Table 1: Densities and snow loads for individual levels in 1967 and 1978

The deformation of a 20 m deep firn pit in the accumulation area of Kesselwandferner was surveyed over aperiod of 11 years. Six or seven surveying markers had been installed at each of 14 levels. The survey shows tImt the shear strain rate is independent of depth and the originally circular pit cross section was changed into an ellipse. In the direction of the glacier flow, the diameter was increased, the strain rate being approximately independent of depth. Transverse to the flow, however, the diameter decreased, the strain rate becoming higher as the depth increased. The vertical strain rates responsible for thinning of firn layers decrease with depth.

(Table 1) Rodent (lemming and vole) densities in 5 study areas in the Canadian Arctic

Lemmings construct nests of grass and moss under the snow during winter, and counting these nests in spring is 1 method of obtaining an index of winter density and habitat use. We counted winter nests after snow melt on fixed grids on 5 areas scattered across the Canadian Arctic and compared these nest counts to population density estimated by mark-recapture on the same areas in spring and during the previous autumn. Collared lemmings were a common species in most areas, some sites had an abundance of brown lemmings, and only 2 sites had tundra voles. Winter nest counts were correlated with lemming densities estimated in the following spring (r(s) = 0.80, P < 0.001), but less well correlated with densities the previous autumn (r(s) = 0.55, P < 0.001). Winter nest counts can be used to predict spring lemming densities with a log-log regression that explains 64% of the observed variation. Winter nest counts are best treated as an approximate index and should not be used when precise, quantitative lemming density estimates are required. Nest counts also can be used to provide general information about habitat-use in winter, predation rates by weasels, and the extent of winter breeding.

Discovery of WASP-113b and WASP-114b, two inflated hot-Jupiters with contrasting densities

We present the discovery and characterisation of the exoplanets WASP-113b and WASP-114b by the WASP survey, SOPHIE and CORALIE. The planetary nature of the systems was established by performing follow-up photometric and spectroscopic observations. The follow-up data were combined with the WASP-photometry and analysed with an MCMC code to obtain system parameters. The host stars WASP-113 and WASP-114 are very similar. They are both early G-type stars with an effective temperature of ~5900K, [Fe/H] ~0.12 and T_{eff} ~4.1 dex. However, WASP-113 is older than WASP-114. Although the planetary companions have similar radii, WASP-114b is almost 4 times heavier than WASP-113b. WASP-113b has a mass of 0.48 M_{Jup} and an orbital period of ~4.5 days; WASP-114b has a mass of 1.77 M_{Jup} and an orbital period of ~1.5 days. Both planets have inflated radii, in particular WASP-113 with a radius anomaly of Re=0.35. The high scale height of WASP-113b (~950 km ) makes it a good target for follow-up atmospheric observations.

Automatically Evolving Rotation-invariant Texture Image Descriptors by Genetic Programming

In computer vision, training a model that performs classification effectively is highly dependent on the extracted features, and the number of training instances. Conventionally, feature detection and extraction are performed by a domain-expert who, in many cases, is expensive to employ and hard to find. Therefore, image descriptors have emerged to automate these tasks. However, designing an image descriptor still requires domain-expert intervention. Moreover, the majority of machine learning algorithms require a large number of training examples to perform well. However, labelled data is not always available or easy to acquire, and dealing with a large dataset can dramatically slow down the training process. In this paper, we propose a novel Genetic Programming based method that automatically synthesises a descriptor using only two training instances per class. The proposed method combines arithmetic operators to evolve a model that takes an image and generates a feature vector. The performance of the proposed method is assessed using six datasets for texture classification with different degrees of rotation, and is compared with seven domain-expert designed descriptors. The results show that the proposed method is robust to rotation, and has significantly outperformed, or achieved a comparable performance to, the baseline methods.

Vegetative and reproductive development of shoots of different order of three maize hybrids at two contrasting population densities

p.21-32

Densities, viscosities and derived thermophysical properties of water-saturated imidazolium-based ionic liquids

In order to evaluate the impact of the alkyl side chain length and symmetry of the cation on the thermophysical properties of water-saturated ionic liquids (ILs), densities and viscosities as a function of temperature were measured at atmospheric pressure and in the (298.15 to 363.15) K temperature range, for systems containing two series of bis(trifluoromethylsulfonyl)imide-based compounds: the symmetric [C n C n im][NTf2] (with n = 1-8 and 10) and asymmetric [C n C1im][NTf2] (with n = 2-5, 7, 9 and 11) ILs. For water-saturated ILs, the density decreases with the increase of the alkyl side chain length while the viscosity increases with the size of the aliphatic tails. The saturation water solubility in each IL was further estimated with a reasonable agreement based on the densities of water-saturated ILs, further confirming that for the ILs investigated the volumetric mixing properties of ILs and water follow a near ideal behaviour. The water-saturated symmetric ILs generally present lower densities and viscosities than their asymmetric counterparts. From the experimental data, the isobaric thermal expansion coefficient and energy barrier were also estimated. A close correlation between the difference in the energy barrier values between the water-saturated and pure ILs and the water content in each IL was found, supporting that the decrease in the viscosity of ILs in presence of water is directly related with the decrease of the energy barrier.

Influence of stocking densities in the nursery phase on the growth of Macrobrachium amazonicum reared in net pens

The Amazon river prawn (Macrobrachium amazonicum) is a native species with great potential for aquaculture, based on promising results obtained from experimental culture trials in Brazil. The influence of different stocking densities on the development of prawns reared in cages in the nursery phase as well as on their growth when transferred to grow-out net pens at lower densities was evaluated. In the nursery phase, juveniles I (0.157 +/- 0.014 g, 47 days old) were stocked in 0.5 m(-2) cages at densities of 400, 800 and 1200 m(-2). After 71 days, prawns were transferred to grow-out net pens of 2.0 m(-2), at a density of 20 juveniles II m(-2). The treatments were determined by the mean weights registered for the prawns (118 days old) previously stocked at 400, 800 and 1200 juveniles I m(-2) in the nursery phase: 0.94 +/- 0.07 g (T1), 0.61 +/- 0.04 g (T2) and 0.48 +/- 0.07 g (T3), respectively. In the nursery phase, mean survival was above 96%, whereas mean weights were significantly higher (P<0.05) for the density of 400 prawns m(-2). The highest biomass (276.7 g) and productivity (1152 juveniles II m(-2)) were registered at the density of 1200 prawns m(-2), differing significantly (P<0.05) from the lower densities. One month after the transfer of the animals to the net pens, there was recovery in the specific growth rate (SGR) of prawns in all treatments which was significantly higher (P<0.05) in T3 (4.01 +/- 0.36% day(-1)) and T2 (3.60 +/- 0.18% day(-1)). The feed conversion efficiency (FCE) in the first month after the transfer was also significantly higher (P<0.05) in T3 (78.2 +/- 19.1%) when compared to T1 (39.8 +/- 9.5%). These results suggest the occurrence of a compensatory growth in M. amazonicum after transferring them to lower densities, which can point out high densities for nursery cages as a viable practice. After 277 days of grow-out phase in net pens in the cold season, survival, mean weight and biomass did not differ significantly among the treatments, indicating the viability of using net pens in stocking prawns during autumn and winter, since the minimum temperature does not drop below 17 degrees C. Influence of stocking density during the nursery phase on the grow-out of prawns was not observed. The population structure in prawns reared in net-pens was similar to that observed in earthen ponds. (C) 2012 Elsevier B.V. All rights reserved.

Effect of high densities on growth, stress response and plasma amino acid levels in senegalese sole (Solea senegalensis, Kaup 1858)

Dissertação de mest. em Aquacultura e Pescas, Faculdade de Ciências do Mar e do Ambiente, Univ. do Algarve, 2006

Transport stress in matrinxa, Brycon cephalus (Teleostei : Characidae), at different densities

Matrinxa, Brycon cephalus, is a native teleost fish from the Amazon Basin, and is of economic importance for cultivation for food and sport in Brazil. Mortality losses due to handling and transport of this stenohaline freshwater species are common. The effects of transportation at different densities on the biochemical stress responses of matrinxa (mean weight 1 kg) were examined. Fish were subjected to three different transport densities (100, 200, and 300 kg m(-3)) for four h in water with added salt (0.6%). The fish were bled at departure (baseline level), arrival (immediately after transportation) and at 24 and 96 h after arrival (recovery period). Blood glucose, cortisol, sodium, chloride, potassium and ammonia were used as stress bioindicators. No mortality was observed and no alterations in plasma cortisol were registered. However, blood glucose and ammonia levels increased and serum sodium and plasma chloride decreased on arrival for the fish transported at the highest densities. These stress responses were transient and the concentrations returned to baseline levels within 24 h. This study showed that matrinxa can be transported at densities as high as those tested in the present study, at least under the conditions employed in this study. A recovery period of at least 24 h is strongly recommended.

Acetic acid ketonization over Fe3O4/SiO2 for pyrolysis bio-oil upgrading

A family of silica supported, magnetite nanoparticle catalysts was synthesized and investigated for continuous flow acetic acid ketonization as a model pyrolysis bio-oil upgrading reaction. Physicochemical properties of Fe3O4/SiO2 catalysts were characterized by HRTEM, XAS, XPS, DRIFTS, TGA and porosimetry. Acid site densities were inversely proportional to Fe3O4 particle size, although acid strength and Lewis character were size invariant, and correlated with the specific activity for vapor phase acetic ketonization to acetone. A constant activation energy (~110 kJ.mol-1), turnover frequency (~13 h-1) and selectivity to acetone of 60 % were observed for ketonization across the catalyst series, implicating Fe3O4 as the principal active component of Red Mud waste.

Rota's universal operators and invariant subspaces in Hilbert spaces

A Hilbert space operator is called universal (in the sense of Rota) if every operator on the Hilbert space is similar to a multiple of the restriction of the universal operator to one of its invariant subspaces. We exhibit an analytic Toeplitz operator whose adjoint is universal in the sense of Rota and commutes with a quasi-nilpotent injective compact operator with dense range. In particular, this new universal operator invites an approach to the Invariant Subspace Problem that uses properties of operators that commute with the universal operator.