Les gasteropodes aquatiques associés aux plantes flottantes

The gasteropods sampling from roots system of floating plants Pistia striatiotes, Salvinia molesta, Salvinia nymphellula, Eichhornia crassipes, show that those biotopes are not azoic. We collected 18 species of gasteropods. The mapping of the species collected has been realized and permitted to identify three regions and three groups of gasteropods: 1 The gasteropods collected between 5° and 7° South; 2 The gasteropods collected between 8° and 10° North; 3 The widespread gasteropods. The species distribution according to latitude shows that 90% of species are found between 5° and 6° South, 65% between 6° and 7° South, 20% between 7° and 8°, 20% between 8° and 9° and 15% between 9° and 10° North.

Étude du crabe rouge profond Geryon quinquedens en Côte d'Ivoire. 2 - Éléments de biologie et d'écologie avec références aux résultats obtenus au Congo

Geryon quinquedens is present along the West African continental slope at depths from 300 to 1000 m, on silt-clay sediments. Geryon is a cold and rather poorly oxygenated water loving species. It is easily caught by traps as it is a scavenger and predatory crustacea. In a given area its distribution does not appear to be homogeneous: for example, densities of red crabs are higher in the eastern and western region of Côte d'Ivoire than in the central zone. Similar observations can be made off Congo, Angola and United States. It can be assumed that there is a relation between the abundance of Geryon and the productivity level of the area. Geographical variations of sex ratio are suspected to be correlated with the density distribution. Males and females have not the same bathymetric distribution: females are only common in the shallower waters (300-500 m) whereas males are present in the whole biotope. Seasonal migrations occur down and up the slope in both the sexes and are certainly related to the reproductive biology. Knowledge of the reproductive biology is also necessary to understand fishing-trap catch rate: egg maturation extends over several months and ovigerous females are exceptionally caught by traps; males also are less available during the same period (March to August) when migrations are less important; in this period, mean size increases and probably this happens at the end of a moult. From September to February the catch-rates increase. Growth is slow compared with other littoral Guinean Crustacea (Peneides). Females become sexually mature at a size of 80 mm (carapace width): modification in the allometric relations of abdomen and carapace are then conspicuous.

Simulation stochastique des structures démographiques. Application aux populations d'albacores, Thunnus albacares

A computer program has been written in order to generate a population of fishes following a Von Bertalanffy growth curve with a random Gaussian variability for birth dates and growth parameters K and L ∞. Standard deviations for these 3 parameters are chosen separately for each run. Fishing and natural mortalities are applied to this population. Using as an input parameters usually taken for yellowfin in the eastern Atlantic, the simulation suggests a standard deviation between 1 and 2 months for the birth dates in this population. It also indicates that increasing levels of fishing mortalities must produce a better agreement between age and length for the larger fish.

Sensitivity of wear rates in the micro-scale abrasion test to test conditions and material hardness

Micro-scale abrasion (ball cratering) tests were performed with different combinations of ball and bulk specimen materials, under different test conditions, such as load and abrasive slurry concentration. Wear modes were classified into two types: with rolling particle motion and with grooving particle motion. Wear rates observed with rolling particle motion were relatively insensitive to test conditions, whereas with grooving motion they varied much more. It is suggested that rolling abrasion is therefore a more appropriate mode if reproducible test results are desired. The motion of the abrasive particles can be reliably predicted from the knowledge of hardnesses and elastic properties of the ball and the specimen, and from the normal load and the abrasive slurry concentration. General trends in wear resistance measured in the micro-scale abrasion test with rolling particle motion are similar to those reported in tests with fixed abrasives with sliding particle motion, although the variation in wear resistance with hardness is significantly smaller. © 2004 Published by Elsevier B.V.

Sources of variability in the free-ball micro-scale abrasion test

In the 'free-ball' version of the micro-scale abrasion or ball-cratering test the rotating ball rests against a tilted sample and a grooved drive shaft. Tests under nominally identical conditions with different apparatus commonly show small but significant differences in measured wear rate. An indirect method has been developed and demonstrated for continuous on-line measurement of the coefficient of friction in the free-ball test. Experimental investigation of the effects of sample tilt angle and drive shaft groove width shows that both these factors influence the stability of the rotation of the ball, and the shape of the abrasive slurry pool, which in turn affect the coefficient of friction in the wear scar area and the measured wear rate. It is suggested that in order to improve the reproducibility of this method the geometry of the apparatus should be specified. For the apparatus used in this work with a steel ball of 25 mm diameter, a sample tilt angle of 60-75° and a shaft groove width of about 10mm provided the most stable ball motion and a wear rate which showed least variability. © 2004 Elsevier B.V. All rights reserved.

A Test of Computer-assisted Matching Using the North Pacific Humpback Whale, Megaptera novaeangliae, Tail Flukes Photograph Collection

Testing was conducted of a computer-assisted system for matching humpback whale tail flukes photographs. Trials with a 12,000-photographs database found no differences in match success between matching by computer and matching by comparing smaller catalogs ranging in size from 200 to 400 photographs. Tests with a 24,000-photographs database showed that, on average, the first match was found after examining about 130 photographs whether the photograph quality was excellent, good, or poor. Match success did not appear to be strongly related to whether the tail flukes had especially distinctive markings or pigment patterns (recognition quality). An advantage of computer-assisted matching is the ability to compare new photographs to the entire North Pacific collection, where no bias is introduced based on expectation of resightings within or between specific areas, or based on expectation of behavioral role (e.g. matching “known” females to “known” females).