of 11.7 cm, is energized by a square pipe-array jet-type singlet oxygen generator (SPJSOG) and employs a nozzle bank with a designed Mach number of 2.5. The SPJSOG has advantages over the traditional plate-type JSOG in that it has less requirements on basic hydrogen peroxide (BHP) pump, and more important, it has much better operational stability. The SPJSOG without a cold trap and a gas-liquid separator could provide reliable operations for a total gas flow rate up to 450 mmol/s and with a low liquid driving pressure of around 0.7 atm or even lower. The nozzle bank was specially designed for a COIL using nitrogen as the buffer gas. The cavity was designed for a Mach number of 2.5, in order to provide a gas speed and static temperature in the cavity similar to that for a traditional COIL with helium buffer gas and a Mach 2 nozzle. An output power of 2.6 kW was obtained for a chlorine flow rate of 140 mmol/s, corresponding to a chemical efficiency of 20.4%. When the chlorine flow rate was reduced to 115 mmol/s, a higher chemical efficiency of 22.7% was attained. Measurements showed that the SPJSOG during normal operation could provide a singlet oxygen yield Y greater than or equal to 55%, a chlorine utilization U greater than or equal to 85%, and a relative water vapor concentration w = [H2O]/([O-2] + [Cl-2]) less than or equal to 0.1.