Influence of the state of the inlet endwall boundary layer on the interaction between pressure surface separation and endwall flows

This paper describes the effect of the state of the inlet boundary layer (laminar or turbulent) on the structure of the endwall flow on two different profiles of low-pressure (LP) turbine blades (solid thin and hollow thick). At present the state of the endwall boundary layer at the inlet of a real LP turbine is not known. The intention of this paper is to show that, for different designs of LP turbine, the state of the inlet boundary layer affects the performance of the blade in very different ways. The testing was completed at low speed in a linear cascade using area traversing, flow visualization and static pressure measurements. The paper shows that, for a laminar inlet boundary layer, the two profiles have a similar loss distribution and structure of endwall flow. However, for a turbulent inlet boundary layer the two profiles are shown to differ significantly in both the total loss and endwall flow structure. The pressure side separation bubble on the solid thin profile is shown to interact with the passage vortex, causing a higher endwall loss than that measured on the hollow thick profile.

Marketing of value-added products from silver carp and involvement of rural people in the production and marketing chain

Cost-profit analysis and market testing of some value-added products from silver carp such as fish mince block, fish sausage, fish ball, fish stick and fish burger were analyzed during April 2001 to March 2002. The study also explored the possibility to involve rural low-income people in the production and marketing of such products. The production of silver carp was higher in greater Jessore and Mymensingh districts but the price remained low during the peak-harvesting season in October to November. The price varied with size of the fish, season, market characteristics and effective demand of the buyers. Price of about 500 g size fish was found to be Tk. 20-25/kg in the rural markets. The average size of fish in the rural markets was 3S0-550 g while that in the urban markets it was 700-1,200 g. The cost of production of the value added products and profit margin were assessed on the basis of market price of the raw material as well as that of the finished products, transportation, storage and marketing costs. The profit margins of 34%, 39%, 81% and 31% of their sales price were obtained for fish sausage, fish ball, fish stick and fish burger, respectively. Actual production cost could be minimized if the fish is purchased directly from the farmers. Consumer's acceptance and marketability tests showed that both rural and urban people preferred fish ball than fish sausage. However, response towards the taste, flavor and color of fish ball and fish sausage was found to vary with occupations and age of the consumers. A correlation was observed between age group and acceptance of new products. Fish ball, fish stick and fish burger were found to be the most preferable items to the farmers because of easy formulation process with common utensils. Good marketing linkage and requirement of capital had been identified as the prerequisites for operating small-scale business on value-added fish products.

Time lag between catching and curing of fish and its influence on the finished product. 1. Mackerel

A study is made to determine the maximum permissible time lag both under iced and not iced storage conditions between the catching of mackerel (Rastrelliger kanagurta) and its curing, so that the quality of the finished product is within tolerable limits. Based on physical, chemical, bacteriological and taste panel studies the maximum time lag permissible is fixed as 8hrs under not iced condition and 3 days under iced condition. Icing of fish is also found to affect the tasting qualities of the finished product.

Relationship between COPD and polymorphisms of HOX-1 and mEPH in a Chinese population

Recent studies have proposed that susceptibility to chronic obstructive pulmonary disease (COPD) might be related with the polymorphisms of some genes encoding antioxidant enzymes, such as heme oxygenase-1 (HOX-1) and microsomal epoxide hydrolase (mEPH).

Absence of association between SNPs in the promoter region of the insulin-like growth factor 1 (IGF-1) gene and longevity in the Han Chinese population

Previous studies have indicated that genetic variations in the factors of insulin/insulin-like growth factor 1 (IGF-1) signaling pathway could influence human life-span by affecting IGF-1 levels. The promoter region of the IGF-1 gene is an obvious candida

Absence of association between SERPINE2 genetic polymorphisms and chronic obstructive pulmonary disease in Han Chinese: a case-control cohort study

Background: Recent studies have proposed that the serine protease inhibitor E2 (SERPINE2) was a novel susceptibility gene for chronic obstructive pulmonary disease (COPD) in Caucasians. However, this issue still remained controversial. Additional evidence

Security considerations in the design and peering of RFID discovery services

There is growing interest in Discovery Services for locating RFID and supply chain data between companies globally, to obtain product lifecycle information for individual objects. Discovery Services are heralded as a means to find serial-level data from previously unknown parties, however more realistically they provide a means to reduce the communications load on the information services, the network and the requesting client application. Attempts to design a standardised Discovery Service will not succeed unless security is considered in every aspect of the design. In this paper we clearly show that security cannot be bolted-on in the form of access control, although this is also required. The basic communication model of the Discovery Service critically affects who shares what data with whom, and what level of trust is required between the interacting parties. © 2009 IEEE.

Coupling between elytra of some beetles: Mechanism, forces and effect of surface texture

Lightweight materials, structures and coupling mechanisms are very important for realizing advanced flight vehicles. Here, we obtained the geometric structures and morphologies of the elytra of beetles and ascertained its coupling zone by using the histological section technique and SEM. We set up a three-dimensional motion observing system to monitor the opening and closing behaviour of elytra in beetles and to determine the motion mechanism. We constructed a force measuring system to measure the coupling forces between elytra. The results show that elytra open and close by rotating about a single axle, where the coupling forces may be as high as 160 times its own bodyweight, the elytra coupling with the tenon and mortise mechanism, surface texture and opening angle between elytra heavily influence the coupling forces. These results may provide insights into the design mechanism and structure for future vehicles of flight.

Evaluation and comparison of ozone, hydrogen peroxide and physical treatment on fungal infection prevention and hatching rate of Iranian sturgeon (Acipenser persicus)

Ozone due to having low half-life and devoid of environmental harmful effects is recognized as one of the most effective disinfectant and fungicide in aquaculture. The objective of this study is to consider the effects of periodicay ozonation, hydrogen peroxide treatment, and physical treatment capability in hatching rate enhancement. Three concentrations of 0.05, 0.1 and 0.15 ppm ozone (10 min) and peroxide hydrogen with dose of 500 and 1000 ppm in two procedures accompanied with physical treatment and without physical treatment were examined on hatching rate. In the first year, Egg ozonation (0.1 ppm) with physical treatment have been resulted the greatest hatching rate (81.4%). In the second year, egg treatment with 1000 ppm hydrogen peroxide with physical treatment have been showed the greatest hatching rate (78%). Average hatching rate for the blank control treatment (without disinfectin and physical treatment) was 32.7%. From the economic viewpoint, 0.05 ppm ozone with physical treatment, due to considerable minimizing at consumption energy and ozonation system retention costs, indicated as the best treatment than other ozone treatments for fungal control. Very low correlation (r=-0.14) have been observed between hatchery water temperature and fungal infection percentage in control treatment.

The purpose, costs and benefits of fish introductions: with specific reference to the great lakes of Africa

A reduction in native fish stocks and the need to increase fish production for food, recreation, ornamental purposes and to control disease vectors and weeds have often justified and led to introduction of non-native fishes. Some of these introductions have been followed by benefitial and others by undesirable consequences. For instance introduction of the Nile perch Lates niloticus L. and several tilapiine species into lakes Victoria and Kyoga, and the clupeid Limnothrissa miodon into lakes Kariba and Kivu have resulted in increases in the quantity of fish available to the people around them. Predation by Nile perch and competition with introduced tilapiine species in lakes victoria and Kyoga have caused a severe decline and in some cases total disappearance of many of the native fish species.therefore the concern about fish introductions arises

Environmental factors influencing composition, abundance and distribution of water hyacinth

Relationships between nutrient concentrations and water hyacinth biomass and composition have been studied in the shallow inshore bays of lakes Victoria, Kyoga and Albert. Additional information was obtained from Victoria Nile, Albert Nile and Kagera River. In this section, seasonal changes in nutrients and oxygen concentrations are used to explain changes in water hyacinth composition, biomass and distribution in Lake Victoria. Lake Victoria is of particular interest because it experienced strong hyacinth infestations in 1995, a sink in 1998 and resurgence in 2001. The lake has also been extensively sampled and provides time series data in nutrient, oxygen, mixing and thermal stratification which provide an opportunity to relate water hyacinth distribution and biomass to environmental factors. The possible origins and impacts of nutrient loads into Lake Victoria are also discussed in relation to water hyacinth proliferation and distribution especially in relation to known 'hot-spots'.

The morphology of decorated amyloid fibers is controlled by the conformation and position of the displayed protein.

Self-assembled structures capable of mediating electron transfer are an attractive scientific and technological goal. Therefore, systematic variants of SH3-Cytochrome b(562) fusion proteins were designed to make amyloid fibers displaying heme-b(562) electron transfer complexes. TEM and AFM data show that fiber morphology responds systematically to placement of b(562) within the fusion proteins. UV-vis spectroscopy shows that, for the fusion proteins under test, only half the fiber-borne b(562) binds heme with high affinity. Cofactor binding also improves the AFM imaging properties and changes the fiber morphology through changes in cytochrome conformation. Systematic observations and measurements of fiber geometry suggest that longitudinal registry of subfilaments within the fiber, mediated by the interaction and conformation of the displayed proteins and their interaction with surfaces, gives rise to the observed morphologies, including defects and kinks. Of most interest is the role of small molecule modulation of fiber structure and mechanical stability. A minimum complexity model is proposed to capture and explain the fiber morphology in the light of these results. Understanding the complex interplay between these factors will enable a fiber design that supports longitudinal electron transfer.