Heat and mass transfer in tubular inorganic membranes

Inorganic membranes, permeation, diffusion, heat transfer, mass transfer, axial dispersion

Regenerative action of the wall on the heat transfer for directly and indirectly heated rotary kilns

Rotary kilns, Regenerative wall, heat transfer, directly fired, indirectly fired

Möglichkeiten und Grenzen des Distance Learning am Beispiel des Alberta Distance Learning Centre in Kanada : Analyse und Transfer auf den Schulkontext Sachsen-Anhalts

Distance learning, Canadian educational system, institution, medial learning, school system Saxony-Anhalt, system theory, qualitative research

Impuls und Transfer : literarische Feldbildungsprozesse in Magdeburg im 17. und 18. Jahrhundert

Magdeburg, Univ., Fak. für Geistes-, Sozial- und Erziehungswiss., Diss., 2007

Influence of the wall on the heat transfer process in rotary kiln

Magdeburg, Univ., Fak. für Verfahrens- und Systemtechnik, Diss., 2010

Mathematical model to analyze the heat transfer in tunnel kilns for burning of ceramics

Magdeburg, Univ., Fak. für Verfahrens- und Systemtechnik, Diss., 2013

Transfer von kognitivem Training in den Alltag bei älteren Erwachsenen

Magdeburg, Univ., Fak. für Humanwiss., Diss., 2013

Analysis study of the axial transport and heat transfer of a flighted rotary drum operated at optimum loading

Magdeburg, Univ., Fak. für Verfahrens- und Systemtechnik, Diss., 2015

Development of a new method for the characterisation of bioreactors concerning heat and mass transfer

Since the specific heat transfer coefficient (UA) and the volumetric mass transfer coefficient (kLa) play an important role for the design of biotechnological processes, different techniques were developed in the past for the determination of these parameters. However, these approaches often use imprecise dynamic methods for the description of stationary processes and are limited towards scale and geometry of the bioreactor. Therefore, the aim of this thesis was to develop a new method, which overcomes these restrictions. This new approach is based on a permanent production of heat and oxygen by the constant decomposition of hydrogen peroxide in continuous mode. Since the degradation of H2O2 at standard conditions only takes place by the support of a catalyst, different candidates were investigated for their potential (regarding safety issues and reaction kinetic). Manganese-(IV)-oxide was found to be suitable. To compensate the inactivation of MnO2, a continuous process with repeated feeds of fresh MnO2 was established. Subsequently, a scale-up was successfully carried out from 100 mL to a 5 litre glass bioreactor (UniVessel®)To show the applicability of this new method for the characterisation of bioreactors, it was compared with common approaches. With the newly established technique as well as with a conventional procedure, which is based on an electrical heat source, specific heat transfer coefficients were measured in the range of 17.1 – 24.8 W/K for power inputs of about 50 – 70 W/L. However, a first proof of concept regarding the mass transfer showed no constant kLa for different dilution rates up to 0.04 h-1.Based on this, consecutive studies concerning the mass transfer should be made with higher volume flows, due to more even inflow rates. In addition, further experiments are advisable, to analyse the heat transfer in single-use bioreactors and in larger common systems.

Numerical simulation of combined heat transfer phenomena (conduction, convection, and radiation). Application to he optimisation of thermal systems

Thermal systems interchanging heat and mass by conduction, convection, radiation (solar and thermal ) occur in many engineering applications like energy storage by solar collectors, window glazing in buildings, refrigeration of plastic moulds, air handling units etc. Often these thermal systems are composed of various elements for example a building with wall, windows, rooms, etc. It would be of particular interest to have a modular thermal system which is formed by connecting different modules for the elements, flexibility to use and change models for individual elements, add or remove elements without changing the entire code. A numerical approach to handle the heat transfer and fluid flow in such systems helps in saving the full scale experiment time, cost and also aids optimisation of parameters of the system. In subsequent sections are presented a short summary of the work done until now on the orientation of the thesis in the field of numerical methods for heat transfer and fluid flow applications, the work in process and the future work.

Influence de deux milieux séquentiels pour la culture d'embryons sur la production d'hormone gonadotrophine chorionique et de progestérone par des cellules JEG-3 et BeWo [Effects of different embryo development media on hCG and progesterone release by JEG-3 and BeWo cells]

Current in vitro fertilisation (IVF) practice requires synchronisation between the¦environment of cultured oocytes and embryos and the surroundings to what they would have¦been exposed to in vivo. Commercial, sequential media follow this requirement but their exact¦composition is not available. We have compared two widely used IVF culture media systems using¦the two choriocarcinoma cell lines JEG-3 and BeWo. The two hormones hCG and progesterone¦were determined in the culture supernatants as endpoints. In both cell lines, but in a more¦pronounced way in JEG-3, progesterone rather than hCG production was stimulated, and a¦higher hormone release was observed in the fertilisation than in the cleavage media. Differences¦between manufacturers were small and did not favour one system over the other. We conclude¦that both sequential media systems can be equally well used in current IVF laboratory practice.¦© 2012 Elsevier Masson SAS. All rights reserved.

Patterns of oxygen consumption during establishment of cephalocaudal polarity in the early chick embryo.

Oxygen uptake was studied during the establishment of cephalocaudal polarity in the very early chick embryo, i.e., 10 hr before (stage VI) and at laying (stage X). Oxygen fluxes in minute regions of the intact blastoderms were measured in vitro by scanning microspectrophotometry in the presence or absence of glucose. The oxygen consumption of the whole blastoderm remained constant (6 nmol O2 X hr-1) throughout the period studied, although the number of cells increased more than twofold. The regional oxygen fluxes varied from 0.41 to 1.13 nmol O2 X hr-1 X mm-2 at stage VI and from 0.42 to 0.70 nmol O2 X hr-1 X mm-2 at stage X. At stage VI, the oxygen flux in the center of the blastoderm was significantly higher than that in its periphery. This pattern remained evident when the values were corrected for cell number or for cytoplasmic volume. At stage X, there was a tendency for the oxygen fluxes to decrease from the posterior to the anterior regions of the area pellucida. Thus the pattern of oxidative metabolism in the late uterine embryos seems to change from radial to bilateral. This change of symmetry probably reflects the process of formation of the embryonic axis. In addition, the fact that the oxygen uptake was similar in the presence or absence of glucose suggests that early chick embryos metabolize essentially intracellular stores.

Role of a mouse monoclonal IgE antibody in passive transfer of immunity to Schistosoma japonicum infection

We have been able to produce a mouse monoclonal IgE antibody specific to an adult worm antigen extracted from Schistosoma japonicum (Sj). The antibody was able to elicit passive cutaneous anaphylaxis in the rat skin against Sj with the highest titer of 1:256,000 but did not cross-react with S. mansoni antigen. The antibody recognized a 97-kDa molecule expressed on the surface of mechanically transformed schistosoma of S. japonicum. Passive transfer of the antibody into mice in the early stage of challenge infection resulted in a partial but significant reduction of recovery of adult worms. Induction of eosinophilia by an oral administration of embryonated eggs of Toxocara canis prior to challenge infection enhanced the reduction.

Food availability affects the maternal transfer of androgens and antibodies into eggs of a colonial seabird.

Mothers can improve the quality of their offspring by increasing the level of certain components in their eggs. To examine whether or not mothers increase deposition of such components in eggs as a function of food availability, we food-supplemented black-legged kittiwake females (Rissa tridactyla) before and during egg laying and compared deposition of androgens and antibodies into eggs of first and experimentally induced replacement clutches. Food-supplemented females transferred lower amounts of androgens and antibodies into eggs of induced replacement clutches than did non-food-supplemented mothers, whereas first clutches presented no differences between treatments. Our results suggest that when females are in lower condition, they transfer more androgens and antibodies into eggs to facilitate chick development despite potential long-term costs for juveniles. Females in prime condition may avoid these potential long-term costs because they can provide their chicks with more and higher quality resources.

Transfer of ultrasmall iron oxide nanoparticles from human brain-derived endothelial cells to human glioblastoma cells.

Nanoparticles (NPs) are being used or explored for the development of biomedical applications in diagnosis and therapy, including imaging and drug delivery. Therefore, reliable tools are needed to study the behavior of NPs in biological environment, in particular the transport of NPs across biological barriers, including the blood-brain tumor barrier (BBTB), a challenging question. Previous studies have addressed the translocation of NPs of various compositions across cell layers, mostly using only one type of cells. Using a coculture model of the human BBTB, consisting in human cerebral endothelial cells preloaded with ultrasmall superparamagnetic iron oxide nanoparticles (USPIO NPs) and unloaded human glioblastoma cells grown on each side of newly developed ultrathin permeable silicon nitride supports as a model of the human BBTB, we demonstrate for the first time the transfer of USPIO NPs from human brain-derived endothelial cells to glioblastoma cells. The reduced thickness of the permeable mechanical support compares better than commercially available polymeric supports to the thickness of the basement membrane of the cerebral vascular system. These results are the first report supporting the possibility that USPIO NPs could be directly transferred from endothelial cells to glioblastoma cells across a BBTB. Thus, the use of such ultrathin porous supports provides a new in vitro approach to study the delivery of nanotherapeutics to brain cancers. Our results also suggest a novel possibility for nanoparticles to deliver therapeutics to the brain using endothelial to neural cells transfer.