Frequent p53 mutations and occasional loss of chromosome 4 in invasive bladder carcinoma induced by N-butyl-N-(4-hydroxybutil)nitrosamine in B6D2F1 mice

B6D2F1 mice (45/group) were treated with N-butyl-N-(4- hydroxybutyl)nitrosamine (BBN) or uracil as follows: Group 1 received 0.05% BBN in drinking water for the entire experiment, Group 2 received 5 mg of BBN by gastric gavage in 0.1 mL of 20% ethanol twice per week for 10 wk, Group 3 received a 2.5% uracil-containing diet for the entire experiment, and Group 4 was controls (received 0.1 mL of 20% ethanol by gavage twice per week for 10 wk). The surviving mice in Group 1 were killed after week 26 and those in the other groups after week 30. By week 15, three of 11 Group 1 and one of 15 Group 2 mice had bladder carcinoma. By 26 and 30 wk, respectively, invasive carcinomas were observed in 33 of 34 and six of 21 mice in Groups 1 and 2 and renal pelvic carcinomas in 11 of 34 and three of 21 mice in Groups 1 and 2. Four of 19 uracil-treated mice had bladder nodular hyperplasia. By polymerase chain reaction-single-strand conformation polymorphism and sequence analyses, 16 of 20 and two of five bladder carcinomas from Groups 1 and 2, respectively, showed mutations in the p53 gene. Ha-ras mutation was present in one case. Loss of heterozygosity analysis with simple-sequence length polymorphism markers for chromosome 4 showed that 10 of 21, two of 15, and nine of 13 mice in Groups 1-3, respectively, had heterozygous or homozygous deletions. B6D2F1 mice are therefore susceptible to the urothelial carcinogenic effects of BBN and develop frequent p53 mutations and chromosome 4 deletions. Chromosome 4 deletions were also seen with uracil.

Effects of Plasma Immersion Ion Implantation (PIII) of nitrogen on hardness, composition and corrosion resistance of Ti-6Al-4V alloy

Ti-6Al-4V samples have been treated by PHI processing at different temperatures (400-800°C), treatment time (30-150 min) and plasma potential (100 and 420 V). Hardness measurements results showed an enhancement of the hardness for all implanted samples. XRD results detected the Ti 2N phase and the best corrosion resistance was found for the samples processed at higher temperature and lower PIII time.

Multiparticulate systems of pectin-chitosan: Study of swelling and drug release

The aim of this study was to prepare multiparticulate systems of pectin:chitosan (PC:CS) and to evaluate their swelling ratio and the drug release in different environments. PC:CS particles containing triamcinolone were prepared by a complex coacervation/ionotropic gelation method in aqueous environment. The polymer ratio, the calcium concentration and the contact time of the capsules with chitosan dispersion for particles formation and the structures obtained were analyzed. The systems were characterized in relation to morphology, size, swelling, and drug release behavior. The methodology used allowed the production of spherical particles with narrow range of size distribution. The entrapment efficiency for triamcinolone was 84.31 ± 439. It was observed that the particles present a relatively low swelling ratio in acidic medium and a larger swelling ratio in enteric medium. The release profile was dependent on pH and can be related with the swelling ratio.

Flexibility and torsional resistance of three nickel-titanium retreatment instrument systems

Aim To assess the dimensional characteristics, flexibility and torsional behaviour of nickel-titanium retreatment instruments. Methodology Using image analysis software and high-resolution digital images, the instrument length, tip angle, diameter at 3mm from the tip and the distance between the blades (pitch length) of the following eight instruments were measured (n=12 for each measurement parameter): the ProTaper Universal retreatment (PTU-R) D1, D2 and D3 instruments; the R-Endo R1, R2 and R3 retreatment instruments; and the Mtwo retreatment (Mtwo-R) sizes 25 and 15 retreatment instruments. Maximum torque and the angular deflection at fracture as well as the bending moment at 45° were measured (n=12) according to the International Standards Organisation (ISO) specification number 3630-1. Data were analysed using the analysis of variance (α=0.05). Results The length of the active part of the instruments was found to vary according to the depth of the canal into which they were designed to reach. The pitch length also increased along the active length. The PTU-R D1 and the Mtwo-R instruments had active tips. Measurements of the bending moment at 45° revealed that the Mtwo-R 15 instrument was the most flexible, whereas the PTU-R D1 was the least flexible. The maximum torque tended to increase as the instrument diameter at 3mm from the tip increased, whereas the angular deflection at fracture varied in the opposite direction. Conclusions The geometrical characteristics of the retreatment instruments and their flexibility and torsion behaviour were consistent with their intended clinical application. © 2011 International Endodontic Journal.

Pathological and molecular analysis of Turkey coronavirus replication in captive wild Turkey embryos (broad-breasted bronze breeder)

The degree of genetic and pathologic variation exhibited by a turkey Coronavirus (TCoV) strain was investigated after nine serial passages in 25-day-old turkey embryos obtained from wild broad-breasted bronze breeders. In spite of spleen, liver, kidneys, cloacal bursa and thymus have been collected and analysed, the main histopathological changes were only documented in the intestine sections. Microscopic lesions were characterized as mild enteritis, low degree of enterocyte vacuolization and detachment of the intestinal villous after five consecutive passages and were considered absent in the last passages. Genealogic analysis based on S1 and S2 DNA sequences suggested that Brazilian isolate might be considered as originated from TCoV strains circulating in the United States, as 100% identity with TCoV-Gl strain. Although S1 S2 sequences from each passage revealed no significant point mutations, and no correlation could be speculate between S2 nucleotide changes and pathologic features in infected embryos. This is the first demonstration of wild turkey embryos as a model for TCoV isolation and propagation.

How to plan, AFROSIBER: the nine point method and its application to development planning

Includes bibliography

Chemical properties and decay resistance of eucalyptus grandis wood from steamed logs

The objective of this study was evaluate the effect of the log steaming on the chemical properties and decay resistance of Eucalyptus grandis wood. Logs with diameter between 20 and 22 cm were studied. Half of logs were kept in its on original condition, and the other half was steamed at 90°C for 13 hours. The holocellulosc, Klason lignin, total extractives content and the weight loss caused by the decay fungus Pycnoporus sanguineous were characterized. The results showed that the log steaming of E. grandis wood cause: (l)a significantly decreased in holocellulose content; (2) an increase of 4.8% and 4.4% in total extractives and lignin content, respectively; and (3) a decrease in its durability against the decay fungus P. sanguineus in order of 13.03%. Copyright © (2012) by WCTE 2012 Committee.

Perfil de resistência genótica do HIV-1 em pacientes com falha na terapia antirretroviral atendidos pela Rede Nacional de Genotipagem (RENAGENO) na região de Botucatu, SP-Brasil

Pós-graduação em Pesquisa e Desenvolvimento (Biotecnologia Médica) - FMB

Animal models of alcohol and drug dependence

Drug addiction has serious health and social consequences. In the last 50 years, a wide range of techniques have been developed to model specific aspects of drug-taking behaviors and have greatly contributed to the understanding of the neurobiological basis of drug abuse and addiction. In the last two decades, new models have been proposed in an attempt to capture the more genuine aspects of addiction-like behaviors in laboratory animals. The goal of the present review is to provide an overview of the preclinical procedures used to study drug abuse and dependence and describe recent progress that has been made in studying more specific aspects of addictive behavior in animals.

Impact strength and abrasion resistance of high strength concrete with rice husk ash and rubber tires

The paper discusses the application of High Strength Concrete (HSC) technology for concrete production with the incorporation of Rice Husk Ash (RHA) residues by replacing a bulk of the material caking and rubber tires with partial aggregate volume, assessing their influence on the mechanical properties and durability. For concrete with RHA and rubber, it was possible to reduce the brittleness by increasing the energy absorbing capacity. With respect to abrasion, the RHA and rubber concretes showed lower mass loss than the concrete without residues, indicating that this material is attractive to be used in paving. It is thus hoped that these residues may represent a technological and ecological alternative for the production of concrete in construction works.

Fine-tuning of a nanostructure, swelling, and drug delivery profile by blending ureasil-PEO and ureasil-PPO hybrids

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Effect of the Layering Technique on Bond Strength and Cohesive Resistance of a Porcelain-Zirconia System

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Survey of Minas frescal cheese from Southwest Minas Gerais for virulence factors and antimicrobial resistance in Escherichia coli isolates

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Three-point functions and su(1 vertical bar 1) spin chains

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)