A study on stratification of concentration in crystal-growth of alpha-liio3 by holographic-interferometry

A new thermoplastic-photoconductor laser holographic recording system has been used for real-time and in situ observation of alpha-LiIO3 crystal growth. The influence of crystallization-driven convection on the concentration stratification in solution has been studied under gravity field. It is found that the stratification is closely related to the seed orientation of alpha-LiIO3 crystal. When the optical axis of crystal seed C is parallel to the gravity vector g, the velocity of the concentration stratification is two times larger than that in the case of C perpendicular-to g. It needs 40 h for the crystalline system of alpha-LiIO3 to reach stable concentration distribution (expressed as tau) at 47.6-degrees-C. The time tau is not sensitive to the seed orientation. Our results provide valuable data for designing the crystal growth experiments ia space.

Ce：Mn：LiNbO3晶体紫外记录研究

采用紫外光作记录光在Ce：Mn：LiNbO3晶体中实现非挥发全息记录，灵敏度可达0．0803cm／J，衍射效率（固定）为5．07％，比采用红光为记录光，紫外光为敏化光的非挥发双中心记录方案均提高了50多倍。分析表明，采用紫外光作为记录光，深能级电子被激发比例极大提高，参与光折变过程的电子平均运动周期变短．提高了衍射效率和灵敏度；深浅能级电子光栅的同相位，使得固定空间电荷场变强。文中还研究了退火对记录性能的影响。

LiNbO3：Fe：Ni晶体非挥发全息存储研究

采用三种不同的双光记录方案进行了LiNbO3：Fe：Ni晶体全息存储实验．详细研究了饱和衍射效率、固定衍射效率、动态范围和记录灵敏度，以及退火条件对记录的影响。结果表明，氧化LiNbO3：Fe：Ni晶体的饱和衍射效率、固定衍射效率和记录灵敏度比其他报道的双掺杂LiNbO3晶体高。结合掺杂能级图，理论分析了LiNbO3双掺杂晶体深陷阱中心能级的相对位置及其微观光学参量对全息记录性能的影响。LiNbO3：Fe：Ni晶体有望成为一种新的高效率非挥发全息存储材料。

Prescription for optimizing holograms in LiNbO3 : Fe : Mn

The photorefractive holographic dynamics of grating formation in photochromic doubly doped LiNbO3:Fe:Mn crystal is studied numerically and analytically in terms of the two-center model of Kukhtarev Et al. [Ferroelectrics 22, 949 (1979)]. The relations among the recorded and fixed space-charge fields and the doping densities, the oxidation-reduction states of the fields, and the intensities of UV-sensitizing and red recording beams are studied. Important conditions and effects are feued, and an optimal prescription for material doping and oxidation-reduction processing is suggested in which the crystal can be strongly oxidized and the Mn-doping density is smaller than the Fe-doping density. (C) 2000 Optical Society of America. OCIS codes: 050.7330, 190.5330, 090.2900.

Effect of microcosmic optical parameters of dopants on the signal-to-noise ratio in doubly doped LiNbO3 crystals

We propose a united theory that describes the two-center recording system by taking scattering noise into account. The temporal evolution of the signal-to-noise ratio in doubly doped photorefractive crystals is described based on jointly solving material equations and coupled-wave equations with the fourth-order Runge-Kutta method. Roles of microcosmic optical parameters of dopants on the signal-to-noise ratio are discussed in detail. The theoretical results can confirm and predict experimental results. (c) 2005 Elsevier GmbH. All rights reserved.

采用紫外光提高双掺杂铌酸锂晶体中全息记录的灵敏度和光栅强度

提出了一种在双掺杂铌酸锂晶体中用调制的双紫外光进行非挥发全息记录的方法。与通常的用紫外光敏化的非挥发全息记录相比，这种方法可以大幅度地提高光栅强度和记录灵敏度。联立双中心物质方程和双光束耦合波方程，数值分析了光栅强度和衍射效率随时间的变化并讨论了掺杂浓度和记录光强对紫外光非挥发全息记录机制下光折变效应的影响。研究发现，紫外光记录得到的深浅中心的光栅具有相同的相位，总的光栅（深浅中心光栅的叠加）强度为两光栅强度之和，固定过程中深中心的光栅得到增强；增大深浅中心掺杂的浓度可以提高光栅强度，增大记录紫外光的光强

Wideband two-port beam splitter of a binary fused-silica phase grating

The usual beam splitter of multilayer-coated film with a wideband spectrum is not easy to achieve. We describe the realization of a wideband transmission two-port beam splitter based on a binary fused-silica phase grating. To achieve high efficiency and equality in the diffracted 0th and -1st orders, the grating profile parameters are optimized using rigorous coupled-wave analysis at a wavelength of 1550 nm. Holographic recording and the inductively coupled plasma dry etching technique are used to fabricate the fused-silica beam splitter grating. The measured efficiency of (45% x 2) = 90% diffracted into the both orders can be obtained with the fabricated grating under Littrow mounting. The physical mechanism of such a wideband two-port beam splitter grating can be well explained by the modal method based on two-beam interference of the modes excited by the incident wave. With the high damage threshold, low coefficient of thermal expansion, and wideband high efficiency, the presented beam splitter etched in fused silica should be a useful optical element for a variety of practical applications. (C) 2008 Optical Society of America.

Polarization multiplexing holographic optical recording of a new photochromic diarylethene

A new unsymmetrical photochromic diarylethene 1a is synthesized, and the photochromic properties of it are also investigated. The compound exhibits good photochromism with UV/ visible light irradiation. Compound 1a in polymethyl methacrylate ( PMMA ) film changes color upon 313- nm light irradiation from colorless to blue, in which the absorption maximum is observed at 587 nm. Photon- mode polarization multiplexing holographic optical recording is performed successfully using this compound as a recording medium. In the diarylethene 1b/ PMMA film, polarization multiplexing hologram recording and retrieval, and a combination with the angular multiplexing scheme, are demonstrated systematically. The results indicate that recording capacity can be significantly improved with the combined method of polarization and angular multiplexing holographic recording. (C) 2008 Society of Photo- Optical Instrumentation Engineers.

Enhanced multiwavelength holographic profilometry by laser mode selection

A method for improving the accuracy of surface shape measurement by multiwavelength holography is presented. In our holographic setup, a Bi12TiO20 photorefractive crystal was the holographic recording medium, and a multimode diode laser emitting in the red region was the light source in a two-wave mixing scheme. on employing such lasers the resulting holographic image appears covered with interference fringes corresponding to the object relief, and the interferogram spatial frequency is proportional to the diode laser's free spectral range (FSR). Our method consists in increasing the effective free spectral range of the laser by positioning a Fabry-Perot etalon at the laser output for mode selection. As larger effective values of the laser FSR were achieved, higher-spatial-frequency interferograms were obtained and therefore more sensitive and accurate measurements were performed. The quantitative evaluation of the interferograms was made through the phase-stepping technique, and the phase map unwrapping was carried out through the cellular-automata method. For a given surface, shape measurements with different interferogram spatial frequencies were performed and compared with respect to measurement noise and visual inspection. (c) 2007 Society of Photo-Optical Instrumentation Engineers.

Single-exposure, photorefractive holographic surface contouring with multiwavelength diode lasers

We studied the use of multiwavelength diode lasers for surface profilometry through holographic recording in sillenite Bi(12)TiO(20) crystals. When such lasers are used, the holographic image from single-exposure recordings appears covered with interference fringes providing information on the surface relief of the object. By taking advantage of the narrow interference fringes due to the multiwavelength emission of the laser, we obtained interferograms by holographic recording with two reference beams, which improves the surface analysis by visual inspection and enhances the profilometry sensitivity. (c) 2005 Optical Society of America.

Two-dimensional photonic crystals in antimony-based films fabricated by holography

In this work, we demonstrated the fabrication of two-dimensional (2D) photonic crystals layers (2D-PCLs) by combining holographic recording and the evaporation of antimony-based glasses. Such materials present high refractive indices that can be tuned from 1.8 to 2.4, depending on the film composition; thus, they are interesting dielectric materials for fabrication of 2D-PCLs. The good quality of the obtained samples allowed the measurement of their PC properties through the well-defined Fano resonances that appear in the transmittance spectrum measurements at different incidence angles. The experimental results are in good agreement with the calculated band diagram for the hexagonal asymmetric structure. (C) 2008 American Institute of Physics.

Design, construction, and performance of a real-time holographic refractometry prototype for liquid analysis

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Enhanced multi-wavelength holographic profilometry by laser mode selection

The application of multi-wavelength holography for surface shape measurement is presented. In our holographic setup a Bi12TiO 20 (BTO) photorefractive crystal was the holographic recording medium and a multimode diode laser emitting in the red region was the light source in a two-wave mixing scheme. The holographic imaging with multimode lasers results in multiple holograms in the BTO. By employing such lasers the resulting holographic image appears covered of interference fringes corresponding to the object relief and the interferogram spatial frequency is proportional to the diode laser free spectral range (FSR). We used a Fabry-Perot étalon at the laser output for laser mode selection. Thus, larger effective values of the laser FSR were achieved, leading to higher-spatial frequency interferograms and therefore to more sensitive and accurate measurements. The quantitative evaluation of the interferograms was performed through the phase stepping technique (PST) and the phase map unwrapping was carried out through the Cellular-Automata method. For a given surface, shape measurements with different interferogram spatial frequencies were performed and compared, concerning measurement noise and visual inspection.

Generalized Partial Response Equalization and Data-Dependent Noise Predictive Signal Detection Over Media Models for TDMR

Two-dimensional magnetic recording (2-D TDMR) is an emerging technology that aims to achieve areal densities as high as 10 Tb/in(2) using sophisticated 2-D signal-processing algorithms. High areal densities are achieved by reducing the size of a bit to the order of the size of magnetic grains, resulting in severe 2-D intersymbol interference (ISI). Jitter noise due to irregular grain positions on the magnetic medium is more pronounced at these areal densities. Therefore, a viable read-channel architecture for TDMR requires 2-D signal-detection algorithms that can mitigate 2-D ISI and combat noise comprising jitter and electronic components. Partial response maximum likelihood (PRML) detection scheme allows controlled ISI as seen by the detector. With the controlled and reduced span of 2-D ISI, the PRML scheme overcomes practical difficulties such as Nyquist rate signaling required for full response 2-D equalization. As in the case of 1-D magnetic recording, jitter noise can be handled using a data-dependent noise-prediction (DDNP) filter bank within a 2-D signal-detection engine. The contributions of this paper are threefold: 1) we empirically study the jitter noise characteristics in TDMR as a function of grain density using a Voronoi-based granular media model; 2) we develop a 2-D DDNP algorithm to handle the media noise seen in TDMR; and 3) we also develop techniques to design 2-D separable and nonseparable targets for generalized partial response equalization for TDMR. This can be used along with a 2-D signal-detection algorithm. The DDNP algorithm is observed to give a 2.5 dB gain in SNR over uncoded data compared with the noise predictive maximum likelihood detection for the same choice of channel model parameters to achieve a channel bit density of 1.3 Tb/in(2) with media grain center-to-center distance of 10 nm. The DDNP algorithm is observed to give similar to 10% gain in areal density near 5 grains/bit. The proposed signal-processing framework can broadly scale to various TDMR realizations and areal density points.

组合外加电场提高Fe：LiNbO3中90°记录体全息的衍射效率

针对90°全息记录结构的特殊性，在记录和读出阶段分别施加不同极性的外加电场，实现了Fe：LiNbO3晶体中高衍射效率的全息记录和读出。在库赫塔列夫（Kukhtarev）方程基础上引人两维耦合波理论，对组合外加电场提高掺铁铌酸锂晶体光折变特性的机理进行了探讨。实验和理论计算结果都表明这种分别在记录和读出过程施加不同极性组合的外加电场是在Fe：LiNbO3中实现高衍射效率90°记录结构体全息的有效技术方案。