Effects of longer heavy vehicles on traffic congestion

Two-lane, "microscopic" (vehicle-by-vehicle) simulations of motorway traffic are developed using existing models and validated using measured data from the M25 motorway. An energy consumption model is also built in, which takes the logged trajectories of simulated vehicles as drive-cycles. The simulations are used to investigate the effects on motorway congestion and fuel consumption if "longer and/or heavier vehicles" (LHVs) were to be permitted in the UK. Baseline scenarios are simulated with traffic composed of cars, light goods vehicles and standard heavy goods vehicles (HGVs). A proportion of conventional articulated HGVs is then replaced by a smaller number of LHVs carrying the same total payload mass and volume. Four LHV configurations are investigated: an 18.75 m, 46 t longer semi-trailer (LST); 25.25 m, 50 t and 60 t B-doubles and a 34 m, 82 t A-double. Metrics for congestion, freight fleet energy consumption and car energy consumption are defined for comparing the scenarios. Finally, variation of take-up level and LHV engine power for the LST and A-double are investigated. It is concluded that: (a) LHVs should reduce congestion particularly in dense traffic, however, a low mean proportion of freight traffic on UK roads and low take-up levels will limit this effect to be almost negligible; (b) LHVs can significantly improve the energy efficiency of freight fleets, giving up to a 23% reduction in fleet energy consumption at high take-up levels; (c) the small reduction in congestion caused by LHVs could improve the fuel consumption of other road users by up to 3% in dense traffic, however in free-flowing traffic an opposite effect occurs due to higher vehicle speeds and aerodynamic losses; and (d) underpowered LHVs have potential to generate severe congestion, however current manufacturers' recommendations appear suitable. © 2013 IMechE.

A Novel Architecture of Vision Chip for Fast Traffic Lane Detection and FPGA Implementation

This paper presents a novel architecture of vision chip for fast traffic lane detection (FTLD). The architecture consists of a 32*32 SIMD processing element (PE) array processor and a dual-core RISC processor. The PE array processor performs low-level pixel-parallel image processing at high speed and outputs image features for high-level image processing without I/O bottleneck. The dual-core processor carries out high-level image processing. A parallel fast lane detection algorithm for this architecture is developed. The FPGA system with a CMOS image sensor is used to implement the architecture. Experiment results show that the system can perform the fast traffic lane detection at 50fps rate. It is much faster than previous works and has good robustness that can operate in various intensity of light. The novel architecture of vision chip is able to meet the demand of real-time lane departure warning system.

adaptive location update mechanism for network-constrained moving objects in changeful traffic conditions

Natl Chiao Tung Univ, Dept Comp Sci

Novel information sharing syntax for data sharing between police and community partners, using role-based security.

The exchange of information between the police and community partners forms a central aspect of effective community service provision. In the context of policing, a robust and timely communications mechanism is required between police agencies and community partner domains, including: Primary healthcare (such as a Family Physician or a General Practitioner); Secondary healthcare (such as hospitals); Social Services; Education; and Fire and Rescue services. Investigations into high-profile cases such as the Victoria Climbié murder in 2000, the murders of Holly Wells and Jessica Chapman in 2002, and, more recently, the death of baby Peter Connelly through child abuse in 2007, highlight the requirement for a robust information-sharing framework. This paper presents a novel syntax that supports information-sharing requests, within strict data-sharing policy definitions. Such requests may form the basis for any information-sharing agreement that can exist between the police and their community partners. It defines a role-based architecture, with partner domains, with a syntax for the effective and efficient information sharing, using SPoC (Single Point-of-Contact) agents to control in-formation exchange. The application of policy definitions using rules within these SPoCs is inspired by network firewall rules and thus define information exchange permissions. These rules can be imple-mented by software filtering agents that act as information gateways between partner domains. Roles are exposed from each domain to give the rights to exchange information as defined within the policy definition. This work involves collaboration with the Scottish Police, as part of the Scottish Institute for Policing Research (SIPR), and aims to improve the safety of individuals by reducing risks to the community using enhanced information-sharing mechanisms.

On the Convergence of Statistical Techniques for Inferring Network Traffic Demands

Accurate knowledge of traffic demands in a communication network enables or enhances a variety of traffic engineering and network management tasks of paramount importance for operational networks. Directly measuring a complete set of these demands is prohibitively expensive because of the huge amounts of data that must be collected and the performance impact that such measurements would impose on the regular behavior of the network. As a consequence, we must rely on statistical techniques to produce estimates of actual traffic demands from partial information. The performance of such techniques is however limited due to their reliance on limited information and the high amount of computations they incur, which limits their convergence behavior. In this paper we study strategies to improve the convergence of a powerful statistical technique based on an Expectation-Maximization iterative algorithm. First we analyze modeling approaches to generating starting points. We call these starting points informed priors since they are obtained using actual network information such as packet traces and SNMP link counts. Second we provide a very fast variant of the EM algorithm which extends its computation range, increasing its accuracy and decreasing its dependence on the quality of the starting point. Finally, we study the convergence characteristics of our EM algorithm and compare it against a recently proposed Weighted Least Squares approach.

Structural Analysis of Network Traffic Flows

Network traffic arises from the superposition of Origin-Destination (OD) flows. Hence, a thorough understanding of OD flows is essential for modeling network traffic, and for addressing a wide variety of problems including traffic engineering, traffic matrix estimation, capacity planning, forecasting and anomaly detection. However, to date, OD flows have not been closely studied, and there is very little known about their properties. We present the first analysis of complete sets of OD flow timeseries, taken from two different backbone networks (Abilene and Sprint-Europe). Using Principal Component Analysis (PCA), we find that the set of OD flows has small intrinsic dimension. In fact, even in a network with over a hundred OD flows, these flows can be accurately modeled in time using a small number (10 or less) of independent components or dimensions. We also show how to use PCA to systematically decompose the structure of OD flow timeseries into three main constituents: common periodic trends, short-lived bursts, and noise. We provide insight into how the various constituents contribute to the overall structure of OD flows and explore the extent to which this decomposition varies over time.

itmBench: Generalized API for Internet Traffic Managers

Internet Traffic Managers (ITMs) are special machines placed at strategic places in the Internet. itmBench is an interface that allows users (e.g. network managers, service providers, or experimental researchers) to register different traffic control functionalities to run on one ITM or an overlay of ITMs. Thus itmBench offers a tool that is extensible and powerful yet easy to maintain. ITM traffic control applications could be developed either using a kernel API so they run in kernel space, or using a user-space API so they run in user space. We demonstrate the flexibility of itmBench by showing the implementation of both a kernel module that provides a differentiated network service, and a user-space module that provides an overlay routing service. Our itmBench Linux-based prototype is free software and can be obtained from http://www.cs.bu.edu/groups/itm/.

Diagnosing Network-Wide Traffic Anomalies

Anomalies are unusual and significant changes in a network's traffic levels, which can often involve multiple links. Diagnosing anomalies is critical for both network operators and end users. It is a difficult problem because one must extract and interpret anomalous patterns from large amounts of high-dimensional, noisy data. In this paper we propose a general method to diagnose anomalies. This method is based on a separation of the high-dimensional space occupied by a set of network traffic measurements into disjoint subspaces corresponding to normal and anomalous network conditions. We show that this separation can be performed effectively using Principal Component Analysis. Using only simple traffic measurements from links, we study volume anomalies and show that the method can: (1) accurately detect when a volume anomaly is occurring; (2) correctly identify the underlying origin-destination (OD) flow which is the source of the anomaly; and (3) accurately estimate the amount of traffic involved in the anomalous OD flow. We evaluate the method's ability to diagnose (i.e., detect, identify, and quantify) both existing and synthetically injected volume anomalies in real traffic from two backbone networks. Our method consistently diagnoses the largest volume anomalies, and does so with a very low false alarm rate.