Diode-clamped three-level inverter-based battery/supercapacitor direct integration scheme for renewable energy systems

This paper describes a diode-clamped three-level inverter-based battery/supercapacitor direct integration scheme for renewable energy systems. The study is carried out for three different cases. In the first case, one of the two dc-link capacitors of the inverter is replaced by a battery bank and the other by a supercapacitor bank. In the second case, dc-link capacitors are replaced by two battery banks. In the third case, ordinary dc-link capacitors are replaced by two supercapacitor banks. The first system is supposed to mitigate both long-term and short-term power fluctuations while the last two systems are intended for smoothening long-term and short-term power fluctuations, respectively. These topologies eliminate the need for interfacing dc-dc converters and thus considerably improve the overall system efficiency. The major issue in aforementioned systems is the unavoidable imbalance in dc-link voltages. An analysis on the effects of unbalance and a space vector modulation method, which can produce undistorted current even in the presence of such unbalances, are presented in this paper. Furthermore, small vector selection-based power sharing and state of charge balancing techniques are proposed. Experimental results, obtained from a laboratory prototype, are presented to verify the efficacy of the proposed modulation and control techniques.

Five-level Z-source diode-clamped inverter

This study proposes a five-level Z-source diode-clamped inverter designed with two intermediate Z-source networks connected between the dc input sources and rear-end inverter circuitry. By partially shorting the Z-source networks, new operating states not previously reported for two-level Z-source inverter are introduced here for operating the proposed inverter with voltage buck-boost energy conversion ability and five-level phase voltage switching. These characteristic features are in fact always ensured at the inverter terminal output by simply adopting a properly designed carrier modulation scheme, which always inserts two partial shoot-through states per half carrier cycle for smooth balanced operation. Theoretical findings and practical issues identified are eventually verified by constructing a scaled down laboratory prototype for testing.

HFL micro inverter with front-end diode clamped multi-level inverter and half-wave cycloconverter

A high-frequency-link (HFL) micro inverter with a front-end diode clamped multi-level inverter and a grid-connected half-wave cycloconverter is proposed. The diode clamped multi-level inverter with an auxiliary capacitor is used to generate high-frequency (HF) three level quasi square-wave output and it is fed into a series resonant tank to obtain high frequency continuous sinusoidal current. The obtained continuous sinusoidal current is modulated by using the grid-connected half-wave cycloconverter to obtain grid synchronized output current in phase with the grid voltage. The phase shift power modulation is used with auxiliary capacitor at the front-end multi-level inverter to have soft-switching. The phase shift between the HFL resonant current and half-wave cycloconverter input voltage is modulated to obtain grid synchronized output current.

An experimental approach to air gap optimisation for a correction-less small field diode

Aim A recent Monte Carlo based study has shown that it is possible to design a diode that measures small field output factors equivalent to that in water. This is accomplished by placing an appropriate sized air gap above the silicon chip (1) with experimental results subsequently confirming that a particular Monte Carlo design was accurate (2). The aim of this work was to test if a new correction-less diode could be designed using an entirely experimental methodology. Method: All measurements were performed on a Varian iX at a depth of 5 cm, SSD of 95 cm and field sizes of 5, 6, 8, 10, 20 and 30 mm. Firstly, the experimental transfer of kq,clin,kq,msr from a commonly used diode detector (IBA, stereotactic field diode (SFD)) to another diode detector (Sun Nuclear, unshielded diode, (EDGEe)) was tested. These results were compared to Monte Carlo calculated values of the EDGEe. Secondly, the air gap above the EDGEe silicon chip was optimised empirically. Nine different air gap “tops” were placed above the EDGEe (air depth = 0.3, 0.6, 0.9 mm; air width = 3.06, 4.59, 6.13 mm). The sensitivity of the EDGEe was plotted as a function of air gap thickness for the field sizes measured. Results: The transfer of kq,clin,kq,msr from the SFD to the EDGEe was correct to within the simulation and measurement uncertainties. The EDGEe detector can be made “correction-less” for field sizes of 5 and 6 mm, but was ∼2% from being “correction-less” at field sizes of 8 and 10 mm. Conclusion Different materials will perturb small fields in different ways. A detector is only “correction-less” if all these perturbations happen to cancel out. Designing a “correction-less” diode is a complicated process, thus it is reasonable to expect that Monte Carlo simulations should play an important role.

The psychology of containment : mis/representing emotional and behavioural difficulties in Australian schools

The number of students in special schools has increased at a rapid rate in some Australian states, due in part to increased enrolment under the categories of emotional disturbance (ED) and behaviour disorder (BD). Nonetheless, diagnostic distinctions between ED and BD are unclear. Moreover, despite international findings that students with particular backgrounds are over-represented in special schools, little is known about the backgrounds of students entering such settings in Australia. This study examined the government school enrolment data from New South Wales, the most populous of the Australian states. Linear and quadratic trends were used to describe the numbers and ages of students enrolled in special schools in the ED and BD categories. Changes between 1997 and 2007 were observed. Results showed an over-representation of boys that increased across the decade and a different pattern across age for boys and girls. Consistent with international findings, these results indicate that trends in special school placements are unrelated to disability prevalence in the population. Rather, it is suggested that schools act to preserve time and resources for others by removing their more challenging students: most typically, boys.

Pt/WO3 nanoplatelet/SiC Schottky diode based hydrogen gas sensor

This paper presents the fabrication and study of a Schottky diode based on Pt/WO3 nanoplatelet/SiC for H2 gas sensing applications. The nanostructured WO3 films were synthesized from tungsten (sputtered on SiC) via an acidetching method using a 1.5 M HNO3 solution. Scanning electron microscopy of the developed films revealed platelet crystals with thicknesses in the order of 20-60 nm and lengths between 100-700 nm. The current-voltage characteristic and dynamic response of the diodes were measured in the presence of air and 1% H2 gas balanced in air from 25 to 300°C. Upon exposure to 1% H2, voltage shifts of 0.64, 0.93 and 1.14 V were recorded at temperatures of 120, 200 and 300°C, respectively at a constant forward bias current of 500 μA.

Novel schmitt trigger based on lahbda diode

A new circuit to realise a Schmitt trigger has been conceived. This circuit, which is based on the well known lambda diode, is suitable for integration using CMOS technology. It requires only three devices and is probably simpler than any other conventional Schmitt trigger circuit.

Evaluation of visual stress symptoms in Age-matched Dyslexic, Meares–Irlen syndrome (MIS) and normal adults

AIM To examine the prevalence of dyslexia and Meares–Irlen syndrome (MIS) among female students and determine their level of visual stress in comparison with normal subjects. METHODS A random sample of 450 female medical students of King Saud University Riyadh (age range, 18 - 30 years) responded to a wide range of questions designed to accomplish the aims of this study. The detailed questionnaire consisted of 54 questions with twelve questions enquiring on ocular history and demography of participants while 42 questions were on visual symptoms. Items were categorized into; critical and non-critical questions (CQ and NCQ) and were rated on four point Likert scale. Based on the responses obtained, the subjects were grouped into normal (control), dyslexic with or without MIS (Group 1) and subjects with MIS only (Group 2). Responses were analysed as averages and mean scores were calculated and compared between-groups using one way analysis of variance to evaluate total (TVSS = NCQ + CQ), critical and non-critical visual stress scores. The relationship between categorical variables such as age, handedness and condition were assessed with Chi- Square test. RESULTS The completion rate was 96.8% and majority of the respondents (92%) were normal readers, 2% dyslexic and 6% had MIS. They were age-matched. More than half of the participants had visited an eye care practitioner in the last 2yrs. About 13% were recommended eye exercises and one participant experienced pattern glare. Hand preference was not associated with any condition but Group 1 subjects (3/9, 33%) were significantly more likely to be diagnosed of lazy eye than Group 2 (2/27, 7%) and control (27/414, 5%) subjects. The mean ± SD of TVSS responses were 63 ± 14 but it was 44 ± 9 for CQ and 19 ± 5 for NCQ. Responses from all three variables were normally distributed but the CQ responses were on the average more positive (82%) in Group 2 and less positive (46%) in Group 1 than control. With NCQ, the responses were equally less positive in Group 1 and 2 than control. Group 2 subjects showed significantly higher TVSS (P = 0.002), NCQ (P = 0.006) and CQ (P = 0.008) visual stress scores than control but no difference between Group 1 and control subjects, was observed for all scores (P > 0.05, for all comparisons). CONCLUSION The prevalence of dyslexia and MIS among Saudi female students was 2 and 6%, respectively. Critical questions performed best for assessing visual stress symptoms in dyslexic and MIS subjects. Generally, students with MIS were more sensitive to visual stress than normal students but dyslexics were more likely to present with a lazy eye than MIS and normal readers.

Electromechanical interactions in a carbon nanotube based thin film field emitting diode

Carbon nanotubes (CNTs) have emerged as promising candidates for biomedical x-ray devices and other applications of field emission. CNTs grown/deposited in a thin film are used as cathodes for field emission. In spite of the good performance of such cathodes, the procedure to estimate the device current is not straightforward and the required insight towards design optimization is not well developed. In this paper, we report an analysis aided by a computational model and experiments by which the process of evolution and self-assembly (reorientation) of CNTs is characterized and the device current is estimated. The modeling approach involves two steps: (i) a phenomenological description of the degradation and fragmentation of CNTs and (ii) a mechanics based modeling of electromechanical interaction among CNTs during field emission. A computational scheme is developed by which the states of CNTs are updated in a time incremental manner. Finally, the device current is obtained by using the Fowler–Nordheim equation for field emission and by integrating the current density over computational cells. A detailed analysis of the results reveals the deflected shapes of the CNTs in an ensemble and the extent to which the initial state of geometry and orientation angles affect the device current. Experimental results confirm these effects.

Experimental investigation of the dependence of barrier height on metal work function for metal---SiO2---p---Si (MIS) Schottky-barrier diodes in the presence of inversion

The dependence of barrier height on the metal work function of metal-SiO2-p-Si Schottky barrier diodes was investigated and nonlinearity was found. This is explained by the theoretical model proposed recently by Chattopadhyay and Daw. The values of interface trap density and fixed charge density of the insulating layer of the diodes were calculated using this model and found to be appreciably different from those estimated by the usual method.

Control of barrier height of MIS tunnel diodes using deep level impurities

The barrier height of MIS tunnel diodes is studied considering the effect of deep impurities. It is shown that the barrier height of a given MIS-system can be controlled by changing the density and the activation energy of the defect level. The study leads to the conclusion that deep impurities of character opposite to shallow impurities enhance the barrier height. On the other hand, the barrier height is lowered when the type of the deep impurities is the same as that of shallow impurities.