Mooloomba House, Point Lookout, North Stradbroke Island

North elevation, deck below and belvedere above, as seen from path to beach.

Cladding detail, Mooloomba House, Point Lookout, North Stradbroke Island

Detail view of cladding to upper level dining studio.

Design, Science and Conceptual Analysis

Philosophers expend considerable effort on the analysis of concepts, but the value of such work is not widely appreciated. This paper principally analyses some arguments, beliefs, and presuppositions about the nature of design and the relations between design and science common in the literature to illustrate this point, and to contribute to the foundations of design theory.

A Future for the Past: Rethinking the Garden Suburb

In the quest for sustainability in affluent urban societies we could do much worse than to look again at what the garden suburb attempted to do. Brentham garden suburb in West London, which has recently celebrated its centenary, is a case in point.

Experimental Analysis of Froude Number Effect on Air Entrainment in the Hydraulic Jump

A hydraulic jump is characterized by strong energy dissipation and mixing, large-scale turbulence, air entrainment, waves and spray. Despite recent pertinent studies, the interaction between air bubbles diffusion and momentum transfer is not completely understood. The objective of this paper is to present experimental results from new measurements performed in rectangular horizontal flume with partially-developed inflow conditions. The vertical distributions of void fraction and air bubbles count rate were recorded for inflow Froude number Fr1 in the range from 5.2 to 14.3. Rapid detrainment process was observed near the jump toe, whereas the structure of the air diffusion layer was clearly observed over longer distances. These new data were compared with previous data generally collected at lower Froude numbers. The comparison demonstrated that, at a fixed distance from the jump toe, the maximum void fraction Cmax increases with the increasing Fr1. The vertical locations of the maximum void fraction and bubble count rate were consistent with previous studies. Finally, an empirical correlation between the upper boundary of the air diffusion layer and the distance from the impingement point was provided.

Using the level set method to model endogenous lava dome growth

Modeling volcanic phenomena is complicated by free-surfaces often supporting large rheological gradients. Analytical solutions and analogue models provide explanations for fundamental characteristics of lava flows. But more sophisticated models are needed, incorporating improved physics and rheology to capture realistic events. To advance our understanding of the flow dynamics of highly viscous lava in Peléean lava dome formation, axi-symmetrical Finite Element Method (FEM) models of generic endogenous dome growth have been developed. We use a novel technique, the level-set method, which tracks a moving interface, leaving the mesh unaltered. The model equations are formulated in an Eulerian framework. In this paper we test the quality of this technique in our numerical scheme by considering existing analytical and experimental models of lava dome growth which assume a constant Newtonian viscosity. We then compare our model against analytical solutions for real lava domes extruded on Soufrière, St. Vincent, W.I. in 1979 and Mount St. Helens, USA in October 1980 using an effective viscosity. The level-set method is found to be computationally light and robust enough to model the free-surface of a growing lava dome. Also, by modeling the extruded lava with a constant pressure head this naturally results in a drop in extrusion rate with increasing dome height, which can explain lava dome growth observables more appropriately than when using a fixed extrusion rate. From the modeling point of view, the level-set method will ultimately provide an opportunity to capture more of the physics while benefiting from the numerical robustness of regular grids.

Modification of the in vivo four-point loading model for studying mechanically induced bone adaptation

We modified the noninvasive, in vivo technique for strain application in the tibiae of rats (Turner et al,, Bone 12:73-79, 1991), The original model applies four-point bending to right tibiae via an open-loop, stepper-motor-driven spring linkage, Depending on the magnitude of applied load, the model produces new bone formation at periosteal (Ps) or endocortical surfaces (Ec.S). Due to the spring linkage, however, the range of frequencies at which loads can be applied is limited. The modified system replaces this design with an electromagnetic vibrator. A load transducer in series with the loading points allows calibration, the loaders' position to be adjusted, and cyclic loading completed under load central as a closed servo-loop. Two experiments were conducted to validate the modified system: (1) a strain gauge was applied to the lateral surface of the right tibia of 5 adult female rats and strains measured at applied loads from 10 to 60 N; and (2) the bone formation response was determined in 28 adult female Sprague-Dawley rats. Loading was applied as a haversine wave with a frequency of 2 Hz for 18 sec, every second day for 10 days. Peak bending loads mere applied at 33, 40, 52, and 64 N, and a sham-loading group tr as included at 64 N, Strains in the tibiae were linear between 10 and 60 N, and the average peak strain at the Ps.S at 60 N was 2664 +/- 250 microstrain, consistent with the results of Turner's group. Lamellar bone formation was stimulated at the Ec.S by applied bending, but not by sham loading. Bending strains above a loading threshold of 40 N increased Ec Lamellar hone formation rate, bone forming surface, and mineral apposition rate with a dose response similar to that reported by Turner et al, (J Bone Miner Res 9:87-97, 1994). We conclude that the modified loading system offers precision for applied loads of between 0 and 70 N, versatility in the selection of loading rates up to 20 Hz, and a reproducible bone formation response in the rat tibia, Adjustment of the loader also enables study of mechanical usage in murine tibia, an advantage with respect to the increasing variety of transgenic strains available in bone and mineral research. (Bone 23:307-310; 1998) (C) 1998 by Elsevier Science Inc. All rights reserved.

Sources of information about HIV/AIDS and perceived risk of infection among heterosexual young adults: 1989 and 1994

This paper reports a study of sources of information about HIV/AIDS and trust of the sources among heterosexuals in 1989 (113 females and 91 males) and 1994 (185 females and 66 males). We also examined whether perceived personal risk of HIV infection was predicted by sources of information about HIV/AIDS, trust of the sources, how informed about AIDS people believed they were, and perceived risk of infection to others, as well as whether there was a relationship between perceived personal risk and safe sex behaviour Participants received most of their information about AIDS/HIV from magazines, newspapers, and television, but placed most trust on sources such as doctors and HIV/AIDS organisations. Perceived personal risk was influenced most by perceived risk to friends and to people with the same sexual practices. In the 1994 sample, perceived personal risk was correlated with the amount of condom use among participants with sexual experience. These results indicate ther has been. relative stability across a five-year period. They also point to the continuing discrepancy among young heterosexuals between the most-used and most-trusted sources of information, as well as to the importance of peer influence on perceptions of personal risk of HIV infection.

Long-term clozapine treatment identifies significant improvements in clinical and functioning scales

The majority of clinical drug trials only cover a small number of variables over a short period of time on a small group of people. The objective of this study was to track a large group of people over a long period of time, using a diverse range of variables with a naturalistic design to assess the ‘real world’ use of clozapine. Fifty-three people with treatment-resistant schizophrenia were recruited into a 2-year study which assessed the subjects using the following scales: Positive and Negative Syndrome Scale (PANSS), Clinical Global Impression Scale (CGI), Life Skills Profile (LSP), and Role Functioning Scale (RFS). Discharge, leave, and ward movement rates were also monitored. All subjects were inpatients at a tertiary psychiatric facility. Thirty-three percent of the group was discharged. Seventythree percent moved to less cost-intensive wards, and the leave rate increased by 105”/0. Sixty-seven percent of the study group were identified as responders by the 24-month time point. Twenty-four percent of the group had their CGI scores reduced to 2 or better 0, =O.OOOl). Significant improvements were identified in the RFS (p = 0.02) and LSP (p = 0.0001). Long-term clozapine treatment has identified a significant group of responders on a variety of measures.