Multilevel high-voltage pulse generation based on a new modular solid-state switch

This paper describes a modular solid-state switching cell derived from the Marx generator concept to be used in topologies for generating multilevel unipolar and bipolar high-voltage (HV) pulses into resistive loads. The switching modular cell comprises two ON/OFF semiconductors, a diode, and a capacitor. This cell can be stacked, being the capacitors charged in series and their voltages balanced in parallel. To balance each capacitor voltage without needing any parameter measurement, a vector decision diode algorithm is used in each cell to drive the two switches. Simulation and experimental results, for generating multilevel unipolar and bipolar HV pulses into resistive loads are presented.

Carbon surfaces for the oxidative quantification of pravastatin: glassy-carbon vs. screen-printed carbon electrodes

The electrooxidative behavior of pravastatin (PRV) in aqueous media was studied by square-wave voltammetry at a glassycarbon electrode (GCE) and at a screen-printed carbon electrode (SPCE). Maximum peak current intensities in a pH 5.0 buffer were obtained at +1.3 V vs. AgCl/Ag and +1.0 V vs. Ag for the GCE and SPCE surface respectively. Validation of the developed methodologies revealed good performance characteristics and confirmed their applicability to the quantification of PRV in pharmaceutical products, without significant sample pretreatment. A comparative analysis between the two electrode types showed that SPCEs are preferred as an electrode surface because of their higher sensitivity and the elimination of the need to clean the electrode’s surface for its renewal, which frequently is, if not always, the rate-limiting step in voltammetric analysis.

Solid-State bipolar Marx modulator modeling

A mathematical model that simulates the operation of a solid-state bipolar Marx modulator topology, including the influence of parasitic capacitances is presented and discussed as a tool to analyze the circuit behavior and to assist the design engineer to select the semiconductor components and to enhance the operating performance. Simulations show good agreement with experimental results, considering a four stage circuit assembled with 1200 V isolated gate bipolar transistors and diodes, operating at 1000 V dc input voltage and 1-kHz frequency, giving 4 kV and 10-mu s output pulses into several resistive loads. Results show that parasitic capacitances between Marx cells to ground can significantly load the solid-state switches, adding new operating circuit conditions.

Hospitalization flow in the public and private systems in the state of Sao Paulo, Brazil

OBJECTIVE To describe the migration flows of demand for public and private hospital care among the health regions of the state of Sao Paulo, Brazil. METHODS Study based on a database of hospitalizations in the public and private systems of the state of Sao Paulo, Southeastern Brazil, in 2006. We analyzed data from 17 health regions of the state, considering people hospitalized in their own health region and those who migrated outwards (emigration) or came from other regions (immigration). The index of migration effectiveness of patients from both systems was estimated. The coverage (hospitalization coefficient) was analyzed in relation to the number of inpatient beds per population and the indexes of migration effectiveness. RESULTS The index of migration effectiveness applied to the hospital care demand flow allowed characterizing health regions with flow balance, with high emigration of public and private patients, and with high attraction of public and private patients. CONCLUSIONS There are differences in hospital care access and opportunities among health regions in the state of Sao Paulo, Brazil.

Spatial patterns of leprosy in a hyperendemic state in Northern Brazil, 2001-2012

ABSTRACT OBJECTIVE To describe the spatial patterns of leprosy in the Brazilian state of Tocantins. METHODS This study was based on morbidity data obtained from the Sistema de Informações de Agravos de Notificação (SINAN – Brazilian Notifiable Diseases Information System), of the Ministry of Health. All new leprosy cases in individuals residing in the state of Tocantins, between 2001 and 2012, were included. In addition to the description of general disease indicators, a descriptive spatial analysis, empirical Bayesian analysis and spatial dependence analysis were performed by means of global and local Moran’s indexes. RESULTS A total of 14,542 new cases were recorded during the period under study. Based on the annual case detection rate, 77.0% of the municipalities were classified as hyperendemic (> 40 cases/100,000 inhabitants). Regarding the annual case detection rate in < 15 years-olds, 65.4% of the municipalities were hyperendemic (10.0 to 19.9 cases/100,000 inhabitants); 26.6% had a detection rate of grade 2 disability cases between 5.0 and 9.9 cases/100,000 inhabitants. There was a geographical overlap of clusters of municipalities with high detection rates in hyperendemic areas. Clusters with high disease risk (global Moran’s index: 0.51; p < 0.001), ongoing transmission (0.47; p < 0.001) and late diagnosis (0.44; p < 0.001) were identified mainly in the central-north and southwestern regions of Tocantins. CONCLUSIONS We identified high-risk clusters for transmission and late diagnosis of leprosy in the Brazilian state of Tocantins. Surveillance and control measures should be prioritized in these high-risk municipalities.

Specialized care for people with AIDS in the state of Ceara, Brazil

OBJECTIVE To analyze if the distribution of specialized care services for HIV/AIDS is associated with AIDS rates. METHODS Ecological study, for which the distribution of 10 specialized care services in the Ceara state, Northeastern Brazil, was obtained, and the mean rates of the disease were estimated per mesoregion. We evaluated 7,896 individuals who had been diagnosed with AIDS, were aged 13 years or older, lived in Ceara, and had been informed of their condition between 2001 and 2011. Maps were constructed to verify the relationship between the distribution of AIDS cases and institutionalized support networks in the 2001-2006 and 2007-2011 periods. BoxMap and LisaMap were used for data analysis. The Voronoi diagram was applied for the distribution of the studied services. RESULTS Specialized care services concentrated in AIDS clusters in the metropolitan area. The Noroeste Cearense and west of the Sertoes Cearenses had high AIDS rates, but a low number of specialized care services over time. Two of these services were implemented where clusters of the disease exist in the second period. The application of the Voronoi diagram showed that the specialized care services located outside the metropolitan area covered a large territory. We identified one polygon that had no services. CONCLUSIONS The scenario of AIDS cases spread away from major urban areas demands the creation of social support services in areas other than the capital and the metropolitan area of the state; this can reduce access barriers to these institutions. It is necessary to create specialized care services for HIV/AIDS in the Noroeste Cearense and north of Jaguaribe.

Consistent state software transactional memory

Dissertação apresentada na Faculdade de Ciências e Tecnologia da Universidade Nova de Lisboa para a obtenção do Grau de Mestre em Engenharia Informática

Difficulties in access and estimates of public beds in intensive care units in the state of Rio de Janeiro

ABSTRACT OBJECTIVE To estimate the required number of public beds for adults in intensive care units in the state of Rio de Janeiro to meet the existing demand and compare results with recommendations by the Brazilian Ministry of Health. METHODS The study uses a hybrid model combining time series and queuing theory to predict the demand and estimate the number of required beds. Four patient flow scenarios were considered according to bed requests, percentage of abandonments and average length of stay in intensive care unit beds. The results were plotted against Ministry of Health parameters. Data were obtained from the State Regulation Center from 2010 to 2011. RESULTS There were 33,101 medical requests for 268 regulated intensive care unit beds in Rio de Janeiro. With an average length of stay in regulated ICUs of 11.3 days, there would be a need for 595 active beds to ensure system stability and 628 beds to ensure a maximum waiting time of six hours. Deducting current abandonment rates due to clinical improvement (25.8%), these figures fall to 441 and 417. With an average length of stay of 6.5 days, the number of required beds would be 342 and 366, respectively; deducting abandonment rates, 254 and 275. The Brazilian Ministry of Health establishes a parameter of 118 to 353 beds. Although the number of regulated beds is within the recommended range, an increase in beds of 122.0% is required to guarantee system stability and of 134.0% for a maximum waiting time of six hours. CONCLUSIONS Adequate bed estimation must consider reasons for limited timely access and patient flow management in a scenario that associates prioritization of requests with the lowest average length of stay.

Design state exploration applied to the development of a remote lab for projectile launch experiments

This paper describes the application of Design State Exploration techniques in the development of a remote lab for projectile motion experiments. The application was enabled by the existence of two independent teams: one composed of a series of internships that started first and another with two grantees that started a few months later. The paper presents evidence on how this approach provided gains in the development process conducted by the second team that benefited from design state exploration studies performed by the first team. This particular aspect is highlighted in relation to the work already presented in the 10th Remote Engineering and Virtual Instrumentation (REV) conference.

Solid-state sensory properties of Calix-Poly(Phenylene Ethynylene)s toward nitroaromatic explosives

This study is primarily focused in establishing the solid-state sensory abilities of several luminescent polymeric calix[4]arene-based materials toward selected nitroaromatic compounds (NACs), creating the foundations for their future application as high performance materials for detection of high explosives. The phenylene ethynylene-type polymers possessing bis-calix[4]arene scaffolds in their core were designed to take advantage of the known recognition abilities of calixarene compounds toward neutral guests, particularly in solid-state, therefore providing enhanced sensitivity and selectivity in the sensing of a given analyte. It was found that all the calix[4]arene-poly(para-phenylene ethynylene)s here reported displayed high sensitivities toward the detection of nitrobenzene, 2,4-dinitrotoluene and 2,4,6-trinitrotoluene (TNT). Particularly effective and significant was the response of the films (25-60 nm of thickness) upon exposure to TNT vapor (10 ppb): over 50% of fluorescence quenching was achieved in only 10 s. In contrast, a model polymer lacking the calixarene units showed only reduced quenching activity for the same set of analytes, clearly highlighting the relevance of the macrocyclics in promoting the signaling of the transduction event. The films exhibited high photostability (less than 0.5% loss of fluorescence intensity up to 15 min of continuous irradiation) and the fluorescence quenching sensitivity could be fully recovered after exposure of the quenched films to saturated vapors of hydrazine (the initial fluorescence intensities were usually recovered within 2-5 min of exposure to hydrazine).

Marx-Type solid-state bipolar modulator topologies: Performance comparison

The operation of generalized Marx-type solid-state bipolar modulators is discussed and compared with simplified Marx-derived circuits, to evaluate their capability to deal with various load conditions. A comparative analysis on the number of switches per cell, fiber optic trigger count, losses, and switch hold-off voltages has been made. A circuit topology is obtained as a compromise in terms of operating performance, trigger simplicity, and switching losses. A five-stage laboratory prototype of this circuit has been assembled using 1200 V insulated gate bipolar transistors (IGBTs) and diodes, operating with 1000 V dc input voltage and 1 kHz frequency, giving 5 kV bipolar pulses, with 2.5 mu s pulse width and 5 mu s relaxation time into resistive, capacitive, and inductive loads.

Modeling of a solid-state bipolar blumlein generator for N stages

This paper models an n-stage stacked Blumlein generator for bipolar pulses for various load conditions. Calculation of the voltage amplitudes in time domain at the load and between stages is described for an n-stage generator. For this, the reflection and transmission coefficients are mathematically modeled where impedance discontinuity occurs (i.e., at the junctions between two transmission lines). The mathematical model developed is assessed by comparing simulation results to experimental data from a two-stage Blumlein solid-state prototype.

On the finding of biomphalaria tenagophila naturally infected with Schistosoma mansoni in the State of Minas Gerais, Brazil

Natural infection in Biomphalaria tenagophila with Schistosoma mansoni was observed for the first time in a small area, in Jaboticatubas, in the State of Minas Gerais, Brazil. In view of this finding, the Authors decided to carry out some detailed investigations, since B. glabrata has been known as the vector snail of schistosomiasis in that State. B. tenagophila was found naturally infected throughout the investigation period (15 months). Strains of the snail and of the parasite were isolated four times, and then maintained at the laboratory through B. tenagophila — hamster passages. The possibilities of B. tenagophila to play a role in the epidemiology of the human disease in the State of Minas Gerais, in the future, are discussed.

The effect of Schistosoma mansoni infection on child morbidity in the State in Bahia, Brazil: II — Analysis at the individual level

The present investigation was carried out on a sample of 840 children (5 to 16 years old) from ten small towns of the State of Bahia in northeastern Brazil. The objetive was to study, by using a cross sectional methodology, the evolution of schistosomiasis morbidity (hepatic and splenic enlargement) in children, and the role of the intensity of S. mansoni infection in this process. The children were analised in three age groups (5 to 8, to 12 and 13 to 16 years old) and classified as uninfected, mildly infected, moderately infected and heavily infected according to the number of eggs in the stool. In children aged 5 to 8 years, increasing egg counts were not associated with increasing frequencies of hepatic or splenic enlargement. In the 9 to 12 years old group and association was observed with the prevalence of hepatic enlargement, but not with the prevalence of spleen enlargement. In the oldest group, 13 to 16 years old, an association was observed with the prevalence of enlargement of both organs. It was evident that in this population schistosomiasis morbidity develops in the early period of life as a gradual process starting with liver enlargement and followed by spleen enlargement some years later. It was found that the intensity of infection has a fundamental role in this process, although there is a latent period of some years before clinical splenomegaly appears in moderate-heavily infected children. The Authors suggest that the prevalence of splenomegaly in the 13 to 16 years old group is a good measure of the community level of schistosomiasis morbidity and could be used to measure the impact of control programs.

Leishmania mexicana in Didelphis marsupialis aurita in São Paulo State, Brazil

Foi identificada pela primeira vez a presença de L. mexicana em Didelphis marsupialis aurita, no Estado de São Paulo — Município de Conchas, através de caracterização bioquímica.