968 resultados para AC and DC conductivities
Resumo:
Technical analysis of Low Voltage Direct Current (LVDC) distribution systems shows that in LVDC transmission the customer voltage quality is higher. One of the problems in LVDC distribution networks that converters both ends of the DC line are required. Because of the converters produce not pure DC voltage, but some fluctuations as well, the huge electrolytic capacitors are required to reduce voltage distortions in the DC-side. This thesis master’s thesis is focused on calculating required DC-link capacitance for LVDC transmission and estimation of the influence of different parameters on the voltage quality. The goal is to investigate the methods of the DC-link capacitance estimation and location in the transmission line.
Resumo:
Chemical composition of leaf volatiles of Rosmarinus officinalis and Baccharis dracunculifolia cultured in Southeast of Brazil has been characterized by GC/MS after simultaneous distillation-extraction. The main components in volatiles of these species showed in common α-pinene, myrcene, 1,8 cineole and camphor. Camphor was the major component among volatiles of B. dracunculifolia and R. officinalis with concentrations exceeding 25%. B. dracunculifolia volatiles possessed more sesquiterpenes (21.4%) than R. officinalis (16.7%), such as caryophyllene (1.9%) and α-humulene (0.4%). Lower concentrations of nerolidol and spathulenol were achieved in volatiles of B. dracunculifolia. Considering both species, there was a predominance of monoterpenes.
Resumo:
Fuel cells are a promising alternative for clean and efficient energy production. A fuel cell is probably the most demanding of all distributed generation power sources. It resembles a solar cell in many ways, but sets strict limits to current ripple, common mode voltages and load variations. The typically low output voltage from the fuel cell stack needs to be boosted to a higher voltage level for grid interfacing. Due to the high electrical efficiency of the fuel cell, there is a need for high efficiency power converters, and in the case of low voltage, high current and galvanic isolation, the implementation of such converters is not a trivial task. This thesis presents galvanically isolated DC-DC converter topologies that have favorable characteristics for fuel cell usage and reviews the topologies from the viewpoint of electrical efficiency and cost efficiency. The focus is on evaluating the design issues when considering a single converter module having large current stresses. The dominating loss mechanism in low voltage, high current applications is conduction losses. In the case of MOSFETs, the conduction losses can be efficiently reduced by paralleling, but in the case of diodes, the effectiveness of paralleling depends strongly on the semiconductor material, diode parameters and output configuration. The transformer winding losses can be a major source of losses if the windings are not optimized according to the topology and the operating conditions. Transformer prototyping can be expensive and time consuming, and thus it is preferable to utilize various calculation methods during the design process in order to evaluate the performance of the transformer. This thesis reviews calculation methods for solid wire, litz wire and copper foil winding losses, and in order to evaluate the applicability of the methods, the calculations are compared against measurements and FEM simulations. By selecting a proper calculation method for each winding type, the winding losses can be predicted quite accurately before actually constructing the transformer. The transformer leakage inductance, the amount of which can also be calculated with reasonable accuracy, has a significant impact on the semiconductor switching losses. Therefore, the leakage inductance effects should also be taken into account when considering the overall efficiency of the converter. It is demonstrated in this thesis that although there are some distinctive differences in the loss distributions between the converter topologies, the differences in the overall efficiency can remain within a range of a few percentage points. However, the optimization effort required in order to achieve the high efficiencies is quite different in each topology. In the presence of practical constraints such as manufacturing complexity or cost, the question of topology selection can become crucial.
Resumo:
The aim of this study was to investigate the photosynthetic performance in populations of two legume tree species, Stryphnodendron adstringens (Mimosoideae), typical from Cerrado, and Cassia ferruginea (Caesalpinoideae) from the Atlantic Rain Forest. The photosynthetic traits were assessed by measures of chlorophyll fluorescence in progenies of naturally pollinated plants from three populations of S. adstringens and a population of C. ferruginea. Plants of S. adstringens growing under similar conditions of C. ferruginea plants demanded higher light values for photosynthesis saturation, 600 µmol.m-2.s-1 and 350 µmol.m-2.s-1 respectively, and showed higher intrinsic photosynthetic efficiency of photosystem II, Fv/Fm of 0.814 versus 0.783 in C. ferruginea. The highest values of Fv/Fm observed in S. adstringens can explain the highest electron transport rates (ETR) obtained for this species. No significant differences were found among progenies from different C. ferruginea trees nor among populations of S. adstringens, and only in few cases, variation among progenies within populations were found for S. adstringens plants. The fact that fluorescence parameters distinguished species but not populations or most of progenies may be related to low intraspecific genetic variation of these chlorophyll fluorescence traits or due to lack of expression on genetic differences in plants under no stressful conditions.
Resumo:
and glades. This species blooms throughout the year, attracting arthropods of various guilds, including herbivores, pollinators and predators. In this study, done over a two year period, we described the phenology of T. adenantha and assessed the seasonal variation in arthropod numbers of different guilds. We also determined the periods of lowest and highest seed set. T. adenantha population showed a peak in flowering in March-April (rainy season) with greater production of achenes in December-April. April and October had respectively highest and lowest number of fertilized, undamaged ovules, and this pattern is possibly related with population dynamics of pollinators and herbivores. In August, which was the period of greatest damage to the stigma (by geometrid larvae), there was a positive relationship between the proportion of unfertilized ovules and flowers with damaged stigma, suggesting that floral herbivory may affect reproduction in T. adenantha. We discuss the complex dynamics of the beneficial and harmful interactions between arthropods and the host plant.
Resumo:
The objective of this work was to study, using light and fluorescence microscopy and scanning electron microscopy, the morphology and secretory products of glandular trichomes of Cordia verbenacea DC. (Boraginaceae), known as 'baleeira', a species used in folk medicine as anti-inflammatory, analgesic, anti-ulcerogenic and healing agent. Two classes of glandular trichomes were recognized, globular and reniform. A morphological study of the secretory head and the characterization of the secretory product are also presented. Secretory products of globular trichomes consisted of essential oils, whereas reniform trichomes consisted basically of phenolic compounds such as flavonoids. No pre-established regions for releasing secretory products were found.
Resumo:
Achyrocline satureioides (Lam.) DC. (Compositae) is a medicinal herb used in Argentina, Uruguay, Brazil and Paraguay for its choleretic, antispasmodic and hepatoprotective properties. The presence of the flavonoid quercetin and its derivatives, and of different phenolic acids such as caffeic, chlorogenic and isochlorogenic acids in the aerial parts of this plant has led us to study the antioxidant activity of its extracts using different bioassays. The inhibition of luminol-enhanced chemiluminescence by the aqueous and methanolic extracts was used to show that their total reactive antioxidant potential index (TRAP; in µM Trolox equivalents) was 91.0 ± 15.4 and 128.1 ± 20.1 µM, respectively, while the total antioxidant reactivity index (TAR) was calculated to be 1537 ± 148 and 1910 ± 171 µM. Only the methanolic extract was capable of reducing iron (II)-dependent DNA damage. Lipid peroxidation was assessed by two different methods. The aqueous extract reduced hydroperoxide-initiated chemiluminescence in rat liver homogenates at all concentrations in a dose-dependent manner, with a calculated IC50 = 225 µg/ml, while the methanolic extract was only effective at higher concentrations (100 and 1000 µg/ml). Both aqueous and methanolic extracts were capable of reducing the production of thiobarbituric acid reactive substances (TBARS) in rat liver homogenates, with an IC50 >1000 µg/ml. The results obtained suggest that the extracts of A. satureioides possess significant free radical scavenging and antioxidant activity in vitro, a fact that should encourage future in vivo studies.
Resumo:
Fractionation of the EtOH extract from aerial parts of Baccharis uncinella C. DC. (Asteraceae) led to isolation of caffeic and ferulic acids, which were identified from spectroscopic and spectrometric evidence. These compounds exhibit antioxidant and anti-inflammatory properties and have been shown to be effective in the prevention/treatment of metabolic syndrome. This study investigated whether the combined treatment of caffeic and ferulic acids exhibits a more significant beneficial effect in a mouse model with metabolic syndrome. The combination treatment with caffeic and ferulic acids was tested for 60 days in C57 mice kept on a high-fat (40%) diet. The data obtained indicated that treatment with caffeic and ferulic acids prevented gain in body weight induced by the high-fat diet and improved hyperglycemia, hypercholesterolemia and hypertriglyceridemia. The expression of a number of metabolically relevant genes was affected in the liver of these animals, showing that caffeic and ferulic acid treatment results in increased cholesterol uptake and reduced hepatic triglyceride synthesis in the liver, which is a likely explanation for the prevention of hepatic steatosis. In conclusion, the combined treatment of caffeic and ferulic acids displayed major positive effects towards prevention of multiple aspects of the metabolic syndrome and liver steatosis in an obese mouse model.
Resumo:
This master’s thesis studies the case company’s current purchase invoice process and the challenges that are related to it. Like most of other master’s thesis this study consists of both theoretical- and empirical parts. The purpose of this work is to combine theoretical and empirical parts together so that the theoretical part brings value to the empirical case study. The case company’s main business is frequency converters for both low voltage AC & DC drives and medium voltage AC Drives which are used across all industries and applications. The main focus of this study is on the current invoice process modelling. When modelling the existing process with discipline and care, current challenges can be understood better. Empirical study relays heavily on interviews and existing, yet fragmented, data. This, along with own calculations and analysis, creates the foundation for the empirical part of this master’s thesis.
Resumo:
Acerola is a fruit that can be consumed in the form of juice and pulp. However, during its processing, a large amount of waste is generated (seed and bagasse). Adding value to these by-products is of great interest, since their use can enrich foods with nutrients and fiber. In this study, we performed phytochemical screening, determined the proximate and mineral composition, bioactive compounds and the technological functional properties of acerola seed flour and acerola bagasse flour. Seeds were dried in a ventilated oven at ± 45 °C and the bagasse was lyophilized. Samples were ground, stored in flasks protected from light. Phytochemical screening revealed metabolites of nutritional and pharmacological interest and no potentially toxic substances in the flours. Seed flour and bagasse flour showed high levels (g 100 g- 1 of dry matter - DM) of soluble fiber: 4.76 and 8.74; insoluble fiber: 75.76 and 28.58, and phenolic compounds: 4.73 and 10.82, respectively. The flours also showed high absorption of water, oil and emulsion stability, presenting potential for inclusion in meat products and bakery products.
Resumo:
AbstractThis study analyzed the addition of huitlacoche paste (HP) in baked tortilla chips (TC), evaluating its effects on functional, physicochemical and structural changes during processing. Two blue corn grains were nixtamalized, stone milled, air dried and milled to obtain flour; commercial blue corn flour (TM1) and commercial TC (TM2) were used as controls. Additions of 0, 3, 6 and 9% of HP were formulated; masas were prepared at 55% moisture content (MC), precooked and baked in an industrial machine. TC crispiness was influenced by grain characteristics and percentage of HP. Huitlacoche paste addition caused an increase in total dietary fiber (from 5.27 to 14.54%), total soluble phenolics content (from 17.52 to 37.60 mg GAE/100 g) and antioxidant capacity (from 6.74 to 7.98 μmol TE/g) in TC. Results suggest that tortilla chips added with huitlacoche can be an alternative to prepare this traditional edible fungus and produce healthier snacks, not fried and enriched with bioactive compounds.
Power Electronic Converters in Low-Voltage Direct Current Distribution – Analysis and Implementation
Resumo:
Over the recent years, smart grids have received great public attention. Many proposed functionalities rely on power electronics, which play a key role in the smart grid, together with the communication network. However, “smartness” is not the driver that alone motivates the research towards distribution networks based on power electronics; the network vulnerability to natural hazards has resulted in tightening requirements for the supply security, set both by electricity end-users and authorities. Because of the favorable price development and advancements in the field, direct current (DC) distribution has become an attractive alternative for distribution networks. In this doctoral dissertation, power electronic converters for a low-voltage DC (LVDC) distribution system are investigated. These include the rectifier located at the beginning of the LVDC network and the customer-end inverter (CEI) on the customer premises. Rectifier topologies are introduced, and according to the LVDC system requirements, topologies are chosen for the analysis. Similarly, suitable CEI topologies are addressed and selected for study. Application of power electronics into electricity distribution poses some new challenges. Because the electricity end-user is supplied with the CEI, it is responsible for the end-user voltage quality, but it also has to be able to supply adequate current in all operating conditions, including a short-circuit, to ensure the electrical safety. Supplying short-circuit current with power electronics requires additional measures, and therefore, the short-circuit behavior is described and methods to overcome the high-current supply to the fault are proposed. Power electronic converters also produce common-mode (CM) and radio-frequency (RF) electromagnetic interferences (EMI), which are not present in AC distribution. Hence, their magnitudes are investigated. To enable comprehensive research on the LVDC distribution field, a research site was built into a public low-voltage distribution network. The implementation was a joint task by the LVDC research team of Lappeenranta University of Technology and a power company Suur-Savon S¨ahk¨o Oy. Now, the measurements could be conducted in an actual environment. This is important especially for the EMI studies. The main results of the work concern the short-circuit operation of the CEI and the EMI issues. The applicability of the power electronic converters to electricity distribution is demonstrated, and suggestions for future research are proposed.
Resumo:
Arkit: A-D4 E1. - S. 34 tyhjä.