939 resultados para Si doping
Resumo:
Servicios registrales
Resumo:
Servicios registrales
Resumo:
The use of certain perfonnance enhancing substances and methods has been defined as a major ethical breach by parties involved in the governance of highperfonnance sport. As a result, elite athletes worldwide are subject to rules and regulations set out in international and national anti-doping policies. Existing literature on the development of policies such as the World Anti-Doping Code and The Canadian antiDoping Program suggests a sport system in which athletes are rarely meaningfully involved in policy development (Houlihan, 2004a). Additionally, it is suggested that this lack of involvement is reflective of a similar lack of involvement in other areas of governance concerning athletes' lives. The purpose ofthis thesis is to examine the history and current state of athletes' involvement in the anti-doping policy process in Canada's high-perfonnance sport system. It includes discussion and analysis of recently conducted interviews with those involved in the policy process as well as an analysis of relevant documents, including anti-doping policies. The findings demonstrate that Canadian athletes have not been significantly involved in the creation of recently developed antidoping policies and that a re-evaluation of current policies is necessary to more fully recognize the reality of athletes' lives in Canada's high-perfonnance sport system and their rights within that system.
Resumo:
The specific heat of single-crystal U Pd2 Si2 has been studied using both the step heating and continious heating methods for the temperature range 2 to 250 K. Successive phase transitions at Tl = 136I< and T2 = 108I< are reported, which are consistent with current publications. The transition at 40K, which was previously reported, has not been detected. Recent published elastic neutron scattering data, magnetic susceptibility and resistivity results suggest that U Pd2 Si2 may be a heavy fermion compound, however, the electronic specific heat coefficient I (= 18.97 ;~), obtained from the specific heat Cv measurements, is smaller than that of the conventional heavy fermion system. The Debye temperature of U Pd2Si2 is found to be 116.55K. The possibility is discussed that the maximum in CIT in the low-temperature range 2 to 4K corresponds to Schottky anomaly induced by localized magnetic impurities .
Resumo:
Flow injection analysis (FIA) was applied to the determination of both chloride ion and mercury in water. Conventional FIA was employed for the chloride study. Investigations of the Fe3 +/Hg(SCN)2/CI-,450 nm spectrophotometric system for chloride determination led to the discovery of an absorbance in the 250-260 nm region when Hg(SCN)2 and CI- are combined in solution, in the absence of iron(III). Employing an in-house FIA system, absorbance observed at 254 nm exhibited a linear relation from essentially 0 - 2000 Jlg ml- 1 injected chloride. This linear range spanning three orders of magnitude is superior to the Fe3+/Hg(SCN)2/CI- system currently employed by laboratories worldwide. The detection limit obtainable with the proposed method was determin~d to be 0.16 Jlg ml- 1 and the relative standard deviation was determined to be 3.5 % over the concentration range of 0-200 Jig ml- 1. Other halogen ions were found to interfere with chloride determination at 254 nm whereas cations did not interfere. This system was successfully applied to the determination of chloride ion in laboratory water. Sequential injection (SI)-FIA was employed for mercury determination in water with the PSA Galahad mercury amalgamation, and Merlin mercury fluorescence detection systems. Initial mercury in air determinations involved injections of mercury saturated air directly into the Galahad whereas mercury in water determinations involved solution delivery via peristaltic pump to a gas/liquid separator, after reduction by stannous chloride. A series of changes were made to the internal hardware and valving systems of the Galahad mercury preconcentrator. Sequential injection solution delivery replaced the continuous peristaltic pump system and computer control was implemented to control and integrate all aspects of solution delivery, sample preconcentration and signal processing. Detection limits currently obtainable with this system are 0.1 ng ml-1 HgO.
Resumo:
Gene doping is the most recent addition to the list of banned practices formulated by the World Anti-doping Agency. It is a subset of doping that utilizes the technology involved in gene therapy. The latter is still in the experimental phase but has the potential to be used as a type of medical treatment involving alterations of a patient‘s genes. I apply a pragmatic form of ethical inquiry to evaluate the application of this medical innovation in the context of sport for performance-enhancement purposes and how it will affect sport, the individual, society and humanity at large. I analyze the probable ethical implications that will emerge from such procedures in terms of values that lie at the heart of the major arguments offered by scholars on both affirmative and opposing sides of the debate on gene doping, namely fairness, autonomy and the conception of what it means to be human.
Resumo:
Dark brown sediment with clasts ranging from small to large. Clasts range from angular to sub-rounded. Lineations are abundant in this sample, along with comet structures. Grain stacks and rotation structures can also be seen in minor amounts.
Resumo:
Tesis (Maestría en Ciencias con Especialidad en Físicoquímica) UANL
Resumo:
Tesis (Maestría en Ciencias de la Ingeniería Mecánica con Especialidad en Materiales) U.A.N.L.
Resumo:
Tesis (Maestría en Ciencias de la Ingeniería Mecánica con Especialidad en Materiales) U.A.N.L.
Resumo:
Tesis (Maestría en Ciencias de la Ingeniería Mecánica con Especialidad en Materiales) U.A.N.L.
Resumo:
Tesis (Maestría en Ciencias de la Ingeniería Mecánica con Especialidad en Materiales) - U.A.N.L, 2001
Resumo:
Tesis ( Maestro en Ciencias de la Ingeniería Mecánica con Especialidad en Materiales) U.A.N.L.
Resumo:
Tesis ( Maestro en Ciencias de la Ingeniería Mecánica con Especialidad en Materiales) U.A.N.L.
Resumo:
Teis ( Maestro en Ciencias de Ingeniería Mecánica con Especialidad en materiales) U.A.N.L.