The influence of matrix mediated hopping conductivity, filler concentration, aspect ratio and orientation on the electrical response of carbon nanotube/polymer nanocomposites

A model to simulate the conductivity of carbon nanotube/polymer nanocomposites is presented. The proposed model is based on hopping between the fillers. A parameter related to the influence of the matrix in the overall composite conductivity is defined. It is demonstrated that increasing the aspect ratio of the fillers will increase the conductivity. Finally, it is demonstrated that the alignment of the filler rods parallel to the measurement direction results in higher conductivity values, in agreement with results from recent experimental work.

Predictors of Successful Weight Control: Cross-Cultural Moderators of Treatment Outcomes

Given the heterogeneity of effect sizes within the population for any treatment, identifying moderators of outcomes is critical [1]. In weight management programs, there is a high individual variability in terms of weight loss and an overall modest success [2]. Some people will adopt and sustain attitudes and behaviors associated with weight loss, while others won’t [3]. To predict weight loss outcome just from the subject’s baseline information would be very valuable [4,5]. It would allow to: - Better match between treatments and individuals - Identify the participants with less probability of success (or potential dropouts) in a given treatment and direct them to alternative therapies - Target limited resources to those most likely to succeed - Increase cost-effectiveness and improve success rates of the programs Few studies have been dedicated to describe baseline predictors of treatment success. The Healthy Weight for Life (USA) study is one of the few. Its findings are now being cross-validated in Portuguese samples. This paper describes these cross-cultural comparisons.

Analysis of mediation and reciprocal effects of changes in weight, self-esteem, and exercise in a behavioral weight loss treatment

Improving the treatment of obesity remains a critical challenge. Several health behaviour change models, often based on a social-cognitive framework, have been used to design weight management interventions (Baranowski et al., 2003). However, most interventions have only produced modest weight reductions (Wadden et al., 2002) and socialcognitive variables have shown limited power to predict weight outcomes (Palmeira et al., 2007). Other predictors, and possibl alte nati e e planatory models, are needed to better understand the mechanisms by which weight loss and other obesity treatment-outcomes are brought about (Baranowski, 2006). Self-esteem is one of these possible mechanisms, because is commonly reported to change during the treatment, although these changes are not necessarily associated with weight loss (Blaine et al., 2007; Maciejewski et al., 2005). This possibility should be more evident if the program integrates regular exercise, as it promotes improvements in subjective well-being (Biddle & Mutrie, 2001), with possible influences on long-term behavioral adherence (e.g. diet, exercise). Following the reciprocal effects model tenets (Marsh & Craven, 2006), we expect that the influences between changes in weight, selfesteem and exercise to be reciprocal and might present one of the mechanisms by which obesity treatments can be improved.

Direct Power Control of Matrix Converter Based Unified Power Flow Controllers

This paper presents the Direct Power Control of Three-Phase Matrix Converters (DPC-MC) operating as Unified Power Flow Controllers (UPFC). Since matrix converters allow direct AC/AC power conversion without intermediate energy storage link, the resulting UPFC has reduced volume and cost, together with higher reliability. Theoretical principles of DPC-MC method are established based on an UPFC model, together with a new direct power control approach based on sliding mode control techniques. As a result, active and reactive power can be directly controlled by selection of an appropriate switching state of matrix converter. This new direct power control approach associated to matrix converters technology guarantees decoupled active and reactive power control, zero error tracking, fast response times and timely control actions. Simulation results show good performance of the proposed system.

Predictive Optimal Matrix Converter Control for a Dynamic Voltage Restorer with Flywheel Energy Storage

This paper presents a predictive optimal matrix converter controller for a flywheel energy storage system used as Dynamic Voltage Restorer (DVR). The flywheel energy storage device is based on a steel seamless tube mounted as a vertical axis flywheel to store kinetic energy. The motor/generator is a Permanent Magnet Synchronous Machine driven by the AC-AC Matrix Converter. The matrix control method uses a discrete-time model of the converter system to predict the expected values of the input and output currents for all the 27 possible vectors generated by the matrix converter. An optimal controller minimizes control errors using a weighted cost functional. The flywheel and control process was tested as a DVR to mitigate voltage sags and swells. Simulation results show that the DVR is able to compensate the critical load voltage without delays, voltage undershoots or overshoots, overcoming the input/output coupling of matrix converters.

Validity of self-reported weight: a study of urban brazilian adults

In order to evaluate the validity of self-reported weight for use in obesity prevalence surveys, self-reported weight was compared to measured weight for 659 adults living in the Porto Alegre county, RS Brazil in 1986-87, both weights being obtained by a technician in the individual's home on the same visit. The mean difference between self-reported and measured weight was small (-0.06 +/- 3.16 kg; mean +/- standard deviation), and the correlation between reported and measured weight was high (r=0.97). Sixty-two percent of participants reported their weight with an error of < 2 kg, 87% with an error of < 4 kg, and 95% with an error of < 6 kg. Underweight individuals overestimated their weight, while obese individuals underestimated theirs (p<0.05). Men tended to overestimate their weight and women underestimate theirs, this difference between sexes being statistically significant (p=0.04). The overall prevalence of underweight (body mass index < 20) by reported weight was 11%, by measured weight 13%; the overall prevalence of obesity (body mass index > 30) by reported weight was 10%, by measured weight 11%. Thus, the validity of reported weight is acceptable for surveys of the prevalence of ponderosity in similar settings.

Mid-upper arm circumference in pregnant women and its relation to birth weight

OBJECTIVE: In order to determine the relationship between some maternal anthropometric indicators and birth weight, crown-heel length and newborn's head circumference, 92 pregnant women were followed through at the prenatal service of hospital in S. Paulo, Brazil. MATERIAL AND METHOD: The following variables were established for the mother: weight, height, mid-upper arm circumference, pre-pregnancy weight, gestational weight gain and Quetelet's index. For the newborn the following variables were recorded: birth weight, crown-heel length, head circumference and gestational age by Dubowitz's method. RESULTS: Significant associations were noted between gestational age and newborn variables. In addition, maternal mid-arm circumference (MUAC) and pre-pregnancy weight were found to be positively correlated to birth weight (r=0.399; r=0.378, respectively). The multivariate linear regression shows that gestational age, mother's arm circumference and pre-pregnancy weight continue to be significant predictors of birth weight. On the other hand, only gestational age and mother's age was associated with crown-heel length. Similarly MUAC was significantly associated with crown-heel length (r= 0.306; P=0.0030). CONCLUSION: Maternal mid-upper arm circumference is a potential indicator of maternal nutritional status. It could be used in association with other anthropometric measurements, instead of pre-pregnancy weight, as an alternative indicator to assess women at risk of poor pregnancy outcome.

Reliability of self-reported weight and height among State bank employees

INTRODUCTION: Self-reported weight and height were compared with direct measurements in order to evaluate the agreement between the two sources. METHOD: Data were obtained from a cross-sectional study on health status from a probabilistic sample of 1,183 employees of a bank, in Rio de Janeiro State, Brazil. Direct measurements were made of 322 employees. Differences between the two sources were evaluated using mean differences, limits of agreement and intraclass correlation coefficient (ICC). RESULTS AND CONCLUSIONS: Men and women tended to underestimate their weight while differences between self-reported and measured height were insignificant. Body mass index (BMI) mean differences were smaller than those observed for weight. ICC was over 0.98 for weight and 0.95 for BMI, expressing close agreement. Combining a graphical method with ICC may be useful in pilot studies to detect populational groups capable of providing reliable information on weight and height, thus minimizing resources needed for field work.

Risk factors for the increasing trend in low birth weight among live births born by vaginal delivery, Brazil

OBJECTIVE: To identify risk factors for low birth weight (LBW) among live births by vaginal delivery and to determine if the disappearance of the association between LBW and socioeconomic factors was due to confounding by cesarean section. METHODS: Data were obtained from two population-based cohorts of singleton live births in Ribeirão Preto, Southeastern Brazil. The first one comprised 4,698 newborns from June 1978 to May 1979 and the second included 1,399 infants born from May to August 1994. The risks for LBW were tested in a logistic model, including the interaction of the year of survey and all independent variables under analysis. RESULTS: The incidence of LBW among vaginal deliveries increased from 7.8% in 1978--79 to 10% in 1994. The risk was higher for: female or preterm infants; newborns of non-cohabiting mothers; newborns whose mothers had fewer prenatal visits or few years of education; first-born infants; and those who had smoking mothers. The interaction of the year of survey with gestational age indicated that the risk of LBW among preterm infants fell from 17.75 to 8.71 in 15 years. The mean birth weight decreased more significantly among newborns from qualified families, who also had the highest increase in preterm birth and non-cohabitation. CONCLUSIONS: LBW among vaginal deliveries increased mainly due to a rise in the proportion of preterm births and non-cohabiting mothers. The association between cesarean section and LBW tended to cover up socioeconomic differences in the likelihood of LBW. When vaginal deliveries were analyzed independently, these socioeconomic differences come up again.

Aplicação do ABC no sector de transporte público rodoviário de mercadorias: estudo de caso em PME

Mestrado em Contabilidade e Finanças Orientado por: Doutora Cláudia Lopes

Estudo de caso

História Clínica: Um paciente com história de diversas lesões nos membros inferiores foi intervencionado em ambos os pés, onde realizou uma tenossinovectomia dos peroneais com reparação de ruptura desses tendões (ao pé direito em 2006 sendo actualmente ao esquerdo). Avaliação Objectiva: Apresentava dor, edema, limitação articular de todos os movimentos da tibio-társica, fraqueza muscular, pés cavos e alterações do padrão de marcha e do equilíbrio. Objectivo: foi verificar se a mobilização com movimento (MWM) do astrágalo e da articulação tibio-peroneal inferior levava a uma diminuição da dor e aumentava a amplitude de dorsiflexão e inversão neste doente com pé cavo. Intervenção: foi realizada MWM do astrágalo e do perónio na articulação tibioperoneal inferior em descarga e em semi-carga, sendo mantida essa nova posição com uma ligadura de tape. Resultados: o paciente aumentou as amplitudes articulares em descarga e em carga, diminuiu o edema da perna e pé, aumentou a funcionalidade, mas em termos de força muscular não foram quantificadas alterações. Conclusão: mesmo o paciente tendo pé cavo e sequelas de uma tenossinovectomia dos peroneais, as manobras de mobilização com movimento do astrágalo e da articulação tíbio-peroneal inferior levaram a uma eliminação da dor e a um aumento da amplitude articular.

Determination of electricity consumers’ load profiles via weighted evidence accumulation clustering using subsampling

With the electricity market liberalization, the distribution and retail companies are looking for better market strategies based on adequate information upon the consumption patterns of its electricity consumers. A fair insight on the consumers’ behavior will permit the definition of specific contract aspects based on the different consumption patterns. In order to form the different consumers’ classes, and find a set of representative consumption patterns we use electricity consumption data from a utility client’s database and two approaches: Two-step clustering algorithm and the WEACS approach based on evidence accumulation (EAC) for combining partitions in a clustering ensemble. While EAC uses a voting mechanism to produce a co-association matrix based on the pairwise associations obtained from N partitions and where each partition has equal weight in the combination process, the WEACS approach uses subsampling and weights differently the partitions. As a complementary step to the WEACS approach, we combine the partitions obtained in the WEACS approach with the ALL clustering ensemble construction method and we use the Ward Link algorithm to obtain the final data partition. The characterization of the obtained consumers’ clusters was performed using the C5.0 classification algorithm. Experiment results showed that the WEACS approach leads to better results than many other clustering approaches.

Infant mortality and low birth weight in cities of Northeastern and Southeastern Brazil

OBJECTIVE: To compare estimates of low birth weight (LBW), preterm birth, small for gestational age (SGA), and infant mortality in two birth cohorts in Brazil. METHODS: The two cohorts were performed during the 1990s, in São Luís, located in a less developed area in Northeastern Brazil, and Ribeirão Preto, situated in a more developed region in Southeastern Brazil. Data from one-third of all live births in Ribeirão Preto in 1994 were collected (2,839 single deliveries). In São Luís, systematic sampling of deliveries stratified by maternity hospital was performed from 1997 to 1998 (2,439 single deliveries). The chi-squared (for categories and trends) and Student t tests were used in the statistical analyses. RESULTS: The LBW rate was lower in São Luís, thus presenting an epidemiological paradox. The preterm birth rates were similar, although expected to be higher in Ribeirão Preto because of the direct relationship between preterm birth and LBW. Dissociation between LBW and infant mortality was observed, since São Luís showed a lower LBW rate and higher infant mortality, while the opposite occurred in Ribeirão Preto. CONCLUSIONS: Higher prevalence of maternal smoking and better access to and quality of perinatal care, thereby leading to earlier medical interventions (cesarean section and induced preterm births) that resulted in more low weight live births than stillbirths in Ribeirão Preto, may explain these paradoxes. The ecological dissociation observed between LBW and infant mortality indicates that the LBW rate should no longer be systematically considered as an indicator of social development.

Matrix Converter-Based Unified Power-Flow Controllers: Advanced Direct Power Control Method

This paper presents a direct power control (DPC) for three-phase matrix converters operating as unified power flow controllers (UPFCs). Matrix converters (MCs) allow the direct ac/ac power conversion without dc energy storage links; therefore, the MC-based UPFC (MC-UPFC) has reduced volume and cost, reduced capacitor power losses, together with higher reliability. Theoretical principles of direct power control (DPC) based on sliding mode control techniques are established for an MC-UPFC dynamic model including the input filter. As a result, line active and reactive power, together with ac supply reactive power, can be directly controlled by selecting an appropriate matrix converter switching state guaranteeing good steady-state and dynamic responses. Experimental results of DPC controllers for MC-UPFC show decoupled active and reactive power control, zero steady-state tracking error, and fast response times. Compared to an MC-UPFC using active and reactive power linear controllers based on a modified Venturini high-frequency PWM modulator, the experimental results of the advanced DPC-MC guarantee faster responses without overshoot and no steady-state error, presenting no cross-coupling in dynamic and steady-state responses.