Status of water hyacinth infestation and control in River Kagera

During a regional workshop held in Mukono, Uganda (May 2001) by scientists and technocrats from Kenya, Tanzania and Uganda, working on water hyacinth management under the Lake Victoria Environmental Management Project (LVEMP), it was resolved that a survey of River Kagera be made to study the status of water hyacinth infestation and biological control in the river. Reports at the Mukono Workshop indicated that although Tanzania and Uganda had made serious effort to introduced biological control weevils (Neochefina eichhorniae and Neochetina brucht) on the weed in River Kagera, the level of establishment of biological control in the river was doubtful. Large quantities of water hyacinth biomass drifted down River Kagera into Lake Victoria daily. Similar reports of apparent inability of biological control weevils to fully establish and have effect on water hyacinth in River Nile, especially the Upper Victoria Nile, were also made by Uganda, and large quantities of weed biomass continuously drifted down the Upper Victoria Nile into Lake Kyoga. This was in spite of the successful control of the weed in Lake Victoria between 1998 and 2000

Photoluminescence and transmission spectra of nanocrystalline GaAs1-xSbx embedded in silica films

The composite films of the nanocrystalline GaAs1-xSbx-SiO2 have been successfully deposited on glass and GaSb substrates by radio frequency magnetron co-sputtering. The 10K photoluminescence (PL) properties of the nanocrystalline GaAs1-xSbx indicated that the PL peaks of the GaAs1-xSbx nanocrystals follow the quantum confinement model very closely. Optical transmittance spectra showed that there is a large blue shift of optical absorption edge in nanocrystalline GaAs1-xSbx-SiO2 composite films, as compared with that of the corresponding bulk semiconductor, which is due to the quantum confinement effect.

Reflection and transmission properties of double submerged rectangular blocks

An analytic method is used to study the reflection and transmission coefficients of the double submerged rectangular blocks (DSRBs) in oblique waves.. The scattering potentials are obtained by means of the eigenfunction expansion method, and expressions for the reflection and transmission coefficients are determined. The boundary element method is employed to verify the correctness of the present analytical method. The DSRBs have better performance than the single submerged rectangular block (SSRB) in certain cases. The reflection and transmission properties of the DSRBs are investigated for some specific cases, and the influences of the geometric parameters are also presented.

Information Processing and Transmission in Cellular Automata

A cellular automaton is an iterative array of very simple identical information processing machines called cells. Each cell can communicate with neighboring cells. At discrete moments of time the cells can change from one state to another as a function of the states of the cell and its neighbors. Thus on a global basis, the collection of cells is characterized by some type of behavior. The goal of this investigation was to determine just how simple the individual cells could be while the global behavior achieved some specified criterion of complexity ??ually the ability to perform a computation or to reproduce some pattern. The chief result described in this thesis is that an array of identical square cells (in two dimensions), each cell of which communicates directly with only its four nearest edge neighbors and each of which can exist in only two states, can perform any computation. This computation proceeds in a straight forward way. A configuration is a specification of the states of all the cells in some area of the iterative array. Another result described in this thesis is the existence of a self-reproducing configuration in an array of four-state cells, a reduction of four states from the previously known eight-state case. The technique of information processing in cellular arrays involves the synthesis of some basic components. Then the desired behaviors are obtained by the interconnection of these components. A chapter on components describes some sets of basic components. Possible applications of the results of this investigation, descriptions of some interesting phenomena (for vanishingly small cells), and suggestions for further study are given later.

TCP Optimization through FEC, ARQ and Transmission Power Tradeoffs

TCP performance degrades when end-to-end connections extend over wireless connections-links which are characterized by high bit error rate and intermittent connectivity. Such link characteristics can significantly degrade TCP performance as the TCP sender assumes wireless losses to be congestion losses resulting in unnecessary congestion control actions. Link errors can be reduced by increasing transmission power, code redundancy (FEC) or number of retransmissions (ARQ). But increasing power costs resources, increasing code redundancy reduces available channel bandwidth and increasing persistency increases end-to-end delay. The paper proposes a TCP optimization through proper tuning of power management, FEC and ARQ in wireless environments (WLAN and WWAN). In particular, we conduct analytical and numerical analysis taking into "wireless-aware" TCP) performance under different settings. Our results show that increasing power, redundancy and/or retransmission levels always improves TCP performance by reducing link-layer losses. However, such improvements are often associated with cost and arbitrary improvement cannot be realized without paying a lot in return. It is therefore important to consider some kind of net utility function that should be optimized, thus maximizing throughput at the least possible cost.

FREQUENCY SELECTIVE SURFACE WITH DUAL BAND SWITCHABLE REFLECTION AND TRANSMISSION CHARACTERISTICS

A pin diode-loaded active doubly periodic flat strip FSS is shown to act as a dynamic screen. It is shown that by means of d.c. bias control, we can utilize the screen in, (1) transmission mode as a dual band electromagnetic shutter, or with the inclusion of a ground plane in reflection mode, (is (2) it dual band refection canceller. (3) an amplitude shift keying (ASK) spatial modulator. The properties of the FSS are characterized using a specially designed parallel plate waveguide simulator that permits normal incidence excitation of the FSS under test. (C) 2009 Wiley Periodicals. Inc. Microwave Opt Technol Lett 51: 2059-2061, 2009; Published online in Wiley Inter-Science (www. interscience.wiley.com). DOI 10.1002/mop.24547

Analysis and Design of Class-E3F and Transmission-Line Class-E3F2 Power Amplifiers

In this paper, analysis and synthesis approach for two new variants within the Class-EF power amplifier (PA) family is elaborated. These amplifiers are classified here as Class-E3 F2 and transmission-line (TL) Class-E3 F 2. The proposed circuits offer means to alleviate some of the major issues faced by existing topologies such as substantial power losses due to the parasitic resistance of the large inductor in the Class-EF load network and deviation from ideal Class-EF operation due to the effect of device output inductance at high frequencies. Both lumped-element and transmission-line load networks for the Class-E 3 F PA are described. The load networks of the Class-E3 F and TL Class-E 3 F2amplifier topologies developed in this paper simultaneously satisfy the Class-EF optimum impedance requirements at fundamental frequency, second, and third harmonics as well as simultaneously providing matching to the circuit optimum load resistance for any prescribed system load resistance. Optimum circuit component values are analytically derived and validated by harmonic balance simulations. Trade-offs between circuit figures of merit and component values with some practical limitations being considered are discussed. © 2010 IEEE.

Reflection and Transmission at a Phase Discontinuous Interface

In this paper we extend the derivation of the modified form Snells's law that occurs when an additional phase profile is introduced at the material interface. We show that this permits electromagnetic (EM) beam steering, negative refraction and retrodirective action opportunities for such engineered surfaces even if they are immersed in a uniform dielectric. Simple expressions for the retrodirected and negatively refracted beams are derived along with the propagation conditions that occur at the boundary interface inside the critical angle range. It is also demonstrated how the transmission and reflected power levels are affected by the additional phase taper introduced at the surface.

A congestion management and transmission price simulator for competitive electricity markets

In a liberalized electricity market, the Transmission System Operator (TSO) plays a crucial role in power system operation. Among many other tasks, TSO detects congestion situations and allocates the payments of electricity transmission. This paper presents a software tool for congestion management and transmission price determination in electricity markets. The congestion management is based on a reformulated Optimal Power Flow (OPF), whose main goal is to obtain a feasible solution for the re-dispatch minimizing the changes in the dispatch proposed by the market operator. The transmission price computation considers the physical impact caused by the market agents in the transmission network. The final tariff includes existing system costs and also costs due to the initial congestion situation and losses costs. The paper includes a case study for the IEEE 30 bus power system.

Cultural innovation and transmission of tool use in wild chimpanzees:evidence from field experiments

Animal Cognition, V.6, pp. 213-223

Flyer about the Dominion Power and Transmission Company bonds from R.W. Harris and Co. Bankers

Flyer (2 double sided pages, printed) about the Dominion Power and Transmission Company bonds from R.W. Harris and Co. Bankers, New York, n.d.

Studies on weed infestation and tea growth under various weed management methods in a young Tea (Camellia sinensis [L.] kuntze) plantation

A field experiment was conducted in the low country of Sri Lanka, during the period 1994–1995 to investigate the severity of weed infestation and tea growth in relation to weed management methods in newly established tea (Camellia sinensis[L.] Kuntze). Manual weeding (hand and slash weeding) at various intervals was compared with various herbicides, with or without mulching. Weed control with herbicides was superior to that of hand weeding at 6-week intervals or more. Weed control with oxyfluorfen at 0.29 kg ai ha−1 + paraquat at 0.17 kg ai ha−1 or glyphosate at 0.99 kg ai ha−1 + kaolin at 3.42 kg ha−1 were superior. Plots unweeded for 12 weeks or more produced significantly greater (P < 0.05) weed biomass than plots unweeded for 6 weeks. Although the least weed dry weight (P < 0.05) and the greatest number of weed species were recorded with hand weeding at 2 week intervals, there was no particular benefit on tea growth when compared with hand weeding at 6 and 12 week intervals. Inter row mulching in chemically treated plots was more favorable for tea growth than no mulching, while living weed cover in unmulched slash weeded plots suppressed tea growth. A combination of mulching and herbicides, particularly oxyfluorfen and paraquat, followed by hand weeding at least every 6–8 weeks was considered the most appropriate weed management system for young tea.