Essential Oil Composition of Diploid and Tetraploid Clones of Ginger (Zingiber officinale Roscoe) Grown in Australia

Ginger oil, obtained by steam distillation of the rhizome of Zingiber officinale Roscoe, is used in the beverage and fragrance industries. Ginger oil displays considerable compositional diversity, but is typically characterized by a high content of sesquiterpene hydrocarbons, including zingiberene, arcurcumene, â-bisabolene, and â-sesquiphellandrene. Australian ginger oil has a reputation for possessing a particular “lemony” aroma, due to its high content of the isomers neral and geranial, often collectively referred to as citral. Fresh rhizomes of 17 clones of Australian ginger, including commercial cultivars and experimental tetraploid clones, were steam distilled 7 weeks post-harvest, and the resulting oils were analyzed by GC-MS. The essential oils of 16 of the 17 clones, including the tetraploid clones and their parent cultivar, were found to be of substantially similar composition. These oils were characterized by very high citral levels (51-71%) and relatively low levels of the sesquiterpene hydrocarbons typical of ginger oil. The citral levels of most of these oils exceeded those previously reported for ginger oils. The neral-to-geranial ratio was shown to be remarkably constant (0.61 ( 0.01) across all 17 clones. One clone, the cultivar “Jamaican”, yielded oil with a substantially different composition, lower citral content and higher levels of sesquiterpene hydrocarbons. Because this cultivar also contains significantly higher concentrations of pungent gingerols, it possesses unique aroma and flavor characteristics, which should be of commercial interest.

Microgrid frequency control using multiple battery energy storage system (BESSs)

The work is a report of research on using multiple inverters of Battery Energy Storage Systems with angle droop controllers to share real power in an isolated micro grid system consisting of inertia based Distributed Generation units and variable load. The proposed angle droop control method helps to balance the supply and demand in the micro grid autonomous mode through charging and discharging of the Battery Energy Storage Systems while ensuring that the state of charge of the storage devices is within safe operating conditions. The proposed method is also studied for its effectiveness for frequency control. The proposed control system is verified and its performance validated with simulation software MATLAB/SIMULINK.

The storage stability of passionfruit concentrate

Passionfruit (Passiflora edulis) concentrates (542 g/kg soluble solids) prepared in a wiped-film evaporator were stored for up to 6 months at - 18°, 4° and 20°C. Yeast and mould counts were taken and colour changes noted during storage. When suitable diluted concentrate colour and flavour were acceptable for 1 month at 20°C, 3 months at 4°C and 6 months at -18°C. Commercial short-term storage of concentrate at temperatures above -18°C appears to be feasible. An address presented to the 20th Annual Convention AIFST, Albury NSW, 16th- 20th May, 1987

Storage of Macadamia Nut-In-Shell

The effect of moisture content and storage temperature on the high quality storage life on macadamia nut-in-shell (NIS), and the subsequent influence of NIS storage on the shelf-life of roasted kernel, is being investigated. Macadamia integrifolia 'Keauhou" (HAES 246) NIS is being stored at 5°, 25°C and 40°C with a moisture content of 15.0, 12.5, 10.0, 7.5 and 3.5% for a maximum of 12 months. Preliminary results showed that unacceptable levels of visual mould developed on NIS with 15.0 and 12.5% moisture at 25°C following relatively short periods of storage. Discolouration and the production of an off-flavour in the raw kernel resulted after 1 month's storage of NIS with a moisture content of 10.0% at 40°C. Roasting times were reduced with increased storage duration of NIS with a moisture content of 15.0, 12.5 and 10.0% at 25°C, 15.0 and 12.5% at 5°C and 3.5% at 40°C. The percentage of roasted kernel rejects increased with increased storage duration of NIS with a moisture content of 15.0 and 12.5% at 25°C.

Near infrared reflectance as a rapid and inexpensive surrogate measure for fatty acid composition and oil content in peanuts (Arachis hypogaea L.)

The fatty acid composition of ground nuts (Arachis hypogaea L.) commonly known as peanuts, is an important consideration when a new variety is being released. The composition impacts on nutrition and, importantly, self-life of peanut products. To select for suitable breeding material, it was necessary to develop a rapid, non-derstructive and cost-efficient method. Near infrared spectroscopy was chosen as that methodology. Calibrations were developed for two major fatty-acid components, oleic and linoleic acids and two minor components, palmitic and stearic acids, as well as total oil content. Partial least squares models indicated a high level of precision with a squared multiple correlation coefficient of greater than 0.90 for each constitutent. Standard errors for prediction for oleic, linoleic, palmitic, stearic acids and total oil content were 6.4%, 4.5%, 0.8%, 0.9% and 1.3% respectively. The results demonstrated that reasonable calibrations could be developed to predict oil composition and content of peanuts for a breeding programme.

Impact of cold storage on glucosinolate levels in seed-sprouts of broccoli, rocket, white radish and kohl-rabi

The effect of cold storage on glucosinolate concentration was examined in 7-day-old seed-sprouts of broccoli, kohl rabi, white radish and rocket. Principal glucosinolates identified were glucoraphanin and glucoerucin (in broccoli, kohl rabi and rocket), glucoiberin (in broccoli and kohl rabi), and glucoraphenin and glucodehydroerucin (in white radish). Generally, sprouts showed no significant changes in individual glucosinolate concentrations during storage at 4°C for 3 weeks. The exception to this was rocket, which showed a significant decline in glucoerucin and glucoraphanin after 1 and 2 weeks, respectively. These preliminary results indicate that as there is no significant loss of glucosinolates in broccoli, radish and kohl rabi sprouts, these sprouts may be stored under domestic refrigeration conditions without significant loss of potential anti-cancer compounds. Rocket sprouts, on the other hand, should be consumed soon after purchase if glucosinolate levels are to be maintained.

Statistical Optimization of Iron Electrodes for Alkaline Storage Batteries

A pressed-plate Fe electrode for alkalines storage batteries, designed using a statistical method (fractional factorial technique), is described. Parameters such as the configuration of the base grid, electrode compaction temperature and pressure, binder composition, mixing time, etc. have been optimised using this method. The optimised electrodes have a capacity of 300 plus /minus 5 mA h/g of active material (mixture of Fe and magnetite) at 7 h rate to a cut-off voltage of 8.86V vs. Hg/HgO, OH exp 17 ref.

Oxygen transfer in circular surface aeration tanks

Surface aeration systems employed in activated sludge plants are the most energy-intensive units of the plants and typically account for a higher percentage of the treatment facility's total energy use. The geometry of the aeration tank imparts a major effect on the system efficiency. It is said that at optimal geometric onditions, systems exhibits the maximum efficiency. Thus the quantification of the optimal geometric conditions in surface aeration tanks is needed. Optimal geometric conditions are also needed to scale up the laboratory result to the field installation. In the present work, experimental studies have been carried out on baffled and unbaffled circular surface aeration tanks to ascertain the optimal geometric conditions. It is found that no optimal geometric conditions exist for the liquid/water depth in circular surface aeration tanks; however, for design purposes, a standard value has been assumed. Based on the optimal geometric conditions, a scale-up equation has been developed for the baffled circular surface aeration tanks.

Evaluation of three storage systems used for chilling and holding swordfish

Swordfish are kept chilled, not frozen, for up to 15 days before being unloaded at Australian ports. Swordfish landed alive, and to a lesser extent prerigor, have better quality when unloaded. Warmer fishing waters did not lead to poorer quality at unloading. There was a serious loss of quality during long fishing trips. Sex had no influence on swordfish quality. Three methods of chilling were evaluated: refrigerated seawater (RSW) chilling for up to 2 days followed by storage under ice, refrigerated brine (seawater with extra salt added) for up to 2 days followed by storage in a freshwater ice slurry, and ice slurry (freshwater ice mixed with seawater) for up to 2 days followed by storage under ice only. Two fishing trips were monitored for each method. The freshness indicator K value was used to determine which method produced the best quality swordfish when unloaded at the factory. Storage method played a larger role in quality loss than capture conditions. Refrigerated brine produced the best quality swordfish when the machinery functioned properly closely followed by RSW. Ice slurry chilling of large fish such as swordfish exhibited initial delays in the reduction of core temperature which led to lower quality. This method could be improved with the addition of mechanical circulation. Mechanical problems, which resulted in minor increases of temperature during brine storage, led to a much larger loss of quality than would be expected.

Clonal propagation and storage of subtropical pines in Queensland, Australia

Clonal forestry is the approach used for deployment of Pinus elliottii x P. caribaea hybrids in Queensland, Australia. Clonal forestry relies on the ability to maintain juvenility of stock plants while selections are made in field tests, so that genetic gains are not eroded by the effects of stock plant maturation. Two parallel approaches are employed in Queensland to maintain juvenility of clonal material. Firstly, the ortet and several ramets of each clone are maintained as archive hedges <20-cm height for the duration of field tests. Secondly, shoots from archive hedges are stored in tissue culture at low temperature and low irradiance to slow growth and slow maturation. Once the best clones have been identified, production hedges are derived from both archive hedges and tissue culture shoots. About 6 million rooted cuttings are produced annually, representing almost the entire planting program of Pinus in subtropical Queensland.

Ways and Means for Disposal of Surplus Water in Storage Reservoirs and other Irrigation and Flood Protective Works

In the paper new way of classifying spillways have been suggested. The various types, merits and demerits or existing spillway devices have been discussed. The considerations governing the choice of a design of a spillway have been mention. A criteria for working out the economics of spillway design has been suggested. An efficient surplus sing device has next been described and compared with other devices. In conclusion it has been suggested that the most efficient and at the same time economical arrangement will be a combination of devices. In conclusion it has been suggested will be a combination of crest gate, volute siphons and high head gates. The appendix gives a list of devices used in dams in various parts of the world.

Value-adding Australian sardines: Factors affecting rates of deterioration in sardine (Sardinops sagax) quality during post-harvest handling

Deficiencies in sardine post-harvest handling methods were seen as major impediments to development of a value-adding sector supplying Australian bait and human consumption markets. Factors affecting sardine deterioration rates in the immediate post-harvest period were investigated and recommendations made for alternative handling procedures to optimise sardine quality. Net to factory sampling showed that post-mortem autolysis was probably caused by digestive enzyme activity contributing to the observed temporal increase in sardine Quality Index. Belly burst was not an issue. Sardine quality could be maintained by reducing tank loading, and rapid temperature reduction using dedicated, on-board value-adding tanks. Fish should be iced between the jetty and the processing factory, and transport bins chilled using an efficient cooling medium such as flow ice.

Management of mould mite Tyrophagus putrescentiae (Schrank) (Acarina: Acaridae): A case study in stored animal feed

An integrated pest management (IPM) strategy was developed to manage infestations of mould mite Tyrophagus putrescentiae (Schrank) in stored animal feed, due to the increasing importance of these mites as pests of feed processing and storage facilities in Australia. This strategy involved several aspects such as limiting the moisture content of the processed feed to 12%, admixing vegetable oil to some feed (2% w/w), strict hygiene practice in and around the processing and storage facility, and rejection of infested grain at the receiving point. Additionally, seven contact insecticides and the fumigant phosphine were evaluated for their effectiveness against the mould mite to assess their potential integration into the IPM strategy. Among them, pyrethrin synergised with piperonyl butoxide, the insect growth regulator s-methoprene and a newly developed bacterium-based material spinosad controlled the mites. Moreover, the fumigant phosphine at 1 mg/litre over a six days exposure period also controlled these mites. So far, the IPM strategy, without any involvement of insecticides or fumigant has resulted in a complete eradication of the mite population in this particular case of stored animal feed.