Emissions from realistic operation of residential wood pellets heating systems

Emissions from residential combustion appliances vary significantly depending on the firing behaviours and combustion conditions, in addition to combustion technologies and fuel quality. Although wood pellet combustion in residential heating boilers is efficient, the combustion conditions during start-up and stop phases are not optimal and produce significantly high emissions such as carbon monoxide and hydrocarbon from incomplete combustion. The emissions from the start-up and stop phases of the pellet boilers are not fully taken into account in test methods for ecolabels which primarily focus on emissions during operation on full load and part load. The objective of the thesis is to investigate the emission characteristics during realistic operation of residential wood pellet boilers in order to identify when the major part of the annual emissions occur. Emissions from four residential wood pellet boilers were measured and characterized for three operating phases (start-up, steady and stop). Emissions from realistic operation of combined solar and wood pellet heating systems was continuously measured to investigate the influence of start-up and stop phases on total annual emissions. Measured emission data from the pellet devices were used to build an emission model to predict the annual emission factors from the dynamic operation of the heating system using the simulation software TRNSYS. Start-up emissions are found to vary with ignition type, supply of air and fuel, and time to complete the phase. Stop emissions are influenced by fan operation characteristics and the cleaning routine. Start-up and stop phases under realistic operation conditions contribute 80 – 95% of annual carbon monoxide (CO) emission, 60 – 90% total hydrocarbon (TOC), 10 – 20% of nitrogen oxides (NO), and 30 – 40% particles emissions. Annual emission factors from realistic operation of tested residential heating system with a top fed wood pelt boiler can be between 190 and 400 mg/MJ for the CO emissions, between 60 and 95 mg/MJ for the NO, between 6 and 25 mg/MJ for the TOC, between 30 and 116 mg/MJ for the particulate matter and between 2x10-13 /MJ and 4x10-13 /MJ for the number of particles. If the boiler has the cleaning sequence with compressed air such as in boiler B2, annual CO emission factor can be up to 550 mg/MJ. Average CO, TOC and particles emissions under realistic annual condition were greater than the limits values of two eco labels. These results highlight the importance of start-up and stop phases in annual emission factors (especially CO and TOC). Since a large or dominating part of the annual emissions in real operation arise from the start-up and stop sequences, test methods required by the ecolabels should take these emissions into account. In this way it will encourage the boiler manufacturers to minimize annual emissions. The annual emissions of residential pellet heating system can be reduced by optimizing the number of start-ups of the pellet boiler. It is possible to reduce up to 85% of the number of start-ups by optimizing the system design and its controller such as switching of the boiler pump after it stops, using two temperature sensors for boiler ON/OFF control, optimizing of the positions of the connections to the storage tank, increasing the mixing valve temperature in the boiler circuit and decreasing the pump flow rate. For 85 % reduction of start-ups, 75 % of CO and TOC emission factors were reduced while 13% increase in NO and 15 % increase in particle emissions was observed.

Degree projects improving co-operation between the teacher education program and schools : - Swedish experiences

In 1977, when teacher education inSwedenwas incorporated into the university system, the main reason was to transform it into an academic tradition. Now, nearly 30 years later, there is still tension between the academic and the vocational tradition; they show up as different and separated elements in a program that is meant to prepare students for a career as a teacher and for a possible future career as a researcher in this field. This tension gives rise to a risk of allowing parallel “tracks” to develop and of isolating the degree thesis work from other courses. On the teacher-training program in which we are involved, close co-operation with partner-schools, where the practical part of the program takes place, has been established. Here, the students´ degree theses are an important factor in making this co-operation work on a concrete level. Accordingly, the purpose of the degree thesis is both to reflect problems in schools and contribute to better teaching in the individual school, but also to offer relevant educational subject matter to the students, which may be adapted as an element in the university’s research environments. From these points of view, the degree thesis is an important part of teacher education and rather more than just a single course. The degree thesis should be an element that gives the students an opportunity to show that they have reached central goals in the teacher education program. It should also be an integral part in the development of critical and scholarly thinking, deepening pedagogical and didactic knowledge and giving the students an opportunity to apply research methods. We will here use two minor case studies: one that compares teacher education programs in five Swedish universities and one minor study at one of those universities, in order to elaborate on the questions: - What purpose has a degree thesis and what role does it play in teacher education? - What criteria are relevant to assessing a degree thesis and what qualities do the degree theses have? - Is it possible to assess a degree thesis fairly and what happens to students who do not pass? - How could the degree thesis be used to improve the contact between the teacher education program and its partner schools in order to contribute to the development of the individual school?

Vuxna personers upplevelse av hälsorelaterad livskvalité efter en gastric bypass operation : –En litteraturöversikt

Bakgrund: Fetma och övervikt har blivit vanligare den senaste tiden och är idag ett stort hälsoproblem över hela världen. Många har svårt att gå ner i vikt på egen hand vilket har gjort att kirurgi har blivit allt vanligare de senaste åren. Gastric bypass är idag den vanligaste kirurgiska metoden för viktminskning och har visat goda resultat. Däremot kan den hälsorelaterade livskvalitén påverkas då operationen innebär en stor livsstilsförändring. Syfte: Syftet med denna studie var att beskriva vuxna personers upplevelse av hälsorelaterad livskvalité efter en gastric bypass operation. Metod: En litteraturöversikt med 11 kvantitativa och 3 kvalitativa vetenskapliga artiklar som ligger till grund för hur vuxna personer upplever sin hälsorelaterade livskvalité efter en gastric bypass operation. Resultat: Hälsorelaterad livskvalité (HRQOL) har visat en förbättring i samtliga studier efter en gastric bypass operation. HRQOL har haft sin topp efter 1 månad i samtliga skalor utifrån SF-36 frågeformulär. Slutsats: Den stora livsstilsförändringen som personer går igenom efter en gastric bypass operationen har visat förbättringar i HRQOL på både lång och kort sikt. Bidragande faktorer som kan påverka den förbättrade hälsorelaterade livskvalitén kan bland annat vara uppfyllda förväntningar av operationen och fysisk aktivitet.

Managing respondent co-operation in Australian telephone research

Non-response to telephone surveys threatens the accuracy of the collected data and leads to increased research costs. This study examines ways in which Australian telephone research providers are combating non-response by managing the issue of respondent co-operation, including the management of the interviewers and of the survey process. The research found that many of these response-rate boosting practices proposed in the literature are not available to Australian telephone researchers, mainly for cost and regulatory reasons.

A study of train group operation multi-agent model oriented RITS

In this paper, aiming at describing interrelationships and communication mechanisms among agents based on a multi-agent framework of Railway Intelligent Transportation System (RITS), we construct the model about stations and trains in the system, which is called Agent-Oriented G-Net Train Group Operation Model (AGNTOM). The framework degrades the complexity of computation and makes the distribution of simulation system easy in design. The simulated experiments prove that the model provides an effective approach for dealing with communication problems in the system.

A scalable and robust framework for agent-based heterogeneous database operation

How to operate database efficiently and unfailingly in agent-based heterogeneous data source environment is becoming a big problem. In this paper, we contribute a framework and develop a couple of agent-oriented matchmakers with logical ring organization structure to match task agents' requests with middleware agents of databases. The middleware agent is a wrapper of a specific database and is run on the same server with the database management system. The matchmaker is of the features of proliferation and self-cancellation according to the sensory input from its environment. The ring-based coordination mechanism of matchmakers is designed. Two kinds of matchmakers, namely, host and duplicate, are designed for improving the scalability and robustness of agent-based system. The middleware agents are improved for satisfying the framework. We demonstrate the potentials of the framework by case study and present theoretical and empirical evidence that our approach is scalable and robust.

The future of Victoria's greatest asset : the coast. An independent review of the Coastal Management Act 1995 after ten years of operation

This report is in essence a critique of the Victorian Coastal Management Act 1995 (VCMA), followed by recommendations for improving the Act and its implementation. The author recognises that of course the Coastal Management Act 1995 is far from the sole piece of legislation or element of governance for Victorian coastal planning and management (see Wescott, 1988.1990,1993,1995, Birrell,1994). But the Act is the leading element of Victorian coastal governance and hence an analysis and critique of its operation after ten years, and recommendations for improvements to the Act, should enhance future coastal planning and management.

Development of an optimum factory model for a manufacturing operation through computer simulation

Often manufacturing enterprises will maintain high levels of Work In Progress (WIP) to maximise production throughput. Using computer simulation, this thesis investigates a manufacturing facility and identifies an optimal level of WIP. At this optimum throughput is maximised, manufacturing lead times are minimised, and the WIP level is significantly reduced.

Fault tolerance operation of cooperative manipulators

Autonomous or teleoperation of critical tasks in space applications require fault tolerant robotic manipulators. These manipulators are able to maintain their tasks even if a joint fails. If it is presumed that the manipulator is fault tolerant on its trajectory, then the next step is to provide a fault tolerant force at the end-effector of the manipulator. The problem of cooperative fault tolerant force is addressed in this paper within the operation of two manipulators. The cooperative manipulators are used to compensate the force jump which occurs on the force of the end-effector of one manipulator due to a joint failure. To achieve fault tolerant operation, the contribution of the faulty joint for the force of the end-effector of the faulty manipulator is required to be optimally mapped into the torque of the faulty and healthy manipulators. The optimal joint torque reconfigurations of both manipulators for compensating this force jump are illustrated. The proposed frameworks are deployed for two cooperative PUMA560 manipulators. The results of the case studies validate the fault tolerant cooperation strategies.